1Byone Products Inc. USER MANUAL 400 Watt Low Lying Fog Machine Model No.: O00QL-0045

Transcription

1 1Byone Products Inc. USER MANUAL 400 Watt Low Lying Fog Machine Model No.: O00QL-0045 It is very important to operate this product according to the following instructions. Failure to do so may render your guarantee void. What is Included 1 x Product Body with Power Cable 1 x User Manual 1 x Warranty Card 1 x Wired Control Cable and Box 1 x Plastic Water Bag INTRODUCTION Product Overview Product Body with Power Cable Wired Control Cable and Box Plastic Water Bag User Manual Specifications Fuse: 5A, 125V Output Time: 35-45s Fog Output: 2,000CFM Output Distance: 8.2ft(2.5M) Power Consumption: 400W Warm Up Time: 3-5 Minutes Tank Capacity: 1300ml (0.35gal) Power Sources : Input AC120V 60Hz Outline Size: x 8.35 x 7.83 in.(410.5 x 212 x 199 mm) Wired on/off controller (included): 6.56ft(2M) length cord

2 Names for Parts A B C E D F H G I (A) Spray Nozzle (B) Handle (C) Tank Lid (D) Product Cover (E) Ice Reservoir Knob (F) Wired Control Cable Interface (G) Fuse Knob (H) On/Off Switch (I) Water Drainage Tube (J) On/Off Switch (K) Wired Control Indication Light (L) Wired Control Box (M) Wired Control Cable M K J L How to Use? Before using the fog machine, you have to prepare Fog Liquid (not included). Then operate according to following sequence. 1. Remove all the packages. 2. Carefully put this product onto a clean, flat and solid surface, close to the power socket. 3. Unscrew the lid on the tank by turning counterclockwise and pour the Fog Liquid inside. Do not spill Fog Liquid onto the product body. Do not overfill. If liquid gets into the Fog Machine, leave it to be dry completely before plugging in. Do not cut, pinch, or break the tube connected through the tank lid. Screw the lid clockwise to the tank tightly. Always make sure there is enough Fog Liquid in the tank before using the Fog Machine. 4. Unscrew and remove the Ice Reservoir Knob. Lift the front cover by placing fingers underneath the cover and pushing up to expose the ice reservoir. Put ice on top of metal shelf; allow space for cover to close. Set the Knob back to secure. 5. Insert the Water Drainage Tube (located at the back of the fog Machine) into the Plastic Water Bag, which is to collect the water from the melting ice. 6. Connect the wired control cable to the Interface at the back of the Fog Machine. 7. Connect the product with proper power socket. Set the On/Off Switch to on position at the back of the machine. 8. Warm up time is approximately 4 5 minutes. When fully heated, the Wired Control Indication Light will turn on and the Fog Machine will be ready to produce and spray fog. 9. Set the On/Off Switch to on position on the Wired Control Box, nozzle will start spraying fog. 10. The nozzle will stop spraying fog if you set the On/Off Switch to off position on the Wired Control Box. 11. Turn off the product before refilling fog liquid to the fog machine. 12. Unplug the product when not in use. 13. To refill the tank; turn off the unit, unplug and follow the directions in Step 3.

3 A: Fog Machine B: Wired Control Box and Cable C: Fog Liquid (not included) D: Plastic water bag E: Power Cable Additional Information (a) It is normal if there is condensation on the nozzle of the Fog Machine. (b) A small amount of fog may spray during or after operation. (c) The Fog Machine will have to reheat after long spray. It will stop operation for a short period in order to heat up to operating temperature again. While this is happening, fog cannot be produced. The Wired Control Indication Light will turn on again when the unit is ready to generate more fog. (d) All fog machines are apt to clogging due to the consistency of Fog Liquid and the high temperatures at which it vaporizes. (e) Please check the ice level every 30 minutes and Maintenance and Cleaningrefill ice according to the above point 5 if you need the machine to spray low-lying fog. Maintenance and Cleaning Maintenance and cleaning shall only be done to the product surface. Unplug this product from the power socket before cleaning. Do not wet any electric parts of this product. Please use a dry, soft cloth instead of sharp tools for cleaning. If you find there is any subsidence or residue, it is advised to empty all Fog Liquid from the machine and clean the tank. Please unplug the machine from power socket before cleaning. Storage To store the machine for an extended period of time, it is important to take out the ice from the ice reservoir and dry it up. 1. Remove the ice. Take out the ice from the ice reservoir and dry it up. 2. Remove the tank lid. Pour out the fog liquid in the fog machine to a container. 3. Keep the fog machine working for a few seconds to run out the fog liquid in the fog machine. 4. Fill a little fog machine cleaner liquid in the tank, and keep the fog machine working till running out. 5. Switch off, unplug the fog machine, and put it on a flat, dry place.

4 Fuse Replacement If the Fog Machine does not work at all when it is connected to the power socket, then it is probably that the fuse has been broken. WARNING: Risk of electric shock and fire. Disconnect from power socket before replacing the fuse. 1. Turn the fuse knob counterclockwise to reveal the fuse. 2. Replace the fuse with the same size and type fuse: 5A, 125V 3. Place fuse in cover and reinstall by turning clockwise. Be sure not to over tighten. Cautions and Warnings Please read through this instructions manual before use. Before use, check the fog machine to see if there is any crack in the product cover, wired control cable and box, power cable and plug. Make sure there is not any exposed wire. Do not use if any of the above conditions is found. The fog machine will become hot during use. After use, please wait for some minutes before trying to touch it by hand. Keep away from the spray nozzle at least 0.5 meters when the nozzle spraying fog. DO NOT expose the fog to any asthmatics or allergenic sensitive people. Attention! Do not place the product onto wet or uneven surfaces. Accidental falls may cause fire. The product shall be changed if it has become damaged or thermally deformed. Disconnect this product from power immediately in case of malfunction. Do not resume use until it s repaired. Do not use the Fog Machine or Remote Control Transmitter outdoors. They are not waterproof. Do not operate the product without fog liquid. Check the level of fog liquid every 30 minutes during use, and check before use every time. The product will be burned out if works without the fog liquid. Pour fog liquid carefully to avoid spills which could result in electrical shock. Do not use if liquid spills onto the machine. Let it dry completely before plugging in. Do not overfill the fog liquid. Do not spray in the direction Of flames or people. Do not open unit. Only an electrician can change the power cable. This product is not a toy. Please keep this unit out of reach of children and pets. Close supervision is necessary when this product is used by invalids, or disabled persons, or near children. Use this product only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer. Keep the power cable away from heated surfaces. Keep away from flames and flammable / explosive substances to avoid fire or explosions. Never pour other liquids such as water, gas, oil etc. into the fog machine. Never drop or insert any object into any opening. Please unplug the power cable if you want to stop use of this unit for long time. Use the fog machine in well-ventilated areas. Avoid the fog to be sprayed to food or pets. It is suggested not to breathe the fog for a long time. The external flexible cable of this product cannot be replaced; if the power cable is damaged, the product shall be destroyed. Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. The fog may set off some smoke detectors or sprinkler systems. Please test to see if any smoke detector or sprinkler system will be activated by fog or not. It is necessary to make sure the room has adequate ventilation.

5 WEEE Directive & Product Disposal At the end of its serviceable life, this product should not be treated as household or general waste. It should be handed over to the applicable collection point for the recycling of electrical and electronic equipment. General Troubleshooting Symptom Possible Cause Possible Action Circuit breaker or fuse keeps Excessive load on the circuit Make sure that the total load blowing does not exceed 80% of the breaker or fuse nominal current Short circuit along the power lines Check the power lines and power cords Product does not power up Blown fuse Replace blown fuse with a good one of the same type and rating Internal problem Please contact our service and will replacement or repair Noise sound when you used Fog juice pipeline jam Try to maintain correct fog juice pipeline smoothly It will more longer life if you periodic cleaning every two months If you still experience problems after trying the above solutions, contact 1byone Service Support and will resolve your problem ASAP. Contact Information 1byone Product Inc E PHILADELPHIA ST UNIT M, ONTARIO, CA United States