Multi Energy Boilers Duo 1 & 2 Triplex 0 & 3000 Biotriplex Oil Gas LPG Wood Briquettes Electricity Solar thermal Solar photovoltaics
Jaspi Multi Energy Jaspi has been developing and manufacturing highlong before the interest in biofuels grew to the current can also be connected wind / water turbines and solar All our multi energy boilers are factory fitted with electric efficiency multi energy boilers for more than two decades, immersion back-up heaters. These 3-element heaters levels. Our long experience and knowledge have made photovoltaic panels. us the market leaders in our field. Jaspi Duo, Triplex and Biotriplex have two furnaces in one unit, allowing both of the furnaces to operate simultaneously or only one at the time. This gives the user flexibility and choice of the fuel without the need to alter the boiler in any way. It is common that the boiler runs on oil or gas during the week and then at the weekend when there is often more time, solid fuel wood / briquettes are used. Our boilers can also be connected directly to the solar thermal panels, without a thermal storage tank. If the use of wood is regular, it is recommended that the boiler is coupled with a thermal storage tank as this allows a higher amount of energy from the wood burning to be stored for later reuse. A Jaspi multi energy boiler is a sound investment for a greener future.
Jaspi Duo 1 & Duo 2 Multi Energy Boilers Jaspi Duo is a reliable and efficient boiler with an extremely long service life. Thick insulation and modern burning technology results in high effiency with low emmissions. An integrated domestic hot water coil produces a constant flow of mains pressure water. The oil/gas and solid fuel furnaces are completely separate but the boiler needs only one flue. This reduces the installation and maintenance costs. Optional solar coil connects directly to the solar thermal panels, without a thermal store. Oil / Gas or combination use Duo boilers work on very high efficiency. The burner can be chosen according to the available fuel and power needed. When the burner is correctly installed, the boiler needs to be cleaned only once a year. Jaspi Duo boilers have a burner thermostat pre-installed. The Termomix mixing valve allows direct connection to the heating system and can be fitted with a constant temperature or weather compensated controller. Log / Briquett use The differences between the Duo 1 and Duo 2 boilers are the length of the wood furnace, water capacity and the total power output. Jaspi Duo 1 can take 30cm logs whilst the Duo 2 takes 50cm logs. A new design burning chamber produces higher burning temperatures with less emissions and more efficient use of the fuel. A thermal storage tank connected to the boiler improves the efficiency even further and allows multiple heat sources to be connected together. Description 1. Termomix mixing valve DN20 (R3/4") 2. Heating circuit flow DN20 (R3/4") 3. Heating circuit return DN20 (R3/4") 4. Domestic hot water out Ø22 mm 5. Mains cold water in Ø22 mm 6. Flue connection 255x mm 7. Return from the thermal tank (or expansion) DN25 (R1 ) 8. Draft requlator connection D20 R3/4" 9. Thermostat pocket for anti-boiling valve DN15 (R1/2") 10. Flow to the thermal tank DN25 (R1") 11. Drain DN15 (R1/2") 12. Cleaning hatch (wood furnace) 13. Wood furnace 14. Secondary air regulator 15. Fire check hatch 16. Draft regulator 17. Oil / Gas / LPG hatch 18. Flame check window 19. Cleaning hatch (burner side) 20. Flue gas analyzer connection 21. Control panel 22. Pressure gauge 23. Thermometer 24. Immersion heater thermostat 25. Immersion heater over temperature cut-off 26. Burner thermostat 27. Burner over temperature cut-off Solar coil (optional) Included in the standard delivery Oil burner, Riello R40G3B 19-35kW Immersion heater 2-6kW 230VAC single phase Flue 255xmm to Ø160mm (6") converter Termomix heating mixing valve Boiler cleaning kit Optional fittings Electric Immersion heater 3, 4.5 or 6kW 230V / 3-phase TSK Anti-boiling valve Termovar & ACG Heat Loading units 1.5bar Pressure relief valve ½" or ¾" Automix heating flow controllers Recommended flue material: Recommended min. flue height: 4.5 / 5.0 M Brick 250cm² / Steel Ø160mm (6") DHW coil flow rates: 130 l / 40 C / 10 min. (Duo 1) 200 l / 45 C / 10 min. (Duo 2) Recommended Thermal tank: 500-1200 L Max. recommended solar panel area 4 sqm Model Power (kw) Oil/Gas Wood Elec. Water tank L Dimensions Wood Furnace Dimensions Weight Kg Working pressure bar Maximum temp C Part number Duo 1S 22 20 160 1420 x 720 x 610 700 x 250 x 380 300 1,5 505 8008 Duo 2S 26 25 235 1420 x 720 x 760 700 x 250 x 530 365 1,5 505 8022 E&OE
Jaspi Triplex 0 & 3000 Multi Energy Boilers Jaspi Triplex boilers have a highly efficient ceramic wood furnace which burns the wood at a very high temperature. The result is nearly smokeless burning and an efficient use of the fuel. Triplex boilers minimal emmissions when using oil, gas or wood exceed the standards set by the EU regulations. An integrated domestic hot water coil produces a constant flow of mains pressure water. The oil/gas and solid fuel furnaces are completely separate but the boiler needs only one flue. This reduces the installation and maintenance costs. Triplex boilers are clean and efficient. The burner can be chosen according to the available fuel and power needed. When the burner is correctly installed, the boiler needs to be cleaned only once a year. All Triplex boilers have a burner thermostat pre-installed. The Termomix mixing valve allows direct connection to the heating system and can be fitted with a constant temperature or weather compensated controller. Optional solar coil connects directly to the solar thermal panels, without a thermal store. The difference between the Triplex 0 and 3000 boilers are in their power output and the weight. Triplex 2000 has the same power output than the Triplex 0 but is enclosed with doors. All Triplex boilers can take a generous amount of 35cm logs. A thermal storage tank connected to the boiler allows higher amounts of energy to be stored and improves the wood burning efficiency even further. The tank can also be used to connect multiple heat sources together but is not necessary for the solar if the boiler has a solar coil fitted. Description 1. Domestic hot water out Ø22 mm 2. Mains cold water in Ø22 mm 3. Flow to the thermal tank DN25 (R1") 4. Return from the thermal tank (+expansion) DN25 (R1") 5. Draft regulator connection DN20 (R3/4") 6. Fire check hatch 7. Secondary air regulator 8. Wood filling hatch 9. Primary air hatch 10. Wood furnace cleaning hatch 11. Fire check window 12. Drain DN15 (R1/2") 13. Oil / Gas burner hatch 14. Flame check window 15. Cleaning hatch (burner side) 16. Flue gas analyzer connection 17. Termomix mixing valve R¾" 18. Heating flow 19. Heating return 20. Control panel 21. Burner thermostat 22. Immersion thermostat 23. Thermometer 24. Pressure gauge 25. Flue connection 255x125 mm 26. Anti-boiling valve thermostat pocket DN15 (R1/2") Included in the standard delivery Oil burner, Riello R40G3B 19-35kW Immersion heater 2-6kW 230VAC single phase Flue 255xmm to Ø160mm (6") converter Termomix heating mixing valve Boiler cleaning kit Optional fittings Electric Immersion heater 3, 4.5 or 6kW 230V / 3-phase TSK Anti-boiling valve Termovar & ACG Heat Loading units 1.5bar Pressure relief valve ½" or ¾" Recommended flue material: Brick 250cm² / Steel Ø160mm (6") Automix heating flow controllers Recommended min. flue height: 4.5 / 5.0 M Solar coil Recommended Thermal tank: 500-1500 L Max. recommended solar panel area 4 sqm Model Power (kw) Oil/Gas Wood Elec. Water tank L Dimensions Wood Furnace Dimensions Weight Kg Working pressure bar Maximum temp C Part number Triplex 0 25 25 235 1420 x 720 x 820 535 x 250 x 380 335 1,5 505 8015 Triplex 3000 35 25 235 1420 x 720 x 820 535 x 250 x 380 380 1,5 505 8020 E&OE
Jaspi Biotriplex multi energy boiler Oil or gas (25 kw) Wood (25 kw) Electricity (6 kw) The twin-furnace Jaspi Biotriplex is a powerful, reliable and environmentally clean boiler for domestic and small industrial use. It integrates latest technology with high efficiency. Biotriplex high temperature combustion uses the wood economically with clean burning and low emissions. The gasification process reduces the wood consumption and extends the boiler cleaning intervals considerably. The wood furnace of the Biotriplex boiler is fitted with ceramic grate bars guaranteeing a high combustion temperature. Maximum log length is 35 cm. Optional solar coil connects directly to the solar thermal panels, without a thermal store. The Biotriplex boiler can be easily cleaned from the front and has enough ash space to further extend cleaning intervals. Generous water space and an efficient copper comb coil guarantee a considerable hot water production rate. The Biotriplex boiler with a correctly adjusted oil or gas burner achieves an efficiency of more than 90%. The oil / gas furnace and wood furnace of the Biotriplex twin-furnace boiler operate independently and are completely separate from each other. The boiler needs only a single flue reducing the installation costs. We recommend that the Biotriplex is connected to a 500-3000 l thermal storage tank. This combination will also allow solar and wind energy to be used. The boiler is supplied with a 4 kw back-up electric immersion heater which can be used to increase the boilers output or to connect directly to the solar, wind or hydro power. 1. Domestic hot water coil + Solar coil (if fitted) 2. Wood furnace filling hatch 3. Wood furnace ash removal 4. Wood furnace cleaning hatch 5. Oil / Gas furnace burner hatch 6. Oil / Gas furnace cleanout hatch 7. Oil / Gas furnace ash removal 8. Primary combustion air damper 9. Secondary combustion air damper 10. 4-way mixing valve 11. 250 x 120 mm flue connection 12. Optional TIGEX draft damper 13. R 1 safety valve- / boiling nozzle, thermal storage tank outlet 14. R 1 thermal storage tank return nozzle 15. R 1 additional heating circuit mixing valve connection 16. R 1/2 drain connection 17 R 1 2 anti-boiling thermal valve and thermal storage tank loading unit probe connections 18. Firing throat 19. Top turbulance plate 20. Lower turbulance plate 21. Electric cable clamps For available heating controllers, please see our website. 22. Control panel 23. Connection point 24. Electric immersion heating element behind the panel Optional fittings 25. Mineral wool insulation Included in the standard delivery Electric Immersion heater 3, 4.5 or 6kW 230V / 3-phase Oil burner, Riello R40G3B 19-35kW TSK Anti-boiling valve Immersion heater 2-6kW 230VAC single phase Termovar & ACG Heat Loading units Flue 255xmm to Ø160mm (6") converter 1.5bar Pressure relief valve ½" or ¾" Termomix heating mixing valve Automix & Vexve heating flow controllers Boiler cleaning kit Solar coil Model Jaspi Biotriplex Capacity kw Oil/Gas electricity wood Water volume l Weight kg Min. draft mm H2O 25 6 25 240 480 2,5 Design pressure bar 1,5 Design temperature C 110 Flue recommendation: metal Ø 160 mm, brick 250 cm Minimum flue height: 5 m Maximum recommended solar panel area 4 sqm. We reserve the right to modify the design and dimensions. 2
Jaspi Duo boiler in direct heating & DHW connection Jaspi Biotriplex - GTV Thermal Tank - Heat Pump Jaspi Biotriplex - GTV Thermal Tank - Solar Thermal Jaspi Biotriplex - Solar Economy Thermal Tank - Solar Thermal System connection examples. Do not use as detailed installation drawings.
Jaspi Thermal Storage JASPI UK ISO 14001 ISO 9001 EN ISO 3834-2 Tel. 0845 862 7007 mail@northmangroup.co.uk