2000 WATT CYCLONIC BAGLESS VACUUM CLEANER

Transcription

1 Instruction Manual 2000 WATT CYCLONIC BAGLESS VACUUM CLEANER Model Rated Voltage (V) Rated Frequency (Hz) Rated Power (W) V V 50 Hz 2000 Watts Model: V0409 Please read this Instruction Manual carefully before operation and follow all guidelines before using this vacuum cleaner. Please keep this Manual for future reference. 1

2 TABLE OF CONTENTS SAFETY INSTRUCTIONS... 3 ASSEMBLY... 5 VARIABLE SUCTION CONTROL... 5 MOTOR THERMOSTAT... 6 HIGH EFFICIENCY DOUBLE CYCLONE SYSTEM... 6 REMOVING THE DUST CANISTER... 6 CARRYING THE VACUUM CLEANER... 7 CLEANING THE PRE-MOTOR FILTER... 7 CLEANING THE OUTLET FILTER... 7 CONDITIONS OF WARRANTY

3 SAFETY INSTRUCTIONS FOR HOUSEHOLD USE ONLY! When using your vacuum, basic safety precautions should always be observed, including the following: 1. Do not leave vacuum cleaner unattended when it is plugged in. Unplug from outlet when not in use and before pulling filters out. 2. To reduce the risk of electric shock, do not use outdoors or on wet surfaces. 3. Do not allow children to use vacuum. Close attention is necessary when used near children. 4. Use only as described in this manual. Use only manufacturer s recommended attachments. 5. Do not use with damaged cord or plug. Do not use vacuum cleaner if it has been dropped, damaged, left outdoors or dropped into water. Return appliance to the place of purchase for examination, repair or adjustment. 6. Do not pull or carry by cord. Do not use cord as a handle, close a door on the cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces. 7. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord. 8. Do not handle plug or vacuum cleaner with wet hands. 9. Do not put any objects into openings. Do not use with any openings blocked and do not restrict airflow. Keep all openings free of dust, lint, hair, and anything that may reduce airflow. 10. Keep hair, loose clothing, fingers and all parts of body away from openings and moving parts. 11. Do not pick up hard or sharp objects such as nails, screws, coins, etc. 12. Do not pick up hot coals, cigarettes, matches or any hot, smoking or burning objects. 13. Do not use without filters in place. 14. Turn off all controls before plugging or unplugging vacuum cleaner. 15. Use extra care when vacuuming on stairs. 16. Do not pick up flammable or combustible materials (lighter fluid, gasoline, etc) or use in the presence of explosive liquids or vapor. 17. Do not pick up toxic materials (ie. chlorine, bleach, ammonia, drain cleaner, etc). 18. Do not use n an enclosed space filled with vapors given off by oil based paints, paint thinner, moth proofing, flammable dust or other explosive or toxic vapors. 19. Always unplug this appliance before connecting or disconnecting vacuum hose. Do not allow plug to whip when rewinding. 20. Use only on dry indoor surfaces. 21. Do not use for any purpose other than described in this manual. 22. Store your appliance indoor in a cool dry area. 23. Do not immerse the hand vacuum into water or other liquids. 24. Keep end of hose, wands and other openings away from your face and body. 25. Do not use the cleaner to clean your pets or any animal. 26. Keep the head (eyes, ear, mouth, etc) away from the openings, when the cleaner is working. 27. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. 28. Children should be supervised to ensure that they do not play with the appliance. 29. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. 3

4 WARNINGS: If the suction opening of the unit, the hose or the telescopic tube are blocked, turn off the vacuum cleaner and remove the blocking substance before you start the unit again. 1. Do not operate the vacuum cleaner too close to a heater or radiators. 2. Before inserting the power plug into the wall outlet, make sure that your hands are dry. 3. Before you start the unit, make sure to remove large or sharp objects that might damage the dust tank and hose. 4. When pulling out the power plug from the wall outlet, pull the plug not the power cord. 5. Do not use without all filters in place. Note: This vacuum cleaner is equipped with a plug and power cord that retract automatically. If the cord or plug get damaged, it must be replaced by a qualified technician. Warning: Hold the plug when rewinding the cord. Do not allow the cord to whip when rewinding. 4

5 ASSEMBLY Note: Always remove the power plug from the wall outlet before assembling or removing accessories. 1. Connect the end of the flexible hose into the air intake duct of the vacuum cleaner (picture 1). Push it in until you hear a click, indicating it is locked into position. 2. Push the chrome telescopic tube into the curved wand/hose extension. 3. Push forward on the plastic button of the telescopic tube to extend it (picture 2). 4. Push the telescopicc tube into the floor brush. Adjust the tube to the desired length. Picture 1. Picture 2. VARIABLE SUCTION CONTROL Note: Once all attachments are in place, unwind a sufficient length of cable and insert the plug into the wall outlet. A yellow mark on the power cord shows the ideal cable length. Do not pull the power cord beyond the red mark. 1. Insert the power plug into the wall outlet. 2. Press the power on/off button (picture 3) to turn the vacuum cleaner on, and adjust the revolving control button to adjust the suction power (picture 4). 3. To rewind the power cord, press the cord rewind button (picture 3) with one hand and guide the power cord with the other hand to ensure that it does not whip causing damage or injury. 4. To adjust the suction power, slide the variable suction control button on the suction hand to control the suction power of the vacuum cleaner. Rewind Button Picture 3. On/Off Button Picture 4. Revolving Control Button 5

6 MOTOR THERMOSTAT T Important: This motor is equipped with a motor protective thermostat. If for some reason the vacuum cleaner should overheat, the thermostat will automatically turn the unit off. Should this occur, unplug the vacuum cleaner from the wall outlet and turn off switch. Remover dust cup and empty dust cup filter. Allow the unit to cool for approximately 1 hour. To restart, re-plug into wall outlet and turn switch back on. HIGH EFFICIENCY DOUBLE CYCLONE SYSTEM Note: This vacuum cleaner has a special feather-double cyclone for dust collection that is composed of two parts which are inner and outer dust chambers. The double cyclone canister ensuress that the majority of the dust stays in the outer space and only some tiny dust particles will get to the inner part. This guarantees the airflow into the motor and the air current out of the unit is neat. When the outer space is full, you can take out the canister and press the button to release the bottom lid above the dust basket (picture 5). Canister Button Bottom Lid Picture 5. REMOVING THE DUST CANISTER 1. Depress the buttons at the top/front on the revolving arm (picture 6) and lift it up. The dust canister will then be released so you can remove it. 2. Take out the dust canister and empty it if required by pressing the button on the canister handle (picture 5). 3. To re-insert the dust canister, fit the canister in and make sure it is secured into the right position. 4. Close the revolving arm down and make sure it locks into place with the unit. Handle Picture 6. Revolving Arm Picture 7. Canister Handle 6

7 CARRYING THE VACUUM CLEANER 1. When the vacuum cleaner is in the horizontal position, you can pick it up by using the handle on top of the unit (picture 6). 2. When the vacuum cleaner is in the vertical (upright) position, you can use the carry-handle in front of the dust canister (picture 7) to carry the unit. CLEANING THE PRE-MOTOR FILTER Warning: Always unplug the unit from electrical outlet before removing the dust canister. 1. Push the power on/off button to off and disconnect the power cord from the wall outlet. 2. Remove the flexible hose. 3. Depress the buttons at the top/front on the revolving arm (pictures 6 and 7) and lift the revolving arm up. 4. Remove the dust canister from the unit. 5. Take out the round pre-motor filter from underneath the revolving arm. 6. Use clean water to clean the filter. 7. Dry the filter thoroughly and insert the filter back into position (do not place the filter next to fire or high temperature objects). 8. Close the revolving arm down until it locks into position and re-attach the vacuum hose. Please note: The sponge filter material in the cleaner will became dusty over time. This is normal and will not affect the performance of the filter. If the sponge filter is so dusty that suction does not return to 100%, then we suggest that the filter be removed and rinsed under clean water and allowed to dry for 24 hours by airing before refitting into the vacuum (do not place the filter next to fire or high temperature objects). This should be done once every six months or when suction appears to be reduced. Important: Please note that there is a safety switch inside the vacuum to prevent the unit from overheating. If the vacuum temperature is too high, the safety switch will be turned on. This will help prevent the motor from burning out. Note: The suction hole of the unit must be open and free of any obstructions at all times. Otherwise, the motor will overheat and could become damaged. CLEANING THE OUTLET FILTER The vacuum cleaner has an outlet filter to ensure the air current out of the unit is clean. It is situated on the bottom of the unit (underneath the vacuum cleaner). To remove it, simply release the knobs on the outlet filter grid, then the grid will pop out automatically. To ensure optimal filtering of the exhaust air, you should occasionally clean the sponge filter by rinsing under clean water and then dry it thoroughly before inserting it back into place. 1. Remove the outlet filter grid. 2. Now remove the sponge outlet filter and clean it by rinsing under clean water. The sponge filter should be replaced every 6-12 twelve months depending on usage. Never operate the vacuum cleaner without all filters in their correct place. 3. Dry the filter thoroughly before inserting it back into place (do not place the filter next to fire or high temperature objects). Important: All filters should be checked regularly for signs of damage, preferably after each cleaning task. The filters must be replaced immediately if they become damaged. Always disconnect the vacuum from the electrical outlet when checking the filters. 7

8 Cleanstar Pty Ltd ABN: ACN: Radford Road, Reservoir VICTORIA 3073 Phone: (03) Fax: (03) Web: CONDITIONS OF WARRANTY This document outlines the terms and conditions of warranty for your Cleanstar product. This is an important document that should be kept with your proof of purchase documents in a safe place for future reference should you require service for your product. Thank you for purchasing your new Cleanstar product. We are confident this product will give you trouble-free use and excellent service, provided the operator uses and maintains the product in accordance with the Instruction Manual. Please read the Instruction Manual carefully before using the product for correct operation and maintenance procedures, and store it in a safe place for future reference. 1. This is a parts and labour warranty against faulty or defective parts, materials or workmanship in manufacturing, when the product is used and operated in accordance with the Instruction Manual. 2. This product carries a 12 month (1 year) warranty period that commences from the original date of purchase by the first user/purchaser, and is not transferable. 3. The warranty covers only personal, domestic or household use of the product to remove dry dirt and dust from household carpets, flooring and fabrics. 4. This product is not suitable for commercial or industrial cleaning applications and therefore no warranty applies in this case. 5. This warranty only applies to products purchased and used in Australia. 6. At all times during the warranty period, Cleanstar shall, at its sole discretion, determine whether repair, replacement or refund will apply if the product has a valid warranty claim applicable to it. 7. The repair or replacement of the product under this warranty does not extend the original period of warranty. 8. Please note that this warranty will be voided in the following cases (which are not exhaustive) and the warranty does not apply to the cost of replacing any parts of the product resulting from: Accidental damage; Normal wear and tear; Neglect, misuse or physical abuse by the operator, including failure to properly maintain or service; Any alterations, modifications or tampering with the product without the prior written consent of Cleanstar; Incomplete or improper installation; Incorrect, improper or inappropriate operation; Insect or vermin infestation; Power surges, electrical storm damage or incorrect power supply/voltage; Excessive use or use for which this product has not been designed; Vacuuming up water, liquids, toner, powders, glass, hazardous, flammable or corrosive materials, plaster dust, concrete dust and other similar building or construction materials; 8

9 Failure to comply with the operating instructions contained in the Manual supplied with the product; If the product is rented; If the product is used outside of Australia; If the product was serviced or repaired by anyone other than Cleanstar, or one of Cleanstar s Authorised Service Agents (ASA). Cleanstar is unable to accept any responsibility under this warranty for any repair work not carried out by an ASA or from the use of non-genuine parts. 9. This warranty does not cover service calls, travelling time or consumable parts such as belts, dust bags, filters, hose or hose parts, rods and wands, floor tools and accessories, motor brushes and other like consumable items, unless defective in manufacture. In order to prolong the life of accessories and consumables, regular care and maintenance is recommended. 10. Please retain your original proof of purchase which will be required before you can make a claim under this warranty. If proof of purchase can not be provided at the time of a warranty claim or service, any work carried out on the cleaner is chargeable. 11. Any transportation and delivery costs involved in the repair of defective parts shall be borne by the claimant. In all instances, unless the product is transported by Cleanstar or a Cleanstar authorised representative, the product is transported at the owner s cost and risk while in transit to and from Cleanstar or its ASA. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The benefits conferred by this warranty are in addition to other rights and remedies under law in respect of the product to which this warranty relates. TO INQUIRE ABOUT MAKING A CLAIM UNDER THIS WARRANTY, PLEASE FOLLOW THESE STEPS: a) carefully check the Instruction Manual and the terms of this warranty; b) have the name and model number of the appliance available; c) have the proof of purchase available (ie. invoice, receipt, etc) showing where the appliance was purchased from and date of purchase; d) call Cleanstar on (03) to speak to one of our customer service staff. 9