Premium Electric Stove 2000W G PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE R AN T E UA 2 E G INSTALLATION & INSTRUCTION MANUAL Model: DEF979408 YEAR UA RANT EE
IMPORTANT: These instructions should be read carefully and retained for future reference. Quick Reference Guide 1. Make sure the power supply used corresponds to the rating label. 2. It is normal when the heaters are turned on for the first time or when they are turned on after not having been use for a long period of time the heaters may emit some smell and fumes. This will disappear when the heater has been on for a short while. 3. If the heater does not emit heat, consult your instruction manual for further information. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN NO USER-SERVICEABLE PARTS INSIDE HIGH TEMPERATURE KEEP ELECTRICAL CORDS,DRAPERY AND OTHER FURNISHINGS AT LEAST 1 METRE FROM FRONT OF THE HEATER AND KEEP THEM AWAY FROM THE SIDES OF HEATER WARNING RISK OF FIRE- KEEP COMBUSTIBLE MATERIAL AWAY FROM FRONT OF HEATER. SERVICING SHOULD BE DONE ONLY WHILE THE HEATER IS UNPLUGGED FROM POWER SUPPLY. CAUTION WHEN CHANGING BULBS REPLACE ONLY WITH E14 CLEAR,CANDLE TYPE(SCREW FITTING) RATING 220-240V, 4W LED FOR ALL LAMPS. Light Bulbs are not covered under warranty 1
Important When using electrical appliances, to reduce the risk of fire, electric shock and injury to persons, basic precautions should always be followed, including the following: 1. Read all instructions before use. 2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided use handle when moving this heater. 3. Keep combustible materials such as furniture, pillows, bedding, papers, clothes, and curtains at least 7cm away from the front of heater and keep them away from the sides of heater. 4. Extreme caution is necessary when any heater is used by or near children and whenever the heater is in operation and unattended. 5. Always unplug the heater when not in use. 6. Do not operate any heater with damaged cord or plug or after the heater has malfunctioned or has been dropped or damaged in any manner. Return heater to an authorised service facility for repair. 7. Do not use outdoors. 8. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heaters where it may fall into a bathtub or other water container. 9. Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the like. Arrange cord away from traffic areas and where it will not be tripped over. 10. To disconnect heater, turn control to off, then remove plug from outlet. 11. Connect to properly grounded outlet only. 12. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater. 13. To prevent a possible fire, do not block air intake or exhaust in any manner. 14. Do not use near soft surfaces, like a bed, where openings may become blocked. 15. A heater has hot and arcing parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used or stored. 16. Use this heater only as described in manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. 17. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. 18. Do not strike the heater glass. 19. Always use properly grounded, fused and polarized outlets. 20. Always disconnect power before performing any cleaning or maintenance, or relocation of the heater. 21. When transporting or storing the heater keep in a dry place, free from excessive vibration and store so as to avoid damage. 22. A motor powers the flame effect and it is normal for the motor to make some noise as it slowly rotates and helps to create the beautiful 3D flame effect. Some rooms have more or less furnishings than others resulting in varying noise amplification. 23. Whilst every effort is made to ensure packing materials are kept outside of the plastic bag that covers your heater in the box, there is a remote chance that some packing may lodge itself in the heater part of the unit. If you notice this on close inspection, please remove it. When turning your heater on for the first time it is normal for the heater to emit a little new heater smell which quickly pass. 24. You may notice some light coming from under or from the sides of the unit. This is normal and the holes allow the unit to breathe. Do not attempt to block these holes. 25. This heater is to be used on a 220 / 240 V, 8 AMP, grounded circuit. Do not use in an outlet controlled by a switch or dimmer switch. Avoid plugging other appliances into the same circuit as heater. 26. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. 2
Instructions Flame effect / Light bulb replacement Caution! Bulbs will become very hot; allow at least 10 minutes for bulbs to be cool before touching The flame effect on this electric stove heater is created by two 4 watt LED bulbs with an E14 (small) socket base. Only use this type of light bulb. To service light bulbs, unplug power cord from outlet, locate access panel on back of stove. Remove screws and panel. Light bulbs may come loose or may be damaged during shipping. If flame effect does not work properly, check to be certain that both bulbs are finger tight and are in working order. Replace light bulbs as needed. Replace access panel. Do not operate with out access panel in place. Do not remove back cover of heater, as there are no serviceable parts. Controls / Operation On the top right of the unit you will see the control panel, which includes 3 switches and 2 adjustors; namely, one on/off switch, two heater switch, one dimming adjustor and one thermostat adjustor. PLUG REPLACEMENT If the plug is damaged and requires replacement, follow the wiring instructions supplied with the new plug. The green and yellow wire must be connected to the terminal marked with the letter E or the earth symbol. The blue wire must be connected to the terminal marked with the letter N. The brown wire must be connected to the terminal marked with the letter L. A 13 amp plug to BS 1363 must be fitted a 13 Amp fuse to BS 1362. * For your safety and protection, this unit is earthed through the power cord plug when plugged into a matching wall socket. If you are not sure whether the wall sockets in your home are properly earthed, consult a qualified electrician. Do not use plug adaptors or extension cords with this unit. Flame ON/OFF Switch: Turn on the first switch for 1000 watts heat and the second switch for 2000 watts of heat. Note the second switch will only work once the first switch has been turned on. 1000/2000W ON/OFF Switch: Turn on the first switch for 1000 watts heat and the second switch for 2000 watts of heat. Note the second switch will only work once the first switch has been turned on. Dimming Adjustor: Rotate this control to adjust the intensity of the flame. The flame intensity control can only be used when the switch is on. Temperature Adjustor: Rotate this control to adjust your individual temperature requirements. Once the desired temperature is achieved, the heat source will turn off. After reading safety instructions and this entire manual, be certain that the controls are in the off position. 3
Instructions 1. Dimming adjustor 2. Temperature Adjustor 3. Heat 2000W 4. Heat 1000W 5. On/Off Switch Temperature Limiting Control 1 2 3 4 5 This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature, (115 degrees Celsius) the heater will automatically turn off. To reset: Unplug unit from wall, wait for 5 minutes, plug back in and continue to use. Cleaning Turn heater OFF and unplug from outlet. Use a vacuum or duster to keep heat and vent area clean from dust and dirt. The exterior of the stove should be cleaned with a damp cloth or duster. Do not use abrasive cleaners, liquid sprays, or any other cleaner that may scratch the surface. Warranty This electric stove heater has a limited warranty for a period of 2 years from the date of purchase. The original dated sales receipt is required for all warranty claims. This warranty does not include the replacement of glass, legs, handles or light bulbs. The following will void this warranty: Damage caused from misuse, tampering or altering heater in any manner, damage from being used in the wrong power source, water damage, damage caused from heater being used outdoors, damaged caused from heater being used for extended periods of time, or damaged caused if heater is used in a commercial application. This heater is intended for residential use only. Not intended for primary heat source. 4
De Vielle, Unit 5, Northern Cross Business Park, North Road, Finglas, Dublin 11, Ireland TEL: +353 1 823 9200 EC Declaration of Conformity We herewith declare, De Vielle, Unit 5, Northern Cross Business Park, North Road, Finglas, Dublin 11, Ireland, that the following product complies with the appropriate basic safety and health requirements of the EC Directive based on its design and type, as brought into circulation by us. In case of alteration of the product, not agreed upon by us, this declaration will lose its validity Description: Model: Serial Number: Applicable EC Directives: Electric Stove DEF979408/BLT-999B-2.5 N/A EC Council Directive 2004/108/EC Tested according to: EN 55014-1 : 2006 EN 55014-2 : 1997+A1+A2 EN 61000-3-2 : 2006 EN 61000-3-3 : 2008 The crossed out wheelie bin symbol on this item indicates that this appliance needs to be disposed of in an environmentally friendly way when it becomes of no further use or has worn out. Contact your local authority for details of where to take the item for re-cycling. www.devielle.ie