Dansk standard DS/EN ISO 1736 2. udgave 2008-11-10 Tørmælk og tørmælksprodukter Bestemmelse af fedtindhold Gravimetrisk metode (Referencemetode) Dried milk and dried milk products Determination of fat content Gravimetric method (Reference method)
DS/EN ISO 1736 København DS projekt: M231536 ICS: 67.100.10 Første del af denne publikations betegnelse er: DS/EN ISO, hvilket betyder, at det er en international standard, der har status både som europæisk og dansk standard. Denne publikations overensstemmelse er: IDT med: ISO 1736:2008. IDT med: EN ISO 1736:2008. DS-publikationen er på engelsk. Denne publikation erstatter: DS/EN ISO 1736:2000. DS-publikationstyper Dansk Standard udgiver forskellige publikationstyper. Typen på denne publikation fremgår af forsiden. Der kan være tale om: Dansk standard standard, der er udarbejdet på nationalt niveau, eller som er baseret på et andet lands nationale standard, eller standard, der er udarbejdet på internationalt og/eller europæisk niveau, og som har fået status som dansk standard DS-information publikation, der er udarbejdet på nationalt niveau, og som ikke har opnået status som standard, eller publikation, der er udarbejdet på internationalt og/eller europæisk niveau, og som ikke har fået status som standard, fx en teknisk rapport, eller europæisk præstandard DS-håndbog samling af standarder, eventuelt suppleret med informativt materiale DS-hæfte publikation med informativt materiale Til disse publikationstyper kan endvidere udgives tillæg og rettelsesblade DS-publikationsform Publikationstyperne udgives i forskellig form som henholdsvis fuldtekstpublikation (publikationen er trykt i sin helhed) godkendelsesblad (publikationen leveres i kopi med et trykt DS-omslag) elektronisk (publikationen leveres på et elektronisk medie) DS-betegnelse Alle DS-publikationers betegnelse begynder med DS efterfulgt af et eller flere præfikser og et nr., fx DS 383, DS/EN 5414 osv. Hvis der efter nr. er angivet et A eller Cor, betyder det, enten at det er et tillæg eller et rettelsesblad til hovedstandarden, eller at det er indført i hovedstandarden. DS-betegnelse angives på forsiden. Overensstemmelse med anden publikation: Overensstemmelse kan enten være IDT, EQV, NEQ eller MOD IDT: Når publikationen er identisk med en given publikation. EQV: Når publikationen teknisk er i overensstemmelse med en given publikation, men præsentationen er ændret. NEQ: Når publikationen teknisk eller præsentationsmæssigt ikke er i overensstemmelse med en given standard, men udarbejdet på baggrund af denne. MOD: Når publikationen er modificeret i forhold til en given publikation.
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM EN ISO 1736 October 2008 ICS 67.100.10 Supersedes EN ISO 1736:2000 English Version Dried milk and dried milk products - Determination of fat content - Gravimetric method (Reference method) (ISO 1736:2008) Lait sec et produits à base de lait sec - Détermination de la teneur en matière grasse - Méthode gravimétrique (Méthode de référence) (ISO 1736:2008) This European Standard was approved by CEN on 14 October 2008. Milchpulver und Trockenmilcherzeugnisse - Bestimmung des Fettgehaltes - Gravimetrisches Verfahren (Referenzverfahren) (ISO 1736:2008) CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Management Centre or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG Management Centre: rue de Stassart, 36 B-1050 Brussels 2008 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN ISO 1736:2008: E
EN ISO 1736:2008 (E) Contents Page Foreword...3 2
EN ISO 1736:2008 (E) Foreword This document (EN ISO 1736:2008) has been prepared by Technical Committee ISO/TC 34 "Agricultural food products" in collaboration with Technical Committee CEN/TC 302 Milk and milk products - Methods of sampling and analysis the secretariat of which is held by NEN. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by April 2009, and conflicting national standards shall be withdrawn at the latest by April 2009. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights. This document supersedes EN ISO 1736:2000. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and the United Kingdom. Endorsement notice The text of ISO 1736:2008 has been approved by CEN as a EN ISO 1736:2008 without any modification. 3
INTERNATIONAL STANDARD ISO 1736 IDF 9 Fourth edition 2008-10-15 Dried milk and dried milk products Determination of fat content Gravimetric method (Reference method) Lait sec et produits à base de lait sec Détermination de la teneur en matière grasse Méthode gravimétrique (Méthode de référence) Reference numbers ISO 1736:2008(E) IDF 9:2008(E) ISO and IDF 2008
ISO 1736:2008(E) IDF 9:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. Neither the ISO Central Secretariat nor the IDF accepts any liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies and IDF national committees. In the unlikely event that a problem relating to it is found, please inform the ISO Central Secretariat at the address given below. COPYRIGHT PROTECTED DOCUMENT ISO and IDF 2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO or IDF at the respective address below. ISO copyright office International Dairy Federation Case postale 56 CH-1211 Geneva 20 Diamant Building Boulevard Auguste Reyers 80 B-1030 Brussels Tel. + 41 22 749 01 11 Tel. + 32 2 733 98 88 Fax + 41 22 749 09 47 Fax + 32 2 733 04 13 E-mail copyright@iso.org E-mail info@fil-idf.org Web www.iso.org Web www.fil-idf.org Published in Switzerland ii ISO and IDF 2008 All rights reserved
ISO 1736:2008(E) IDF 9:2008(E) Contents Page Foreword... iv Foreword... v 1 Scope...1 2 Normative references...1 3 Terms and definitions...1 4 Principle...2 5 Reagents...2 6 Apparatus...2 7 Sampling...3 8 Preparation of test sample...4 9 Procedure...4 9.1 Test portion...4 9.2 Blank tests...4 9.3 Preparation of fat-collecting vessel...5 9.4 Determination...5 10 Calculation and expression of results...7 10.1 Calculation...7 10.2 Expression of results...8 11 Precision...8 11.1 Interlaboratory test...8 11.2 Repeatability...8 11.3 Reproducibility...8 12 Test report...8 Annex A (informative) Notes on procedures...9 Annex B (informative) Alternative procedure using fat-extraction tubes with siphon or wash-bottle fittings...11 Bibliography...14 ISO and IDF 2008 All rights reserved iii
ISO 1736:2008(E) IDF 9:2008(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 1736 IDF 9 was prepared by Technical Committee ISO/TC 34, Food products, Subcommittee SC 5, Milk and milk products, and the International Dairy Federation (IDF). It is being published jointly by ISO and IDF. This fourth edition of ISO 1736 IDF 9 cancels and replaces the third edition (ISO 1736:2000), of which it constitutes a minor revision. iv ISO and IDF 2008 All rights reserved
ISO 1736:2008(E) IDF 9:2008(E) Foreword IDF (the International Dairy Federation) is a non-profit organization representing the dairy sector worldwide. IDF membership comprises National Committees in every member country as well as regional dairy associations having signed a formal agreement on cooperation with IDF. All members of IDF have the right to be represented at the IDF Standing Committees carrying out the technical work. IDF collaborates with ISO in the development of standard methods of analysis and sampling for milk and milk products. Draft International Standards adopted by the Action Teams and Standing Committees are circulated to the National Committees for voting. Publication as an International Standard requires approval by at least 50 % of the IDF National Committees casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IDF shall not be held responsible for identifying any or all such patent rights. ISO 1736 IDF 9 was prepared by the International Dairy Federation (IDF) and Technical Committee ISO/TC 34, Food products, Subcommittee SC 5, Milk and milk products. It is being published jointly by IDF and ISO. All work was carried out by the Joint ISO-IDF Action Team Fat of the Standing Committee on Main components in milk under the aegis of its project leader, Mr G.J. Beutick (NL). This edition of ISO 1736 IDF 9 cancels and replaces IDF 9:1987, of which it constitutes a minor revision. ISO and IDF 2008 All rights reserved v
INTERNATIONAL STANDARD ISO 1736:2008(E) IDF 9:2008(E) Dried milk and dried milk products Determination of fat content Gravimetric method (Reference method) WARNING The use of this International Standard may involve hazardous materials, operations and equipment. This International Standard does not purport to address all the safety problems associated with its use. It is the responsibility of the user of this International Standard to establish safety and health practices and determine the applicability of regulatory limitations prior to use. 1 Scope This International Standard specifies the reference method for the determination of the fat content of dried milk and dried milk products. The method is also applicable to dried milk with a fat content of 40 % mass fraction or more, dried whole, dried partially skimmed, and dried skimmed milk, dried whey, dried buttermilk and dried butter serum. The method is not applicable when the powder contains hard lumps which do not dissolve in ammonia solution or free fatty acids in significant quantities. NOTE When the powder contains hard lumps which do not dissolve in ammonia solution or contains free fatty acids in significant quantities, noticeable by a distinct smell, the result of the determination will be too low. With such products, a method using the Weibull-Berntrop principle is suitable (see ISO 8262-3 IDF 124-3 [3] ). 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 835, Laboratory glassware Graduated pipettes ISO 1042, Laboratory glassware One-mark volumetric flasks ISO 3889 IDF 219, Milk and milk products Specification of Mojonnier-type fat extraction flasks ISO 4788, Laboratory glassware Graduated measuring cylinders 3 Terms and definitions For the purposes of this document, the following terms and definitions apply. 3.1 fat content of dried milk and dried milk products mass fraction of substances determined by the procedure specified in this International Standard NOTE The fat content is expressed as a percentage mass fraction. ISO and IDF 2008 All rights reserved 1