'' Stone Fireplace Model# SRFP41301 Instructions Manual

Transcription

1 '' Stone Fireplace Model# SRFP430 Instructions Manual Questions, problems, missing parts? Before returning to your retailer, call our customer service department at , 8 a.m. - 8 p.m., EST Monday - Friday. Or customerservice@shinerichgroup.com.

2 Table of Contents Table of Contents Warnings... 2 Tools Required... 4 Parts List... 5 Hardware... 6 Assembly Instructions... 7 Care and Maintenance...4 Warranty Information... 5 REMINDER BEFORE ASSEMBLY Verify that all parts are included with your fireplace BEFORE you begin assembly by checking the Parts and Hardware List. For your convenience, some parts may be pre-assembled or attached to fireplace components. If all parts are not included, do not attempt to assemble fireplace. Call the toll free number on the cover page for replacement parts. Leave hardware installed HALF-TIGHTENED on the fireplace during assembly until unit is completely assembled, then finish tightening all hardware installed. YOUR OWNER S MANUAL Keep and store this Owner s Manual for future reference it contains important instructions and procedures for safety and maintenance.

3 Warnings! For Outdoor Use Only (outside any enclosure) WARNING! WARNING. Improper Installation, adjustment, alteration, service, or maintenance may result in property damage, injury or death. 2. Read the Installation, operation, maintenance instructions thoroughly before installing or servicing this equipment. 3. Failure to follow these instructions could result in a fire or explosion, which could cause property damage, personal injury or death. Save these instructions for future reference. If you are assembling this fireplace for someone else, give this manual to him or her to save for future reference.! WARNING FOR YOUR SAFETY. DO NOT use this fireplace without reading this entire document and all WARNINGS, cautions and instructions. 2. This item is for outdoor use only, and shall NOT be used in a building, garage or any other enclosed area. 3. DO NOT use this fireplace for indoor heating. TOXIC carbon monoxide fumes can accumulate and cause asphyxiation or death. 4. This fireplace is NOT for commercial use. 5. This fireplace is NOT to be operated by children. 6. This fireplace is NOT to be used in or on boats or recreational vehicles. 7. Always use in accordance with all applicable local, state and national codes. Contact your local fire department for details on outdoor burning. 8. When using this fireplace, exercise the same precautions you would with any open fire. 9. The use of alcohol, prescription or non-prescription drugs may impair the consumer s ability to properly assemble or safely operate this fireplace. 0. This fireplace is for use with dry, seasoned hardwood. It will burn hotter, more completely and create less smoke.. DO NOT burn charcoal briquette, lump charcoal, manufactured logs, driftwood, trash, leaves, papers, cardboard, plywood, painted or stained or pressure treated wood. Avoid using softwoods such as pine or cedar that can throw sparks. 2. DO NOT alter this fireplace in any manner. 3. DO NOT use this fireplace until it is COMPLETELY assembled and all parts are securely fastened and tightened. 2

4 Warnings 4. DO NOT store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. 5. DO NOT store or use an LP gas cylinder within 0 feet (3.05m) of this fireplace while it is in operation. 6. DO NOT use this fireplace near automobiles, trucks, vans or recreational vehicles. 7. DO NOT use in an explosive atmosphere. Keep outdoor area clean and free from combustible materials, gasoline and other flammable liquids. 8. DO NOT use this fireplace under an overhead or near any unprotected combustible constructions. Avoid using near or under overhanging trees and shrubs. 9. Always use this fireplace on a hard level non-combustible surface such as concrete, rock or stone. An asphalt or blacktop surface may not be acceptable for this purpose. DO NOT use on wooden decks. 20. Always empty this fireplace before each use. 2. DO NOT wear flammable or loose clothing when operating this fireplace. 22. DO NOT use in windy conditions. 23. DO NOT use gasoline, kerosene, diesel fuel, lighter fluid to start or relight fires. 24. Keep all electrical cords away from a hot fireplace. 25. All surfaces of this fireplace are hot when in operation. To avoid burns, DO NOT touch fireplace until it has completely cooled unless you are wearing protective gear (potholders, gloves, BBQ mittens, hot pads etc). Never touch ashes or coals to see if they are hot. 26. DO NOT leave a lit fireplace unattended, especially around children and pets. 27. DO NOT attempt to move or store this fireplace until ashes and coals are completely extinguished. 28. DO NOT remove ashes or coals until they are completely extinguished. 29. Use heat-resistant gloves or hot pads when contacting handles. 30. Use long, sturdy fireplace tools when adding or moving logs. 3. DO NOT place wood directly into bottom of the fireplace. Place wood only on the charcoal grid. 32. DO NOT overload the fireplace. DO NOT add additional firewood until the fire burns down. 33. DO NOT lean over this fireplace when lighting or when in use. 34. DO NOT place hot pit tools onto combustible surface such as grass, wooden deck or furniture. 35. Avoid breathing smoke from the fire and avoid getting it into your eyes. 36. This fireplace should be thoroughly inspected and cleaned on a regular basis. 37. After a period of storage and/or non-use, check for signs of damage and creosote build-up. DO NOT operate until necessary repairs and/or clean up is executed. 38. Death, serious injury or damage to property may occur if the above is not followed exactly. 3

5 Tools Required A B Q C D E P O K I J L H G F M N Description (Not included) Picture Phillips Head Screwdriver Adjustable open end wrench 4

6 Parts List Part # Description Picture Quantity A Chimney cap B Roof C Panel D Connecting pole 3 E Door spindle 4 F Pin 4 G Panel 2 H I J K L Right door Door holder Door knob Hook Charcoal grid 2 M Fire bowl N Base O Left door P Panel 3 Q Panel 4 5

7 Hardware Hardware # Description Picture Quantity AA M5 x 35mm Bolt 4 BB M5 x 6mm Bolt 8 CC M5 x 2mm Bolt 8 ST5.5 x 3mm Bolt 33 EE D6 Washer FF D5 Washer 4 D5 Spring Washer 2 M5 Nut 2 II D6 Spring Washer 3 JJ M6 Nut 2 NOTE: Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents above. If any part is missing or damaged, do not attempt to assemble the product. Contact customer service for replacement parts. 6

8 Assembly Instructions NOTE: Assemble the fireplace on a non-abrasive level surface.if missing parts please contact customer service. Step Attach Door knob (J) to Left door (O) with D6 spring washer (II) and M6 nut (JJ). See Figure O JJ II Hardware Used II D6 Spring Washer x J JJ M6 Nut x Step 2 Attach Door knob (J) and Door holder (I) to Right door (H) with (2) D6 washer (EE), (2) D6 spring washers (II), and M6 nut (JJ). See Figure 2 2 H Hardware Used JJ EE J EE D6 Washer x II I II D6 Spring Washer x 2 JJ M6 Nut x 7

9 Assembly Instructions NOTE: Assemble the fireplace on a non-abrasive level surface.if missing parts please contact customer service. Step 3 Attach Panel (C) and Panel 2 (G) to Connecting pole (D) with (0) ST5.5 x 3mm bolts (). (3) M5 x 2mm bolts (CC), (3) D5 spring washers () and (3) M5 nuts (). See Figure 3 3 C D G CC Hardware Used CC M5 x 2 Bolt x 3 ST5.5 x 3 Bolt x 0 D5 Spring Washer x 3 M5 Nut x 3 8

10 Assembly Instructions NOTE: Assemble the fireplace on a non-abrasive level surface.if missing parts please contact customer service. Step 4 Attach Panel 4 (Q) and Panel (C) to Connecting pole (D) with (0) ST5.5 x 3mm bolts (). (2) M5 x 2mm bolts (CC), (2) D5 spring washers () and (2) M5 nuts (). See Figure 4 4 C D Q Hardware Used CC M5 x 2 Bolt x 2 ST5.5 x 3 Bolt x 0 D5 Spring Washer x 2 M5 Nut x 2 9

11 Assembly Instructions NOTE: Assemble the fireplace on a non-abrasive level surface.if missing parts please contact customer service. Step 5 Attach Panel 4 (Q) and Panel 3 (P) to Connecting pole (D) with (0) ST5.5 x 3mm bolts (), (3) M5 x 2mm bolts (CC), (3) D5 spring washers () and (3) M5 nuts (). See Figure 5 5 Q Hardware Used CC M5 x 2 Bolt x 3 P D ST5.5 x 3 Bolt x 0 D5 Spring Washer x 3 M5 Nut x 3 6 AA Step 6 With help from at least one person, lift Base (N) and place in desired location. Attach panel assembly to Base (N) with (4) M5 x 35mm bolts (AA), (4) D5 washers (FF), (4) D5 spring washers () and (4) M5 nuts (). NOTE: Please line up the holes on panel assembly and the base (N). See Figure 6 Hardware Used AA M5 x 35mm Bolt x 4 N FF FF D5 Washer x 4 D5 Spring Washer x 4 M5 Nut x 4 FF 0

12 Assembly Instructions NOTE: Assemble the fireplace on a non-abrasive level surface.if missing parts please contact customer service. Step 7 Line up the hole both of panel assembly and Left door (O) then fix them with (2) door spindle (E). Insert the (2) pin (F) into the hole on the door spindles (E). Repeat the same procedure to install the Right door (H). See Figure 7 7 O E E O E F H

13 Assembly Instructions NOTE: Assemble the fireplace on a non-abrasive level surface.if missing parts please contact customer service. Step 8 Connect decoration Chimney cap (A) to Roof (B) with (3) ST5.5 x 3mm Bolts (). See Figure 8 8 A B Hardware Used ST5.5 x 3 Bolt x 3 Step 9 Connect Roof (B) and panel assembly with (8) M5 x 6mm bolts (BB). See Figure 9 9 B BB Panel assembly Hardware Used BB M5 x 6 Bolt x 8 2

14 Assembly Instructions Step 0 Place Charcoal grid (L) on top of Fire bowl (M) followed by Hook (K) and close front doors, then latch door holder. See Figure 0 0 3

15 Care and Maintenance Lighting. Make sure there is only a small amount of ash in the bottom of the bowl. 2. Place a layer of dry kindling or a natural fire-starter onto the center of the grate. 3. Place above that a layer of dry seasoned hardwood that is no more than 3/4 the diameter of the bowl. 4. Use a match to light kindling or fire-starter. 5. Using the hook that is provided and heat resistant gloves, replace spark guard screen once the kindling or fire-starter is lit. Tending the Fire You may need to shift and/or add logs for an ideal experience. DO NOT place a hot spark guard screen or hot fireplace tools onto combustible surfaces such as grass wooden deck or furniture.. Using the hook that is provided and heat resistant gloves, carefully remove spark guard screen. 2. While using a long handled fireplace tool, shift coals and logs to allow additional airflow. 3. DO NOT add gasoline, kerosene, diesel fuel, lighter fluid or alcohol to relight or enhance an existing fire. 4. Wait until glowing coals have developed before adding any additional wood. If additional wood is required, place wood on top coals, be careful not to shift ashes. Extinguishing. Allow fire to burn itself out. 2. DO NOT use water to extinguish as this is dangerous and can cause damage to this outdoor fire pit. Inspecting safety and longer is cool to the touch., and fireplace If damage to any component is detected, do not operate until repairs are made. Cleaning the finish. Storage The weight printed on the carton is an average number and just for reference ONLY. 4

16 Warranty Information The appliance has been manufactured under the highest standards of quality and workmanship. We warrant to the original consumer purchaser that all aspects of this product will be free of defects in material and workmanship for one year () from the date of purchase. A replacement for any defective part will be supplied free of charge for installation by the consumer. Defects or damage caused by the use of other than genuine parts are not covered by this warranty. This warranty shall be effective from the date of purchase as shown in the purchaser s receipt. This warranty is valid for the original consumer purchaser only and excludes industrial, commercial or business use of the product, product damage due to shipment or failure which results from alteration, product abuse, or product misuse, whether performed by a contractor, service company, or consumer. We will not be responsible for labor charges and / or damage incurred in installation, repair or replacement, nor for incidental or consequential damage. Need help? call our toll free number at: or us at: customerservice@shinerichgroup.com 5