PART III: CERTIFICATES OF COMPLETION

Transcription

1 Stafford County Fire Marshal s Office Handbook for Building/Fire Code Policies and Guidelines PART III: CERTIFICATES OF COMPLETION Office of the Fire Marshal Phone: Fax: Edition

2 Stafford County Fire and Rescue Department Office of the Fire Marshal 1225 Courthouse Road, PO BOX 339, Stafford, VA (540) FAX (540) Table of Contents NFPA 13 Certificate of Completion Commercial Sprinklers NFPA 13R, 13D Certificate of Completion Residential Sprinklers NFPA 17 Certificate of Completion Dry Chemical Fire Protection System NFPA 17A Certificate of Completion Wet Chemical Fire Protection System (Hood) NFPA 20 Acceptance Test Form Fire Pump Test NFPA 24 Certificate of Completion Underground Fire Line NFPA 72 Certificate of Completion Fire Alarm NFPA 2001 Acceptance Test Form Clean Agent Fire Protection System

3

4

5

6

7

8

9 Copyright by National Fire Protection Association (NFPA). NFPA 17 is licensed, by agreement for individual use. No other reproduction or transmission in any form permitted without written permission of NFPA. For inquiries or to report unauthorized use, contact FIGURE A Sample Acceptance Test Report.

10 Copyright by National Fire Protection Association (NFPA). NFPA 17A is licensed, by agreement for individual use. No other reproduction or transmission in any form permitted without written permission of NFPA. For inquiries or to report unauthorized use, contact FIGURE A Sample Wet Chemical System Acceptance Test Report.

11

12

13 Print

14 Copyright by National Fire Protection Association (NFPA). NFPA 13 HBK is licensed, by agreement for individual use. No other reproduction or transmission in any form permitted without written permission of NFPA. For inquiries or to report unauthorized use, contact

15 Copyright by National Fire Protection Association (NFPA). NFPA 72 is licensed, by agreement for individual use. No other reproduction or transmission in any form permitted without written permission of NFPA. For inquiries or to report unauthorized use, contact FIGURE 7.8.2(a) System Record of Completion. (SIG-FUN)

16 Copyright by National Fire Protection Association (NFPA). NFPA 72 is licensed, by agreement for individual use. No other reproduction or transmission in any form permitted without written permission of NFPA. For inquiries or to report unauthorized use, contact FIGURE 7.8.2(a) Continued

17 Copyright by National Fire Protection Association (NFPA). NFPA 72 is licensed, by agreement for individual use. No other reproduction or transmission in any form permitted without written permission of NFPA. For inquiries or to report unauthorized use, contact FIGURE 7.8.2(a) Continued

18 Fire Plan Review and Inspection Guidelines Clean Agent System Acceptance Inspection IFC , 2008 NFPA 2001, and 2007 NFPA 72 Date of Inspection: Permit Number: Business/Building Name: Address of Project: Contractor: Contractor s Phone: Reference numbers following worksheet statements represent an NFPA code section unless otherwise specified. Pass Fail NA_ 1. Received clean agent system certification from installer. 2. Control panel and components match approved plans. 3. Approved drawing on site, as-builts required when installation is not the same as the plans. 4. Control panel, piping, nozzles, and other components location are the same as shown on the plans. 5. Zones are properly identified on panel(s). 6. Verify dedicated 120 AC branch circuit and labeling, Device location same as plans. 8. Devices are located in all areas required by the code. 9. Devices are properly wired and in raceways, Type and gauge of wire or cable match plans hour monitoring service agency received signals and conveys the type signals received, Verify proper operation of magnetic door-releasing hardware and/or ventilation shutdown, Battery load test: system switched to battery operation 24 hours earlier, then activate audible circuit for 5 minutes, (2). 14. Pull stations comply with NFPA 72, distinct appearance, and mounted at proper height and location which is no more that 4 ft. above the floor, , Under primary and secondary power operational tests are performed including : A. power light on and in normal condition. B. supervisory signals: pressure switches, valves, etc.. C. silence switches. D. trouble signals and panel light operate for each circuit tested, disconnect wires. from devices and end-of-line resistors. E. trouble and alarm reset switches operate. F. a second initiating zone overrides silence switch. G. audible and visual operation. H. panel lamp test switch operates. I. field zone signals correspond with panel zones. J. detection devices and manual pull stations operate. K. abort switch is in protected area; requires manual pressure and initiates visual/audible devices, , Piping and nozzles are restrained so no unacceptable movement occurs, prior to the pressure test, Piping pneumatically tested for 10 minutes at 40 PSIG and the pressure drop shall not exceed 20 percent of the test pressure, Nozzles shall not be installed at a location were injury can occur. 19. Release circuit is tested at the storage container. 20. Pull stations activate system and override abort switch, Test connection to a monitoring company or a location receiving signal, Protected area is properly sealed and tested using a fan and smoke pencil, An enclosure or room integrity room leakage test (fan test) may be required, A quantitative method shall be used and results provided that confirm 85 percent of the concentration holds for 10 minutes, Warning and instruction signage is properly posted. 200

19 Fire Plan Review and Inspection Guidelines 25. Perform a flow test with compressed air or inert gas to verify unobstructed pipes and nozzles, Additional Comments: Inspection Date: Approved or Disapproved FD Inspector: Inspection Date: Approved or Disapproved FD Inspector: Inspection Date: Approved or Disapproved FD Inspector: 201