professional the the the 2
from -- computer y 5 (page12) -- Quiet Design --does the sound of the compressor starting Rmany minute second minute second random to help avoid power surges RFP-- This protection feature will a ensure indoor emperature does not fall below freezingwhen your PTAC (which is can be switched off (please see page 9) feature off (see section U room temperature rises lit lit l keypad Fan Cforation ofthe u application by electric the run after the to 3
Amperage and voltage of the PTAC and branch circuit must match according to local cord. n VV V V Van- r 4
When units are shipped with a sleeve: We recommend always to use a Frigidaire sleeve. When units are shipped without a sleeve: Your product that spsthe inside air on side 5
Frigidaire RIGIDAIRE RIGIDAIRE GRILLE ing (see FrigidaireGE C,the actual baffle kit mlookimagen 6
ATION OF A FRIGIDAIRE PTAC INTO A FRIGIDAIRE WALL SLEEVE 8 9 0 1 2 10 8 11 9 12 7
the screw 13 FORDUCTED INSTALLATIONS ONLY 10 4 18 NOTE: Upward air direction should only be used on ducted installations. 4 15 8
the 10 4 16 17 /Energy Saver: Cooling /Energy Saver: Heating 4 1. 2. The dip adjust accordingly inorderto allow the wall t control of the unit. When in wall mode, the control panel will be disabled. 3*4.Energy Saverip Switches /Energy Saver This is the most efficient mode for electrical usage. 5*6. 7. the 9
V V SYSTEM CONFIGURATION KEYPAD CONFIGURATION Keypad Configuration You can customize your unit additionally using the keypad configuration options. To enter Keypad configuration Connect the unit to power. Press and hold the "fan speed" and the "V" for 5 continuous seconds, within 30 seconds of the unit being powered up. If the unit has had power for more than 30 continuous seconds, keypad configuration cannot be made. To scroll through the Keypad Configuration Options Press and release the "fan speed" to select the keypad configurations. The stored value will be displayed. To modify configuration settings Press and release the Setpoint " " or Setpoint " V " buttons. To exit Keypad Configuration Keypad Configuration will end on its own 30 seconds after the last button press or when the "mode" on the Keypad is pressed. There are 4 configuration options 1. Fahrenheit/Celsius Display Switch: Change between degrees Fahrenheit and Celsius on the display. An F indicates Fahrenheit display and 'C' indicates Celsius. Default is degrees F. 2. Indoor Air Temperature Sensor Biasing for Cooling mode: Sometimes known as an anticipator, the air temperature sensor bias is used to adjust the room air temperature reading when in cooling mode. (Not normally required.) 3. Indoor Air Temperature Sensor Biasing for Heating mode: Sometimes known as an anticipator, the air temperature sensor bias is used to adjust the room air temperature reading when in heating mode. (Not normally required.) 4. Indoor Temperature Display: Change between showing the setpoint or desired temperature during heating and cooling modes (SP) or displaying the actual room temperature during heating and cooling modes (AA). SP mode is the default mode. If SP is selected the desired setpoint temperature will be displayed during heating and cooling modes, regardless of what the actual temperature is in the room. If AA mode is selected, the room temperature will be displayed during heating, cooling and fan only modes. If the mode button has been changed to either heating or cooling modes, setpoint will be displayed for 10 seconds. After the 10 seconds, the room temperature will again be displayed. If the on/off button is depressed (when the unit is off ) and the last mode was either cooling or heating mode, the setpoint will be displayed for 10 seconds before displaying room temperature. During heating and cooling modes, if either the up or down setpoint key is depressed, the display will show the setpoint for 10 seconds. Then the room temperature will be displayed again. Switchover between Emergency Auto Cooling Allowed and Emergency Auto Cooling Rejected: Press " " or " V " to switch between the display of Emergency Auto Cooling Allowed and Emergency Auto Cooling Rejected. Emergency Auto Cooling Allowed: the diode displays CA. Emergency Auto Cooling Rejected: the diode displays CD. Auto cooling operation:, 10 2010 Electrolux Home Products, Inc. All rights reserved.
the 18 19 21 S19 control panel guard twolow fanhi fan L H on page 17 1
20 ncorrect 21 20 21 Frigidaireon- they errorthe cani 23 Table 5 STATUS LED Indicator Definitions 1 Indoor air temp sensor open/short 8-segment display F1, with STATUS light flash 1 times and off 3 sec, repeat 2 Indoor coil sensor open or short 8-segment display F2, with STATUS light flash 2 times and off 3 sec, repeat 3 Outdoor coil sensor open/short 8-segment display F4, with STATUS light flash 3 times and off 3 sec, repeat NOTE: When status 4 Freeze Guard protection 8-segment display FP light is flashing, it will 5 Indoor coil freeze protection STATUS light flash 5 times and off 3 sec, repeat be ON for 1 seconds 6 Outdoor coil high temp protection STATUS light flash 6 times and off 3 sec, repeat and OFF for another 7 Defrost (heat pump type) STATUS light flash 7 times and off 3 sec, repeat 8 Indoor coil high temp protection STATUS light flash 8 times and off 3 sec, repeat 1 seconds. 9 Thermostat wiring error STATUS light flash 9 times and off 3 sec, repeat 2
V "ON-OFF" unit. "mode" " " 4. "V" 5. "fan speed" It is used for setting high, medium, low or auto fan speed. The corresponding LED will be lit when selected. 6. "timer" It is used for setting timer function.
V OPERATION 7. Timer function (1) Timer ON: When the unit is off, timer ON can be set. Setting range is 0.5~24h. When timer ON time is reached, the system will operate according to the set mode. (2) Timer OFF: When the unit is off, timer OFF can be set. Setting range is 0.5~24h. When timer OFF time is reached, the system will stop operation. (3) Timer Setting: Press "timer" to set timer function and TIMER icon will be on. The time can be adjusted by pressing" " or "V" buttons. The range of timer setting is from 0.5h to 24h. 5 seconds after timer setting, the timer function will be activated and TIMER icon will be on. (4) Timer Preview: When timer function has been set, press "timer" to preview the remaining time of timer. (5) If Timer function has been set, turning on/off the unit or power failure will cancel timer setting. 4
from its sleeve inspect dirt can Product failure due to improper care or lack of maintenance is not covered by warranty 23 Product failure due to improper care or lack of maintenance is not covered by warranty o days (or sooner depending on application). 24 25 15
16
17
SAFETY PRECAUTIONS SAFETY PRECAUTIONS DANGER! Avoid Serious Injury or Death 1. Do not attempt to install air conditioner by yourself. 2. This air conditioner contains no user-serviceable parts. Always call an authorized Electrolux servicer for repairs. 3. When moving the air conditioner, always call an authorized Electrolux servicer for disconnection and re-installation. 4. Do not insert or place fingers or objects into the air discharge area in the unit. 5. Do not start or stop the air conditioner by unplugging the power cord or turning off the power at the electrical box. 6. Do not cut or damage the power cord. 7. If the power cord is damaged it should only be replaced by an authorized Electrolux servicer. 8. In the event of a malfunction (sparks, burning smell, etc.) immediately stop the operation, disconnect the power cord, and call an authorized Electrolux servicer. 9. Do not operate the air conditioners with wet hands. 10. Do not pull on the power cord. 11. Do not drink any water that is drained from the air conditioners. CAUTION! Avoid Injury or damage to the unit or other property 1. Provide occasional ventilation during use. Do not direct airflow at fireplaces or other heat related sources as this could cause flare ups or make units run excessively. 2. Do not place containers containing water on unit. 3. Turn off the air conditioner at the power source when it will not be used for an extended period of time. 4. Periodically check the condition of the unit s installation base for any damage. 5. Do not apply heavy pressure to the radiator fins of the units. 6. Operate the unit with air filters in place. 7. Do not block or cover the intake grille, discharge area and outlet ports. 8. Ensure that any electrical/electronic equipment is one yard away from the unit. 9. Do not use or store flammable gases near the unit. INSTALLATION WARNINGS 1. Carefully read the installation section of this manual before beginning. 2. Follow each step as shown. 3. Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only. 4. Pay attention to danger and safety notices. 18
MAJOR APPLIANCE WARRANTY Your appliance is covered by a limited one-year warranty and a limited 2-5 year warranty on the sealed system (the compressor, condenser, evaporator and tubing). For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions. From the second to the fifth year from your original purchase date, Electrolux will repair or replace any parts in the Sealed Refrigeration System (compressor, condenser, evaporator and tubing) that prove to be defective in materials or workmanship. The consumer will be responsible for diagnostic costs and any removal, transportation and reinstallation costs which are required because of service, costs for labor, parts and transportation other than with respect to the Sealed Refrigeration System. (this italic area appears inconsistent with the rest of the warranty where you indicate that you are responsible for repairing and replacing) Exclusions This warranty does not cover the following: 1. Products with original serial numbers that have been removed, altered or cannot be readily determined. 2. Product that has been transferred from its original owner to another party or removed outside the USA or Canada. 3. Rust on the interior or exterior of the unit. 4. Products purchased "as-is" are not covered by this warranty. 5. Service calls which do not involve malfunction or defects in materials or workmanship, or used other than in accordance with the provided instructions. 6. Service calls to correct the installation of your appliance or to instruct you how to use your appliance. 7. Expenses for making the appliance accessible for servicing, such as removal of trim, cupboards, shelves, etc., which are not a part of the appliance when it is shipped from the factory. 8. Service calls to repair or replace appliance light bulbs, air filters, water filters, other consumables, or knobs, handles, or other cosmetic parts. 9. Surcharges including, but not limited to, any after hour, weekend, or holiday service calls, tolls, ferry trip charges, or mileage expense for service calls to remote areas, including the state of Alaska. 10. Damages to the finish of appliance or facility incurred during installation, including but not limited to floors, cabinets, walls, etc. 11. Damages caused by: services performed by unauthorized service companies; use of parts other than genuine Electrolux parts or parts obtained from persons other than authorized service companies; or external causes such as abuse, misuse, inadequate power supply, accidents, fires, or acts of God. DISCLAIMER OF IMPLIED WARRANTIES; LIMITATION OF REMEDIES CUSTOMER'S SOLE AND EXCLUSIVE REMEDY UNDER THIS LIMITED WARRANTY SHALL BE PRODUCT REPAIR OR REPLACEMENT AS PROVIDED HEREIN. CLAIMS BASED ON IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO ONE YEAR OR THE SHORTEST PERIOD ALLOWED BY LAW, BUT NOT LESS THAN ONE YEAR. ELECTROLUX SHALL NOT BE LIABLE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SUCH AS PROPERTY DAMAGE AND INCIDENTAL EXPENSES RESULTING FROM ANY BREACH OF THIS WRITTEN LIMITED WARRANTY OR ANY IMPLIED WARRANTY. SOME STATES AND PROVINCES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSE- QUENTIAL DAMAGES, OR LIMITATIONS ON THE DURATION OF IMPLIED WARRANTIES, SO THESE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. THIS WRITTEN WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY ALSO HAVE OTHER RIGHTS THAT VARY FROM STATE TO STATE. If You Need Service Keep your receipt, delivery slip, or some other appropriate payment record to establish the warranty period should service be required. If service is performed, it is in your best interest to obtain and keep all receipts. Service under this warranty must be obtained by contacting Electrolux at the addresses or phone numbers below. This warranty only applies in the USA and Canada. In the USA, your appliance is warranted by Electrolux Major Appliances North America, a division of Electrolux Home Products, Inc. In Canada, your appliance is warranted by Electrolux Canada Corp. Electrolux authorizes no person to change or add to any obligations under this warranty. Obligations for service and parts under this warranty must be performed by Electrolux or an authorized service company. Product features or specifications as described or illustrated are subject to change without notice. USA 1.866.942.1567 Electrolux Major Appliances-North America 10200 David Taylor Drive Charlotte NC 28262 Canada 1.866.942.1567 Electrolux Canada Corp. 5855 Terry Fox Way Mississauga, Ontario, Canada L5V 3E4 2009 Electrolux Home Products, Inc. All rights reserved. 19
66129907342