Intelligent Robot Vacuum Cleaner Hohm Dirtbot 2.0 User Manual For models: HRV-001, HRV-002, HRV-003, HRV-004, HRV-011, HRV-012, HRV-013, HRV-014
Thank you for purchasing the Hohm Dirtbot 2.0. Hope you enjoy it. Please feel comfortable in knowing that your Dirtbot 2.0 robot vacuum cleaner comes with a 1 year warranty. If the Dirtbot comes to you with defects out of the box, then please contact us or the seller. We will be sure that you experience 5 star service. 1
Table of Contents 1. Safety Instructions 3 2. Packing Contents and Technical Specifications 4-5 2.1 Packing Contents 2.2 Components & Parts 2.3 Technical Specifications 3. Product Use 5-6 3.1 Battery Charging 3.2 Operating the Dirtbot 3.3 Remote Control 4. Care and Maintenance 6-8 4.1 Cleaning the Surface 4.2 Cleaning the Dustbin 4.3 Replacing the Filter 4.4 Cleaning & Replacing the Side Brushes 4.5 Cleaning the Driving Wheels 4.6 Wiping the Visual Sensors 4.7 Replacing the Battery 5. Alarm and Prompt Functions 9 6. Troubleshooting 9 7. Other Questions 10 2
1.Safety Instructions Before operating the Dirtbot, please read the following safety instructions and follow all safety measures. Please read these instructions completely save and the save manual the manual in easy in an retrievable easy retrievable location. location. Note: 1. This product is for indoor use only, do not use outdoors. 2. Only use with the original power adapter included in the packaging, otherwise it will likely result in product damage. 3. Please do not disassemble the product by yourself. 4. Please remove easily damaged items off the ground (such as glasses, cables, etc.) Brush and suction may damage them and they may damage the product. 5. In order to prevent tripping, please advise other people in the room when the product is in use. 6. Please empty dustbin and clean the product after each use. 7. To conserve energy, please power off the product if it is idle. 8. Do not use this product in humid environments such as the bathrooms. 9. Please do not connect adapter power outlet when your hands are wet. 10. Do not operate this product near flammable items. 11. Please do not use this product to clean sharp objects such as pieces of glass, pins, nails, etc. These objects may block the suction or damage the product. 12. This product may not be able to cross the ridges of more than 5 mm. 13. Operable temperature range is between 4 ~ 50, do not use in high temperature environments. 14. Before this product is scrapped, please dismantle the battery from the product. Please make sure to disconnect the power before demolition of the battery. 15. Please abide to safe recycling standards when disposing of the battery. 3
超薄智能机器人扫地机 2. Packing Contents and Technical Specifications 2.1 Packing Contents Main Body Adapter Remote Control Robot Vacuum Cleaner User Manual Side Brush (2) User Manual 2.2 Components & Parts Light Sensor Infrared Receiver Status Indicator Lamp Charging Input Port Power Switch Sensors Universal Wheel Dust Absorption Pore Surface Cover Side Brush Side Brush Dustbin Lid Dustbin Sensor Sensor Wheel Battery Compartment Cover Wheel 4
2.3 Technical Specifications Main Body Rated Voltage DC 12 V Rated Power 15 W Battery Rechargeable (Charge time 3 ~ 5 H) Dustbin Capacity 0.2 L Noise Level 50 DB Charge Time 5 H Working Hours 60 min Maximum Cleaning Area 120-150 m Size 300*61mm N.W. 1.8 Kg Adapter Input Voltage 110-240 V Output Voltage 17 V Rated Frequency 50/60 Hz 2 Remote Control Operating Voltage DC 3 V Battery AAA*2pcs Control Method IR38 KHz Control Distance 7 M 0 Operating Temperature Range -10~45 C Operating Humidity Range 90 RH Size 101*53*13 mm Hohm reserves the right to continuously update and improve product technology and design. Besides, the ultimate power of interpretation is owned by our company. About Noise: Data is recorded in company laboratory tests in accordance with international testing standards: IEC 60704-1:1997, IEC 60704-2:2001. 3. Product Use 3.1 Battery Charging Before plugging the charging cable to the Dirtbot, please check to make sure the ports are not blocked with any dirt or dust. Connect the charging cable. the LED indicator will begin to flash a green light which notifies you that the Dirtbot is charging. In order to get best performance out of your Dirtbot, please charge and discharge the battery for a set of 3 cycles. This will achieve maximum battery longevity. Charging time is about 12 hours. Note: Do not subject the Dirtbot or battery to extreme hot or cold temperatures, It may damage the battery, prolong charging times, or lead to battery failure. 3.2 Operating the Dirtbot Press the power button on the side of the Dirtbot to turn on. To turn off, press the same power button. Note: When the battery of the Dirtbot is low, the LED indicator will turn on to notify you that the Dirtbot requires charging. When the Dirtbot is vacuuming, allow it to vacuum in a well lit room so as not to trip over it while it is operational. 5
3.3 Remote Control Press the power button to turn on the Dirtbot and once again to turn it off. When the red light is on, this indicates that the Dirtbot is on standby mode. Press the up arrow button to go forward. Press the left arrow button to turn left. Press the right arrow button to turn right. Press the down arrow button to go back. Press the play/pause button to stop/standby and to continue. 4. Care and Maintenance 4.1 Cleaning the Surface Power off the Dirtbot before cleaning. To clean the surface of the Dirtbot, use a dry or damp cloth. Do not allow water to drain into the Dirtbot. Do not use any chemical products to clean the Dirtbot. 4.2 Cleaning the Dustbin 1 Power off the Dirtbot and take out the dustbin. 2 Open the lid of dustbin, take out the debris from the filter inside and dispose of it in the trash. 3 4 Re-install the filter and the lid of the dustbin. Place the dustbin back into the Dirtbot. Note: If there is an excessive amount of dust in the dustbin, you can wash the filter with flowing lukewarm temperature. Wait before the filter is completely dry before using the Dirtbot again. 6
4.3 Replacing the Filter If the filter is overused or damaged, please replace with a new one. 1 Take out of the dustbin from the Dirtbot and remove any debris that is in it. 2 Open the support guard of the cotton filter side. 3 4 Lay a new filter cotton on the filter support guard, close it slightly. Re-install the filter components to the dustbin. 4.4 Cleaning & Replacing the Side Brushes 1. Catch hold of the side brush and pull outward. 2. Clean the side brush and the side brush groove with a dry or damp cloth. 3. Re-install the side brush to the Dirtbot. Note: Side brushes are easy to wear down, please replace them in time. Regular checking is recommended. 4.5 Cleaning the Driving Wheels Please keep the wheels clear of debris, dirt, hair, etc. 7
4.6 Wiping the Visual Sensors Wipe the Visual Sensor Visual sensors are in front of the bottom of the Dirtbot, they can sense a height of less than 5 cm. It's recommended to wipe the visual sensors with a dry cloth in case dust accumulates and performance goes down. Power off the Dirtbot and clean the dustbin. Wipe the visual sensors with a dry cloth carefully. 4.7 Replacing the Battery 1. Power off the Dirtbot and empty the dustbin. 2. Remove the screw at the bottom of the battery cover with a screwdriver. 3. Pull out the connector at the end of the battery cable from the main body. 4. Insert the new battery according to the positive and negative electrodes.. 8
5. Alarm and Prompt Functions Green light flashes when the Dirtbot is under charging. Green light remains on when charging is complete. Indicator light won't be on if charging fails. Under the following circumstances, the Dirtbot stops working and indicator flashes green light. 1. Dustbin is not well-installed. 2. The wheels hang in the air. 3. The Dirtbot is stuck. 6. Troubleshooting Faults Codes 1 Faults Cases The Dirtbot gets into troubles Solutions When working, the Dirtbot may run into troubles, in which case, it will try to find a way out on its own. If it fails to do so, please help it. Possible troubles: 1. Being entwined by wire or/and hair on the floor. 2. Being entwined by fringe of curtain or carpet. 3. Being obstructed by too many barriers. 2 The Dirtbot fails to sense stair The Dirtbot can detect a height of 5 cm, but its sensibility may reduce if the floor is too smooth or reflective. In this case, it's necessary to set a barrier here lest it should fall down. If the case is not like this, please check the sensor to see whether there is too much dust on it. 3 The side brushes don t rotate 1. Please make sure the Dirtbot is fully charged. 2. Please check the side brushes, they may well be entwined by hair, wire, etc. If the side brushes are not properly installed, please install again. If the side brushes are broken, please replace with new ones. 4 Noise becomes louder Please power off, empty the dustbin and turn over the Dirtbot, then do the following steps: 1. Check and clean the dust absorption pore. 2. Check the wheels to make sure they are not entwined. 3. Check and clean the side brushes. 9
7. Other Questions: 1. How long does the Dirtbot work after fully charged? A: Working duration depends on the type of floor. For flat wooden and tile floor, it is about 60 minutes. 2. Is the Dirtbot suitable for unattended operation. A: Yes, but in order to prevent tripping, please advise other people in the room when the Dirtbot is in use. 3. What is installed inside of the Dirtbot to help it avoid stairs and barriers? A: We installed light sensors inside, which can help it avoid stairs and barriers. 4. Is the Dirtbot able to clean under furnitures? A: Yes, the Dirtbot is able to clean under furnitures such as bed, cabinet, sofa, tea table, etc. 9. Since the main body of the Dirtbot is round, how does it clean the corner? A: The Dirtbot can work along the wall, and the side brushes can round up dust. But because of the technical limitation, a small piece of area around the corner is beyond the Dirtbot's reach. 10. Does the Dirtbot affect pet's mood? A: The Dirtbot won't create harsh noise when working, so it won't let pet feel uneasy. However, it's also necessary to observe your pet if the Dirtbot is used for the first time. 11. What if liquid infiltrates into the Dirtbot? A: 1) Please power off instantaneously, then take dustbin out, and dry it. 2) Please take filter cutton out, and dry it. 3) Before reuse, please dry all parts at least 12 hours. 5. What's the cleaning area if the Dirtbot is fully charged? A: Normally the cleaning area is about 120-150 m2, but it is subject to the actual situation. 12. What if the side brushes get broken frequently? A: Before use, please clear off wires from the floor. Besides, please prepare some spare brushes for replacement. 6. What if the Dirtbot meets barriers? A: Normally the Dirtbot will automatically find a way out on its own, if not, please help it. 7. Why does the Dirtbot leak garbage when working? A: First, maybe there is too much garbage in it, please empty the dustbin. Second, the brushes may well be entwined, please clean them. 13. What if the battery is running low? A: When the battery is running low, the Dirtbot will move to a relatively brighter place so that users can easily find it. Therefore, please provide a certain amount of light when the Dirtbot is in use. 14. If the abovementioned answers can not help you, please contact us or the seller. 8. Why doesn't the Dirtbot charge? A: First, please properly install the battery and make sure the screw is not loose, if so, please retighten it. Second, please check the adapter and plug it in. 10
Choose Hohm Dirtbot Enjoy A New Lifestyle For models: HRV-001, HRV-002, HRV-003, HRV-004, HRV-011, HRV-012, HRV-013, HRV-014