PROPOSED CHANGE TO THE 2012 BUILDING CODE O. REG. 332/12 AS AMENDED

Transcription

1 Ministry of Municipal Affairs PROPOSED CHANGE TO THE 2012 BUILDING CODE O. REG. 332/12 AS AMENDED CHANGE NUMBER: SOURCE: B Ontario-NBC CODE REFERENCE: Division B / and DESCRIPTION OF THE PROPOSED AMENDMENT This proposed change would permit the use of a residential warning system in lieu of an interconnected smoke alarm system. This new system allows the connection of heat detectors, CO alarms, other life safety devices and remote monitoring capabilities. It is also capable of supervising the interconnected devices. EXISTING 2012 BUILDING CODE PROVISION(S) Smoke Alarms (1) Except as permitted by Sentence (6), smoke alarms conforming to CAN/ULC-S531, Smoke Alarms, shall be installed in each dwelling unit and, except for care, care and treatment or detention occupancies required to have a fire alarm system, in each sleeping room not within a dwelling unit. (2) At least one smoke alarm shall be installed on each storey and mezzanine of a dwelling unit. (3) On any storey of a dwelling unit containing sleeping rooms, a smoke alarm shall be installed in, (a) each sleeping room, and (b) a location between the sleeping rooms and the remainder of the storey, and if the sleeping rooms are served by a hallway, the smoke alarm shall be located in the hallway. (4) A smoke alarm shall be installed on or near the ceiling. (5) Except as permitted by Sentence (6), smoke alarms required by Sentence (1) shall, (a) be installed with permanent connections to an electrical circuit, (b) have no disconnect switch between the overcurrent device and the smoke alarm, and (c) in case the regular power supply to the smoke alarm is interrupted, be provided with a battery as an alternative power source that can continue to provide power to the smoke alarm for a period of not less than seven days in the normal condition, followed by 4 min of alarm. (See Appendix A.) (6) Suites of residential occupancy are permitted to be equipped with smoke detectors in lieu of smoke alarms, provided the smoke detectors, (a) are capable of independently sounding audible signals within the individual suites, (b) except as provided by Sentence (7), are installed in conformance with CAN/ULC-S524, Installation of Fire Alarm Systems, and verified in conformance with CAN/ULC-S537, Verification of Fire Alarm Systems, and (c) form part of the fire alarm system. Building and Development Branch Page 1

2 (7) Smoke detectors permitted to be installed in lieu of smoke alarms as provided in Sentence (6) are not required under Clause (6)(b) to sound an alarm throughout the rest of the building, provided they sound localized alarms within individual suites and otherwise meet the requirements of Clause (6)(b). (See Appendix A.) (8) If more than one smoke alarm is required in a dwelling unit, the smoke alarms shall be wired so that the actuation of one smoke alarm will cause all smoke alarms within the dwelling unit to sound. (9) A smoke alarm required by Sentence (1) shall be installed in conformance with CAN/ULC-S553, Installation of Smoke Alarms. (10) Except as permitted by Sentence (11), a manually operated silencing device shall be incorporated within the circuitry of a smoke alarm installed in a dwelling unit so that it will silence the signal emitted by the smoke alarm for a period of not more than 10 min, after which the smoke alarm will reset and again sound the alarm if the level of smoke in the vicinity is sufficient to reactuate the smoke alarm. (11) Suites of residential occupancy equipped with smoke detectors installed in conformance with CAN/ULC-S524, Installation of Fire Alarm Systems, as part of the fire alarm system in lieu of smoke alarms as permitted by Sentence (6), need not incorporate the manually operated silencing device required by Sentence (10). (12) The sound patterns of smoke alarms shall, (a) meet the temporal patterns of alarm signals, or (b) be a combination of temporal pattern and voice relay. (13) Smoke alarms required by Sentence (1) shall have a visual signalling component conforming to the requirements in (Light, Color and Pulse Characteristics) of NFPA 72, National Fire Alarm and Signaling Code. (See Appendix A.) (14) The visual signalling component required by Sentence (13) need not, (a) be integrated with the smoke alarm provided it is interconnected to it, (b) be on battery backup, or (c) have synchronized flash rates, when installed in a dwelling unit. (15) The luminous intensity for visual signalling components required by Sentence (13) that are installed in sleeping rooms shall be a minimum of 175 cd Voice Communication Systems PROPOSED CODE CHANGE Revise existing Article and add new Article as follows: Smoke Alarms (1) Except as provided in Article smoke alarms shall be installed in accordance with this Article. (12) Except as permitted by Sentence (7), smoke alarms conforming to CAN/ULC-S531, Smoke Alarms, shall be installed in each dwelling unit and, except for care, care and treatment or detention occupancies required to have a fire alarm system, in each sleeping room not within a dwelling unit. (23) At least one smoke alarm shall be installed on each storey and mezzanine of a dwelling unit. (34) On any storey of a dwelling unit containing sleeping rooms, a smoke alarm shall be installed in, (a) each sleeping room, and (b) a location between the sleeping rooms and the remainder of the storey, and if the sleeping rooms are served by a hallway, the smoke alarm shall be located in the hallway. Building and Development Branch Page 2

3 (45) A smoke alarm shall be installed on or near the ceiling. (56) Except as permitted by Sentence (7), smoke alarms required by Sentence (2) shall, (a) be installed with permanent connections to an electrical circuit, (b) have no disconnect switch between the overcurrent device and the smoke alarm, and (c) in case the regular power supply to the smoke alarm is interrupted, be provided with a battery as an alternative power source that can continue to provide power to the smoke alarm for a period of not less than seven days in the normal condition, followed by 4 min of alarm. (See Appendix A.) (67) Suites of residential occupancy are permitted to be equipped with smoke detectors in lieu of smoke alarms, provided the smoke detectors, (a) are capable of independently sounding audible signals within the individual suites, (b) except as provided by Sentence (8), are installed in conformance with CAN/ULC-S524, Installation of Fire Alarm Systems, and verified in conformance with CAN/ULC-S537, Verification of Fire Alarm Systems, and (c) form part of the fire alarm system. (78) Smoke detectors permitted to be installed in lieu of smoke alarms as provided in Sentence (7) are not required under Clause (7)(b) to sound an alarm throughout the rest of the building, provided they sound localized alarms within individual suites and otherwise meet the requirements of Clause (7)(b). (See Appendix A.) (89) If more than one smoke alarm is required in a dwelling unit, the smoke alarms shall be wired so that the actuation of one smoke alarm will cause all smoke alarms within the dwelling unit to sound. (910) A smoke alarm required by Sentence (2) shall be installed in conformance with CAN/ULC-S553, Installation of Smoke Alarms. (1011) Except as permitted by Sentence (12), a manually operated silencing device shall be incorporated within the circuitry of a smoke alarm installed in a dwelling unit so that it will silence the signal emitted by the smoke alarm for a period of not more than 10 min, after which the smoke alarm will reset and again sound the alarm if the level of smoke in the vicinity is sufficient to reactuate the smoke alarm. (1112) Suites of residential occupancy equipped with smoke detectors installed in conformance with CAN/ULC- S524, Installation of Fire Alarm Systems, as part of the fire alarm system in lieu of smoke alarms as permitted by Sentence (7), need not incorporate the manually operated silencing device required by Sentence (10). (1213) The sound patterns of smoke alarms shall, (a) meet the temporal patterns of alarm signals, or (b) be a combination of temporal pattern and voice relay. (1314) Smoke alarms required by Sentence (2) shall have a visual signalling component conforming to the requirements in (Light, Color and Pulse Characteristics) of NFPA 72, National Fire Alarm and Signaling Code. (See Appendix A.) (1415) The visual signalling component required by Sentence (14) need not, (a) be integrated with the smoke alarm provided it is interconnected to it, (b) be on battery backup, or (c) have synchronized flash rates, when installed in a dwelling unit. (1516) The luminous intensity for visual signalling components required by Sentence (14) that are installed in sleeping rooms shall be a minimum of 175 cd. Building and Development Branch Page 3

4 Residential Fire Warning Systems (1) Except where a fire alarm system is installed or required in a building, smoke detectors forming part of a residential fire warning system installed in conformance with CAN/ULC-S540 Residential Fire Warning Systems: Installation, Inspection, Testing and Maintenance, are permitted to be installed in lieu of all smoke alarms required by Article , provided that the system (a) is capable of sounding audible signals in accordance with Articles and , (b) is provided with a visual signalling component in accordance with Article , (c) is powered in accordance with Article , and (d) is provided with a silencing device in accordance with Article Voice Communication Systems RATIONALE FOR CHANGE Problem/General Background The building official community has requested the use of residential fire warning systems in lieu of the currently required interconnected smoke alarms. The ULC Committee on Fire Alarm and Life Safety Equipment and Systems updated CAN/ULC-S540, Residential Fire Warning Systems: Installation, Inspection, Testing and Maintenance in fall of This standard provides the minimum requirements for the design, installation, inspection, testing and maintenance of residential fire warning systems for use in suites of residential occupancy, dwelling units and care occupancy. Justification/Explanation This proposed change would harmonize requirements with the model National Building Code of Canada. Interconnected smoke alarms and residential fire warning systems will provide detection and audible signals to alert the occupants of an emergency situation. Allowing the option of a residential fire warning system, will enhance the level of life safety provided to the occupants. Additionally, this allows for the interconnection of heat detectors, CO alarms, other life safety devices and remote monitoring capabilities. This will also allow for the supervision of the interconnected devices. Cost/Benefit Implications Since this requirement will be optional, the costs will be minimal and will vary depending on the option chosen. Enforcement Implications This requirement will facilitate enforcement actions by having the reference to a National Standard. Who is Affected Designers, building officials. Building and Development Branch Page 4

5 Objective Based Analysis Provision Objective/Functional Statement Division B (1) [F81,F11-OS1.5] (2) 1 [F11, F81-OS1.5] (3) 2 [F11-OS1.5] (4) 3 [F11-OS1.5] (5) 4 [F11-OS1.5] (6) 5 [F11,F81-OS1.5] (7) 6 [F11,F81-OS1.5] (8) 7 (9) 8 [F11-OS1.5] (10) 9 [F81,F11-OS1.5] (11) 10 [F81,F11-OS1.5] (12) 11 (13) 12 [F11-OS1.5] (14) 13 [F74-OA-2] [F11-OS1.5] (15) 14 (16) 15 [F74-OA-2] [F11-OS1.5] Division B Division B (1) [F11, F12-OS3.7] Building and Development Branch Page 5

6 Provision Objective/Functional Statement (2) [F11-OS1.5] (3) [F11-OS1.5] (4) F11-OS1.5] [F13-OS1.4,OS1.5] (5) [F11-OS1.5] (6) [F12-OS3.7] (7) [F11-OS1.5] (8) [F11-OS1.5] (9) [F11-OS1.5] (10) OTHER SUPPORTING MATERIALS Building and Development Branch Page 6