INSTALLATION USE AND MAINTENANCE MANUAL. ATC Evolution ATC EVOLUTION. Class I - IP55 INFRARED HEATER ATC ELECTRICAL & MECHANICAL

Size: px

Start display at page:

Download "INSTALLATION USE AND MAINTENANCE MANUAL. ATC Evolution ATC EVOLUTION. Class I - IP55 INFRARED HEATER ATC ELECTRICAL & MECHANICAL"

Kevin Ramsey
5 years ago
Views:

1 ATC EVOLUTION ATC Evolution INFRARED HEATER Class I - IP55 INSTALLATION USE AND MAINTENANCE MANUAL

2 EN USE AND MAINTENANCE 1. IMPORTANT SAFETY INSTRUCTIONS These instructions should be carefully read before installation and retained by the user. The booklet must be kept and delivered to the new user in case of disposal of the heater. The Manufacturer reserves the right to vary the features of the product without prior notice. The technical data are indicative only. 1. This heater is intended solely for the use it has been designed for, namely room and people heating. The Manufacturer is not responsible for any damage that could happen due to improper use. 2. After unpacking make sure that the heater is complete and shows no signs of tampering or any visible damage 3. Keep packing materials, which are potential dangers, away from children. 4. The heater can be used by children of at least 8 years (as well as by persons with reduced physical, sensory or mental capabilities, or lack of experience or required knowledge) provided that they are under supervision, or after they have been instructed relating to the safe use and have understood the potential dangers. Children should not play with the Heater. 5. Cleaning and maintenance must be performed by the user and not by unsupervised children. 6. Children of less than 3 years should be kept away unless continuously supervised. Children aged from 3 years and less than 8 years shall only switch on/off the heater provided that it has been placed or installed in its intended normal operating position and they have been given instruction concerning use of the heater in a safe way and understand the hazards involved, children should always be supervised. 7. Children aged from 3 years and less than 8 years shall not plugin, regulate and clean the heater or perform user maintenance. 2

3 8. Before connecting the heater make sure that the voltage is the same as indicated on the device. 9. Do not use in presence of gas, inflammable or explosive liquids or substances as defined in BS Some fundamental rules which apply to all electrical devices must be observed when using the heater: 11. Do not touch the heater with wet hands. 12. Do not handle the heater when you have bare feet. 13. Do not let children play with the heater. 14. Avoid the use of an extension cord with this product, because the extension cord may overheat and cause a risk of fire. 15. Do not apply any modification to the product. 16. Keep connections dry. 17. If the power supply cord is damaged, do not use the heater until the cord has been replaced. For power cord replacement, always contact an electrican in order to avoid any risk of inury. 18. If the heater is not going to be used for a long period, disconnect it from the power supply. 19. Always disconnect the heater before doing any maintenance. CAUTION - Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present. 2. ELECTRICAL INSTALLATION The installation should always be carried out by a qualified electrician or a competent person in accordance with the current electrical standards: HD 384 CENELEC for Mainland Europe, IEC and BS 7671 for the United Kingdom, IEC 60445(2010) & ET101:2008 for Ireland and IEC Internationally. The energy supply to the heater must always be properly earthed. The heater must be connected to energy supply line by means of the provided H05SS-F silicone cable. 3

4 An overvoltage category III Combined Circuit breaker and Residual Current Device (RCD) with rated earth leakage operation not exceeding 30mA must be fitted upstream on the supply line. The circuit breaker must have a contact opening distance of at least 3 mm. The heaters should always be installed only using the mounting brackets provided or supplied as optional extras, such as double brackets etc. Under no circumstances turn the heater on if it is not mounted horizontally or if the face of the heater is on any surface. The heater must not be recessed in the ceiling. There must be enough space around the top of the heater to ensure adequate ventilation. A minimum air gap of at least 30 cm should always be allowed between the top of the heater and a ceiling or roof. The heater should be at least 50 cm away from any surrounding walls (see figure 1 and 3) and a distance of at least 100 cm should always be left in front of the ATC heaters to ensure safety This unit should be mounted at a minimum of 180 cm above ground level (figure 1). If installed in a toilet, the height should be at least 225 cm in zone 1 and zone 2; in zone 3 the minimum above ground level is 180 cm, according to the rules specific to each Country. 4

5 The heater must not be located either directly below, or in front of a socket-outlet. The heater must be installed so as to prevent any control switches being able to be touched by anyone who is in the shower or bath. Make sure that there is no possibility of inflammable material, combustible material or curtains coming into contact with the heater, there is a risk of fire if this happens The Heater is Class I insulated and is IP55. In order to maintain the protection rate of the heater, the connection to the heater from the power supply must be made with a minimum IP55 system, as per the applicable electrical standard. 3. FITTING Before being used, the heater must be fixed to the wall or to the ceiling by means of the provided supports, as described below. Before drilling any holes for installation, ensure that the surface is solid and that you will not penetrate any water pipes or electrical cables. Ensure that the heater is not facing the ceiling or inflammable materials. 1. Drill four holes in the wall, following the dimensions in the table below: (**) 950 (**) 1300 (**) 1600 (**) 104 (*) 104 (*) 104 (*) 104 (*) Hole spacing (mm) The 104mm spacing (*) must be respected, while the distance between the sliding brackets (**) are recommendations based on the length of the heater. 5

6 2. Fix the two wall brackets (fig. 2 - pos. A) to the wall using rawlplugs of the appropriate size. 3. Mount the curved brackets (fig. 2 - pos. B) to the back of the heater, inserting and sliding them into the relevant slots. 4. Attach the heater to the wall brackets and adjust the angle of the heater positioning on both sides (Figure 2 - pos. C). 5. Three optional brackets are available: Double(cod. 7804) End to end (cod. 7805) Extension (cod. 7806) 4. USE The ATC Evolution range includes heaters with wattages ranging between 1500W and 3200W, suitable for heating private homes as well as public areas (restaurants, pubs). The heaters can be used indoors and outdoors (patios, verandas, balconies). The heating element of this product is hygroscopic (It will absorb moisture). To avoid risk of premature failure or nuisance tripping of the RCD it is necessary to operate the unit for a few hours every 6 months. This heater does not include a device to control ambient temperature. Do not use it in small rooms used by people who are unable to leave such rooms on their own unless they are under constant surveillance. All users should be made aware of all aspects of operation and safety and these instructions should be retained for reference. Ensure that the rays of the heater are aimed into the area that requires heating. If necessary, change the angle of the heater by adjusting the screws on the curved bracket (fig.2-c). 6

7 Do not use the heater directly near a bathtub, a shower, a swimming pool. In unoccupied premises it is recommended that the heating system is switched off and isolated from the electrical supply. Wait minutes after powering on to reach the maximum temperature 5. CARE AND CLEANING Before cleaning, ensure the heater is disconnected from the power supply and allowed to cool. Never immerse the heater in water or any other liquid. To clean, use a soft damp cloth and then dry thoroughly. Make sure all components are dry before using again. Avoid the use of harsh detergents, solvents, and abrasive or aerosol cleaners as they may damage surfaces. 6. TECHNICAL SERVICE If you have any question relevant your heater contact ATC on the numbers given on the front of this manual. 7. TECHNICAL FEATURES Power supply V ~ Hz Power 1500 W 1800 W 2400 W 3200 W Insulation Class I I I I Protection level IP55 IP55 IP55 IP55 Emission IR-C IR-C IR-C IR-C 7

8. ENVIRONMENTALLY COMPATIBLE DISPOSAL OF THE APPLIANCE (Waste Electrical & Electronic Equipment) (Applicable in the European Union and other European countries with separate collection systems) This

8 8. ENVIRONMENTALLY COMPATIBLE DISPOSAL OF THE APPLIANCE (Waste Electrical & Electronic Equipment) (Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature, indicates that it should not be disposed of with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal. 8

9 Fig cm ( min ) 30 cm (min) 180/225 cm (min) 9

10 Fig. 2 A B C 10

11 End to end cm (min) 50 cm (min) Fig. 3 Double Extension

12 9. GUARANTEE Your appliance is guaranteed for 2 years from the date of purchase during this period we will repair or exchange, at our discretion, any faulty or defective parts providing the appliance has been used in accordance with the operating & installation instructions and has not been misused or mistreated in any way. Any unauthorized repair or attempted repair will invalidate the guarantee. You may be asked to return the product to our workshop for inspection to establish whether the fault is covered under the guarantee. The guarantee is valid in the UK and Ireland only. This guarantee is additional to your statutory rights. In the unlikely event of a problem with your appliance please contact your supplier. Head Office & Energy Showrooms: Broomhill Drive, Tallaght, Dublin 24, Ireland. Tel: 353 (1) sales@atc.ie UK Office: Innovation Centre, Gallows Hill, Warwick, CV34 9PL UK Tel: 0044 (0) sales@atc.ie 12

PH1000T PH1500T PH2000T

PH1000T PH1500T PH2000T ATC Sunray Panel Heater Class I - IP 20 3 Year Warranty INSTALLATION USE AND MAINTENANCE MANUAL 1. IMPORTANT SAFETY INSTRUCTIONS These instructions should be carefully read before