1 Features. Outdoor Units R-410A RYN-E3V1B. Split Sky Air Outdoor Units

Transcription

1 Features O u t d o o r U n i S p l i t S k y R Y N - E V B R a Outdoor units for pair application Daikin outdoor units are neat and sturdy and can be mounted easily on a roof or terrace or simply placed against an outside wall. Outdoor units are fitted with a swing compressor, renowned for its low noise and high energy efficiency

2 2 Specifications 2- NOMINAL CAPACITY AND NOMINAL INPUT RYN50EVB RYN60EVB For combination indoor units + outdoor units Cooling capacity Heating capacity Units FTYN50EVB FTYN60EVB Standard kw Standard kw Nominal input Cooling Standard kw For combination indoor units + outdoor units Cooling capacity Heating capacity Heating Standard kw EER Nominal.2.02 COP Nominal.6.4 Energy Labeling Directive Cooling A B Heating A B Annual energy consumption kwh Units FTYN50FVB FTYN60FVB Standard kw Standard kw Nominal input Cooling Standard kw For combination indoor units + outdoor units Heating Standard kw EER Nominal.2.02 COP Nominal.6.4 Energy Labeling Directive Cooling A B Heating A B Annual energy consumption kwh TECHNICAL SPECIFICATIONS RYN50EVB RYN60EVB Casing Colour Ivory White Dimensions Unit Height mm Width mm Depth mm Packing Height mm Width mm Depth mm Weight Unit kg Heat Exchanger Packed Unit kg 5 5 Dimensions Length mm Tube type Nr of Rows 2 2 Fin Pitch mm Nr of Stages 2 2 Hi-Xa(8) Fin Type Waffle fin Treatment Anti-corrosion treatment (PE) Fan Type Propeller Motor Quantity Air Flow Rate (nominal at 20V) Cooling m³/min Heating m³/min Motor Quantity Speed (nominal) Model KFD A Cooling rpm Heating rpm Fan Motor Output W 5 5 2

3 2 Specifications TECHNICAL SPECIFICATIONS RYN50EVB RYN60EVB Compressor Quantity Operation Range Sound Level (nominal) Motor Model 2YC6BXD#A Type Motor Output Hermetically sealed swing compressor W Cooling Min CDB Max CDB Heating Min CWB -5-5 Cooling Heating Max CWB 8 8 Sound Power Sound Pressure Sound Pressure dba dba dba Refrigerant Type R-40A Charge kg.5.5 Refrigerant Oil Type FVC50K Piping connections Standard Accessories Notes Charged Volume l Liquid (OD) Gas Drain Diameter (OD) Diameter (OD) Diameter (OD) mm mm mm 8 8 Piping Length Maximum m 0 0 Additional Refrigerant Charge Max. internunit level difference Heat Insulation Item kg/m 0.02/>0m m Both liquid and gas pipes Drain plug Quantity Item Installation manual Quantity Nominal cooling capacities are based on : indoor temperature : 270CDB, 90CWB, outdoor temperature : 50CDB, equivalent refrigerant piping : 7.5m, level difference : 0m. Nominal heating capacities are based on : indoor temperature : 200CDB, outdoor temperature : 70CDB, 60CWB, equivalent refrigerant piping : 7.5m, level difference : 0m Sound levels are measured in an anechoic room Sound pressure level is a relative value, depending on the distance and acoustic environment. For more details, please refer to sound level drawings of this chapter. The sound power level is an absolute value indicating the power which a sound source generates. 2- ELECTRICAL SPECIFICATIONS RYN50EVB RYN60EVB Power Supply Name V Current Phase Frequency Hz Voltage V Voltage range Minimum V -0% Nominal running current (RLA) Maximum V +0% Cooling (A) Heating (A) Starting current (cooling/ heating) A A A Z-max List No requirements

4 2 Specifications 2- ELECTRICAL SPECIFICATIONS RYN50EVB RYN60EVB Wiring connections Power Supply Intake For Power Supply For connection with indoor Quantity Quantity 4 4 Remark Including earth wiring Outdoor unit only 2 4

5 Features 5

6 4 Capacity tables 4 - Cooling/Heating capacity tables FTYN50F+RYN50E Cooling 50Hz V AFR 4.7 BF 0.28 Outdoor temperature ( CDB) EWB EDB ( C) ( C) TC SHC PI TC SHC PI TC SHC PI TC SHC PI TC SHC PI TC SHC PI 4 Heating 50Hz V AFR 6. Outdoor temperature ( CWB) EDB ( C) TC PI TC PI TC PI TC PI TC PI D0592A SYMBOLS AFR: Air flow rate (m /min) BF: Bypass factor EWB: Entering wet bulb temp. ( C) EDB: Entering dry bulb temp. ( C) TC: Total capacity (kw) SHC: Sensible heating capacity (kw) PI: Power input (kw) Ratings shown are net capacities which include a deduction for indoor fan motor heat 2 shows nominal (rated) capacities and power input. TC, PI and SHC must be calculated by interpolation using the figures in the above tables. (Figures out of the tables should not be used for calculation.) 4 About SHC which are not mentioned on the table, please calculate them with around values in direct proportion. 5 Capacities are based on following conditions: Corresponding refrigerant piping length: Level difference: 7.5 m 0 m 6 Air flow rate (AFR) and Bypass factor (BF) are taburated above. 6

7 4 4 Capacity tables 4 - Cooling/Heating capacity tables FTYN50FVB+RYN50EVB Cooling 50Hz V AFR 4.7 BF 0.28 Outdoor temperature ( CDB) EWB EDB ( C) ( C) TC SHC PI TC SHC PI TC SHC PI TC SHC PI TC SHC PI TC SHC PI Heating 50Hz V AFR 6. Outdoor temperature ( CWB) EDB ( C) TC PI TC PI TC PI TC PI TC PI D0592A SYMBOLS AFR: Air flow rate (m /min) BF: Bypass factor EWB: Entering wet bulb temp. ( C) EDB: Entering dry bulb temp. ( C) TC: Total capacity (kw) SHC: Sensible heating capacity (kw) PI: Power input (kw) Ratings shown are net capacities which include a deduction for indoor fan motor heat 2 shows nominal (rated) capacities and power input. TC, PI and SHC must be calculated by interpolation using the figures in the above tables. (Figures out of the tables should not be used for calculation.) 4 About SHC which are not mentioned on the table, please calculate them with around values in direct proportion. 5 Capacities are based on following conditions: Corresponding refrigerant piping length: Level difference: 7.5 m 0 m 6 Air flow rate (AFR) and Bypass factor (BF) are taburated above. 7

8 4 Capacity tables 4 - Cooling/Heating capacity tables FTYN60FVB+RYN60EVB Cooling 50Hz V AFR 6.2 BF 0.29 Outdoor temperature ( CDB) EWB EDB ( C) ( C) TC SHC PI TC SHC PI TC SHC PI TC SHC PI TC SHC PI TC SHC PI 4 Heating 50Hz V AFR 7.4 Outdoor temperature ( CWB) EDB ( C) TC PI TC PI TC PI TC PI TC PI D05924A SYMBOLS AFR: Air flow rate (m /min) BF: Bypass factor EWB: Entering wet bulb temp. ( C) EDB: Entering dry bulb temp. ( C) TC: Total capacity (kw) SHC: Sensible heating capacity (kw) PI: Power input (kw) Ratings shown are net capacities which include a deduction for indoor fan motor heat 2 shows nominal (rated) capacities and power input. TC, PI and SHC must be calculated by interpolation using the figures in the above tables. (Figures out of the tables should not be used for calculation.) 4 About SHC which are not mentioned on the table, please calculate them with around values in direct proportion. 5 Capacities are based on following conditions: Corresponding refrigerant piping length: Level difference: 7.5 m 0 m 6 Air flow rate (AFR) and Bypass factor (BF) are taburated above. 8

9 4 4 Capacity tables 4 - Cooling/Heating capacity tables FTYN60F+RYN60E Cooling 50Hz V AFR 6.2 BF 0.29 Outdoor temperature ( CDB) EWB EDB ( C) ( C) TC SHC PI TC SHC PI TC SHC PI TC SHC PI TC SHC PI TC SHC PI Heating 50Hz V AFR 7.4 Outdoor temperature ( CWB) EDB ( C) TC PI TC PI TC PI TC PI TC PI D05924A SYMBOLS AFR: Air flow rate (m /min) BF: Bypass factor EWB: Entering wet bulb temp. ( C) EDB: Entering dry bulb temp. ( C) TC: Total capacity (kw) SHC: Sensible heating capacity (kw) PI: Power input (kw) Ratings shown are net capacities which include a deduction for indoor fan motor heat 2 shows nominal (rated) capacities and power input. TC, PI and SHC must be calculated by interpolation using the figures in the above tables. (Figures out of the tables should not be used for calculation.) 4 About SHC which are not mentioned on the table, please calculate them with around values in direct proportion. 5 Capacities are based on following conditions: Corresponding refrigerant piping length: Level difference: 7.5 m 0 m 6 Air flow rate (AFR) and Bypass factor (BF) are taburated above. 9

10 5 Dimensional drawing & centre of gravity 5 - Dimensional drawing RYN50-60 E Drain outlet (I.D. J 5.9 hose for connection) Minimum space for air passage Wall height on air outlet side = less than 200 unit (mm) 5 4 x holes for anchor bolts (M8 or M0) Brand name label Name plate Wiring inlet In case of removing stop valve cover Terminal strip with earth terminal Outdoor air temperature thermistor Liquid stop valve (J 6.4 CuT) Service port Gas stop valve (J 2.7 CuT) D05657D 0

11 5 Dimensional drawing & centre of gravity 5-2 Centre of gravity RYN50-60E 5 The position of foundation bolt 4D0568C

12 6 Piping diagram RYN50-60E Outdoor unit Heat exchanger Outdoor temperature thermistor Capillary tube 6 Heat exchanger thermistor Capillary tube 2 Capillary tube Muffler with filter Refrigerant flow Cooling Heating Capillary tube 4 Propeller fan Motor operated valve Filter Four way valve on : heating Receiver Muffler Field piping Muffler Liquid stop valve Discharge pipe thermistor Compressor Gas stop valve with service port Field piping D0567D 2

13 7 Sound data 7 - Sound pressure spectrum RYN50E (Cooling) RYN50E (Heating) 7 Octave band sound pressure level Octave band sound pressure level approximate threshold hearing for continuous noise approximate threshold hearing for continuous noise D0577B Octave band center frequency (Hz) Measure in anechoic room 2 Operation noise differs with operation and ambient conditions. The operation noise measuring method is in accordance with JISC962 Legend 50Hz, V D0577B Octave band center frequency (Hz) Measure in anechoic room 2 Operation noise differs with operation and ambient conditions. The operation noise measuring method is in accordance with JISC962 Legend 50Hz, V RYN60E (Cooling) RYN60E (Heating) Octave band sound pressure level Octave band sound pressure level approximate threshold hearing for continuous noise approximate threshold hearing for continuous noise D0576A Octave band center frequency (Hz) Measure in anechoic room 2 Operation noise differs with operation and ambient conditions. The operation noise measuring method is in accordance with JISC962 Legend 50Hz, V D0576A Octave band center frequency (Hz) Measure in anechoic room 2 Operation noise differs with operation and ambient conditions. The operation noise measuring method is in accordance with JISC962 Legend 50Hz, V

14 8 Operation range RYN50-60E Cooling Heating 8 Outdoor temp. ( CDB) Continuous operation Pull-down period Outdoor temp. ( CWB) Continuous operation (-5 CDB) temp. ( CWB) Notes: The graphs are based on the following conditions: + Equivalent piping length 7.5 m + Level difference 0 m + Air flow rate high temp. ( CDB) D0288K 4

15 8 Operation range 8 5