Models GDNM16A5BK4AA GDNM20A5BK4AA GDNM24A5BK4AA DEHUMIDIFIER OPERATING INSTRUCTIONS
BEFORE FIRST USE Read and follow all instruction even if you feel you are familiar with product, and find a place to keep it handy for future reference. For your convenience record complete model number (located on product identification plate ) and date you received product, toger with your purchase receipt and attach to warranty and service information. NOTE: The rating of th product ( as marked on product identification plate ) based on specific loading tests. Normal use may draw significantly less power. Installation Instructions IMPORTANT INSTRUCTIONS Do not install and use your dehumidifier before completely reading se instruction. Th will help you optimize operation of your dehumidifier. The following advice and instructions should be followed closely: 1. Your unit must always be used in anupright position because it contains a cooling agent. 2. After unpacking Your unit, place unit upright to allow cooling agent to stabilize, and wait 2 hours before use. Failure to comply with se instructions may damage unit and will invalidate warranty. 3.Th product must not be dposed toger with domestic waste. Th product has to be dposed at an authorized place for recycling of electrical and electronic appliances. 4.The appliance shall not be installed in laundry. 5. appliance shall be installed in accordance with national wiring regulations and must be positioned so that plug accessible. 6.If supply cord damaged, it must be replaced by manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. 1
IMPORTANT SAFEGUARDS When using any electrically powered, basic safety precaution should always be followed, including following: PLEASE READ ALL INSTRUCTION CAREFULLY BEFORE USING THE PRODUCT WARNINNG-to reduce rk of fire, electrical shock or injury to persons or property : 1. Always operate product from a power source of same voltage,frequency and rating as indicated on product identification plate. 2. Close supervion necessary when any product used by or near children or invalids.do allow children to use it as a toy. 3. Do not operate any product with a damaged cord or plug, or after product malfunctions, or dropped or appears damaged in any way. Return complete product to place of purchase for inspection, repair or replacement. 4. Never connect unit to a defective socket. 5. To avoid tripping circuit, DO NOT USE AN EXTENSION CORD FOR THIS UNIT. 6. Make sure that unit correctly connected before turning on unit's power. Never lay down unit while it working. 7. Always keep it in an upright position to avoid any damage to unit. 8. Switch off and unplug from outlet when not in use or before cleaning. 9. To turn on your unit, always use switch on control panel. 10. Never unplug dehumidifier while it working, Th could damage electronic circuits. 11. Never place anything on top of unit and do not cover it with any kind of cloth while it plugged in or in-use. 12. Do not place objects on product or allow objects to obstruct inlet or outlet openings, or operate in close proximity to walls or curtains, etc. 13. The use of attachments or accessories not recommended or sold by product dtributor may cause personal or property hazards or injuries. 14. Keep area around warm air outlet sufficiently clean and make sure that it not congested. 15. Allow at least 500mm(20inches) of air space on all sides of unit for good air ventilation. 16. Do not place power cord under a carpet. 17. Never install unit in direct sunshine. 18. Prevent children from climbing on unit. 19. Th product intended for normal domestic/household use only. 20. Repairs should only be carried out by competent service department. 21. The operating temperature range 5 ~35. 22. Th appliance not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,or lack of experience and knowledge, unless y have been given supervion or instruction concerning use of appliance by a person responsible for ir safety. Children should be superved to ensure that y do not play with appliance. PLEASE READ AND SAVE THESE INSTRUCTIONS 2
PRODUCT DESCRIPTION Control pannel Filter Air outlet Air inlet Knob Side board Tank Power supply cord Castor CONTROL PANEL Water full indication Off Running DEFROST FULL Con Defrost indicator Humidity control knob OFF Continuous Switch off. Dehumidifier continuously running. 3
OPERATING INSTRUCTIONS Start Operation 1. Ensure that unit connected to power socket. 2. Make sure water tank correctly positioned.(if bucket full lamp illuminates when unit first switched on, remove tank and replace it.) 3. Turn humidity control knob to desired setting (NORMAL)or CONTINUOUS to work 4. The unit will shut down when turned to OFF position. Full Bucket Lamp If ambient temperature too low unit will automa- tically start to defrost and light will illuminate. The defrost lamp will also illuminate if air filter becomes clogged. Th unit has 3-min lag due to device for protecting circuit.in order to prolong compressor's working life, compressor will not start until unit has run for 3 minutes. Do not use extension cord or same socket with or electric appliance. The lamp will illuminate when water container full. To empty unit, first unplug from power source n carefully remove tank and empty collected water. Replace bucket carefully before switching unit on again. Remove water in water tank with two hands Defrost Lamp 4
CONTINUOUS DRAINAGE Operation Draining water Continuous drainage of water The unit has a continuous drainage port. Using a commercial hose (with an inner diameter of 14mm), water in drainage tank can be continuously drained out of continuous port of unit. When setting up equipment for continuous drainage, always stop operation first and unplug power supply plug. 1. Dconnect drainage tank and open continuous drainage port. Use nippers or a similar tool to cut away continuous drainage port in side of main unit. 2. Push hose into continuous drainage port. Pass a commercial hose (with an inner diameter of 14mm) through continuous drainage port, and press it firmly into drainage port in main unit, make surewater does not leak.the level height of drain piping should always be not higher than one of drainage port, also drain piping should always be not plugged up,so condensed water can be drained out successfully. Correct Use When Drainage Hose Is Connected When using continuous drainage, PVC hose must be placed below drainage hole. Avoid uneven surfaces and do not 'kink' hose. 5
MAINTENANCE Before cleaning unit, turn it off and unplug it from outlet. EXTERIOR SURFACES OF THE UNIT Clean dehumidifier by using a damp sponge, and dry it with a clean, soft cloth. Never use alcohol or any product containing solvents. Do not immerse unit in water. AIR FILTERS The air filters located inside unit collect dust contained in air. To keep dust from clogging unit, your unit must always be used with its air filters. The build up of dust reduces efficiency of dehumidifier. Therefore, air filters must be cleaned every two weeks, and more often if machine operates in a dusty atmosphere. If filters are obstructed, dehumidifier will be less efficient. To remove filter, as arrow shown. upward and forward until it free of body of unit. Air filter Clean filters with a vacuum cleaner. If filters are very dirty, you can wash m in warm water(never use hot or soapy water). Make sure that air filters are completely dry before putting n back on unit. Do not bend filters. 6
LONG TERM STORAGE At end of season. or when you do not plan to use unit for an extended period of time, we recommend that you take following steps. Remove water from water bucket. If continuous drainage hose connected, dconnect it. Dconnect unit and wrap power cord and plug. Clean unit and store it, protecting it from dust. Store unit in an upright position. Keep it in a cool, dry place and away from sunshine. SPECIFICATIONS Model GDNM16A5BK4AA GDNM20A5BK4AA GDNM24A5BK4AA Rated Voltage 220-240V~ Rated Frequency 50HZ Rated Power 400W 450W 500W Moture Removal 16L/D at 30 Rh80 20 L/D at 30 Rh80 24 L/D at 30 Rh80 Operating Temperature 5-35 Weight 13.5Kg 13.5Kg 14.5Kg Tank capacity 6.5L(Automatic stop at about 5.5L) 7
MAINTENANCE Removing breakdowns If a condition lted below occurs,please check following items to help you to save your time and cost. Condition Cause What to do Has power supply cord been Plug power supply cord into d connected? outlet. The unit does not operate Is " "lamp blinking?(the tank full or in a wrong position. Is temperature of room above38 Cæor below2 C. Dcard water in drainage tank,and n reposition tank. The protection device actuated and unit can not be started in case operation under bad environment(in that case,please do not use dehumidifier). The dehumidifying f unction does not work. Is air filter clogged? Is air intake port or dcharge port obstructed? Clean air filter as instructed under "Caring for dehumidifier". Remove whatever obstructing dcharge port or intake port. No air dcharged Is air filter clogged? Clean air filter instructed under "Caring for dehumidifier". Operation noy Has unit been poorly installed so it tilted or unsteady? Is air filter clogged? Use unit in a stable,sturdy location. Prompt: Put a cushion under unit and help to reduce operation noe. Clean air filter as instructed under "Caring for dehumidifier". After above condition has occurred and corresponding step used but breakdown can not be removed or or breakdown occurs,please contact authorized service centers. 8
9 MAINTENANCE Removing breakdowns symptom increases suddenly noe operation The steam? emits Which stove, kerosene a as such room in device a re frequently?is closed and opened activated. abruptly, res exchanger head of temperature Because of humidity /or and temperature if happens Th unit? for big room too s I doors or windows Are compressor when increases noe operation The Reason dcharged used, first unit When place, takes dehumidifying little Very drop not do humidity The use. during place. takes none or musty. smells air low. room The following symptoms do not indicate a breakdown. echoes unit The at conducted test dehumidifying from left water Th tank. drainage in left stains some are There operation or started operation When circulation until sound some take may refrigerant The small a in or flooring wood room with a in used unit If unit. main in heard noe unusual an changed, mode echo. may it room, stabilizes. problem. a indicate not does it factory, compressor and running fan The stops, unit after minutes 3 within started unit If. work not does stops. compressor and activated operation defrosting automatic or minutes; 3 of delay a after automatically started compressor that so actuated, device protection
Installation and Maintenance of Healthy Filter Installation Instruction: 1. From front of machine, hold side frame of filter and pull it upwards to remove filter. (See Fig. aon right) Air filter (a) 2. Press two clamps on upper of filter frame at same time. Pull it upwards to remove filter frame. (See Fig. bon right) Clamps (b) 3. Place healthy filter flatly on filter. (See Fig. con right) (c) 4. Mount filter frame. Firstly mount two lower clampsand n press and mount upper clamps properly. (See Fig. don right) 5. Mount filter back to machine. (d) Cleaning and Maintenance : Take out healthy filter before cleaning and reinstall it after cleaning according to installation instruction. Pay special attention to that silver ion filter can't be cleaned with water, while active carbon, photocatalyst, low temperature conversion (LTC) catalyst, formaldehyde eliminator, catechin or mite killing filter can, but can't with brush or hard things.dry it in shade or sun after cleaning, but not by wiping. Service Life : The healthy filter commonly has its usage lifetime for one year under normal condition. As for silver ion filter, it invalid when its surface becomes black (green). 10
Mobile air conditioner GREE ELECTRIC APPLIANCES, INC. OF ZHUHAI Add: No.6 Jinji West Rd, Qianshan, Zhuhai, Guangdong, China P.O. Box: 519070 Tel: (86-756) 8617555 (Customer Service Center) Website: http://www.gree.com