1495D. Installation and Operation Manual, 230 Voltage 2/16/2017

Transcription

1 1495D Installation and Operation Manual, 230 Voltage 2/16/2017

2

3 VWR Vacuum Oven 230 Voltage (1495D) Installation and Operation Manual Part Number (Manual): Revision: February 16, 2017 Ü CAN/CSA-C22.2 No : U1: CAN/CSA-C22.2 No :2015 UL :2012/R: UL :2015 EN :2010 EN :2014

4 INTRODUCTION... 5 General Safety Considerations... 5 Engineering Improvements... 6 Contacting Assistance... 6 Recording Data Plate Information... 6 RECEIVING YOUR OVEN... 6 Inspect the Shipment... 7 Orientation Photo... 8 Vacuum Pump... 9 Gaskets... 9 Reference Sensor Device... 9 INSTALLATION Hardwire Requirement Installation Checklist Required Ambient Conditions Environmental Disruptions Power Source Requirements Power Feed Wiring Lifting and Handling Leveling Install the Oven Installation Cleaning Install the Shelving Connect to the Vacuum Supply GRAPHIC SYMBOLS CONTROL PANEL OVERVIEW OPERATION Operating Precautions Theory of Operation Put the Oven into Operation Set the Constant Temperature Set Point Put the Chamber Under Vacuum Set the Over Temperature Limit Heating Profiles USER MAINTENANCE Cleaning and Disinfecting Maintaining Atmospheric Integrity Electrical Components Vacuum Pump Maintenance Calibrate the Temperature display UNIT SPECIFICATIONS Weight Dimensions Capacity Shelf Capacity by Weight Temperature Power REPLACEMENT PARTS... 44

5 GENERAL SAFETY CONSIDERATIONS Note:

6 ENGINEERING IMPROVEMENTS CONTACTING ASSISTANCE RECORDING DATA PLATE INFORMATION Model Number Serial Number

7 INSPECT THE SHIPMENT Guide Profile Programming Included Accessories 3 Shelves 12 Shelf Clips 4 Leveling Feet 1Oil Drain Tray*

8 ORIENTATION PHOTO Figure 1: 1495D

9 VACUUM PUMP GASKETS REFERENCE SENSOR DEVICE

10

11 HARDWIRE REQUIREMENT INSTALLATION CHECKLIST Pre-Installation Install the Oven in a suitable workspace location Set up the Oven for use

12 REQUIRED AMBIENT CONDITIONS ENVIRONMENTAL DISRUPTIONS

13 POWER SOURCE REQUIREMENTS o POWER FEED WIRING

14 LIFTING AND HANDLING LEVELING Note: INSTALL THE OVEN

15 INSTALLATION CLEANING INSTALL THE SHELVING Figure 3: Installing Shelf Clip Figure 2: Shelf Placed on the Clips

16 CONNECT TO THE VACUUM SUPPLY

17 o o o o o o

18

19 Symbol Definition

20

21 Figure 4: Control Panel Power Switch Vacuum Power Switch Over Temperature Limit Thermostat (OTL) Push to Reset

22 Vacuum Gauge

23 Vent Valve o Vacuum Valve

24

25 OPERATING PRECAUTIONS Warning: The oven is not an explosion-proof unit! Avertissement: Ce sont des fours pas résistants aux explosions. Warning Hot Surfaces: These areas are marked with Hot Surface labels. Proper PPE should be employed to minimize risk to burn. Avertissement Surface Chaude: Ces zones sont marqués avec des étiquettes de Surface chaude. Les EPI approprié devraient être employée pour réduire au minimum le risque de brûler.

26 THEORY OF OPERATION

27 Heating Control

28 Note: PUT THE OVEN INTO OPERATION

29 10 Minute Minimum

30 Note: Note: SET THE CONSTANT TEMPERATURE SET POINT

31 PUT THE CHAMBER UNDER VACUUM Vacuum Down

32

33 SET THE OVER TEMPERATURE LIMIT PUSH TO RESET

34 OTL Activation During Normal Operations HEATING PROFILES

35 Warning: Prior to any maintenance or cleaning of this unit, disconnect the power cord from the power supply. Avertissement: Avant d'effectuer toute maintenance ou entretien de cet appareil, débrancher le cordon secteur de la source d'alimentation. CLEANING AND DISINFECTING Cleaning

36 Disinfecting MAINTAINING ATMOSPHERIC INTEGRITY ELECTRICAL COMPONENTS VACUUM PUMP MAINTENANCE

37 CALIBRATE THE TEMPERATURE DISPLAY Note: SET VACUUM

38 Figure 5: Heat Up and Stabilization Phases Oven Chamber Reference Device Reference Device Reference Sensor Reading Oven Temp. Display Offset Value

39

40 Operations Menu

41 Reference Device Reference Device

42 WEIGHT Shipping Net Weight DIMENSIONS Exterior W D H Interior W D H Exterior W D H Interior W D H CAPACITY Cubic Feet Liters SHELF CAPACITY BY WEIGHT Per Shelf Total

43 TEMPERATURE Range Uniformity Stability Heat Up Time to 150 POWER Model AC Voltage Amperage Frequency Phase

44 Description Parts Number

45