Mechanism of audible sound generation during flash lamp operation. Tetsuya Kitagawa, Mitsuru Ikeuchi, Yukihiro Morimoto, Fumihiko Oda

Similar documents
UV-Ozone Technology and Applications

Benefit from our experience and competence Application-focused solutions from UV to IR

Heat Management Methodology

SPECTRAL INSTRUMENTATION

Chemistry Instrumental Analysis Lecture 4. Chem 4631

Non Ionizing Radiation Audit checklist

Curing with Electric Infrared

Equipment specifications (D6)

About us COAT C EMA M C o C ating Ma M c a hine h r ine y r GmbH b H ww w w w. w coa o t a em e a.

Developing UV LED Curing Processes for Converting Applications

CATALYTIC EMITTER - An old idea in new clothes

EMITTER TECHNICAL DATA

Laser Safety and Classification Full Version (CA-1110) Advanced Version (CA-1111) Basic Version (CA-1112)

Gas Temperature Measurements with High Temporal Resolution

Chemistry Instrumental Analysis Lecture 14. Chem 4631

LM-80V , h V LM-30V h V

VS Glow Is the Newest and Most Technically Advanced Infrared Heater that Generates Instantaneous Heat

Low-Frequency Raman Spectroscopy Enabling Affordable Access to the Terahertz Regime

UV measurements for medical applications using SiC photodiodes

The FEL Facility Optical Diagnostics and FEL Characterization

University of California Santa Barbara Department of Chemistry and Biochemistry Optical Characterization Facility. Safe operations manual

'7 Infrared Drying and Curing Systems w4

HiRadMat facility at the CERN SPS

Operations Manual GMA 313 CO 2. Gas Monitor for one detection point

An FT-NIR Primer. NR800-A-006

Development and demonstration of a diode laser sensor for a scramjet combustor

Development of a new X-ray source system using ultraviolet laser for medical treatment

Ref No: Date: September 30, 1994 ELECTRICAL AND ELECTRONIC EQUIPMENT NO. 2

UV LED Measurement Status Update

Why is Laser Safety Important Laser usage is growing rapidly e.g. laser points, CD/DVD, industrial applications Heavy use now in laboratories for

ENHANCED VISION - INFRARED 1

Dated 15-Dec-2000; J. Schilz, subject to change

North Dakota State University Laser Safety

GC DETECTORS Reduction Gas Detector - RGD. Overview

NYC STEM Summer Institute: Climate To Go! Infrared detection of carbon dioxide

LUXEON S. Philips Lumileds does not recommend staring directly into any LED lamp or luminaire. LUXEON S Photobiological Safety Report

Fundamentals of Far-infrared

Stony Brook University Hospital Environmental Health & Safety Policy & Procedure Manual. EH&S 6-8 Original : 1/00 Revision Date: 3/16/15 Pages 6

Development of a variable output LED-365 irradiance standard

Jonathan Sexton Marketing Manager Energy Curing Products Sun Chemical

Why is Laser Safety Important Laser usage is growing rapidly Industrial applications Heavy use now in laboratories for research, analysis Many

Efficient curing processes with innovative UV-LED technology The Heraeus Noblelight UV-LED portfolio

Pyroelectric Infrared Sensor PIR

INFRARED HEATERS APPLICATIONS INFRARED HEATING

16S-Series 150W. In Vivo SPF Sunscreen Testing Solar Simulator

Highly Near-Infrared-Sensitive, Printed Flexible Thermistors. Austin Shearin ext Brewer Science Inc.

Title: Laser Safety Effective Date: 9/91 Revision: 2/97 Number of Pages: 7

Exhaust Air Plenum Heated Supply Air. Direct Impingement Convection Dryer. Heated Drum. Typical Conduction Heating System.

Exercise 1: IR Transmission and Reception

E11 Tests of trace gas concentration multicomponent. monitoring system

NOTE: The color of the actual product may differ from the color pictured in this catalog due to printing limitation.

Laser Damage Measurements

The Growing Viability of UV LED for Wide Web Coating Applications. Tuesday, October 11, 2016

Figure 1-1 Furnace Front Elevation

SAMPLE SPECIFICATIONS CONTINUOUS MONITORING SYSTEM (Insitu)

Heat Transfer: Conduction. Heat Transfer: Conduction

Arc-discharge cleaning of tokamak wall

Fourth Edition HEAT TRANSFER AND CHANGE OF PHASE

DURIP: Fast Oscilloscope and Detectors for Air Laser Research

Instrumental technique (MCP detectors) - Kamalesh ( )

Publication American Institute of Physics. Reprinted with permission.

SIEMENS ULTRAMAT 6 IR CARBON MONOXIDE ANALYZER METHOD VALIDATION FOR TESTING CARBON MONOXIDE IN NITROGEN, NF

YES-3DR HMDS OVEN USERS GUIDE

Used as indicators of indicating the Degree, Functions, Positions etc, in electronic instruments

Bernd Eichler Sales Manager

Current Research Topics in Optical Sensors and Laser Diagnostics

Fire Detection System: An Overview

USER MANUAL MODEL UV MINDER 3D V2.0. Part Number: Revision Level: A

Laser Safety Training Guide

Soft Ionisation Techniques, Terry Whitmore, Hiden Analytical

mach 5 100kHz Digital Joulemeter: M5-SJ, M5-IJ and M5-PJ Joulemeter Probes

Radiation and Laser Safety

Chemical Processes in the Combustion

Recent Advances in Solid State Lasers and Nonlinear Optics for Remote Sensing

-Technology an Enabler for Instantaneous Post Printing Processes

SHENZHEN LAMPLIC TECH CO., LTD UV LED SPOT CURING SYSTEM TECHNICAL MANUAL

PROCESS ECONOMICS PROGRAM

Copyright 2017 by Lasermate Group, Inc.. All rights reserved.

2 Ensure that all personnel in the area are wearing the appropriate protective eyewear.

ACTIVITIES OF THE MEASURING GROUP

DUQUESNE UNIVERSITY. Laser Safety Program

Variable Temperature Microprobe Systems

ENVIRON INTERNATIONAL CORPORATION THE USE OF A GAS-IMAGING DEVICE FOR DETECTING FUGITIVE EMISSIONS IN ETHYLENE FACILITIES

PHYSICS FORM 5 TRANSFER OF THERMAL ENERGY

ML562G84 APPLICATION. Display system. Symbol Parameter Conditions Ratings Unit. Pulse (Duty 40%)

Emission Monitoring System

FOCUS ON LASERS. Philip Campbell RADIATION SAFETY: Principles, Practice, and Emerging Issues March 2018

From THz to X-ray - Inventing the Future. Progress in NIR spectroscopy and its industrial applications

THEORY OR OPERATION 2 SENSOR UNIT - MECHANICAL 6 SENSOR UNIT - ELECTRICAL 8 CONTROL UNIT - MECHANICAL 9 CONTROL UNIT - ELECTRICAL 9 OPTIONS 11

to get there. together. Infrared Sources Swiss made

April, Solid State LED Based Lighting: High Power UV Light Sources for Industrial Applications

INFRARED RADIANT GAS SYSTEMS FOR THERMAL TREATMENTS

Radiant Process Heaters

o Clear instruction for operation o Measurement and control of o Stationary sensor for o Programming capabilities of o Countdown timer selectable

INTERNATIONAL JOURNAL OF RESEARCH GRANTHAALAYAH A knowledge Repository

Temperature dependent Components within the Pyroelectric Detector

OMA-300 Process Analyzer

UV Irreversible Indicators Product Code: UVI-001

UVC Detection as a Potential for Alpha Particle Induced Air Fluorescence Localisation

Laser Cutting Machine Safety Guide (For employers and employees)

Transcription:

Mechanism of audible sound generation during flash lamp operation Ushio Inc. R&D center Tetsuya Kitagawa, Mitsuru Ikeuchi, Yukihiro Morimoto, Fumihiko Oda

Features Pulsed light source High peak power Good color rendering properties 1. High peak power 2. Very short period irradiation (Radiates from the UV to the IR light! ) Solid-state laser pumping Xe flash lamps Relative intensity / a.u. For industrial applications 1.0 0.8 0.6 0.4 0.2 0 200 400 600 800 Wavelength / nm 1000

Xe flash lamps Features Pulsed light source High peak power Good color rendering properties For industrial applications 1. High peak power 2. Very short period irradiation (Radiates from the UV to the IR light! ) Solid-state laser pumping Strobes (Camera) Cure of adhesive agent (DVD) Toner fixing (Copy machine) Thermal treatment of MOSFET

Activation process of an implanted Si wafer p+ Poly-Si Gate Gate Oxide Source p+ p+ Drain p+ p+ n well P - Si Extension (Xj 14nm) Schematic cross sectional view of P- MOS FLA machine for 12 inch wafer (Courtesy of Dainippon Screen MFG.,Co.,Ltd)

Purpose Xe flash lamp USJ formation FLA flash lamp annealing Pulse width 1 ms Energy density on a wafer surface 25 J/cm 2 When flash lamp is operated, significant audible sound is generated the sound generation mechanism has NOT been clarified Purpose To clarify the mechanism of the sound generation

Models of the sound generation Mechanical vibration of the flash lamp tube An object will vibrate and become a sound source, if it is rubbed or struck. 2. Due to the light radiated from the lamp Test experiment Selection of tube materials VUV lamp O 3 free lamp UFQ-75002 Ushio Inc. Two types of the lamps, The intensities of the sound differ.

Experimental set up Precision sound level meter Microphone Outer tube synthetic silica glass Flash lamp Osilloscope 35 cm Role of outer tube : divide the model 1 and 2 The sound by vibration of the tube reduced The sound due to the light not reduced

6 Sound pressure waveform of O 3 free lamp Distance from microphone (cm) 0 10 20 30 40 50 60 70 80 Sound pressure (Pa) 4 2 0-2 Microphone -4 1.6ms (audible frequency component 600Hz) Outer tube & flash lamp -6 0 0.5 1 1.5 2 2.5 Time (ms) The audible frequency component, originated from light The high frequency component vibration of the tube

Frequency analysis of the O 3 free lamp waveform without outer tube 0.1 0.08 27kHz Amplitude (a.u) 0.06 0.04 The audible sound area: 20Hz 20kHz 0.02 0 0 20 40 60 Frequency (khz) Mechanical vibration of tube The sound of 27 khz cannot be heard.

6 Sound pressure waveform of O 3 free lamp Distance from microphone (cm) 0 10 20 30 40 50 60 70 80 Sound pressure (Pa) 4 2 0-2 Microphone -4 1.6ms (audible frequency component 600Hz) Outer tube & flash lamp -6 27kHz non-audible frequency component 0 0.5 1 1.5 2 2.5 Time (ms) The audible sound accompanied by flash lamp operation is from light, not from vibration.

2 Emission spectra of operated lamps in VUV-UV regions Oxygen 1000 Flash light output (arb. units) 1.5 1 0.5 Carbon dioxide Water vapor VUV lamp 100 10 1 Absorption coefficient (cm-1/bar) O 3 free lamp 0 0.1 140 160 180 200 220 240 260 Wavelength (nm) Ref) K. Watanabe, M. Zelikoff, E. C. Y. Inn, Air Force Cambridge Research Center Technical Report 53 (23), (1953) Hypothesis : Oxygen and water vapor may be the cause of the sound generation

Experimental set up To precision sound level meter Microphone Controlled Oxygen Water vapor Air Flash lamp Nitrogen Molecular seives or water Purge box Oxygen concetration Controlled by adjusting air and nitrogen flow Water vapor pressure Controlled by molecular sieves or water

The dependence of maximum sound pressure on the oxygen concentration Oxygen concentration (vol %) 20.5 0.06 VUV lamp 100 13 O 3 free lamp 0.62 0.62 The water vapor pressure was kept at 500Pa VUV lamp noticeably reduced at low oxygen concentration O 3 free lamp NOT depended on the oxygen concentration

The dependence of maximum sound pressure on the water vapor pressure Water vapor pressure (Pa) 2400 500 VUV lamp 100 13 O 3 free lamp 0.88 0.62 The oxygen concentration was kept at 0.06 vol VUV lamp: noticeably reduced O 3 free lamp at low water vapor pressure tended to be reduced

The absorption coefficient of atmospheric main constituents and the spectral distribution of the lamps 2 Oxygen 1000 Flash light output (arb. units) 1.5 1 0.5 Carbon dioxide Water vapor VUV lamp 100 10 1 Absorption coefficient (cm-1/bar) 0 140 160 180 200 220 240 260 Wavelength (nm) O 3 free lamp VUV lamp be influenced by oxygen and water vapor O 3 free lamp be influenced only by water vapor 0.1

Summary We studied the mechanism of the audible sound generation accompanied by flash lamp operation. As result, we clarified as follows; - The audible sound originated from the light which was radiated from the lamp. - Oxygen and water vapor absorb VUV light, water vapor absorbs IR light and heating occurs. Consequently air rapidly expands and the audible sound is generated.