GUIDELINE FOR THE APPLICATION OF SRPS CEN/TS WHEN GRANTING ACCREDITATION TO TESTING LABORATORIES

Transcription

1 GUIDELINE FOR THE APPLICATION OF SRPS CEN/TS WHEN GRANTING ACCREDITATION TO TESTING LABORATORIES Any differences between the Serbian and English versions of this document are not intended, but if in doubt, the Serbian version should be consulted. Reviewed by: Natalija Jovičić Zarić MSc, Quality Manager (QM) Approved by: Jasna Stojanović, Acting Director Issue/Revision: 1/1 Date: Page: 1/5

2 Table of Contents: Page: 1. Scope 3 2. Reference Documents, Definitions and Acronyms 3 3. Application of SRPS CEN/TS General Background Application of SRPS CEN/TS Time line for the application of SRPS CEN/TS Document Distribution 4 5. Annexes 4 6. Forms 7. Document Amendment History 4 5 Issue/Revision: 1/1 Date: Page: 2/5

3 1. SCOPE This document aims to provide information on the policy of the Accreditation Body of Serbia (ATS) as regards the application of SRPS CEN/TS when granting accreditation to laboratories performing periodic measurements of stationary source emissions. The laboratories that have already been accredited or those seeking accreditation as per SRPS ISO/IEC will be additionally assessed in accordance with the requirements of SRPS CEN/TS REFERENCE DOCUMENTS, DEFINITIONS AND ACCRONYMS - SRPS ISO/IEC 17025: 2006, General requirements for the competence of testing and calibration laboratories - SRPS CEN/TS 15675:2009, Air quality Measurement of stationary source emissions Application of EN ISO/IEC 17025:2005 to periodic measurements 3. APPLICATION OF SRPS CEN/TS General Background The technical specification entitled SRPS CEN/TS is a supplement to SRPS ISO/IEC and it contains the explanations and requirements for laboratories performing periodic measurement of stationary source emissions. The technical specification cannot be applied individually as it will only be referenced in the scope of accreditation. The following documents shall be used when applying SRPS CEN/TS 15675: - SRPS EN 15259:2010: Air quality - Measurement of stationary source emissions - Requirements for measurement sections and sites and for the measurement objective, plan and report - SRPS CEN/TS 14793:2010: Stationary source emissions Intralaboratory validation procedure for an alternative method compared to a reference method All annexes to SRPS CEN/TS and SRPS EN are mandatory, not informative. 3.2 Application of SRPS CEN/TS Having in mind the existing policy for the accreditation of these laboratories and the aim to avoid certain problems when applying this technical specification, laboratories have to bear in mind the following key issues: SRPS CEN/TS 15675: Operational procedures and Measurement Plan shall be documented in accordance with the requirements laid down in SRPS EN SRPS CEN/TS 15675: Laboratories shall regularly update the knowledge of the existing air protection laws and regulations particularly pertaining to the emission of air pollutants, and knowledge of emission source processes SRPS CEN/TS 15675: Uncertainty of measurement shall be calculated. Expanded uncertainty of measurement shall be estimated at emission limit value level (where limit values exist). Issue/Revision: 1/1 Date: Page: 3/5

4 5.7.2 SRPS CEN/TS 15675: Requirements defined herein are clearly described in Annex F. Laboratories shall provide documented evidence confirming the fulfilment of the said requirements SRPS CEN/TS 15675: Content/elements of the assessment report shall be clearly described in Annex F to SRPS EN All the details described in the said Annex shall be given in the Assessment Report. Annex B to SRPS CEN/TS 15675: All objective evidence proving the application of these requirements shall be kept in staff files/hr files. When an accredited laboratory contracts sampling out to another accredited laboratory, the Test Report shall contain the description of how the results are obtained and data on estimated uncertainty of measurement. The Sampling Report shall be annexed to the Test Report that was issued, while the test result shall be expressed in the units of the measuring range Time line for the application of SRPS CEN/TS Assessment of laboratories as per SRPS CEN/TS shall be performed on the occasion of the extension to the scope of accreditation of all accredited testing laboratories. When submitting an application for accreditation/extending the scope of accreditation/renewing accreditation, laboratories shall also specify that they wish to be assessed as per SRPS CEN/TS Laboratories shall submit to ATS all the necessary documentation within the time frame defined in the ATS procedures. Witnessing of the work of person(s) performing testing/measurements in the field shall be a mandatory element of these assessments. After the assessment, and following the decision on accreditation, a new scope of accreditation shall be issued to clearly specify the reference to SRPS CEN/TS DOCUMENT DISTRIBUTION This document shall be used by ATS assessors and testing laboratories when preparing documentation needed for the submission of applications for accreditation/extension to the scope of accreditation. This document shall be made available to the ATS assessors that are permanent ATS employees and shall be kept on Juatsrv server (the folder entitled QMS_ATS ). This document shall be made available to other ATS assessors and testing laboratories via the ATS website at 5. ANNEXES None. 6. FORMS None. Issue/Revision: 1/1 Date: Page: 4/5

5 7. DOCUMENT AMENDMENT HISTORY Issue/ revision Issue/ revision date 1/ / Issue/Revision: 1/1 Date: Page: 5/5