Technical Application Guide for UP-SHINE LED Panel Light UP-PL-45W-S
Introduction Up-shine led panel adopts high lumen SMD LED with CRI >8. Top branded driver comes with triac dim, -1V dim and DALI dim, it has perfect dimming range and shares great compatibility with worldwide famous brand dimmers. The ultra slim profile fits seamlessly into any work place. It is available in various installation ways: embedded into ceiling, suspended with hanging wires, surface mounted in a concrete ceiling by using surface mounting frame. Up to 8% energy saving compared to standard CFL Long lifetime of 4, hours Triac dim, -1V dim, DALI dim wide beam angle CCT: K 4K 5K 57K No UV/IR light Environment friendly, without Mercury or any other hazardous substances Application notes IP4 for indoor use only Professional electrician for installation only Switch off before installation Do not touch when in use Keep away from hot steam and corrosive gas Application Areas Office & school lighting: office room, meeting room, class room etc. Commercial lighting: shopping mall, super market, retailer shops etc. Other situations: hospital, laboratory, dust-free workshop etc. Certificates
Product Information 1 8. 25 Technical Specifications Model Voltage Power Power Factor Lumen (±5%) Beam angle CCT Lifespan CRI Dimmable Dimension UP-PL-45W-S AC2V 45W. o K 4h 8 No 1*25*8mm UP-PL-45W-S AC2V 45W. 24 o 4K 4h 8 No 1*25*8mm UP-PL-45W-S AC2V 45W. 2 o 5K 4h 8 No 1*25*8mm UP-PL-45W-S AC2V 45W. o 57K 4h 8 No 1*25*8mm UP-PL-45WD-S AC2V 45W. 25 o K 4h 8 Yes 1*25*8mm UP-PL-45WD-S AC2V 45W. o 4K 4h 8 Yes 1*25*8mm UP-PL-45WD-S AC2V 45W. 2 o 5K 4h 8 Yes 1*25*8mm UP-PL-45WD-S AC2V 45W. 24 o 57K 4h 8 Yes 1*25*8mm Driver data Sheet Driver data DIM Non-dim Input rated Voltage AC2V AC2V Frequency 5Hz 5Hz Input Voltage AC2-24V AC2-24V Efficiency 8% 8% Total load Wattage 45W±5% 45W±5% Power Factor.. Rated input current.22a.22a Full load output Voltage DC5-8V DC5-8V Rated output current 1mA ma Output current range 1mA±5% ma±5% Power tolerance ±5% ±5% Current output tolerance ±5% ±5% Dimming range 8%-1% Dimmer Triac dimmers Short circuit protection PASS PASS Over voltage protection PASS PASS Over temperature protection PASS PASS Withstand voltage AC75V AC75V Fixture Compatibility Rated Wattage Electrical Classification Ingress Protection Operating Temp Operating Humidity Storage Temp 45W Ⅱ IP4-2 o C~45 o C ~% -2 o C~5 o C
Spectral Distribution K 4K.8 Max=58 [1.=2].5SDCM FK.8 Max=7171 [1.=2] 2.SDCM F4K.7.7...5.4. x=.444 y=.44.5.4. x=.841 y=.81.2.2.1.1. 8 5 7 8. 8 5 7 8 5K 57K.8 Max=71 [1.=2].87SDCM F5K.8 Max=7428 [1.=2] 5.57SDCM F57K.7.7...5.4. x=.47 y=.78.5.4. x=.45 y=.75.2.2.1.1. 8 5 7 8. 8 5 7 8 Photometric Diagram K 4K - - -/+18 MH=1m C/18 C/27 Flux out: 21 lm.281ft 27.7,.42fc 1m 2.1, 17lx.52ft.48, 24.8fc 2m 74.78, 2lx 1.1ft 1.cm 2.8ft 21.2cm - - -/+18 MH=1m C/18 C/27 Flux out: 2425 lm.281ft 2.11, 14.2fc 1m 1., 11lx.52ft 7.27 2.4fc 2m 78.2, 28.lx 1.21ft 11.11cm 2.41ft 22.22cm.84ft.88, 1fc m.24, 118.lx.57ft 1.8cm.84ft.24, 17fc m 4.81, 4.lx.2ft.2cm 1.ft 1.77,.214fc 4m 18.7,.8lx 4.77ft 42.52cm 1.ft 1.81,.51fc 4m 1.58, 7.8lx 4.8ft 44.4cm - AVERAGE BEAM ANGLE(5%): 114. DEG -25-2 - -1-5 5 1 2 25 1.4ft 1.1,.77fc 5.ft 5m 11.7, 42.81lx 5.cm Height Eavg, Emax Angle: 114.45deg Diameter - AVERAGE BEAM ANGLE(5%): 114. DEG -25-2 - -1-5 5 1 2 25 1.4ft 1.14, 4.17fc 51.ft 5m.5, 44.85lx 55.54cm Height Eavg, Emax Angle: 11deg Diameter 5K 57K - - -/+18 MH=1m C/18 C/27 Flux out: 24 lm.281ft 28.8, 1.2fc 1m.2, 11lx.52ft 7.255,25.fc 2m 78.2, 27.2lx 1.21ft 11.17cm 2.42ft 22.cm - - -/+18 MH=1m C/18 C/27 Flux out: 242 lm.281ft 2.4, 1.8fc 1m., 1118lx.52ft 7.21 25.fc 2m 78., 27.4lx 1.21ft 11.17cm 2.42ft 22.cm.84ft.225, 1fc m 4.,.lx.ft.5cm.84ft.227, 14fc m 4.7, 4.2lx.ft.5cm 1.ft 1.8,.4fc 4m 1.54,.8lx 4.84ft 44.7cm 1.ft 1.8,.4fc 4m 1.54,.8lx 4.84ft 44.7cm - AVERAGE BEAM ANGLE(5%): 114. DEG -25-2 - -1-5 5 1 2 25 1.4ft 1.12, 4.144fc 51.4ft 5m.4, 44.1lx 55.84cm Height Eavg, Emax Angle: 11deg Diameter - AVERAGE BEAM ANGLE(5%): 114.7 DEG -25-2 - -1-5 5 1 2 25 1.4ft 1.12, 4.4fc 51.4ft 5m.5, 44.71lx 55.84cm Height Eavg, Emax Angle: 114deg Diameter
Polar Diagram Comparison - O +/-18 O O - O O - O O - O O - O O O AVERAGE BEAM ANGLE (5%): 114.2DEG C/18, 11 deg C/21, 114. deg C/24, 114.1 deg C/27, 114.4 deg Driver lifetime & LED light decay rate Driver Lifetime LED Light Decay Rate 11%.4 Lifetime (hours) 8 7 5 4 2 1 5 o C 75 o C 85 o C 5 o C o C Capacitor Tc ( o C) % Luminous Flux % 1% 5% % 85%.5..25.2. 8% 75% FLUX.1.5 U'V' 7%. 1 2 4 5 7 8 1 LifeTime (hours) Temperature The testing is operated at 25 C The lifetime of capacitor, minimum of 5, hours if operated at C, will be doubled whenever the temperature drops 1 C The highest withstand temperature of IC, MOS could be C The highest withstand temperature of LED junction temperature is C 8 Temperature ( o C) 7 5 4 2 1 14:2:22 :2:1 1:11:1 17:2:1 17:5:1 18:44:1 1:5:1 2:2:1 21:17:1 22:8:1 22:5:1 2:5:1 :41:1 1:2:1 2:2:1 :14:1 4:5:1 4:5:1 5:47:1 :8:1 7:2:1 8:2:1 Time The driver lifespan is based on capacitor working temperature. IC Capacitor MOS PCB Fitting Voltage transformer Environmental temperature
Installation 1.Recessed into ceiling 1. Remove ceiling plaster slab 2. Connect power supply. Fix the panel light into right place 4. Stabilize the panel 2. Suspending 1. A.Fix the anchor into target place on the ceiling B.Fix the installation mount on the ceiling with plastic anchor 2. Hang the panel to ceiling with suspended installation kits. Adjust the length of steel wire. Connect the power supply. Surface mounted 1. Fix the bracket of panel light on the ceiling 2. Install hanging fixtures on the panel light. Install the LED Panel light on the bracket 4. Connect the power cord and then it can be used 4. Surface mounted 1. Fix the frame on the ceiling with screw 2. Pull down the side frame. Push the panel into the frame, connect the driver 4. Install the side frame 5. Turn on the power switch, finish the installation Packaging Information SIZE(CM) N.W/pc (KGS) G.W.(KGS) Q'TY(PCS) Carton 1**.5 4.2 2 5 CTNS Q'TY(PCS) VOLUME(CBM) 2'' standard container 4'' standard container 75 28 5 Phone: +8 755 21 78 Add: 2nd building Dingfeng High-Tech Zone, Fuyuan 1st road, Fu Yong Sub-district, Bao'an, Shenzhen China