EC MODEL. EC Model & Split Systems Water Source Heat Pump. 6 to 30 tons

Transcription

1 E & Split Systems Water Source Heat Pump 6 to 30 tons The E, including Split Systems, provides the best combination of performance, comfort and one-of-a-kind features that satisfy the high demands of any commercial building. E MODEL UP TO UP TO OP GLHP WSHP ommercial Sales rochure fhp-mfg.com

2 High-Performance E Split Systems ll the excellent features, functions and benefits that are encompassed in the E package unit are available for the E Split System along with increased flexibility in installation and availability of applications. Increased Flexibility for Installation The E Split condensing section can be placed remotely up to a equivalent 75 feet from the air handler section, which allows for the unit installation to be in locations where space is limited. dditionally, this orientation allows installing the condensing section, which is the major contribu tor to noise and vibration, away from occupied areas. Multiple condensing units may be centrally located to facilitate servicing. The location of the E Split air handlers can be concealed within a variety of areas inside the building where it will connect to air and ventilation ducts to deliver comfort able air. ir handling sections are available in vertical or horizontal configurations to respect many different job site applications. See the below illustrations and the wide range of capacities the E Split System has available for designing in commercial buildings. NOTE: Extended performance data for the E Split Systems can be calculated by deducting 3% from the E package unit performance. (extended performance data is located in the E catalog or on the website at fhp-mfg.com) Technical Specifications E Vertical ir Handler E Horizontal ir Handler E Split Systems ondensing Section E Split Systems ondensing Section E Vertical ir Handler E150-3 ondensing Section Unit Dimensions (width) (depth) (height) E E E E E E E E E E E E Vertical ir Handler Unit Dimensions (width) (depth) (height) E E E E E E E E E E E E Horizontal ir Handler Unit Dimensions (width) (depth) (height) E E E E NOTE: ll dimensions in inches unless otherwise noted. ll dimensions within ". Specifications subject to change without notice.

3 ommercial Water Source Heat Pumps High-Performance E & E Split Systems The E water-to-air heat pump provides one of the best combinations of performance and efficiency available. Safety devices are built into each unit to provide the maximum system protection possible. Quiet omfort abinet - ll panels are insulated with ½" thick, 1.5 lb./cu. ft. dual-density fiberglass insulation for both thermal insulation and noise reduction. For vibration isolation, all compressors are mounted on rubber grommets. Vertical cabinets have an insulated divider panel between the blower compartment and the compressor section to minimize the transmission of compressor noise, and to permit operational service testing without air bypass losed-cell Foam Insulation (option) - Helps to provide cleaner, fiber-free air and reduces sound transmission ompressor lanket (option) - high density sound blanket that minimizes the transmission of compressor noise Service Friendly Unit rrangement - ll units are designed to be serviced from the front of the unit. Schrader valves for the high and low pressure gauges are standard, along with easily accessible electrical box components, allow the diagnosing and servicing of the unit to become a simple task. Insulated bulkheads in all vertical E s separate the compressor section from the blower section, allowing the unit to be serviced easily during operation. Panels are removable to facilitate servicing of the unit. Separate electrical knockouts in the unit corner post allow for easy and safe routing of high and low voltage lines to the inside of the cabinet Robust and Durable onstruction G90 Galvanized Steel abinet - Provides strength and corrosion protection upro-nickel oaxial Heat Exchanger (option) - Protects against corrosion when water conditions are of low quality Heat Pump Reciprocating and Scroll compressors* - Provides durability and ensures that each unit will provide many years of trustworthy performance Safety Flow Proving Switch (option) - Prevents the operation of the compressor should the water supply fail Unit Protection Module (UPM) - Monitors the unit operation and safety controls that protect the unit Dual Refrigerant Freeze Sensors - Monitors if refrigerant temperatures reach freeze limitations and disables unit to protect it ondensate Overflow Protection - ontinuously monitors the drain pan for high condensate water level, and if this exceeds normal operating levels, the compressor operation is interrupted to protect against drain pan overflow Quality Design & Efficiency oilerless ontrol (option) - Disables the compressor and/or activates a remote electric heater should the water temperature dropbelow set point Waterside Economizer (option) - Provides free-cooling without the use of mechanical cooling (compressors) Dual apacity - ll units are designed with dual refrigeration circuits for staged operation Options Designed for any pplication DuoGuard ir oil Protection The E is available with this state-of-the-art coil protection option that features two layers of corrosion protection. ll active copper heat transfer surface on the air coil is coated in a tin plating to resist all common forms of formicary coil corrosion. dditionally, the aluminum fins are pre-coated in a state-of-the-art gold enamel protective layer to provide a long service life in the harshest of environments, including sea coast installations. DuoGuard protected coils exceed 1000 hours of STM 117 salt spray testing. DD ontrols The optional factory mounted DD ontroller is preprogrammed and installed on the unit with the Unit Protection Module (UPM) to be job site ready. The unit will operate in a 100% stand-alone control mode or connect to a uilding utomation System (S) using open protocols net, Modbus, N2 or LonWorks (with an optional Lon card). Stand-alone DD modules must use FHP remote intelligent sensors; minor changes to operating points are made using a separate FHP view hand-held tool connected to either the DD unit controller or through NOTE: *E072 & E096 are provided with dual reciprocating compressors

4 the wall sensor. Zone temperature, leaving air temperature, and leaving water temperature can be monitored from the central control computer and unit fault indication displayed. DD Room and Zone Sensors To complement the controller, osch Thermotechnology orp. offers a line of intelligent FHP space sensors, which provide precision measurement and communication capabilities in an attractive low profile enclosure. On/Off Hot Gas Reheat llows the user to not only control space temperature, but also humidity levels within the conditioned space. Modulating hot gas reheat will maintain the leaving air temperature at a preset value to deliver neutral air to the space. 100% Outside ir The E is capable (as a special order) of providing 100% fresh outside air to most commercial buildings. The purpose is to deliver the make-up air dehumidified and reheated per the design requirements for space temperature, humidity and not to burden the recirculating units Technical Specifications Take-part onstruction To make installations possible into buildings where all that is available are standard-sized doorways and elevators, the take-apart option is the natural choice. dditional Features elt driven TXV 75V transformer dditional Options 100V transformer Hot water or chilled water coil Inverter duty fan motor Relays - EMS, blower monitor, compressor monitor, and pump/valve Phase monitor Fire alarm relay/dual power Wire to 208V Extended range with Schrader valve for head pressure control (by others) Variable frequency drive for fan motors Rotate blower 2" MERV-8 filter Single lower Large Vertical Dual lower Large Vertical E Single lower Large Dimensions (width) (depth) (height) E E E E Single lower Large Dimensions E Dual lower Large Dimensions (width) (depth) (height) E E E E (width) (depth) (height) E E NOTE: ll dimensions in inches unless otherwise noted. ll dimensions within ". Specifications subject to change without notice.

5 Technical Specifications fhp-mfg.com E Large Horizontal E Large Horizontal E Large Dimensions (width) (depth) (height) E E E E E Large Dimensions (width) (depth) (height) E E NOTE: ll dimensions in inches unless otherwise noted. ll dimensions within ". Specifications subject to change without notice. Height excludes mounting rails. SHRE/HRI/ISO HRI ertified Water Loop Heat Pump Ground Water Heat Pump Ground Loop Heat Pump GPM ooling 86 F Heating 68 F ooling 59 F Heating 50 F ooling 77 F Heating 32 F apacity tuh tuh/w apacity tuh OP apacity tuh tuh/w apacity tuh OP apacity tuh tuh/w apacity tuh OP E E E Performance in accordance with RI/ISO E E E E E E E E E NOTE: Ratings based upon HRI/NSI with 1" disposable filter

6 Electrical Data elt Drive Motor Voltage ode Voltage/ Ph/Hz Voltage Min/ Max ompressor Quantity RL LR Motor Quantity FL Total Unit w/elt Drive Motor Min ircuit mps Max Fuse mps E072 E096 E120 E150 E151 E180 E181 E210 E240 E242 E300 E /1/60 197/ /3/60 197/ /3/60 414/ /1/60 197/ /9.8* 47.6/45.1* 50/60* /3/60 197/ /6.2* 29.5/31.0* 40/40* 4 460/3/60 414/ /3.1* 14.6/15.2* 15/20* 5 575/3/60 518/ /2.6* 11.9/12.5* 15/15* /1/60 197/ /3/60 197/ /9.2* 41.3/44.3* 50/50* 4 460/3/60 414/ /4.3* 20.6/21.9* 25/25* 5 575/3/60 518/ /3.7* 15.7/16.8* 20/20* /3/60 197/ /3/60 414/ /3/60 518/ /3/60 197/ /3/60 414/ /3/60 518/ /3/60 197/ /3/60 414/ /3/60 518/ /3/60 197/ /3/60 414/ /3/60 518/ /3/60 197/ /3/60 414/ /3/60 518/ /3/60 197/ /3/60 414/ /3/60 518/ /3/60 197/ /3/60 414/ /3/60 518/ /3/60 197/ /3/60 414/ /3/60 518/ /3/60 197/ /3/60 414/ /3/60 518/ NOTE: *First value is for vertical configurations and second value is for horizontals. osch Thermotechnology orp. 555 NW 65th ourt Fort Lauderdale, FL Phone: Fax: fhp-mfg.com Printed on Elemental hlorine Free, FS-certified, minimum 10% PW paper with vegetable-based inks. Scan the QR code to the right to access product information. opyright 2014 osch Thermotechnology orp. ll rights reserved. Subject to change without notice. 76P