BES Approved Label 1106 Solfac Pro Residual Insecticide Page 1 of 7

Transcription

1 BES Approved Label 1106 Solfac Pro Residual Insecticide Page 1 of 7 MAIN PANEL 500 ml CAUTION KEEP OUT OF REACH OF CHILDREN READ SAFETY DIRECTIONS BEFORE OPENING OR USING Solfac Pro RESIDUAL INSECTICIDE ACTIVE CONSTITUENT: 25 g/l BETACYFLUTHRIN Contents 500 ml GROUP 3A INSECTICIDE For the control of cockroaches, spiders, ants, fleas, flies, silverfish, bedbugs, millipedes, mosquitoes, crickets, stored product pests, armyworm, cutworm, webworm, adult scarabs, sawfly larvae and ornamental pests in the situations specified in the directions for use. IMPORTANT: Read the attached booklet before use. APVMA Approval Number: 59424/500/0906

2 BES Approved Label 1106 Solfac Pro Residual Insecticide Page 2 of 7 MAIN PANEL 200 ml CAUTION KEEP OUT OF REACH OF CHILDREN READ SAFETY DIRECTIONS BEFORE OPENING OR USING Solfac Pro RESIDUAL INSECTICIDE ACTIVE CONSTITUENT: 25 g/l BETACYFLUTHRIN Contents 200 ml GROUP 3A INSECTICIDE For the control of cockroaches, spiders, ants, fleas, flies, silverfish, bedbugs, millipedes, mosquitoes, crickets, stored product pests, armyworm, cutworm, webworm, adult scarabs, sawfly larvae and ornamental pests in the situations specified in the directions for use. IMPORTANT: Read the attached booklet before use. APVMA Approval Number: 59424/200/0906

3 BES Approved Label 1106 Solfac Pro Residual Insecticide Page 3 of 7 Front page of booklet all packs CAUTION KEEP OUT REACH OF CHILDREN READ SAFETY DIRECTIONS BEFORE OPENING OR USING SOLFAC PRO RESIDUAL INSECTICIDE ACTIVE CONSTITUENT: 25 g/l BETACYFLUTHRIN GROUP 3A INSECTICIDE For the control of cockroaches, spiders, ants, fleas, flies, silverfish, bedbugs, mosquitoes, crickets, stored product pests, armyworm, cutworm, webworm, adult scarabs and sawfly larvae in the situations specified in the directions for use. STORAGE AND DISPOSAL: Store in the closed, original container in a cool, well-ventilated area. Do not store for prolonged periods in direct sunlight. Rinse containers before disposal. Add rinsings to spray tank. DO NOT dispose of undiluted chemicals on site. Dispose of at a local authority landfill. If no landfill is available, bury the containers below 500 mm in a disposal pit specifically marked and set up for this purpose clear of waterways, desirable vegetation and tree roots. Empty containers and product should not be burnt. SAFETY DIRECTIONS When using the prepared spray by hand-held equipment wear cotton overalls, over normal clothing, buttoned to the neck and wrist and a washable hat and elbow length PVC gloves. After each days use wash gloves and contaminated clothing. RE-ENTRY Do not enter treated areas until the spray has dried. FIRST AID If poisoning occurs contact a doctor or Poisons Information Centre (Phone Australia ). Remove from contaminated area. Apply artificial respiration if not breathing. MATERIAL SAFETY DATA SHEET Additional Information is listed in the Material Safety Data Sheet. Exclusion of Liability This product must be used strictly as directed, and in accordance with all instructions appearing on the label and in other reference material. So far as it is lawfully able to do so, Bayer CropScience Pty Ltd accepts no liability or responsibility for loss or damage arising from failure to follow such directions and instructions. SOLFAC is a registered trademark of Bayer. Bayer Environmental Science A Business Group of Bayer CropScience Pty Ltd A.B.N Tooronga Rd East Hawthorn, Vic Phone: (03) Fax: (03) Website: Batch Number: DOM: For 24 hour specialist advice in an emergency only phone

4 BES Approved Label 1106 Solfac Pro Residual Insecticide Page 4 of 7 Inside BOOKLET Directions for use: RESTRAINT DO NOT apply spray treatment outdoors if rain is imminent or if area is about to be irrigated Situations Rate Pest Critical Comments Meatworks (nonproduct areas), farm buildings, food processing establishments, shops, offices, factories, storerooms, hospitals, schools, barracks, houses, ships, rubbish tips 10 ml/l water Cockroaches Web-spinning spiders Non-webspinning spiders Ants Fleas Mosquitoes and Flies For use on non-porous surfaces; apply at a rate of 5 L of prepared spray per 100 m 2 not exceeding the point of run-off. For use on porous surfaces or for use through power equipment; apply at a rate of 10 L per 100 m 2 of surface, not exceeding the point of run-off. Thoroughly spray hiding places (eg. cracks and crevices, behind stoves and sinks, in cupboards, around drains, rubbish bins, etc.) until point of run-off. If hiding places are not directly accessible spray barrier strips around them. Repeat treatment as required. Spray spiders, their webbing and areas where spiders may hide directly. It is recommended that webbing is left in place for a few days after application to optimise efficacy. Spray areas where spiders are known to occur. Where possible locate the nest and spray directly into nest entrances. Penetration of insecticide can be assisted by pre-wetting sandy and porous soils with water. A thorough soaking treatment with insecticide mixture is required to destroy the nest. If nest cannot be located then spray infested areas. Clean or vacuum infested areas and burn all dust collected. Lightly spray all infested areas especially under furniture. Pets should be treated with a suitable flea control product registered for that purpose. Do not apply more than 100 ml/m 2 to carpet surfaces. Spray surfaces where flies and mosquitoes are known to come to rest. Flies include external surfaces that are exposed to the morning sun. Mosquitoes spray walls, awnings, fences and vegetated areas in proximity to buildings. Note: The perception of the level of control of flying insects achieved within any given area treated with a residual surface spray will be affected by the extent of in-migration of individuals from external (un-treated) areas. A residual surface spray will only control those insects that alight on the treated surfaces and therefore complete elimination of flying insects from the treated area should not necessarily always be expected..

5 BES Approved Label 1106 Solfac Pro Residual Insecticide Page 5 of 7 Inside booklet contd. Directions For Use (Contd): Situations Rate Pest Critical Comments Meatworks (nonproduct 10 ml/l water Silverfish areas), farm buildings, food processing establishments, shops, offices, factories, storerooms, Crickets hospitals, schools, barracks, houses, ships, rubbish tips Bedbugs Millipedes Direct spray to areas of potential and existing infestations eg under skirting boards and furniture where dark conditions may favour silverfish populations. If spraying inside cupboards or storage areas remove clothing and utensils etc before spraying. Spray infested areas. In addition a barrier treatment can be sprayed across areas where these pests enter buildings. Apply to the bed-frame and walls, cracks, crevices and skirting boards in the vicinity of the bed. Apply as a coarse spray to infested areas. Turf Initial or Cleanout rate - 10 ml/l Maintenance rate or when used as a tank mix with a larvicide - 6 ml/l ml/ 100 m² Stored Product Pests Armyworm Cutworm Webworm ml/100 m² Adult Scarabs (including African black beetle), Ants The use of this product in the control of stored product pests should be considered part of an integrated strategy to prevent development of insect populations. Best results will be obtained where good hygiene is maintained. Infested areas should be cleaned prior to application and regularly cleaned thereafter to reduce food sources for pests. When treating for beetle pests pay special attention to sheltered areas such as cracks and crevices, under furniture and equipment, floors, walls and shelves. Adult moths can be controlled by applying this product to walls and surfaces where the flying adult moths come to rest. Apply to mown turf in a minimum application volume of 200 L/ha (or 2 L/100 m 2 ) and irrigate treated areas after application with up to 4 mm water. Use the higher rate when pest numbers are very high. Repeat as necessary. Application after mowing is recommended to minimise loss of insecticide in clippings. Native plants 6 ml/l Sawfly larvae Apply thoroughly as a full cover spray. Repeat at beginning of renewed pest activity. See note on native plants. Do not spray if it is raining or about to rain. Azaleas Hibiscus Pelargoniums Roses 2 4 ml/5 L water Aphids Bugs (eg passionvine hopper, mealybug, lace bug) Caterpillars Garden weevil Whiteflies Thrips Spray foliage thoroughly when insects are first seen or if they reappear. Spray underneath leaf surfaces. DO NOT spray if it is raining or about to rain. NOT TO BE USED FOR ANY PURPOSE, OR IN ANY MANNER, CONTRARY TO THIS LABEL UNLESS AUTHORISED UNDER APPROPRIATE LEGISLATION.

6 BES Approved Label 1106 Solfac Pro Residual Insecticide Page 6 of 7 Inside booklet contd. GENERAL INSTRUCTIONS Mixing: Add the required quantity of Solfac Pro Residual Insecticide to water while stirring. Application Do not spray the moving parts of any machinery, electric motors or switchgear with the water-based product. Note on application to carpets: Since carpets vary in their thickness, colour and material it is recommended that a small, inconspicuous area of carpet be sprayed and allowed to dry first to ensure that staining will not occur. Allow treated carpets to dry before resuming activity on them. Note on native plants and ornamentals: Solfac Pro Residual Insecticide has been used on a wide range of ornamental plant species without damage. However, some species and varieties are particularly sensitive to chemical sprays and as this is often related to local conditions it is advisable to treat only a small number of plants first, in order to ascertain their reaction before treating the whole target group. GENERAL PRECAUTIONS: For surface treatment only do not spray into the atmosphere using foggers or other devices designed to create an aerosol. Use in food processing areas is limited to crack, crevice and barrier strip treatment only. When using in animal houses do not spray directly onto livestock, their food, water, litter, feed bins, or surfaces that are accessible to the stock. Do not spray directly on humans, exposed food or food utensils or food preparation areas. Avoid contact of spray with timber to which a stain is subsequently to be applied. Evidence of water contact on timber is sometimes only evident once the stain has been applied. BEFORE USE : Remove or cover all exposed foodstuffs. Cover all dishes and utensils and surfaces where food is prepared. AFTER USE : Thoroughly ventilate treated areas. Clean up thoroughly before processing/serving resumes. Insecticide Resistance Warning GROUP 3A INSECTICIDE For insecticide resistance management Solfac Pro is a Group 3A insecticide. Some naturally occurring insect biotypes resistant to Solfac Pro and other Group 3A insecticides may exist through normal genetic variability in any insect population. The resistant individuals can eventually dominate the insect population if Solfac Pro or other Group 3A insecticides are used repeatedly. The effectiveness of Solfac Pro on resistant individuals could be significantly reduced. Since occurrence of resistant individuals is difficult to detect prior to use, Bayer CropScience Pty Ltd accepts no liability for any losses that may result from failure of Solfac Pro to control resistant insects. For further information on managing insecticide resistance contact your local supplier or Bayer Environmental Science representative. Protection of Wildlife, Fish, Crustacea and Environment: Dangerous to fish. Cover fish tanks before using. Do not contaminate ponds, waterways or drains with this product or used container. APVMA Approval Number: 59424/0906

7 BES Approved Label 1106 Solfac Pro Residual Insecticide Page 7 of 7 Rear panel attached to container STORAGE AND DISPOSAL: Store in the closed, original container in a cool, well-ventilated area. Do not store for prolonged periods in direct sunlight. Rinse containers before disposal. Add rinsings to spray tank. DO NOT dispose of undiluted chemicals on site. Dispose of at a local authority landfill. If no landfill is available, bury the containers below 500 mm in a disposal pit specifically marked and set up for this purpose clear of waterways, desirable vegetation and tree roots. Empty containers and product should not be burnt. SAFETY DIRECTIONS When using the prepared spray by hand-held equipment wear cotton overalls, over normal clothing, buttoned to the neck and wrist and a washable hat and elbow length PVC gloves. After each days use wash gloves and contaminated clothing. RE-ENTRY Do not enter treated areas until the spray has dried. FIRST AID If poisoning occurs contact a doctor or Poisons Information Centre (Phone Australia ). Remove from contaminated area. Apply artificial respiration if not breathing. MATERIAL SAFETY DATA SHEET Additional Information is listed in the Material Safety Data Sheet. Exclusion of Liability This product must be used strictly as directed, and in accordance with all instructions appearing on the label and in other reference material. So far as it is lawfully able to do so, Bayer CropScience Pty Ltd accepts no liability or responsibility for loss or damage arising from failure to follow such directions and instructions. IMPORTANT: READ THE ATTACHED BOOKLET BEFORE USE SOLFAC is a registered trademark of Bayer. Bayer Environmental Science A Business Group of Bayer CropScience Pty Ltd A.B.N Tooronga Rd East Hawthorn, Vic Phone: (03) Fax: (03) Batch Number: DOM: For 24 hour specialist advice in emergency only phone