Spare parts list. Hydraulic compactor RC

Transcription

1 Spare parts list Hydraulic compactor RC 150 RC 150 Valid from serial number BGF Valid to serial number

2 RC 150 Spare parts list General information This spare parts list applies to the following: Part number Description Hydraulic compactor RC 150 Use only authorized parts. Any damage or malfunction caused by the use of unauthorized parts is not covered by Warranty or Product Liability. Any unauthorized use or copying of the contents or any part thereof is prohibited. This applies in particular to trademarks, model denominations, part numbers, and drawings. Instructions for use This spare parts list contains no safety regulations and is merely intended to assist in the ordering of spare parts. For information about operating, servicing, or repairing, the relevant Safety and operating instructions must be consulted at all costs. Please observe the safety instructions listed in the relevant Safety and operating instructions! Instructions for ordering It is essential to indicate the serial number of the hydraulic attachment when ordering spare parts! Determine the quantity of individual parts which are required and need to be ordered. The order must indicate the following details: full identification code of the hydraulic attachment required quantity part number description

3 Contents Service, repair and wear part kits Kit list 1 Mechanical Hydraulic compactor 3 Tightening torques 5 Dimensions 7 Options / accessories Hydraulic hoses 8 Optional equipment 11

4 Service, repair and wear part kits Kit list Mon Jul 18 02:37:16 MDT

5 Item Part No. Name Qty L KIT Label kit 1 KIT Seal kit (Hydraulic motor) 1 KIT Rubber isolator kit Rubber isolator Nut Spring washer Hex. Head screw M16 x Washer 17 x 45 x 6 mm Plain washer 17x30x3 4 Mon Jul 18 02:37:16 MDT

6 Mechanical Hydraulic compactor Mon Jul 18 02:37:17 MDT

7 Item Part No. Name Qty L Vent valve Outer housing Rubber isolator Hydraulic hose Rotor Fitting, 90, 9/16-18 UNF-2A, 9/16-18 UNF-2A Hydraulic hose Hydraulic hose Rotor housing Valve block, hydraulic motor side and carrier side: female thread 3/4" - 16" UNF Fitting Tamper plate Cap Nut Plug Bearing Bearing retainer Bearing retainer Washer DIN Washer DIN Spring washer Plug Screw Hex. Head screw M16 x Washer 17 x 45 x 6 mm Hydraulic motor Hex. head screw M10 x 25 mm Hex. head screw M12 x Plain washer 17x30x O-ring 140 x 5 mm 70 IRH (NBR) O-ring 84 x 3 mm 70 IRH (NBR) Fitting 90, 3/4" - 16 UNF-2A, 7/8-14 UNF-2A Seal washer x 23.8 x Bearing cover Fitting, bulkhead ¾" UNF 37º - JIC ½" male Fitting, straight UNF 3/4-16, UNF-2A 3/ Mon Jul 18 02:37:17 MDT

8 Mechanical Tightening torques Mon Jul 18 02:37:18 MDT

9 Item Part No. Name Qty L 1 - Open-ended wrench - pretighten finger tight, then 1-2 turns tighten with the openended wrench Open-ended wrench Nm Allen key - pretighten finger tight, then 1-2 turns tighten with the Allen key Allen key Nm Open-ended wrench - 54 Nm Open-ended wrench Nm Open-ended wrench - 54 / 93 Nm - Mon Jul 18 02:37:18 MDT

10 Mechanical Dimensions Mon Jul 18 02:37:18 MDT

11 This page intentionally left blank Mon Jul 18 02:37:19 MDT

12 Options / accessories Hydraulic hoses Mon Jul 18 02:37:19 MDT

13 Item Part No. Name Qty L Not Shown - Pressure line / tank line Hydraulic hose, I.D. 12 (0.47"), both ends M22 x 1.5, conical seal 24º, length 1750 mm (69 in.) Hydraulic hose, I.D. 12 (0.47"), both ends M22 x 1.5, conical seal 24º, length 2100 mm (83 in.) 2 2 Not Shown - Accessories to the hydraulic hoses Fitting set 1 Not Shown - Drainage for hydraulic motor Hydraulic hose, I.D. 8 (3/8"), M20 x 1.5 conical seal 24-9/16-18 JIC, length 2800 mm (110 in.) 1 Comments for Page: Hydraulic hoses Note Remove the genuine fittings carrier side from the valve block before mounting the fitting set. Mon Jul 18 02:37:19 MDT

14 Options / accessories Optional equipment Mon Jul 18 02:37:19 MDT

15 Item Part No. Name Qty L Cobra & compactor Impact-OIL 1L Cobra Compactor Impact-Oil, 20x1 L (0.22 gal) (0.26 US gal) 1 Not Shown - Adapter plate matching the carrier. Consult the Chicago Pneumatic Customer Center/Dealer in your area Base plate with through borings Bolt kit Open end spanner (24/27 mm) Backfill blade kit 1 Mon Jul 18 02:37:19 MDT

16 No Copyright Construction Tools GmbH