The Appendix is an integral part of Certificate of Accreditation No. 104/2015 of

Similar documents
Schedule of Accreditation issued by United Kingdom Accreditation Service 2 Pine Trees, Chertsey Lane, Staines-upon-Thames.

CMZH Low Smoke 0-Halogen Flame- Retardant Mass Transit Tag

ZH Low Smoke 0-Halogen Flameretardant Identification Sleeves

ELSTA MOSDORFER- Energy Distribution with Competence

Traction Cable Radox 3 GKW

STS Directory Accreditation number: STS 0009

Schedule of Accreditation issued by United Kingdom Accreditation Service 2 Pine Trees, Chertsey Lane, Staines-upon-Thames, TW18 3HR, UK

Dry Corrosion. Test Cabinets. acstestchambers.com

Auto Technology Company Cyclic Corrosion Test Chamber

Dry Corrosion. Test Cabinets. acstestchambers.com

The Laboratory is qualified to update standards identifying the test procedures.

Technical Description. Salt Spray Test Chamber. System Weiss. Mat. No Type SC450

INTERNATIONAL STANDARD

Schedule of Accreditation issued by United Kingdom Accreditation Service 2 Pine Trees, Chertsey Lane, Staines-upon-Thames, TW18 3HR, UK

Tyco Electronics Solar Identification Labels

Corrosion Testing... also with Climate Control

The Laboratory is qualified to update standards identifying the test procedures.

SCOPE OF ACCREDITATION TO ISO/IEC 17025:2005

Corrosion Testing... also with Climate Control

Annex of the certificate (Page 1/5) Accreditation Scope

Internal Use Only INTERNATIONAL ASSOCIATION OF PLUMBING AND MECHANICAL OFFICIALS IAPMO GUIDE CRITERIA FOR

Lexan* Resin 121 Europe-Africa-Middle East: COMMERCIAL

Leather descriptions and technical informations

SCOPE OF ACCREDITATION TO ISO/IEC 17025:2005

INTERNATIONAL STANDARD

Scope of accreditation

Corrosion Testing... also with Climate Control

SCOPE OF ACCREDITATION TO ISO/IEC 17025:2005

USER MANUAL LEEC CLASSIC INCUBATOR. C100, C157 and C330

Schedule of Accreditation issued by United Kingdom Accreditation Service 2 Pine Trees, Chertsey Lane, Staines-upon-Thames, TW18 3HR, UK

Product Tests Report

TECHNICAL SPECIFICATION

Test procedure/ method name. method identification. Testing of industrial and explosion isolation valves and tank lining

SOUTH AFRICAN NATIONAL STANDARD

Evaluating the Effectiveness of VpCI-126

SALT SPRAY & CYCLIC CORROSION CHAMBERS

GUIDELINES FOR DESCRIBING THE ACCREDITATION SCOPES OF TESTING LABORATORIES

TABLE OF CONTENTS. 1.0 INTRODUCTION Scope References Test Specimen Description Summary 1

FIRE RESISTANT CABLES FP300

Transportation. Distribution

INTERNATIONAL STANDARD


This is a preview - click here to buy the full publication ICS ISBN

Product Specification Mono-Shape TM Mark II - 5mm Pitch I.D.C Connectors, For TAB Contacts - RAST5

OPERATION. Closed Operation. Open Operation. Closed Operation. Open Operation

Environmental testing of aerospace equipment

Optics & Radiometry Laboratory

INTERNATIONAL STANDARD

SCOPE OF ACCREDITATION

SCOPE OF ACCREDITATION TO ISO/IEC 17025:2005

SCOPE OF ACCREDITATION TO ISO/IEC 17025:2005. COLTS LABORATORIES, INC. 702 Stevens Avenue Oldsmar, FL Daryl Neely Phone: x204

FLEXIBLE CORRUGATED TUBE

CHEMICALS AND CONSUMER PRODUCTS

METAL PEDESTALS. By Actiu.

Test procedure/ method identification IP 100 (ISO 9096, ČSN EN )

DRAFT TANZANIA STANDARD

FT702LT Turbine control wind sensor gives durability a new meaning FT702LT. series

INTERNATIONAL STANDARD

POINT FLASHING BEACON PFB EX LED HAZARDOUS AREA CLASS I, DIVISION 2

Product Specification EMI Shielded Duplex LC Sealed Receptacle (ODVA Conforming)

EBS/ECS- SERIES SALT SPRAY CHAMBERS

600/1000V XLPE Insulated, LSZH Sheathed, Double steel tape Armoured Power Cables (3 Cores)

ISO INTERNATIONAL STANDARD. Fire protection Automatic sprinkler system Part 9: Requirements and test methods for water mist nozzles

STS Directory Accreditation number: STS 0021

This is a preview - click here to buy the full publication

Early Streamer Emission Lightning Rod REMOTE TESTING

Lexan* Resin 3412R Europe-Africa-Middle East: COMMERCIAL

ISO 9152 INTERNATIONAL STANDARD. Aerospace Bolts, with MJ threads, in titanium alloys, strength class MPa Procurement specification

Twin radial blower DRG 1200

THERMOPLASTIC - NYLON FLAT WASHERS AND SPACERS

INTERNATIONAL STANDARD

POINT HELIDECK LIGHTS PRL-LSM LED v4 LOW SURFACE MOUNT LIGHT

Nexus 120 DC Sounder Nexus 120 DC Sounder with 5J Xenon Beacon Nexus 120 DC Sounder with LED Beacon

Güntner Info. finoox technology. fin and tube heat exchangers. Tailor-made solutions!

INTERNATIONAL STANDARD

Twin radial blower DRG 730

Schedule of Accreditation issued by United Kingdom Accreditation Service 2 Pine Trees, Chertsey Lane, Staines-upon-Thames, TW18 3HR, UK

This document is a preview generated by EVS

fire resistant cables

DECLARATION OF PERFORMANCE ref. no

SOUTH AFRICAN NATIONAL STANDARD

INTERNATIONAL STANDARD

Terminal lugs for LV power cables with aluminum conductors

POINT HELIDECK LIGHTS PRL-LSM LED v4 LOW SURFACE MOUNT LIGHT

600/1000V SR Insulated Flexibles Control Cables (2-4 Cores & Multicores)

INTERNATIONAL STANDARD

Photovoltaic Cables EN H1Z2Z2-K

Schedule of Accreditation issued by United Kingdom Accreditation Service 2 Pine Trees, Chertsey Lane, Staines-upon-Thames, TW18 3HR, UK

INTERNATIONAL STANDARD

This annex is valid from: to Replaces annex dated: Location(s) where activities are performed under accreditation

4P75 CiTipeL Combustible Gas Sensor Part Number: PM

POINT ROLLOVER LIGHTS PRL LED HELIDECK SEMIFLUSH LIGHT

INTERNATIONAL STANDARD

INTERNATIONAL STANDARD

Quality Profile. Centurion. Scientific Limited

PERFORMANCE EVALUATION TEST REPORT. Rendered to: GREENFIELD MANUFACTURING COMPANY. PRODUCT: Hanger Screws

SCREEN DESIGN M-SCREEN 8501 COLLECTION INTELLIGENT FABRICS FOR SOLAR PROTECTION. Widths: Up to 320 cm

POINT ROLLOVER LIGHTS PRL LED HELIPORT INSET LIGHT

ISO INTERNATIONAL STANDARD. Road vehicles Four-pole electrical connectors with pins and twist lock Part 2: Tests and requirements

Industrial Tubes. TECTUBE _cips, TECTUBE _med [GB] KME Germany GmbH & Co. KG

Transcription:

Testing Laboratory locations: 1. Climatic and Corrosion Resistance Testing Laboratory 2. Material Testing Laboratory 3. Testing Laboratory of Camouflage Devices 1. Climatic and Corrosion Resistance Testing Laboratory 1 Determination of corrosion resistance or anti corrosion protection capacity in salt spray chamber: - by NSS method - by AASS method - by CASS method MPSZ01-01 (NSS (Neutral Salt Spray Test): ČSN EN ISO 9227 NSS, EN ISO 9227, DIN EN ISO 9227, ČSN EN ISO 7253, ČSN 34 5791-2-11, EN 60068-2-11, IEC 68-2-11, DIN IEC 68-2-11,BS 2011-2.1, ČSN EN 60068-2-52, ČSN EN 3027, ČOS 999905 method 309, IEC 60068-2-11 Test Ka, IEC 60068-2-52 Test Kb, EN 60068-2-52, ASTM B117, BS 3900-F4,ČSN EN 13523-8, FED-STD- 141, FED-STD-791 Meth. 4001.3, MIL STD-202 Meth. 101E, MIL STD-810 Meth. 509.4, AASS (Acetic Acid Salt Spray Test): ČSN EN ISO 9227, ASTM G85, CASS (Copper Accelerated Acetic Acid Salt Spray Test): ČSN EN ISO 9227, DIN EN ISO 9227, ASTM B368) Page 1 of 5

2 Determination of corrosion resistance or anti corrosion protection capacity in chamber with sulphur dioxide and common moisture condensation 3 Determination of effect of dry heat 4 Determination of effect of moisture condensation MPSZ01-02 (ČSN EN ISO 3231, ČSN ISO 6988, ČSN IEC 68-2-49, DIN 50018, EN ISO 6988, ISO 6988, EN ISO 3231, ISO 3231, BS EN ISO 3231, DIN EN ISO 3231, NF EN ISO 3231, IEC 60068-2-42, IEC 60068-2-49, DIN IEC 68-2-49, BS 3900-F8, BS 5466-8, ASTM G 87-84) MPSZ01-03/1 (ČSN EN 60068-2-2+A MPSZ01-03/2 (BS 3900, ČSN EN ISO 6270-1, ČSN EN ISO 6270-2, BS EN ISO 6270-1, DIN EN ISO 6270-1, EN ISO 6270-1, ISO 6270-1, NF EN ISO 6270-1, ČSN 03 8131, ČSN 03 8135, DIN 50017, MIL-STD-202 Method 104A, MIL-STD-810E) Page 2 of 5

5 Determination of effect of cold 6 Determination of effect of temperature variation 7 Determination of effect of - tests of military equipment resistance to climatic effects of the environment 8 Determination of coating thickness MPSZ01-03/3 (ČSN EN 60068-2-1+A1, IEC 60068-2-1, DIN IEC 60068-2-1, NF EN 60068-2-1/A1, BS EN 60068-2- MPSZ01-03/4 (ČSN EN 60068-2-14, BS EN 60068-2-14, DIN EN 60068-2-14, EN 60068-2-14, IEC 60068-2-14, NF EN 60068-2-14, ČSN IEC 68-2-33, ČSN 67 3098) MPSZ01-03/5 (ČOS 999905- method 302, 303, 304, 306) MPSZ01-04 (ČSN EN ISO 2808, BS EN ISO 2808, DIN EN ISO 2808, EN ISO 2808, ISO 2808, NF EN ISO 2808) 9 Cross-cut test MPSZ01-05 (ČSN EN ISO 2409, BS EN ISO 2409, DIN EN ISO 2409, EN ISO 2409, ISO 2409, NF EN ISO 2409), paints and paint systems, paints and paint systems Page 3 of 5

2. Material Testing Laboratory 101 Determination of mechanical properties by tensile strength test 102 Determination of flexural strength 103 Determination of impact energy by Charpy impact test 104 Determination of hardness by Vickers test 105 Determination of hardness by Brinell test 106 Determination of hardness by Rockwell test 107 Determination of material grain size by metallographic analysis 108 Determination of depth of decarburization 109 Determination of coating thickness 110 Determination surface texture by profile method MPSZ02-01 (ČSN EN ISO 6892- MPSZ02-02 (ČSN EN 843- MPSZ02-03 (ČSN ISO 148-1, Annex A and E) MPSZ02-04 (ČSN EN ISO 6507- MPSZ02-05 (ČSN EN ISO 6506- MPSZ02-06 (ČSN EN ISO 6508- MPSZ02-07 (ČSN EN ISO 643, ČSN EN ISO 2624, ASTM E 112) MPSZ02-08 (ČSN EN ISO 3887, ASTM E 1077) MPSZ02-09 (ČSN EN ISO 1463) MPSZ02-10 (ČSN EN ISO 4288, ČSN EN ISO 4287) Ceramic, glass Page 4 of 5

3. Testing Laboratory of Camouflage Devices The laboratory provides expert opinions and interprets test results. 301 Determination of spectral reflectance of 302 Determination of spectral reflectance of 303 Determination of colour coordinates and colour difference of material 304 Determination of colour coordinates and colour difference of material MPSZ04-01 (ČOS 108018 and ČOS 108016, Chapter 6.2 and 7.6, ČOS 108019 and ČOS 108017, Chapter 7) MPSZ04-02 (ČOS 108003, 2nd Issue, revision 4:2012 and ČOS 108001, Chapter 7.6) MPSZ04-03 (ČOS 108018 and ČOS 108016, Annex A, ČOS 108019 and ČOS 108017, Annex A) MPSZ04-04 (ČOS 108003, 2nd Issue, revision 4:2012) Camouflage and other for nonmilitary Camouflage and other for nonmilitary Camouflage and other for nonmilitary Camouflage and other for nonmilitary Note: MPZS - Testing Laboratory Methodological Procedure Page 5 of 5