Installation Instructions for Med Touch Master Alarms - Wireless Master Alarm Panel Local Sending Master Alarm Panel - Master Alarm Panel - Repeater Page 1 of 7
Common Master Alarm Back Box Assembly Assembling the Master Alarms Bock Box: After installing the Back Box in the wall (The antenna can be mounted out the top or bottom of the Back Box) Flange Nut Flange Nut 1 2 3 4 Hinge Bracket Harness Remove the mounting flange nut from the Top Left hand corner. After removing the flange nut, slide the Antenna through the designated hole at the top of the back box, and slide the bracket over the mounting flange stud. Once the Antenna is through the designated hole and the bracket is adjusted, reinstall the nut and tighten into position Install the hinge brackets onto the lower flange of the box, tighten with mounting screws. Connection for Master Local Source Sending Panel Wireless Alarm 5 Lanyards Mounting Screws 6 Attach Ground Wire Connection Top Antenna Cable connection Top Antenna Harness Attach the Alarm Front to the hinge brackets, and insert the lanyard mounting screws though the lanyards and tightening onto the box studs. (Lanyard Mounting Screws shipped w/ the Back Box) Attach the Ground Wire to the Alarm Front Panel, and also attach the Top Antenna Cable to the outside mating connector. Once your connections are made, attach the Harness Plug as shown above. (See Figure 2 on Sheet 3) 7 Once all of the connections are made, turn the switch to ON from the Power Supply. Close the Alarm Front and tighten the center screw for a completed finish. Page 2 of 7
Figure 2 Master Local Source Sending Panel Wireless Alarm Power Cable Power Button Board Master Boards Sending Board Outside Connector for Antenna Master Power Cable Top Antenna Cable Network Position A Jumper Connector Network Position B Jumper Connector Page 3 of 7
Connection for Master Panel Wireless Alarm Antenna Mounting Screws Power Connection Antenna Cable connection 8 9 Attach Ground Wire Lanyards connection Receiver Cable Assembly Attach the Alarm Front to the hinge brackets, and inserting the lanyard mounting screws though the lanyards and tightening onto the box studs. (Lanyard Mounting Screw shipped w/ the Back Box) Attach the Ground Wire to the Alarm Front Panel, and also attach the Top Antenna Cable to the mating connector. Once your connections are made, attach the Plug and the Power Plug connectors, both connectors are on the same Harness as shown above. (See Figure 3 on Sheet 5) 10 Once all of the connections are made, turn the switch to ON from the Power Supply. Close the Alarm Front and tighten the center screw for a completed finish. Page 4 of 7
Figure 3 Master Panel Wireless Alarm Button Power Board and Harness Module Cable Cable Board Ground Attachment Point Master Board Antenna Cable Page 5 of 7
Connection for Master Repeater Panel Wireless Alarm 11 12 13 Antenna Assembly Back Box Antenna Harness Lanyard Mounting Screws Master Repeater Alarm Front Components for the Repeater Alarm Hinge Brackets Mounting Hardware Lanyards Attach the Alarm Front to the hinge brackets, and inserting the lanyard mounting screws though the lanyards and tightening onto the box studs. (Lanyard Mounting Screws are shipped w/ the Back Box) Attach the Ground Wire to the Alarm Front Panel, and also attach the Top Antenna Cable to the mating connector. Once your connections are made, attach the Plug connector as shown above. Once all of the connections are made, turn the switch to ON from the. Close the Alarm Front and tighten the center screw for a completed finish. Antenna Assembly Figure 4 Master Repeater Alarm Front Antenna Power Harness Connection Button Board Page 6 of 7
This page is left Intentionally Blank Tri-Tech Page 7 of 7