READ AND SAVE THESE INSTRUCTIONS

Transcription

1 Portable Unit Heater Model V~60Hz 4000 WATTS INSTRUCTION MANUAL READ AND SAVE THESE INSTRUCTIONS Please read these instructions carefully and keep for future reference IMPORTANT SAFETY INSTRUCTIONS Read Carefully-These instructions contain vital information for the proper installation, use and efficient PLUG operation TYPE of the heater. Carefully read these 20 instructions amp 240V NEMA # 6-20P before installation, operation, or cleaning of the heater. User should always For Model No: EH (4000W) following this instruction to reduce the risk of fire, electric shock, and injury to persons. WARNING! When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following. 1. Read all instruction before using this heater. 2. Connect to property grounded outlets only. Check heater voltage and amperage on back of heater to make sure it agree with the electric service supplied. 3. Do not use outdoors. 4. This heater is not intended for user in wet or damp locations, never locate heater where it may fall into a bathtub or other water container 5. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, Instruction-English 1 of 5 Printed in China

2 papers, clothes, and curtains at least 3 feet (0.9m) from the front of the heater and away from the sides and rear. 6. Extreme caution is necessary when any heater is used by or near children or invalid and whenever the heater is left operating and unattended. 7. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock, fire, or damage the heater. 8. To prevent a possible fire, do not block air intake or exhaust in any manner. Do not use soft surface, like a bed, where openings may become blocked. Clean as often as necessary to prevent dust from clogging the grilles or element fins. Keep all electrical cords, drapes, paper, plastics and other combustibles away from heater. 9. To disconnect heater, turn selector knob to off position, then remove plug from outlet. 10. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, etc. To prevent entanglement or damage, route cord away from high traffic areas. 11. A heater has hot and arcing or sparking parts insides. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored. 12. If this heater or its power cord become damaged or malfunction in any way, unplug heater discontinue use, and have unite repaired by a reputable repair service. 13. Do not operate heater without stand. 14. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock. or injure to persons. 15. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. If you have to use an extension cord, the cord shall be No. 12 AWG minimum size and rated minimum 4000W. 16. Always unplug heater when not in use. ASSEMBLY This Heater has been pre-assembly in factory. FEATURES LIVE POWER SIGNAL LIGHT ( POWER ON LIGHT) Glows amber when unit is plugged in. Thermostat Control: Off, Low, High Instruction-English 2 of 5 Printed in China

3 Safety Features: Plug-- The cord has a 3-prong plug as shown in Figure 1. No adapter is available, and none should be used. Prior to operating heater, make sure the electrical outlet is of the configuration and capacity appropriate for the heater. See outlet configuration show at the right. This heater is for use on 240 volts. The type outlet is a 240 volt grounding outlet. When properly installed, it provides a ground connection through the cord to the heater to protect operator from electric shock. If you are unable to insert the plug into the outlet, contact an electrician. ELECTRICAL RATINGS This product is rated 16.7 amps (4000W) at 240 Volt AC, 60 Hz. OPERATION For Model No: EH (4000W) Grounding Pin PLUG TYPE 20 amp 240V NEMA # 6-20P Figure 1 WARNING: Be careful not to direct the airstream at draperies, furniture, or other objects that could be damaged by heat. Do not place the heater where a small child maybe may fall over the heater. Do not place the heater where the power cord may be walked on, tripped over or otherwise subjected to hard usage. 1.The heater is for floor mounting. Place the heater on floor or other flat surface free from obstructions, and at least 3 ft. (0.9m) away from any wall or combustible material. 2. With the Thermostat Switch in the OFF position, Insert plug firmly into proper wall outlet. Be sure plug fits tightly. A loose fit will cause overheating and damage to the plug. Plug and cord may feel warm during normal usage. Do not use an extension cord. Always operate heater on its feet in the normal upright position. 3. Turn the THERMOSTAT Control clockwise(right) to the HIGH setting until the knob stops. The heater should begin heating and the fan should start to blow warm air Instruction-English 3 of 5 Printed in China

4 4. Allow the heater to operate until the room temperature reaches the desired level, then slowly rotate the THERMOSTAT Control counter-clockwise(left) until the heater cycles off. At this setting, the heater will cycle on and off automatically to maintain this comfort level. NOTE: Do not force knob beyond its normal stop position. It may be necessary to make minor adjustments to the thermostat to maintain the desired comfort level. Clockwise movement will increase the room temperature. Counter-clockwise movement will decrease room temperature. 5.When heater is not needed, rotate control knob to the OFF position, remove the plug from outlet, and move heater to safe place for storage. NOTE: Each time heater is used, be sure to turn knob full On before turning it back to approximate setting established as most comfortable. (Design of the thermostat requires this operation every time heater is used). IMPORTANT NOTE: Do not expect the heating coils on your heater to glow. Coil elements are normally dark. Air movement over these coils prevents glowing yet provides convection heat, similar to a forced-air furnace. Some glow may occur where the moving air does not directly touch the coils. IF YOUR HEATER FAILS TO OPERATE: Be sure it is plugged in and that the electrical outlet is working. Check that the thermostat is not set too low, turn the thermostat up (clockwise) until the heater restarts. If you still notice the same malfunction mentioned above, remove the plug from the socket and have the appliance serviced by authorized service personnel only. CLEANING AND STORAGE We recommend that the heater be cleaned at least once a month and before off-season storage. Turn the heater OFF and unplug it. Allow it to cool. Use a dry cloth to clean the external surfaces of the heater. If heater is used in very dusty location, use a vacuum cleaner dust brush or high pressure air to remove dust and other foreign material from the grilles Instruction-English 4 of 5 Printed in China

5 DO NOT USE WATER, WAX, POLISH OR ANY CHEMICAL SOLUTION. Clean your heater using the above mentioned steps, then pack the heater in its original container and store it in a cool dry place. This heater does not disassemble. The motor is factory lubricated for life, and will require no further lubrication. SPECIFICATIONS Model NO Voltage /Frequency 240V ~ 60 Hz Output Power (W) & Electric Current (A) 4000W / 16.7A NEMA Code Receptacle 6-20P Dimensions 280x 270x340 (mm) Net Weight 5.7Kgs If you should have any questions regarding operation, contact us toll-free at WARNING OPERATION OF THE SAFETY THERMAL LIMIT INDICATES THE HEATER HAS BEEN SUBJECTED TO SOME ABNORMAL CONDITIONS. IT IS RECOMMENDED THAT THE HEATER BE CHECKED BY A REPUTABLE ELECTRICAL OR REPAIR SERVICE TO INSURE THE HAS NOT BEEN DAMAGED Instruction-English 5 of 5 Printed in China