Dehumidifier. SD-46 SD-46W: with Warm Air SD-46U: with UV Light SD-46UW: with UV Light and Warm Air. Instruction

Transcription

1 Dehumidifier Instruction SD-46 SD-46W: with Warm Air SD-46U: with UV Light SD-46UW: with UV Light and Warm Air.,.,.%50% 60% 70% 80% [] Please read and retain these instructions for future reference.

2 Please take time to read this manual carefully before use and save it for future reference. Page Model no. reference 1 Specification 2 How it works 3 Where to position 3 Before use 4 Parts 5 Operation 6, 7 Drainage 8, 9 Maintenance 10, 11 Trouble shooting 12 Warranty Info 13 SD-46 SD-46W SD-46U SD-46UW 46 Pints/day dehumidifier 46 Pints/day dehumidifier with 600W warm air 46 Pints/day dehumidifier with UV light 46 Pints/day dehumidifier with 600W warm air and UV light

3 Power supply Moisture removal capacity 115 V / 60Hz 46 Pints/day Heating capacity N/A 600 W N/A 600 W Power/Amp consumption 440W / 4A Compressor Refrigerant Rotary R134a Working range F Water tank capacity 12.5 pint Size [WxDxH] 16,14 x 8,27 x 21,46 inch N.W Ibs Above is measured under RT 86 F [30 C], RH 80%. The data marked with * may vary for technical reasons. For greater precision, please refer to the rating label placed on the product.

4 DRY WARMER AIR C( NDENSER MOTOR FAN.EVAPORATER _- "-- : - MOIST SATURATED AIR I ii _ I MICRO: r-_. WATER TANK COMPRESSOR WATER TANK H u- Lij,j.llU Thisproduct is a dehumidifier, It controls relative humidity by passing the air through the unit. forcing the excess moisture to condensate over the cooling elements, Contact with this cold surface causes the moisture in the air to condense, Thiscondensed water then drains safely into the water tank, The dried air then passes through the condenser where it is slightly warmed and re-enters the room at a slightly elevated temperature. Excess moisture wilt travel throughout your home, in the same way that cooking smells waft to every room in the house. For this reason, the dehumidifier should be positioned, so that it can draw this moist air towards from all over the home, Alternatively, if you have a serious problem in one area, you can begin by positioning the dehumidifier close to this area and later moving it to a more central point, it When positioning the dehumidifier, ensure that it is placed on a level surface and with a minimum of 10 cm [4"] of space on either side of the unit to allow for efficient airflow. This dehumidifier is fitted with castors for extra mobility. If you move the unit, it should first be switched off and the water tank emptied. We do not recommend the use of an extension cord, so please try to ensure that the unit is sufficiently close to a fixed main socket. If it is necessary to use an extension cord, please ensure the diameter of the extension cable is at least 1 mm. When the dehumidifier is in operation, outside doors and windows should be closed for most efficient use.

5 Caution! Always keep the unit in vertical position. Leave the unit to stand for at least an hour after transport or when it has been tilted [e.g. during cleaning], before connecting to the main supply. Keep all foreign objects away from the air intake or output openings. The main supply must conform to the specification shown on the rating plate at the back of the unit. If the supply cord is damaged, it must be replaced by an approved service technician or one similarly qualified. Never use the plug to start or stop the unit, Always use the power switch on the control panel. Before moving the unit, first switch off, unplug and empty the water tank. Do not use bug sprays or other flammable cleaners on the unit. Never pour or spray water over the unit. IMPORTANT! Do not use this unit at ambient temperatures below 41 F, to prevent the possibility of evaporating coils from icing,

6 Front 1, Control panel 2, Cover for air outlet 3. Air outlet 4, Water full indicator 5. Water tank 6, Handle Rear 7. Air filter / air inlet 8. Power cord 9, Handle 10. Spout for continuous drainage 11. Water tank 12. Caster 7? I0 Assembly of the filters Grille Washable filter Active carbon filter Filter frar le

7 Control panel Ux/ TIMER Warm air button (SD-46W and SD-46UW only) 2. UV light button (SD-46Uand SD-46UW only) 3. Timer 4. Display window 6 5. Speed [ventilation] button 6. Humidity selection button 7. ON/OFF button Display window I _ 5o%6o%_7 3 \. j I, Humidity display: _ continuous de-humiditying, 50%, 60%, 70%, or 80%. 2, Ambient humidity condition: _good, _fair, _poor _[Good]: Ambient room humidity is between 50% to 70%, _(Fair]: Ambient room humidity is between 30% to 50% or 70% to 80%, _(Poor]: Ambient room humidity is higher than 80%,

8 3. _ Compressor isinprogress,whenunitisde-frosting, thewaterdropswill flash. _ O4 _-- _b Compressor isnotin progress. Water tank is full. 4. WARM AIR indicator: indicates that the Warm Air function is in operation, When WARM AIRfunction is selected, unit will run in high fan speed only. The output air will be slightly warmer than ambient air. [Models SD-46W and SD-46UW only] NOTE:Warm Air will not operate if ambient temperature is higher than 77 F. The PTCHeater is protected by thermostat and thermal fuse for overheat protection. 5. UV [ultraviolet] indicator: indicates that the UV light function is in operation. UV light kills bacteria and sanitizes the air. [Models SD-46U and SD-46UW only] 6. TIMER indicator: sets timed operation from 1 to 24 hours. 7. HUMIDITYlevel indicator: displays the ambient room humidify level. _ A 8. FANspeed indicator: _ high speed, "_ low speed. Operation 1. Plug unit into a correct main socket. [Please refer to the rating label at rear of the unit.] 2. PressON/OFF button to turn on the unit. The compressor will start to work in continuous mode. 3. PressHUMIDITYbutton to set the desired room humidity: continuous de-humidifying, 50%, 60%, 70% or 80%. 4. Pressthe SPEEDbutton to choose high or low fan. 5. To set timer, press the TIMERbutton until desired hours of operation is indicated on display window. One press equals one hour. 6. To use warm air function, press WARM button, [SD-46W and SD-46UW only] 7. To turn on UV light, press the UV button [SD-46U and SD-46UW only] 8. To turn off the unit, press ON/OFF button again. 9. The direction of the air outlet can be adjusted manually.

9 Whenthe watertankbecomesfull,thecompressorwillstopand: _(Water _'_ fullindication]willflash. Theunitwillbeep.Tostopthebeeping,presstheON/OFFbuttonto turnunit off. Thewaterfullindicatorwillturnfrombluelightto redlight. Note:duringoperation,thewaterfullindicatordisplaysa bluelight;thisisnormal andpartofthe designof thisunit.whenwatertankbecomesfull,thelightturns redasa warningsignal. Toemptythewatertank,pulloutgentlyby usingthe handleonthewatertank.after emptyingthetank,placethewatertankbackinplace.makesureitisproperly positioned. NOTE: if the water tank is not positioned correctly, the water full indicator will remain red and unit will beep. If the water tank is full or not correctly positioned, the water indicator will turn from blue to red light. To remove the water tank, pull out gently from the unit by using the handle on the water tank.

10 Continuous drainage When the dehumidifier is operated in very high humidity climates, the water tank will require more frequent drainage. In this situation, it may be more convenient to set up the unit for continuous drainage by following these procedures: 1, Turn unit OFF and unplug power source. 2, Use a screwdriver and remove the round knockout at the back of the unit. [FIG.1) CAUTION When the knockout is removed, this will leave a hole in the housing, Do not cover the opening with any type of plug. if the opening is blocked, water will not be able to flow out and cause possible malfunction to the unit. 3, Connect the drain spout with a water tube of 12 mm. inner diameter. [FIG,2] Note: water tube is not supplied with the unit. 4, Please make sure the tube is securely connected with no sharp bends or kinks. Note: In very cold weather conditions, precautions should be taken to prevent the water tube from freezing. FIG. 1 FIG. 2 / alter tube with inner diameter 2 mm. Note: the tube is t supplied with the unit,

11 Always unplug the unit from the main power supply before cleaning or maintaining the unit. CLEANING THE BODY Use soft cloth to wipe the unit clean. Do not ever use volatile chemicals, gasoline, detergents, chemically treated clothes, or other cleansing solutions, These all could possibly hurt the cabinet. CLEANING THE FILTER For washable filter - Tap the filter lightly or use a vacuum cleaner to remove excess diff. If the filter is particularly dirty, wash with warm water and small amount of gentle detergent. Allow to dry completely. For active carbon filter - This filter is not washable, Its life span is variable and depends on the ambient conditions where the appliance is used, The filter should be checked periodically [about every 6 months] and replaced if necessary, To order carbon filters, please call or visit Grille Washable filter Active carbon filter Filter frame lo

12 STORAGE If unit will not be used for an extended period of time, please: Turn unit off, unplug from power source and secure power cord, Empty water tank and allow to dry completely, Cover the unit and store in cool area, away from direct sunlight, ]]

13 THEUNITDOESNOTOPERATE: Is the unit plugged in? Is the house electricity on? Is the room temperature below 41 F [5 C] or above 95 F (35 C]? If so, then it is out of the working temperature range of the unit. Make sure the humidistat [or ON/OFF switch] is turned on. Check if water tank is positioned correctly and tank is not full. Make sure the air inlet and outlet are not obstructed. THE UNIT SEEMS TO DO NOTHING: Is the filter dusty or contaminated? Is the air intake or outlet blocked? Is the room humidity already quite low? THE UNIT SEEMS TO DO LrF[LE: Are too many windows or doors open? Is there something in the room producing lots of humidity?. THE UNIT IS TOO NOISY: Check whether the unit is sitting on a leveled surface. THE UNIT IS LEAKING: Make sure the unit is in good shape. If you are using continuous drainage, make sure the tube is securely connected. 12

14 SPT WARRANTY Dehumidifier Your Guarantee If this product is found to be faulty as a result of faulty materials or workmanship within one year from date of purchase, it will be repaired or replaced free of charge. This guarantee is subject to the following terms: Sunpentown must be notified of the fault. Proof of purchase must be presented to Sunpentown's nominated representative. The warranty will be void if the product if modified, misused or repaired by an unauthorized person. The warranty after repair will not be extended beyond the original one-year period. All replacement parts will be new or reconditioned. Parts, which are replaced, become the property of Sunpentown. The warranty applies for the use of the product in the USA only. What is NOT COVERED: Warranty does not include freight charges. Incidental or consequential damage caused by possible defects with this product. Damage to product caused by improper power supply voltage, accident, fire, floods or acts of nature. Failure of product resulting from unauthorized modifications to the product. Improper installation or failure to perform the necessary maintenance. This GUARANTEE is in addition to your Statutory Rights SUNPENTOWN INTERNATIONAL INC Baker Parkway, City of Industry, CA Tel: / Fax: npentown.com 13