DRAFT INDUCER CROSS REFERENCE GUIDE FOR FURNACES AND WATER HEATERS THE REPLACEMENT MOTOR AND BLOWER SPECIALISTS

Transcription

1 DRAFT INDUCER CROSS REFERENCE GUIDE FOR FURNACES AND WATER HEATERS THE REPLACEMENT MOTOR AND BLOWER SPECIALISTS

2 ABOUT DRAFT INDUCED BLOWERS Many of the new energy-efficient gas furnaces use induced draft blowers to control flue gas. All induced draft blowers incorporate some type of signaling device to alert the furnace that the induced draft blower is operating. Some use a sail switch in the exhaust air stream. Others utilize a centrifugal switch or electronic sensor built into the motor, and some use a static pressure tap in the blower housing. All blowers are intended to provide air flow prior to ignition. In today s furnace industry, draft inducers are becoming a common replacement part. Since these furnaces are being designed with specific induced draft blowers, it is very important to use exact replacements matching the original blower for safety reasons. These blowers play an important part in controlling the availability of gas to the burners. Most blowers will employ either a centrifugal switch, electronic sensor, or a vacuum tap to generate a signal to the gas valve that the induced draft blower is operating. This feature is necessary to prevent the gas valve from being turned on prematurely or in the event the blower does not operate properly. These blowers control the removal of the burnt by-products. Therefore, only replacement blowers made for specific furnaces or water heaters should be used for these replacements. The following paragraph describes why. The blower is designed to produce a certain amount of air-flow measured in CFM (cubic feet per minute). The airflow in some furnaces is needed to create a specific amount of vacuum at the vacuum tap mentioned above. If the replacement blower is not the exact one needed but looks close, it may produce a lesser vacuum at the vacuum tap. This may not allow the furnace to operate since the furnace will not think the induced draft blower is operating. Water Heater Draft Inducer A.O. SMITH REPLACEMENT WATER HEATER DRAFT INDUCERS W W4 BRADFORD WHITE REPLACEMENT WATER HEATER DRAFT INDUCERS A C W B W W W11 FASCO REPLACEMENT WATER HEATER DRAFT INDUCERS W1 GSW REPLACEMENT WATER HEATER DRAFT INDUCERS W W8 STATE INDUSTRIES REPLACEMENT WATER HEATER DRAFT INDUCERS W W10 Locate the OEM part or model number on the draft inducer you need to replace and use this simple guide to find the FASCO direct replacement draft inducer. Every effort has been made to ensure the accuracy of this reference guide. Design changes may result in different operating characteristics or dimensional changes from one manufacturer to another. Therefore, Regal cannot accept responsibility for the ultimate selection. Always compare draft inducers for interchangeability prior to installing or recommending their use. 1 For a complete line of Fasco products, visit Trademarks and trade names of OEMs are not owned or controlled by Regal Beloit Coporation unless such ownership is expressly claimed on the back cover. The rights associated with those trademarks and trade names remain the property of their respective owners or licensees.

3 AIR PLUS / SCHERBA INDUSTRIES REPLACEMENT DRAFT INDUCERS A PA146 A087 ALADDIN STEEL REPLACEMENT DRAFT INDUCERS A120 AMANA REPLACEMENT DRAFT INDUCERS D A D A A A A A287 ARMSTRONG REPLACEMENT DRAFT INDUCERS JB1N D9430 CARRIER A978 CONSOLIDATED INDUSTRIES REPLACEMENT DRAFT INDUCERS TF A A MH24 A128 JA1N D9619 JA1N D9619 JA1N D9620 JA1N D9620 JA1P D959 JA1P D0960 EXCEL REPLACEMENT DRAFT INDUCERS A100 FEDDERS REPLACEMENT DRAFT INDUCERS A159 AK4K84BX A MH48 A A161 For a complete line of Fasco products, visit 2

4 FRANKLIN REPLACEMENT DRAFT INDUCERS B B MH41 B MH42 B23618 GOODMAN REPLACEMENT DRAFT INDUCERS A B A A MH09 A B A R7-RFB185 A B A D A D A D A B A B A D A A B A D A B A A A A B S A A A A A FB-RFB140 A R7-RFB129 A129 3 For a complete line of Fasco products, visit Trademarks and trade names of OEMs are not owned or controlled by Regal Beloit Coporation unless such ownership is expressly claimed on the back cover. The rights associated with those trademarks and trade names remain the property of their respective owners or licensees.

5 GOODMAN REPLACEMENT DRAFT INDUCERS (CONT.) A MH15 A MH25 A MH32 A B A A A B A D A D A A290 HEIL QUAKER REPLACEMENT DRAFT INDUCERS A064, A C085 ICP REPLACEMENT DRAFT INDUCERS A A A P A A P A A HQ FA A A P A P A P A A P A A A P A148 For a complete line of Fasco products, visit 4

6 ICP REPLACEMENT DRAFT INDUCERS (CONT.) A A A P A P A P A A A A RFB-141 A R7-RFB134 A A A A MH28 A MH33 A MH37 A MH40 A A A P A A A FA A A P A P A A A P A A306 5 For a complete line of Fasco products, visit Trademarks and trade names of OEMs are not owned or controlled by Regal Beloit Coporation unless such ownership is expressly claimed on the back cover. The rights associated with those trademarks and trade names remain the property of their respective owners or licensees.

7 ICP REPLACEMENT DRAFT INDUCERS (CONT.) A A MH47 A A A R7-RFB350 A A307 HQ A151 JOHNSON FURNACE REPLACEMENT DRAFT INDUCERS AO Smith 464 A085 LENNOX REPLACEMENT DRAFT INDUCERS L5501 A T A /20J8901 A J8101 A J4101 A J4101P A J8101P A J4201 A J8901 A T6-2118P A K5101 A J3901 A K5301 A K0401 A K5201 A K6101/ A K4101/88K8401 A K5301P A K5201P A L0101 A R7-RFB135 A135 For a complete line of Fasco products, visit 6

8 LENNOX REPLACEMENT DRAFT INDUCERS (CONT.) A /H A K4101P A MH29 A MH30 A FB-RFB547 A A L0401 A A K0401P A S A L5301 A L1401 A R7-RFB43 A R7-RFB425 A M6701 A P A A M5501 A L4101 A M1601 A M1601 A M7901 A M8101 A M1601 A G8101/ARMSTG A G6601 A G8701 A L1501 A M5001 A M3301 A M3201 A331 7 For a complete line of Fasco products, visit Trademarks and trade names of OEMs are not owned or controlled by Regal Beloit Coporation unless such ownership is expressly claimed on the back cover. The rights associated with those trademarks and trade names remain the property of their respective owners or licensees.

9 MAGIC CHEF REPLACEMENT DRAFT INDUCERS 4MH17, 35035B001, 322P859, DE3L038 HWC Series: 48HWC24A, 48HWC181, 35HWC181, 60HW, 60HWC24A, 60HWC181, 48HW, 60HWC30A, 66HWC18A, 36HWC241, 66HW, 60HWC241, 66HWC181, 66HWC241, 60HWC301, 48HWC241, 66HWC301, 48HWC18A, 60HWC18A, 36HWC18A, 66HWC24A, 36HW, 36HWC24A NORDYNE REPLACEMENT DRAFT INDUCERS A081, A081, A081 A A A A A MH26 A MH27 A A R7-RFB903 A A A A A FB-RFB130 A MH43 A130 RHEEM REPLACEMENT DRAFT INDUCERS D A A A A C088 A C087 A A A245 For a complete line of Fasco products, visit 8

10 RHEEM REPLACEMENT DRAFT INDUCERS (CONT.) AP A A A A R7-RFB139 A MH15 A MH19 A MH21 A MH31 A AP A A A C089 A A A S A FB-RFB142 A RF-RFB136 A MH44 A MH46 A A A A S A247 SKYMARK REPLACEMENT DRAFT INDUCERS MTR-136PK A MH13 A A A A073 9 For a complete line of Fasco products, visit Trademarks and trade names of OEMs are not owned or controlled by Regal Beloit Coporation unless such ownership is expressly claimed on the back cover. The rights associated with those trademarks and trade names remain the property of their respective owners or licensees.

11 OTHER REPLACEMENT DRAFT INDUCERS D341114G01 A C341445P01 A X A D341095P02 A D341095P04 A D341095P01 A D330787P01 A D341663P05 A D342078P01 A D342078P02 A D342078P04 A D342078P05 A D342078P06 A X A X A X A C661452P01 A D340096P04 A A D340096P02 A A X A X A X A X A X A D330757P01 A D330809P01 A D330757P02 A X A C665662P01 A D330900P01 A X A194 For a complete line of Fasco products, visit 10

12 OTHER REPLACEMENT DRAFT INDUCERS (CONT.) R7-RFB143 A MH12 A MH14 A MH34 A MH36 A MH39 A X A D330757P03 A D342094P03 A S X A D342094P02 A S X A D342077P01 A D342077P02 A D342077P03 A D342077P04 A D342077P05 A D342077P06 A D340365P03 A D340623P01 A C663946P01 A C664099P01 A D330757P035 A A A A A X A FB-RFB130 A MH43 A X A D342097P01 A S X A For a complete line of Fasco products, visit Trademarks and trade names of OEMs are not owned or controlled by Regal Beloit Coporation unless such ownership is expressly claimed on the back cover. The rights associated with those trademarks and trade names remain the property of their respective owners or licensees.

13 WILLIAMSON REPLACEMENT DRAFT INDUCERS A ,000 BTU A MH16 A MH22 A118 YORK REPLACEMENT DRAFT INDUCERS A A A A A A C000 A A A A A A P A A A A A R7-RFB391 A RFB-144 A A A MH10 A MH18 A MH20 A MH35 A A A231 For a complete line of Fasco products, visit 12

14 YORK REPLACEMENT DRAFT INDUCERS (CONT.) P A A S A A S A A S A A A A A A A A A A RFB-137 A RFB-137 A MH45 A MH45 A A S A A A A A S A A A For a complete line of Fasco products, visit Trademarks and trade names of OEMs are not owned or controlled by Regal Beloit Coporation unless such ownership is expressly claimed on the back cover. The rights associated with those trademarks and trade names remain the property of their respective owners or licensees.

15 GUIDE TO OEM BRAND NAMES OEM OEM BRANDS OLD OEM NAMES SERVICE BRAND Carrier Carrier, Bryant Payne RCD Day & Night Whirlpool Fast Parts Heil, Tempstar Comfortmaker Arcoaire, Kenmore Goodman Janitrol, Amana Good Parts Lennox Lennox Magic Chef Armstrong Ducane Air-Ease, Excel Advanced Dist. Prods Heatcraft, Bohn Rheem Rheem ProStock Pro-Tech Ruud Weather King York York Henry Moncreif Source1 Luxaire Fraser-Johnston Evcon Borg-Warner Coleman Nordyne Intertherm Lear-Siegler Miller, Frigidaire Tappan, Philco Gibson, Maytag Kelvinator Westinghouse Grandaire Burnham Thermo Pride Burnham ECR Olsen Duo-Matic Olsen Utica Dunkirk For a complete line of Fasco products, visit 14

16 Regal Beloit America, Inc Heil Quaker Blvd. LaVergne, TN Customer Service: Fax: APPLICATION CONSIDERATIONS The proper selection and application of products and components, including paying full attention to the subject of product safety in the application, is the responsibility of the customer. Operating and performance requirements and potential associated issues will vary appreciably depending upon the use and application of such products and components. The scope of the technical and application information included in this publication is necessarily limited. Unusual operating environments and conditions, maintenance requirements, installation configurations, and other factors can materially affect the application and operating results of the products and components and the customer should carefully review its requirements. Any technical advice or reviews furnished by Regal Beloit America, Inc. or its affiliates ( Regal ) with respect to the use of products and components is given in good faith and without charge. However, Regal assumes no obligation or liability for the advice given, or results obtained, all such advice and reviews being given and accepted are at the customer s risk. For a copy of our Standard Terms and Conditions of Sale, Limited Warranty, and Limitations of Liability and Remedy, please contact Customer Service at or the website address: (link to Terms and Conditions of Sale at the bottom of the page). These terms and conditions of sale, disclaimers and limitations of liability apply to any person who may buy, acquire or use a Regal Beloit America Inc. product referred to herein, including any person who buys from a licensed distributor of these branded products. Regal and Fasco are trademarks of Regal Beloit Corporation or one of its affiliated companies Regal Beloit Corporation, All Rights Reserved. MCB17037E Form# F1020E