Tesco Stores Ltd Delamare Road, Cheshunt Herts EN8 9SL Tesco Helpline

Transcription

1 Produced after 13th August 2005 Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. Tesco Stores Ltd Delamare Road, Cheshunt Herts EN8 9SL Tesco Helpline

2 guidelines for use Larder Fridge Model TL120

3 2 SAFETY ELECTRICAL CONNECTIONS Do not allow children to tamper with the controls or play with, in or around the Larder Fridge. Disposal The refrigerant used in your appliance and insulation materials require special disposal procedures. An environmentally friendly method of disposal will ensure that valuable raw materials can be recovered and used again. Ensure that none of the pipes on the back of the appliance are damaged prior to disposal. Up to date information concerning options for disposing of your old appliance and packaging from the new one can be obtained from your retailer or local council office. Locks If your Larder Fridge is fitted with a lock, to prevent children being entrapped keep the key out of reach and not in the vicinity of the appliance. If disposing of an old Larder Fridge break off any old locks or latches as a safeguard Note: This appliance must be earthed. This appliance is fitted with a fused three-pin plug to BS 1363 which will be suitable for use in all houses fitted with sockets to current specifications. If the fitted plug is not suitable for your socket outlets, it should be cut off and carefully disposed of. To avoid a possible shock hazard, do not insert the discarded plug into a socket. Fitting a new plug If for any reason you need to fit a new plug, the flexible mains lead must be connected as shown here. The wires in the mains lead fitted to this appliance are coloured in accordance with the following code: CONNECT BLUE TO NEUTRAL (N) CONNECT GREEN AND YELLOW TO EARTH (E) (Note: some appliances do not have earth wires.) CONNECT BROWN TO LIVE (L) MAKE SURE THE CABLE IS HELD BY THE CLAMP Before refitting the plug cover, check that there are no cut or stray strands of wire inside the plug. Use a 13 Amp BS1362 fuse, only BSI or ASTA approved fuses should be used. If you are in any way unsure which plug or fuse to use, always refer to a qualified electrician. Note: After replacing or changing a fuse on a moulded plug which has a fuse cover, the cover must be refitted to the plug, the appliance must not be used without a fuse cover. If lost, replacement fuse covers can be obtained from an electrical shop. This appliance complies with the following EEC Directives: 73 / 23 EEC (Low Voltage Directive) 89 / 336 EEC (EMC Directive). If the colours of the wires in the mains lead of this appliance do not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The green or yellow wire MUST be connected to the terminal which is marked with the letter or symbol E (Earth) or that is coloured green. The blue or brown wire MUST be connected to the terminal that is marked with the letter L or coloured red.

4 3 GETTING TO KNOW YOUR LARDER FRIDGE Before use Please read these instructions carefully before using your new Tesco Larder Fridge. The Larder Fridge is for indoor and domestic use only. CONTROL DIAL ADJUSTABLE SHELVES INSTALLATION Location Your Larder Fridge must be placed on a firm and flat surface. Your Larder Fridge must be level, if it is not the door s magnetic seal alignment will be affected. The room must be well ventilated, dry and have an average room temperature of between 16 C and 32 C. Don t locate your Larder Fridge near a heat source, e.g. a cooker, boiler or radiator. Avoid placing your Larder Fridge in direct sunlight in sun lounges or conservatories. If you are placing your Larder Fridge in an out-building such as a garage, make sure the Larder Fridge is place above the damp course to avoid condensation. Never place the Larder Fridge in a wall recess or into fitted cabinets or furniture. When in place your Larder Fridge must have 100mm of space to the sides and rear, and 200mm of space above. The door should be able to open to a 160 angle. Note: The door of your Larder Fridge is reversible. See instructions on page 4 for details on how to do this. Your Larder Fridge must be level, if it is not the door s magnetic seal alignment will be affected. Adjust the front feet to suit the level of the floor. Switching on WARNING: Before switching on your Larder Fridge, allow your fridge to stand for at least 4 hours after you have moved it. This allows the coolant fluid time to settle. SALAD BIN LEVELLING FEET BOTTLE STORAGE Before switching on your Larder Fridge you may want to clean the inside of your Larder Fridge. Wipe with a weak solution of bicarbonate of soda and rinse with warm water. For full cleaning instructions see page 5. First check that the power socket is compatible with the plug supplied with your Larder Fridge. If not, see Electrical Connections on page 7. Make sure that the power cord is straight without kinks or coils. DO NOT allow the power cord to sit near the compressor at the back of the Larder Fridge as it can become quite hot during operation. Allow your Larder Fridge to operate for 24 hours before placing any food into it. You can then be sure that it is working properly and you will have allowed time for it to reach its correct temperature. Note: If the Larder Fridge won t be used for a long period of time switch it off, unplug and clean it. Leave the door open to prevent the formation of mildew and smell.

5 4 USING YOUR LARDER FRIDGE Adjusting the temperature To change the internal temperature of the Larder Fridge use the control dial, located inside the fridge. The recommended setting at normal room temperature is 3. The Larder Fridge may not operate at the correct temperature if it is in a particularly hot or cold room or if you open the Larder Fridge doors very often. In this case you will need to adjust the control dial accordingly. Checking the temperature If you are concerned that your Larder Fridge is not being kept cold enough, you can check the temperature of your fridge using a special fridge thermometer. They are available from most supermarkets and hardware shops. FRIDGE/FREEZER THERMOMETER C FREEZER FRIDGE To take the temperature of your Larder Fridge, place the thermometer on the middle shelf of the fridge overnight for an accurate reading. The temperature in the fridge should be between 2 C and 5 C. There are three areas of varying temperature in your Larder Fridge allowing you to store your food in the best way. Cool area Store foods such as milk, eggs, yoghurt, fruit juices, hard cheeses, jarred or bottled sauces or jams, and fats such as butter or margarine. COOL COLDEST SALAD BIN Cold area Store raw or uncooked foods, chilled or precooked meats or ready-meals, prepared salads, desserts or cream. Note: Always wrap raw meat of fish before placing in your Larder Fridge to prevent cross-contamination. Place them on the bottom shelf to prevent them from dripping onto other goods. Salad bin This is the most humid part of the fridge. Store whole vegetables, fruit, fresh salad items, eg. lettuce, tomatoes, radishes, here. Note: We recommend that all produce kept in the salad bin be wrapped. DO NOT STORE FLAMMABLE GASES OR LIQUIDS IN THE FRIDGE. COOL Handy hints Shopping Always refrigerate your food as soon as possible after purchasing. Leaving food in your car or at room temperature for a prolonged period of time could raise food temperature to the level at which harmful bacteria may grow. When you are shopping or when you are traveling home, if you keep all the chilled foods together they will help to keep each other cold. Special insulated bags can be bought from most supermarkets and hardware shops. However, these should only be used to get the chilled foods home, not for storing for any prolonged period of time. Always unpack and place chilled foods in the Larder Fridge before storing dry foodstuffs. Storing Cooked meats should always be stored on a shelf above raw meats to avoid bacterial transfer. Keep raw meats on a plate, which is large enough to collect juices and cover it with cling film or foil. Leave space around food and do not over-stock your fridge. This will allow cold air to circulate around the Larder Fridge. To prevent transfer of flavours and drying out, food should be separately packed or covered. Always let pre-cooked food cool down before you put it in the Larder Fridge. This will stop the internal temperature of the Larder Fridge from rising. To prevent cold air escaping, limit the number of times you open the door. When returning from shopping, sort foods to be kept in your Larder Fridge while the door is closed.

6 5 REVERSING THE DOOR SWING The doors of your Larder Fridge can be reversed. First, ensure the Larder Fridge is unplugged and empty. We recommend you have someone to assist you You will need: Phillips style screwdriver Flat-bladed screwdriver Adjustable spanner. Note: You should never tip it back by more than 45º. The Larder Fridge must rest on soft foam packaging or similar material to avoid damaging the cooling pipes at the rear of the Larder Fridge. Remove the top hinge cover using the flat edge of a screwdriver. Remove the two screws that hold the upper hinge and door in place. Detach the hinge. Lift the door away from the pivot on the lower hinge and place it on a padded surface to prevent scratching Remove the two screws that hold the lower hinge in place and detach it from the Larder Fridge body. Unscrew the foot on the opposite side of the Larder Fridge., and reattach in the place of the removed lower hinge. Before replacing the lower hinge, remove the bolt pin and unscrew the foot to reverse the direction of the lower hinge. Secure using the lower hinge to the opposite side and secure using the two screws.. Then reattach the levelling foot. You can then replace the bolt pin and lower the Larder Fridge door back into place. Make sure the door is the right way up. 8 9 With the door closed, reattach the upper hinge on the new swing side and secure with the two screws. Make sure your Larder Fridge is levelled again before tightening the screws and replacing the upper hinge cover. This will ensure that the magnetic door seal is aligned.

7 6 CLEANING MAINTENANCE TROUBLESHOOTING Clean the Larder Fridge internally with a weak solution of bicarbonate of soda and rise with warm water using a damp sponge or cloth. Always wipe the interior of the Larder Fridge dry before replacing the food. Wash the baskets and shelves in warm soapy water. Ensure they are completely dry before replacing in the Larder Fridge. Use standard furniture polish to clean the Larder Fridge exterior. When cleaning the exterior, make sure that the doors are closed, to prevent polish getting on the magnetic door seal or inside. The grille of the condenser at the back of the Larder Fridge and the adjacent components can be vacuumed using a soft brush attachment. Defrost and clean when food stocks are low. Changing the internal light Before carrying out the bulb replacement always switch off the Larder Fridge and disconnect the electrical supply. Push the lever at the base of the light to the rear to release the light cover. Remove the old bulb by unscrewing in an anti-clockwise direction. Replace with a new bulb (10w) by screwing it in a clockwise direction making sure that it is secure in the bulb holder. Replace the light cover back into position and click back into place. Re-connect your Larder Fridge to the electrical supply and switch on. The Larder Fridge is not working Check it is plugged in and switched on. Check that the fuse in the plug has not blown. Plug in another appliance, such as a lamp, to see if the socket is working. Condensation appears on the outside of the Larder Fridge This may be due to a change in the room temperature. Wipe off any residue of moisture. If the problem continues call the Customer Service Department. The Larder Fridge is making noises Gurgling or whooshing - These noises are caused by the circulation of the refrigerant liquid in the cooling system. It has become more pronounced since the introduction of CFC free gases. This is not a fault and will not affect the performance of your Larder Fridge. Humming, purring or pulsating - This is the compressor motor working, as it pumps the refrigerant around the system. Warranty Your Tesco appliance is covered by a warranty for 12 months from the date of purchase. If a fault develops during this period, please contact the Tesco technical help line on Please have your original purchase receipt with you when you call. This warranty in no way affects your consumer rights.

8 7 TECHNICAL SPECIFICATIONS Model TL120 Space required: Rated Voltage (V) Rated Frequency 50 (Hz) 1059mm Energy Class A+ Appliance type Total Useable volume Climate Class Larder Fridge 92L N Ambient range 16-32ºC Gross Volume (Litres) 120 (Cubic Feet) mm Weight gross (kg) 24 net (kg) 27 Product Dimension h/w/d 840/480/500 (cm) Sound Decibel Rating 39 (db[a])