Document number: 1/5 Manufacturer or representative: OSRAM AG Address: Hellabrunner Straße 1 81543 München Germany Brand name or trade mark: Product type: Product designation: LED module LS_LRXXX-Linear Rigid See attached list The designated product(s) is (are) in conformity with the provisions of the following European Directives. 2006/95/EC 2004/108/EC 2009/125/EC 244/2009 245/2009 /65/EU Directive of the European Parliament and of the Council of 12 December 2006 on the harmonisation of the laws of Member States relating to electrical equipment designed for use within certain voltage limits Directive of the European Parliament and of the Council of 15 September 2004 on the approximation of the laws of the Member States relating to electromagnetic compatibility Directive of the European Parliament and of the Council of 21 October 2009 establishing a framework for the setting of ecodesign requirements for energy-related products Commission Regulation (EC) implementing Directive 2005/32/EC of the European Parliament and of the Council with regard to ecodesign requirements for non-directional household lamps Commission Regulation (EC) implementing Directive 2005/32/EC of the European Parliament and of the Council with regard to ecodesign requirements for fluorescent lamps without integrated ballast, for high intensity discharge lamps, and for ballasts and luminaires able to operate such lamps, and repealing Directive 2000/55/EC of the European Parliament and of the Council Directive of the European Parliament and of the Council of 8 June on the restriction of the use of certain hazardous substances in electrical and electronic equipment Further information regarding compliance with these Directives is given in the annex which constitutes a part of this declaration. Last two digits of the year in which the CE marking was affixed: Place and date of signatures: Signatures: Names: Quality Management Sgd Bernhard Schemmel Quality Management Q LAB Bernhard Schemmel Hellabrunner Str. 1 81543 München This declaration of conformity is issued under the sole responsibility of the manufacturer. It certifies compliance with the indicated Directives, but implies no warranty of properties. 1/5
Annex Document number: The conformity of the designated product(s) with the provisions of the European Directive 2006/95/EC is given by the compliance with the following European Standard(s) or other specifications. If not elsewhere/otherwise indicated the edition/amendment as referenced below applies. EN 60155: 1995 + A1:1995 + A2:2007 EN 60432-1: 2000 + A1:2005 EN 60432-2: 2000 + A1:2005 EN 60432-3: 2003 + A1:2005 + A2: EN 60598-1: + A11:2009 EN 60598-2-1: 1989 EN 60598-2-2: EN 60598-2-3: 2003 + A1: EN 60598-2-4: 1997 EN 60598-2-5: 1998 EN 60598-2-6: 1994 + A1:1997 EN 60598-2-7: 1989 + A2:1996 + A13:1997 EN 60598-2-8: 1997+ A1:2000 + A2: EN 60598-2-10: 2003 EN 60598-2-13: 2006 + A1: EN 60598-2-20: 2010 EN 60598-2-22: 1998 + A1:2003 + A2: EN 60968: 1990 + A1:1993 + A2:1999 EN 61195: 1999 EN 61199: Glow-starters for fluorescent lamps Incandescent lamps Safety specifications Part 1: Tungsten filament lamps for domestic and similar general lighting purposes Incandescent lamps Safety specifications Part 2: Tungsten halogen lamps for domestic and similar general lighting purposes Incandescent lamps Safety specifications Part 3: Tungsten halogen lamps (non-vehicle) Luminaires Part 1: General requirements and tests Luminaires Part 2-1: Particular requirements Fixed general purpose luminaires Luminaires Part 2-2: Particular requirements Recessed luminaires Luminaires Part 2-3: Particular requirements Luminaires for road and street lighting Luminaires Part 2-4: Particular requirements Portable general purpose luminaires Luminaires Part 2-5: Particular requirements Floodlights Luminaires Part 2-6: Particular requirements Luminaires with built-in transformers for filament lamps Luminaires Part 2-7: Particular requirements Portable luminaires for garden use Luminaires Part 2-8 : Particular requirements Handlamps Luminaires Part 2-10: Particular requirements Portable luminaires for children Luminaires Part 2-13: Particular requirements Ground recessed luminaires Luminaires Part 2-20: Particular requirements Lighting chains Luminaires Part 2-22: Particular requirements Luminaires for emergency lighting Self-ballasted lamps for general lighting services Safety requirements Double-capped fluorescent lamps Safety specifications Single-capped fluorescent lamps Safety specifications 2/5
EN 61347-1: + A1: EN 61347-2-1. A1:2006 + Corrigendum:2006 EN 61347-2-2: EN 61347-2-3: EN 61347-2-7: EN 61347-2-8: A1:2006 + EN 61347-2-9: A1:2003 + A2:2006 + EN 61347-2-10: A1:2009 + EN 61347-2-11: Corrigendum:2002 + EN 61347-2-12: 2005 + A1:2010 EN 61347-2-13: 2006 EN 61549: 2003 + A1:2005 + A2:2010 EN 62031: EN 62034: 2006 EN 62035: 2000 + A1:2003 EN 62471: EN 62493: 2010 EN 62532: EN 62560: XXXX EN 62776: XXXX Lamp controlgear Part 1: General and safety requirements Lamp controlgear Part 2-1: Particular requirements for starting devices (other than glow starters) Lamp controlgear Part 2-2: Particular requirements for d. c. or a. c. supplied electronic step-down convertors for filament lamps Lamp controlgear Part 2-3: Particular requirements for a. c. supplied electronic ballasts for fluorescent lamps Lamp controlgear Part 2-7: Particular requirements for battery supplied electronic controlgear for emergency lighting (self-contained) Lamp controlgear Part 2-8: Particular requirements for ballasts for fluorescent lamps Lamp controlgear Part 2-9: Particular requirements for ballasts for discharge lamps (excluding fluorescent lamps) Lamp controlgear Part 2-10: Particular requirements for electronic invertors and convertors for high-frequency operation of cold start tubular discharge lamps (neon tubes) Lamp controlgear Part 2-11: Particular requirements for miscellaneous electronic circuits used with luminaires Lamp controlgear Part 2-12: Particular requirements for d. c. or a. c. supplied electronic ballasts for discharge lamps (excluding fluorescent lamps) Lamp controlgear Part 2-13: Particular requirements for d. c. or a. c. supplied electronic controlgear for LED modules Miscellaneous lamps LED modules for general lighting Safety specifications Automatic test systems for battery powered emergency escape lighting Discharge lamps (excluding fluorescent lamps) Safety specifications Photobiological safety of lamps and lamp systems Assessment of lighting equipment related to human exposure to electromagnetic fields Fluorescent induction lamps Safety specifications Self-ballasted LED-lamps for general lighting services by voltage > 50 V Safety specifications Double-capped LED lamps for general lighting services Safety specifications 3/5
The conformity of the designated product(s) with the provisions of the European Directive 2004/108/EC is given by the compliance with the following European Standard(s) or other specifications. If not elsewhere/otherwise indicated the edition/amendment as referenced below applies. EN 55015: 2006 + A1:2007 + A2:2009 EN 61000-3-2: 2006 + A1:2009 + A2:2009 EN 61000-3-3: EN 61547: 2009 Limits and methods of measurement of radio disturbance characteristics of electrical lighting and similar equipment Electromagnetic compatibility (EMC) Part 3-2: Limits Limits for harmonic current emissions (equipment input current 16 A per phase) Electromagnetic compatibility (EMC) Part 3-3: Limits Limitation of voltage changes, voltage fluctuations and flicker in public low voltage supply systems, for equipment with rated current 16 A per phase and not subjected to conditional connection Equipment for general lighting purposes EMC immunity requirements 4/5
Attached list Document number: Test report ZRD 2860874 000 00 CE Test Reports LR_OM56 Modules Family code 10370920 List of products: LR18CP-OM056-L2050 LR28CA-OM056-L2050 LR18CE-OM056-L2050 5/5