Product Comparison Guide

Transcription

1 Product Comparison Guide EnOcean 902MHz wireless devices for SmartStruxure TM solution and SmartStruxure Lite solution Control Performance Energy savings Better building management

2 Table of contents EnOcean 902MHz devices Lighting applications Occupancy applications HVAC applications...11 Not all products in the catalogue may be available in every country, please check availability with the local Schneider Electric office. 2 Schneider Electric EnOcean 902MHz devices

3 Make your building react to you Improve comfort with sensors that optimize energy use according to your activities 3 Schneider Electric EnOcean 902MHz devices

4 Improve energy efficiency and building comfort Lights turn on when a person enters a room, and turn off when the person leaves. Sensors powered by photovoltaic cells report temperature and humidity readings, which enable HVAC systems to be optimized. Occupancy sensors regulate room comfort when space is occupied outside set schedules. Sensors and switches blend into the decor of a modern office, even when installed on glass walls and panels. These are some of the advantages and optimizations you can gain from wireless energy-harvesting EnOcean devices. Open communications EnOcean is an open communication protocol for energy harvesting products used all over the world. It uses little energy, but enables you to save a lot. Lighting control Our line of wireless light switches, relays, controllers and sensors are perfect for adding lighting control to existing buildings as well as new construction projects. Easy installation Our sensors do not require any external power, the installation process is as simple as placing them on the wall. They can even be relocated easily when the space requirements change. Occupancy sensing Wireless occupancy sensors, as well as door and window contacts can be used to control lighting and optimize HVAC systems based on room occupancy. Efficient control Proper temperature, humidity, light level and occupancy readings allow you to get the most value out of your building's systems. Temperature and humidity sensing Get the temperature and humidity readings you need to optimize energy use without impacting comfort. 4 Schneider Electric EnOcean 902MHz devices

5 EnOcean 902MHz devices Energy harvesting wireless sensors, switches, relays and actuators Schneider Electric products based on the EnOcean protocol are energy harvesting. They generate, via solar cells, piezo-electric generators, or other similar means, the energy needed to function. This eliminates the need to change the device s battery or to connect it to a power source, thereby reducing installation and maintenance costs to a minimum. Integration with SmartStruxure solution EnOcean 902MHz devices can be integrated into Schneider Electric s SmartStruxure solution by using MPM devices (from SmartStruxure Lite solution) that support this mode of communication. MPM devices are all equipped with an ethernet port and can be integrated via LAN into a SmartStruxure solution Automation Server or Enterprise Server using BACnet /IP or EcoStruxureTM Web Services. Integration with SmartStruxure Lite solution EnOcean 902MHz devices can be integrated directly into Schneider Electric s SmartStruxure Lite solution by using MPM devices that support this mode of communication. StruxureWare Building Expert, the software powering SmartStruxure Lite solution, has drivers and objects designed for make integration of EnOcean devices easy. MPM-GW, MPM-UN, MPM-VA Managers (MPM) from the SmartStruxure Lite line of products. Make sure to select the 902MHz EnOcean option (902MHz = E): MPM-xx-Exx-5045 Network field wiring eliminated StruxureWare Building Expert MPM device StruxureWare Building Operation MPM device Automation Server or Enterprise Server 5 Schneider Electric EnOcean 902MHz devices

6 EnOcean 902MHz devices Lighting SED-1R Single rocker light switches This self-powered wireless device is simple to install and uses EnOcean energy harvesting technology to communicate wirelessly with other wireless devices to provide convenient control of lighting, temperature and miscellaneous electric loads. The device features a clean contemporary styling, making it an attractive addition sure to complement any décor. SED-1RS Single rocker light switch SED-1RS-U-5045 Turns on/off, and dims lights SED-xR Relay receivers The relay receiver controls lights or other loads by responding to EnOcean signals from self-powered wireless light switches and/or other compatible transmitters. The relay receiver mounts to junction box knockout holes or inside wiring cavities for maximum wireless range. SED-3R and SED-5R Light relay receivers SED-5R24-U-5045 SED-3R120-U-5045 SED-3R240-U-5045 SED-3R277-U VAC, 6 Amps, manual or automatic on/off 120VAC, 6 Amps, manual or automatic on/off 240VAC, 6 Amps, manual or automatic on/off 277VAC, 6 Amps, manual or automatic on/off 6 Schneider Electric EnOcean 902MHz devices

7 SED-LC Load controllers The load controller is a versatile control device used for applications such as ON/OFF lighting, timed light switch, daylight harvesting, photo inhibit, and occupancy or vacancy based lighting control. Other vertical market applications include process control and hospitality applications. The controller supports radio range confirmation, which allows installers to test signal strength for optimal sensor placement and system integrity and is supported with the SED-LLS and SED-THF sensors. SED-LC277 Lighting load controller 24VAC-277VAC SED-LC277-U VAC-277VAC, 15 Amps, manual or automatic on/off SED-LC347 Lighting load controller 120/277/347VAC SED-LC347-U /277/347VAC, Amps, manual or automatic on/off SED-LC347D Lighting load controller with 0-10V dimming output SED-LC347D-U /277/347VAC, Amps, manual or automatic on/off, 0-10V dimming output 7 Schneider Electric EnOcean 902MHz devices

8 EnOcean 902MHz devices SED-P Plug-in relays The plug-in relay receiver provides ON/OFF control of lamps and other devices. Operation involves plugging the cord of an electrical device into the receiver, and then plugging the receiver into a standard electrical outlet. The device can be controlled using self-powered wireless light switches or sensors. SED-P120 Plug-in light relay SED-P120-U VAC, 15 Amps, manual or automatic on/off SED-LL Light level sensors This photo sensor provides a reliable and simple method to increase energy savings by adding daylight harvesting to your wireless lighting control system. The device controls a single lighting controller or groups of controllers for switching or dimming zone control in relation to the natural light contribution in the area. Batteries are not required due to advanced solar energy harvesting and power management features. The device can operate over 80 hours in darkness from maximum charge levels. SED-LLS Light level sensor SED-LLS-U-5045 Selectable lux (~0-50 fc) and lux (~0-100 fc) ranges 8 Schneider Electric EnOcean 902MHz devices

9 Occupancy SED-KC Key card switch The key card switch saves energy through occupancy based control of lighting, HVAC, and miscellaneous electric loads. The switch is self-powered, and inserting or removing the card generates sufficient kinetic energy to send a wireless signal to other EnOcean-based devices within the room. Guests simply insert their key card in the slot when they enter the room and remove it when they leave. SED-KCS Key card switch SED-KCS-U-5045 Compatible with standard key cards SED-CM Ceiling mounted occupancy sensors The ceiling mounted sensor enables a new level of energy saving control for rooms, hallways, and other common areas. The sensor uses radio frequency technology to communicate wirelessly with other EnOcean-enabled devices to scale back temperature and turn-off lights when a space is unoccupied for a set period of time. The sensor is self-powered by harvesting energy from indoor light. SED-CMS Ceiling mounted occupancy sensor SED-CMS-U-5045 Can operate with 10 lux (100hrs in dark) 9 Schneider Electric EnOcean 902MHz devices

10 EnOcean 902MHz devices SED-WM Wall mounted occupancy sensors The wall mounted sensor is wireless and self-powered making it one of the most cost-effective ways to control energy-use in unoccupied rooms. The device can be installed in minutes as they are wireless and do not require batteries. The device harvests solar energy from indoor light and uses radio frequency technology to communicate wirelessly with other EnOcean-enabled devices to scale back temperature and turnn off lights when it detects a space is unoccupied for a set period of time. SED-CMS Wall mounted occupancy sensor SED-WMS-U-5045 Can operate with 10 lux (100hrs in dark). SED-WD Window and door contact sensors The device can be easily mounted on any standard door or window frame to enable occupancy based control of lighting, HVAC, and miscellaneous electric loads. The sensor uses radio frequency technology to communicate wirelessly with other EnOceanbased devices whenever it detects a door or window has been opened or closed. The sensor is completely self-powered by harvesting ambient solar energy so there are no wires to run or batteries to replace. SED-WDS Window and door contact sensor SED-WDS-U-5045 Detection gap 0.25in/7mm, can operate with 10 lux (6 days in dark), back-up coin cell battery 10 Schneider Electric EnOcean 902MHz devices

11 HVAC SED-T Temperature sensors with humidity, setpoint & fan speed options These temperature and relative humidity sensors provide a reliable and simple method to set up intelligent automation of interior spaces for energy savings. These sensors are suitable for Variable Volume Temperature (VVT) or Variable Air Volume (VAV) forced air systems. The device is capable of operating up to 200 hours in darkness from maximum charge levels, and incorporates the latest diagnostic and configuration features to ensure reliable communications and solar harvesting capability. SED-T00 and SED-TH0 Temperature sensors with humidity option SED-T00-U-5045 Temperature only SED-TH0-U-5045 Temperature and humidity (sensor precision: +/- 3%) SED-TS0 and SED-THS Temperature sensors with setpoint, with humidity option SED-TS0-U-5045 Temperature with setpoint, override button SED-THS-U-5045 Temperature with setpoint, override button, humidity (sensor precision: +/- 3%) SED-THF Temperature sensor with setpoint, humidity and fan speed control SED-THF-U-5045 Temperature with setpoint, override button, humidity (sensor precision: +/- 3%), fan speed button 11 Schneider Electric EnOcean 902MHz devices

12 Retail Perform energy efficiency retrofits without impacting your customer experience by using EnOcean wireless devices that are easy to install and can be relocated if your store s configuration changes. Education Improve student and staff comfort while reducing energy consumption during unoccupied classroom periods. EnOcean devices allow you to optimize lighting and HVAC functionality based on the occupancy of your facilities. Commercial buildings Reduce the energy consumption of your building without compromising occupant comfort. EnOcean devices provide automatic energy savings in any room used intermittently during the day. Hotels/lodging Enhance guest comfort and improve your bottom line by using EnOcean wireless devices that can be installed with minimal effort and downtime. Rooms can be promptly returned to inventory and energy savings can be enjoyed for years to come. Healthcare Optimize your environment, whether it s a patient room, waiting room, or other space within your facility. EnOcean devices improve daily comfort and energy efficiency without disturbing your patients, visitors or staff. For more information, please visit Schneider Electric Jägershillgatan 18 Malmö SE , Sweden Tel.: Schneider Electric 1 High Street North Andover, MA USA Tel.: Schneider Electric 13th Floor, East Wing, Warwick House, Taikoo Place, 979 Kings Road, Quarry Bay, Hong Kong Tel.: February Schneider Electric. All Rights Reserved. Schneider Electric and Make the most of your energy are trademarks owned by Schneider Electric Industries SAS or its affiliated companies. All other trademarks are property of their respective owners. CG-EnOcean902-EN.US v2