VNRZH VNRZH. High Narrow Reach-In Merchandiser 1, 2, 3, 4, & 5 Door (Frozen Food) SHIPPING WEIGHT Case Weight VNRZH LBs GENERAL NOTES

Transcription

1 GENERAL Light controls - occupancy sensors are required Option 1: OEM Provided: OEM anti-condensate and lighting controls (on/off) are standard unless otherwise specified. Option 2: End User Provided: Light controls should be based on occupancy sensors. Store level A/S control should be set to 30% minimum off time at 75ºF/55%RH. SHIPPING WEIGHT Weight LBs

2 ELECTRICAL DATA Length Fans Per High Fans Drain Heater Defrost (1-Phase) 120 Volts 120 Volts 208 Volts 240 Volts Amps Watts Amps Watts Amps Watts Amps Watts 1 Door Door Door Door Door LIGHTING DATA OP45 Optimax Pro 24 Low 120 Volts 120 Volts Length Door Size Amps Watts Amps Watts 1 Door 31" Door 30" Door 30" Door 30" Door 30" ANTI-CONDENSATE DATA Length Individual Circuits I90 Doors ELMD, ELMH, Doors Door Frame Heated Doors Low E Doors Heated Doors Low E Doors 101-LE 120 Volts 120 Volts 120 V 120 V 120 V Amps Watts Amps Watts Amps Watts Amps Watts Amps Watts Door Size 1 Door 31" Door 30" Door 30" Door 30" Door 30" "---" indicates that this feature is not an option on this case model. Drain heater and fan motors share the same circuit (separate cycles). Electrical circuits must be properly sized to accomodate the higher current draw of the tank heater. Data listed is for Optimax Radiant and low power Optimax Pro (high power available). For other lighting options please contact your sales representative. Anti-condensate heat values for Low E doors represent a door with no heat on the glass. Listed discharge air velocity represents the average velocity at the peak of defrost. Defrost Run-off Time applies to Hot Gas Defrost only. Electric Defrost has a 0-minute run-off time. Temperature and defrost settings listed above are recommended start-up settings. Final operational settings may need to be adjusted for the store conditions in which the case operates. The recommended evaporator temperatures may need to be adjusted based on system setup, store conditions, etc. The minimum recommended evaporator temperature is 4 F below the listed evaporator temperature. Low energy doors (no heat on the glass) do not require anti-condensate or lighting controls. Frame A/S heat is cycled off during defrost cycles. Heated doors (heat on the glass) require anti-condensate and lighting controls. Frame A/S heat is cycled off during defrost cycles. Light and A/S wattages above reflect 100% run time. To determine actual daily energy usage at 75ºF/55%RH conditions, reduce the light wattages above by 42% and reduce the A/S values above by the minimum off time.

3 GUIDELINES AND CONTROL SETTINGS DEFROST DATA Defrosts Per Day Run-Off Time Electrical Defrost Fail-Safe Termination Temp Hot Gas Defrost Fail Safe BTUH/door BTUH/door Termination Temp Superheat Set Bulb Superheat Set Bulb Evaporator Evaporator Discharge Air Discharge Air Discharge Air Velocity (FPM) Length Application Door Conventional Parallel 1 Door Frozen Heated Door Frozen Low E Door Ice Cream Heated Door Ice Cream Low E Discharge Air Velocity (FPM) Length Application Door Conventional Parallel 2-5 Door Frozen Heated Door Frozen Low E Door Ice Cream Heated Door Ice Cream Low E "---" indicates that this feature is not an option on this case model. Drain heater and fan motors share the same circuit (separate cycles). Electrical circuits must be properly sized to accomodate the higher current draw of the tank heater. Data listed is for Optimax Radiant and low power Optimax Pro (high power available). For other lighting options please contact your sales representative. Anti-condensate heat values for Low E doors represent a door with no heat on the glass. Listed discharge air velocity represents the average velocity at the peak of defrost. Defrost Run-off Time applies to Hot Gas Defrost only. Electric Defrost has a 0-minute run-off time. Temperature and defrost settings listed above are recommended start-up settings. Final operational settings may need to be adjusted for the store conditions in which the case operates. The recommended evaporator temperatures may need to be adjusted based on system setup, store conditions, etc. The minimum recommended evaporator temperature is 4 F below the listed evaporator temperature. Low energy doors (no heat on the glass) do not require anti-condensate or lighting controls. Frame A/S heat is cycled off during defrost cycles. Heated doors (heat on the glass) require anti-condensate and lighting controls. Frame A/S heat is cycled off during defrost cycles. Light and A/S wattages above reflect 100% run time. To determine actual daily energy usage at 75ºF/55%RH conditions, reduce the light wattages above by 42% and reduce the A/S values above by the minimum off time.

4 2, 3, 4, & 5 Door (Frozen Food) DOOR OPTIONS FRONT OPTIONS FLAT FRONT (V SERIES) STANDARD SWING DOOR 2,3,4,5 - DOOR CASES 30" [76.2 cm] TANK 4" [10.0 cm] FRONT PANEL KICKPLATE

5 TOP WIRING REQUIRED 33 3/4" [85.7 cm] LOAD LIMIT 96 1/8" [244.2 cm] SHIPPING HEIGHT 93 7/8" [238.4 cm] INSTALLED HEIGHT 93 7/8" [238.4 cm] OVERALL CASE HEIGHT 89 7/8" [228.3 cm] CASE HEIGHT 72" [182.8 cm] INTERIOR HEIGHT 23 1/8" [58.7 cm] 72 1/4" [183.5 cm] VISUAL DISPLAY 79" [200.7 cm] DOOR HEIGHT 81" [205.7 cm] FRAME HEIGHT COIL PLENUM 4 1/8" [10.5 cm] 5 3/4" [14.6 cm] 26 1/2" [67.4 cm] 32 7/8" [83.5 cm] 37 1/8" [94.3 cm] 8 1/4" [21.0 cm] 11" [27.9 cm] WIRING TO THE TOP (12" X 10" X 4") 2" AIR GAP REQUIRED PIPING TO THE TOP (OPTIONAL) REAR REFRIGERATION LOCATED 9 1/4" ABOVE FINISH FLOOR 37 1/8" [94.3 cm] 32 7/8" [83.5 cm] 26 1/2" [67.3 cm] 30 1/8" [76.5 cm]** 23 1/2" [59.7 cm]* 23 1/4" [59.1 cm] 3 1/8" [7.9 cm] 7" [17.8 cm] 1 1/2" PVC DRAIN CONNECTION 31" [78.7 cm] (1 DOOR) 60" [152.4 cm] (2 DOOR) 90" [228.6 cm] (3 DOOR) 120" [304.8 cm] (4 DOOR) 150" [381.0 cm] (5 DOOR) DEFAULT REFRIGERATION 8 3/4" [22.2 cm] 1 1/2" [3.8 cm] {END} * : STUB-UP AREA. ** : RECOMMENDED STUB-UP CENTERLINE FOR ELECTRICAL AND HUB DRAINS. Ends add approximately 1" to case height, 1/2" to the back & 1" to the front.