LED Dusk to Down Fixture Features UL cul DLC certificate PHILIPS Chip, high CRI Mean Well IP65 driver,input voltage 100-277VAC No UV or IR in the beam Easy to install and operate Energy saving, long lifespan Light is soft and uniform, safe to eyes Instant start, NO flickering, NO humming Green and eco-friendly without mercury. LED DUSK TO DAWN FIXTURE ITEM # DIMMENSIONS VOLTAGE WATT LUMEN OUTPUT BEAM ANGLE WEIGHT SWWSNC-ST01-035AAA1 9.1x12.8x6.7 AC 110 / 277V 35W 4,300 SWWSNC-ST01-055AAA1 9.1x12.8x6.7 AC 110 / 277V 55W 7,200 150 150 2.7 KG 2.7 KG
Photometrics Notice for User Please turn off power before install or change assembly parts. The input voltage and lamps should be matched, after connecting the power line, Please make sure the wiring section is insulated. No-professionals, must not install and disassemble the lamps.
Materials LED Brand LED Type LED QTY Housing Housing color Optional Accessory PHILIPS LUMILEDS LUXEON 3030 2D (1.5W) 49 PCS Aluminum Silver Brown Photocell sensor Shorting Cap Surge Protective Device Others Operating Temperature -20 TO 45 Operating Humidity 20%-90% RH Storage Temperature -30 TO 80 Storage Humidity 10%-95% Application Outdoor Safety Certification UL cul Warranty Time 5 Years
Cautions: 1. Can not use the electric generator to test the LED lamp. 2.Please abide by related country, regional and local law and regulations when install this fixture. 3. Please turn off the power before installation or maintenance. 4. Proper earth grounding is required to ensure safety. Notice: 1. To avoid possibility of electrical shock or fire, the installation personnel must have professional electric knowledge. 2. Please wear gloves to avoid injury before installation. 3. If any smoke or spark of the wire happened, please turn off the power immediately and notify relevant personnel. LED Dusk to Dawn Installation Instruction Attention: 1. Please check if there is any damage during shipping. If so, please contact manufacturer timely. 2. Please read the installation instruction carefully to check whether all the accessories are complete. After confirmation, then install the fixture according to installation steps. Wiring Diagram: Black/Brown: ACL Green/Yellow White/Blue: ACN Product with Photocell requires assembling the photocell on the fixture before working. Installation Methodl ǀ : 1.Loosen the installation plate on the arm by screw driver.(figure 1) 2.Wiring connection and protection measure be made according to the local wiring mode(figure 2).Put the fixture into arm (the diameter of arm is Ø40-42mm). 3.Tighten screws on the installation plate by screw driver. (Figure 3) Figure 1 Figure 2 Figure 3
Installation Methodl ǁ : 1.Drill holes on the wall by electric drill. (Figure 4) 2.Insert expansion screws into the holes by hammer and take off the nut washer. (Figure 5) 3.Wiring connection and protection measure be made according to the local wiring mode. (Figure 6) 4.Tightly twist the gasket and nut by wrench. (Figure 7) Figure 4 Figure 5 Figure 6 Figure 7 Warning / Avertissement MIN 75 C SUPPLY CONDUCTOR THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED. LES FILS D ALIMENTATION 75 C MIN CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D INSTALLATION PERTINENT, PAR UNE PERSONNE QUI CONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENT AINSI QUE LES RISQUES INHÉRENTS.