LED SPEC Microwave Motion Sensor LED Option: Remote control Suitable for a variety of scenes IR 5.8GHz IP IK WF 66 08 02 Design Lifespan 50,000H Note : 1.The Luminaires are intended for indoor use or under sheiter for outdoor use. 2.Please ensure that the environment is suitable for microwave lamps.
Matters needing attention Before installing the lighting fixtures, please read this instruction manual carefully. The lighting fixtures should be installed, connected and tested by a certified installer based on the local regulations. Lamps should always be installed or replaced with care. Please check the local voltage in accordance with the product requirements before using the product. Relamp can only be done after the power is off and the lamp completely cools down. When a lamp is to be cleaned, make the power off and let it cool down completely.clean the fixture with a soft cloth and a standard PH neutral detergent. Stainless steel finishing should be maintained regularly. Misuse of, or changes to the fixture shall nullify the guarantee. Don t cover the fixtures with flammable materials. If the external flexible cable or this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or similar qualified person in order to avoid an accident. The light soure contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.caution, risk of electric shock. Product Number Explanation 1 Type Linear 5 Function PS: ABCDEFG-HIJK-LM 7 2 Series 6 CCT 3 Size 7 Version 4 Power PS : L011200-40CO-NA Linear,LED,1200mm,40W,Normal,4000K,Version A. O Temperature Characteristics T-ambient 25 C Electrical Characteristics Temperature Operating -20~+40 Storage - 40~+85 Input Voltage: AC120~240V 50/60Hz PF 0.93 THD<20% 0.90
0-170Lux 14m Max. 6M D(14m),H(6m) 10-1800S 0-170Lux 14m Max. 6M D(14m),H(6m) +oo 14m Max. 6M D(14m),H(6m) 0-170Lux Steps dimming control demonstration With sufficient ambient light, the sensor does not switch on the lamp. With insufficient ambient light, the sensor switches on the lamp when motion is detected. After hold time, the sensor dims the lamp at a low light level if no new motion trigger. After stand-by period, the sensor switches off the lamp is no motion is detecred in its detection zone
Special application for underground parking 6m 10m For general parking,when the car close to the lamp will light up, such easy to cause the driver could not be instantly adapt to light shifting sharply and discomfort,however,focusonled provide aperfect solution for such a defect,it can make the driver the car at a distance of 10 meters off the lamps then light up automatically. Widely used subway station Factories Passageway Offices Parking lot 2.5m 3m 4m 5m 6m Detection radius up to 8m,diameter up to 16m 16
1. Features Tri-proof led fixture for IP66 water-proof,dustproof and corrosion-proof Drive with over current,over voltage and over temperature protection Patent and functional design with imaginative appearance High stability isolated driver Excellent heat dissipation depending on whole aluminum housing Maximum efficacy and minimum glare High-tech optical design No UV,No lead, No mercury Sensor hidden in the lamp With lux sensor and infrared remote control 2.Application COMMERCIAL LIGHTING PUBLIC LIGHTING INDUSTRIAL LIGHTING Supermarket Exhibition hall Parking place Etc 3. Product Dimension Tunnel MTR station Train station Bus station Airport Etc Factory/Warehouse Etc Model NO. Size A(mm) Size B(mm) Size C(mm) Size D(mm) L010600-20MW-XA 600 71 84 800 L010900-30MW-XA 900 71 84 800 L011200-40MW-XA 1200 71 84 800 L011500-50MW-XA 1500 71 84 800 L011500-65MW-XA 1500 71 84 800
proofwater box 4. Parameter Model NO. Power Light LED QTY CCT Frosted Cover Clear Cover Beam (W) Source (pcs) (K) Lumers Lm/W Lumens Lm/W CRI Angle L010600-20MW-XA 20 2835 108 4000K 1900 95 2100 105 >80 120 o L010900-30MW-XA 30 2835 156 4000K 2850 95 3150 105 >80 120 o L011200-40MW-XA 40 2835 216 4000K 3800 95 4200 105 >80 120 o L011500-50MW-XA 50 2835 264 4000K 4750 95 5250 105 >80 120 o L011500-65MW-XA 65 2835 324 4000K 6175 95 6825 105 >80 120 o CCTRange: WW(3000K) NW(4000K) DW(5000K) CW(6500K) 5.Installation A.Suspending mounting Ceiling Open hole Electric drill Steel cable Power OFF A : Make a right position and drill a hole B : Screw the steel cable onto the ceiling 2 The min. cable diameter is 3G0.75mm Europe N FG L Power OFF PLS note : PLS put the terminal of power cable into water proof box and use a listed water proof bushing when you link the power Power ON C : Hang the fixture under the steel cable and secure the fixture by steel cable D: Adjust the position of the fixture and
proofwater box B.Ceiling Mounting Open hole Open hole Metal clip Screw Electric drill Screw driver A: Make a right position and drill a hole B: Screw the clip on the ceiling tightly Power OFF 2 The min. cable diameter is 3G0.75mm Metal clip LED Tri-proof light Note : pls put the terminal of power cable into water proof box and use a listed water proof bushing when you link the power N L FG Europe Power OFF Power ON C: Install the lamp into the clips and twist the screw through the clips. D: Adjust the position of the fixture and clean it.. Pls note : Above installation B belongs to our standard installation, if you want to choose our way of A installation then you need to select our optional accessories and pay. Metal Card remote control steel cable One package two pcs One pcs One package two pcs Standard accessories Optional accessories 6.Wiring diagram PE AC 200-240V N L N L PG LED lamp
7.Packaging LED Tri-proof light Metal card buckle A.Pack list Sequence Number 1 2 3 Model NO. LED Tri-proof light Metal card buckle Manual Quantity 1pc 2pcs 1pc B.Packing Data Model No Single Box Pcs/CTN N.W. / pcs (kg) G.W. /CTN (kg) Meas (mm) L010600-20XX-XA 1 6 1.877 12.362 685x307x223 L010900-30XX-XA 1 6 2.579 17.074 985x307x223 L011200-40XX-XA 1 6 3.342 22.152 1285x307x223 L011500-50XX-XA 1 6 4.096 27.086 1585x307x223 L011500-65XX-XA 1 6 4.096 27.086 1585x307x223 8. Safety & EMC Safety standards UL 8750; UL 1598; EN 60598-1: 2015; EN 60598-2-2: 2012; EN 62031: 2008+A1: 2013+A2: 2015; EN 62493: 2015; EN 62471: 2008; EMC emission Compliance to EN55015: 2013,EN61000-3-2: 2014; EN61000-3-3: 2013; EMC immunity Compliance to EN61547: 2009;
9. Lamp Block Diagram AC Input DC Output Driver PCB Sensor 10.Attention This specification is for reference only,we reserve the right to change without notice.if you need the updated info,please contact local distributors or visit our website at https://goled.lighting/