This is the illustrated parts list for the SCCG0 and the SCCP0 Residential Ice Machines hen ordering a service part, always refer to the complete model number of the equipment being repaired to be sure of obtaining the correct part. Many times there are slight differences between models, and having the complete model number will aide in selecting the correct part. SCCG0 & SCCP0 Service Parts Table of Contents Door............................................... Page Cabinet............................................. Page Reservoir and Spray Pump................................... Page Under Bin Parts......................................... Page Control System......................................... Page 7 Schematic Diagram....................................... Page 8 iring Diagram......................................... Page 9 September 009 Page
Door 9 9 0 7 8 7 8 Item Part Number Number Description Door panel kit. Kit includes items thru 8. KDFS SS panel, SS handle 0--0 Corner block, RH 0-0-0 Handle, SS 0--0 Corner block, LH 0--0 Screw 0-8-0 Screw 7 0-0-07 Lockwasher 8 A990-00 Support bracket 9-099-0 Door gasket 0 0-0-0 Screw 0-88-0 Screw - hinge to cabinet 0-8-0 Hinge - top left/bottom right 0-0- Screw - hinge to door 0-8-0 Hinge 0-0-7 Screw A9-00 Door assembly, does not include door panel or hinges 7 0--0 Leg cap, pack of 8 0-87-07 Hole plug 9 0-7-0 Hinge package May 00 Page
Cabinet 0, 0 9 9 8 7 8 7 Item Part Number Number Description 0-0-0 Screw A9-00 Back panel A989-00 Utility routing bracket -- Snap bushing A99-00 Srv panel mntg bracket 0-90-0 Kickplate 7 0-0-8 Screw 8 0--0 Panel handle 9 A98-00 Service panel, SS 0 0-9-0 Bin edging 0-8-0 Screw A9-00 Top hinge brkt, RH SS A9-007 Top hinge brkt, L&RSS* a 0-8-0 Screw to fill holes -09-0 Gasket -09-0 Gasket strip 0--0 Insulation pad A9-00 Top panel, SS 7 0-0-8 Screw 8 A98-00 SS cabinet & bin 9 A98-00 Btm hinge brkt, L&RSS** 0 A8-00 Bin stat bracket/scoop hldr 0-9-0 Scoop A9-00 Service panel * changed / to add left and right hinge mounting. Painted parts no longer available. May 0 Page
Reservoir and Spray Pump 0, 8 7 Rotate item 90 degrees & lift to remove. 9 7 8 9 Reservoir Changed 8/ Item Number Part Number Description -98- ater pump, incl item a a 0-79-00 Fan blade for pump 0-79-0 Pump discharge hose 0-70- Spray nozzle, kit. Set of nozzles, o-rings, screws and nuts. 0-7-0 Spray platform 0-8-0 ater Tee -07- O-ring 7 0--0 Front bracket 8 0-89-0 Thumb screw 9 A97-00 Curtain 0 0-8-0 Clamp 0-08-0 Drain cap, not used after 8/ 0-8-0 Drain tube 0-7-0 Evap bracket, left 0-7-0 Evap bracket, right 0 March 07 Page 0-7-0 Grommet 0-7-0 Clip 7-07-0 O-ring 8 0-8-0 Barbed fitting 9 0-8-0 Spout 0 0-7-0 O-ring 0-7-0 Reservoir Item is a plastic cover that goes over the evaporator tubing and cups. It was added in 0. It is not shown. 0-7-0 Evaporator cover -080-0 Drain plug
Refrigeration System 8 9 7 Item Part Number Number Description A99-00 Suction line accumulator assy 0-7-0 Evaporator 8-877- Compressor Compressor includes overload, relay and drier a 8-877- Overload b 8-877- Relay 0-8-0 Clip 0-07-08 asher 8-700-8 Grommet 7 8-890-0 Condenser 8 0-90-0 Drier 9-0- Hot gas valve 9a -0- HGV coil,, July 00 Page
Under Bin Parts GRAVITY DRAIN MODELS ONLY 7 7 8 9 0 9 0 7 DRAIN PUMP MODELS ONLY 8 Item Part Number Number Description -990-0 Inlet water sol valve 0--0 Screw -0-0 Fan motor 0-97-0 Fan blade A9-00 Fan motor bracket A90-00 Fan shroud 7-0909-0 Gasket, order & cut to fit 8 0-0-0 Air baffle 9-00-0 Pressure switch 0 0-90-0 Spring -0- Pump & motor only 0-08-0 Leg leveler 0-87-8 Hole plug 0-8- Hose clamp 0--0 Drain hose 0-8-08 Hose clamp 7-07-0 Elbow 8 A9-0. Pump kit 9 A7-00 Discharge hose 0 0-0-0 Hose clamp 0--0 Elbow 0-7-0 Check valve 0-8- Hose clamp 0--0 Drain tube 0-0-0 Barbed connector 0-09-0 Switch hose 7 A970-00 Switch bracket September 009 Page
Control System Item Part Number Number Description 0--0 Graphic overlay -99-0 Power switch 0-8-0 Cover -98-0 Timer -00- Cube size thermostat -07- Bin thermostat Not Shown: NS -00-0 Hi voltage harness, lower NS -00-0 Hi voltage harness, upper Note: If replacing the lower harness always replace the upper one too. NS -8- Power cord April 0 Page 7
Schematic Diagram IF DRAIN PUMP IS INSTALLED L N DRAIN PUMP PRESSURE SITCH DRAIN PUMP SAFETY PRESSURE SITCH ON / OFF SITCH BIN LEVEL CONTROL COMPRESSOR CUBE SIZE CONTROL (INITIATE TIMER) HARVEST TIME ADJUSTABLE FROM 0 TO 00 SEC. FACTORY SET TO 70 SEC. NO NC C ATER PUMP FAN MOTOR TIMER ATER SOLENOID HOT GAS SOLENOID SITCHES ON THIS UNIT SHON IN TIMED PORTION OF THE FREEZE CYCLE ITH DRAIN PUMP IN OPERATION September 009 Page 8
iring Diagram BU IF DRAIN PUMP IS INSTALLED DANFOSS CUBE SIZE CONTROL COMM NC SAFETY NO PRESSURE SITCH R POER IN GN/Y ON-OFF SITCH EARTH GROUND PUMP MOTOR GN/Y GE CUBE SIZE CONTROL Y Y OFF ON BIN LEVEL CONTROL COMM NC BU / BU PUMP NO PRESSURE SITCH R C NC HOT GAS SOLENOID R FAN MOTOR TIMER BN DRAIN PUMP MOTOR ATER SOLENOID R/ RELAY - CURRENT OVERLOAD COMPRESSOR February 0 Page 9
SCOTSMAN ICE SYSTEMS 77 Corporate oods Parkway, Vernon Hills, IL 00 800--00 www.scotsman-ice.com 7--0