PANIC HARDWARE ACCESSORIES & PARTS
DX 200 Keepers and strikes PO OSK 3405 Keepers for the vertical bottom latch. Forms a set together with the keeper shown below (PO BSK 3405A) for assembly on a stone threshold or lintel. PO BSK 3405A Keeper for the vertical top latch. PO SK DD Keeper for the rim latch on double doors, in matte black (PO SK DD RZ). Also available in silver with the application of colour code SE (PO SK DD SE). PO BSP 2401 Strike for the vertical top latch. Forms a set together with the socket shown below (PO OSP 2402) for assembly on aluminium and plastic frames where the clear width is between 14 and 21 mm. Including filler plates, for use up to 7 mm. PO OSP 2402 Strike for the vertical bottom latch. PO BSP 2405 Strike for the vertical top latch. For use on a frame that is flush with the door.
A DX 500 Keepers and strikes Recessed door situations The keepers for recessed door situations are supplied as standard with the panic exit hardware. ogte duwstang tussen en 140 1.100 DX mm. PO900 SK Keeper for the latch bolt, for a single-door situation. PO SK 142 DX Keeper for the horizontally closing Pullman latch, side-acting in the frame of a single-door situation. PO SK 3402 DX Keeper for the vertically closing Pullman latch in the upper and lower part of the frame. Flush door situations The keepers and strikes for flush door situations are not supplied with the panic exit hardware as standard. A PO SK 144 DX Keeper for the latch bolt for a flush-mounted double door or when the door is flush with the frame. ngshoogte duwstang tussen 900 en 1.100 mm. PO SP 406 DX Strike for the horizontally closing Pullman latch on a flush-mounted double door or on a flush frame. PO SP 3401 DX Strike for the vertically closing Pullman latch, closing at the top of a flush frame.
Briton series panic exit hardware accessories Briton 3 series Striker PO SLP 376 SE For flush door situations, for the top bolt. Briton 5 series Striker PO OBSK PO 5 Striker for lower vertical Pullman latch in combination with a threshold. Finish: matte black. Dogging device Briton 5 PO VZK 566 SE & PO VZK 576 UF For allowing free access. The manual and permanent hold-open function is operated by a key which holds all latches in the withdrawn position. PO SLP 378 SE Used for wooden double door situations for the latch bolt of the panic exit device on the first-leaf door. PO SLP MDS Used for the latch bolt of flush single and double metal door situations. Briton s panic devices are equipped as standard with tapping screws that are suitable for use on wood and metal. Alarm switch Briton 3 PO EKM SE End cases with an integrated alarm switch are available as an option. This allows the panic device to be integrated with an alarm system that immediately gives a signal when unauthorised use is made of the escape exit. The door can therefore not be opened without the alarm being activated. The system operates on 24-volt DC current, 1.4 amps. Alarm switch Briton 5 PO AS 566 UF & PO AS 576 AK For incorporating the panic device in an electronic alarm system. The alarm is activated upon opening the door. Dogging device Briton 3 PO EKV SE An end case with integrated dogging device for keeping the escape exit door unlocked for an extended period of time to permit free access. The latch bolts are fixed in the withdrawn position, also when the door is pushed into the frame. The mechanism must be released manually in order to let the door lock back into the frame. This feature must not be used on fire and smoke-resistant doors! Briton 3 Bar extension kit The 1900 mm-long upper bar PO VBS 190 SE can be used for doors that require the push bar at a lower position e.g. in schools. Also applicable on doors higher than 2500 mm, up to a maximum door height of 3350 mm. Important!: Doors over 2500 mm high fall outside of the scope of EN 1125 and EN 179. Briton 5 Bar extension kit PO VBS 576 SE For extending the upper Pullman latch in situations where the push bar/touch bar must be placed at a lower location e.g. in schools. The Briton 5 series devices with an extended bar can be applied to doors up to 3350 mm high. Doors higher than 2500 mm fall outside of the scope of EN 1125. Finish: silver.
Panic hardware accessories for the DX series Alarm switch DX 2-serie PO EKM 294 An end case with an alarm switch, allowing the panic push bar to be linked to an alarm system. Vertical bar alarm kit for DX 2 series PO AS 304 Alarm kit for the vertical bar. Sounds upon unauthorised use of the panic device. Anti-dogging mechanism DX 2 and 5 series PO VZM V For fixing in the open position to allow free access. The manual and permanent unlocking mechanism is operated by a cabinet in front of the vertical bar, which holds the latch bolts in the withdrawn position. It is prohibited by law to use a dogging device on fire-resistant doors. The application of the anti-dogging device nullifies compliance with the EN 1125/179 standards and CE classification. DX 2 series anti-dogging device PO ABS 294 This mechanism is placed below the upper latch. When the latch bolts are withdrawn, the mechanism blocks the upper latch and all the latches are held in the withdrawn position. The latches are blocked by pressing the valve. Extending vertical bar PO VBS 190 DX Extra- long upper rod for doors over 2440 mm high, up to 3140 mm max.