40 Third Street Piqua, Ohio 4556-060 www.pumpagents.com PumpAgents.com - Click here for Pricing/Ordering SERIES: WPT SECTION 4C PAGE 5 ISSUED /0 REPLACES /0 SELF-PRIMING CENTRIFUGAL PUMPS For Perchlorethylene and Other.6 S.G. Fluids WPT5 Series WPTA Series WPT5X Series 60 HZ - PERFORMANCE AND SELECTION.6 FLUID S.G. - 0 RPM **Catalog number *AWPTA *WPTA 0WPT5 0WPT5 0WPT5 0WPT5A **Catalog No. with strainer X 0WPT5X X 0WPT5X 0WPT5X 0WPT5AX HP TAPPINGS GPM CAPACITY AT HEAD SHOWN / / / /4 -/ SUCT. DISCH. PSI FEET " " " " 0 4 4 4 8 6 7 8 4 44 5 7 7 6 47 58 7 80 40 0 8 4 55 68 78 0 6 5 6 5 5 6 8 64 74 0 7 0 4 4 58 70 87 5 5 0 6 6 5 66 84 00 40 57 8 8 44 57 80 80 45 64 0 0 4 48 74 44 7 0 7 66 55 78 4 55 60 86 40 65 0 **Catalog number **Catalog No. with strainer HP TAPPINGS L.P.S. CAPACITY AT HEAD SHOWN SUCT. DISCH. KPA METERS 6 4. 0 6.4 7 8.5 7 0. 06. 4 5. 75 7. 0.5 44.6 7.7 4 6. 448 8. *AWPTA *WPTA 0WPT5 0WPT5 0WPT5 0WPT5A X 0WPT5X X 0WPT5X 0WPT5X 0WPT5AX / / / /4 -/ " " " ".5.5... 4.6 5. 5..0.....6 4.4 5.0 5.8 8.8.8.8.0.7.4 4. 4. 5.6 8.5 0. 0..6.. 4.0 4.6 5.6 8.0..0.7.6 4.4 5.4 7. 0.6.6.. 4. 5. 6...7.7.5 5.0 5.0 0.6...0 4.6.7 0.6.4. 4. 0.7.5.4 0.5.5. ** Catalog numbers are for units with single phase motors. For three phase, add prefix, "". Example X. * Maximum suction lift on WPTA - 7 ft. A Crane Co. Company PUMPS & SYSTEMS
SECTION 4C PAGE 6 ISSUED /0 REPLACES /0 40 Third Street Piqua, Ohio 4556-060 END SUCTION CENTRIFUGAL PUMPS Compact, Close-Coupled Design Rugged Bronze-Fitted Cast Iron Construction Leakproof Mechanical Shaft Seal Non-Clogging, Bronze Semi-Open Impeller Stainless Steel Shaft Back Pull-Out Design For Easy Servicing FEATURES Available With or Without Built-In Basket Type Strainer Self-Priming, Once Case is Filled With Fluid Diaphragms, Flappers or Check Valves Are Not Required In Pump Suction Piping. But Are Recommended EVERY pump is factory tested and will meet Hydraulic Institute standards. MOTOR INFORMATION WPTA Series have NEMA Jet Pump Motors. WPT5 & WPT5X Series have rugged Swimming Pool type motors with oversize ball/ball bearing construction. All motors have open-drip proof construction and are rated with standard NEMA Jet Pump service factors for continuous duty operation at all ratings shown. Voltages may differ from some suppliers. Consult factory. Overload Protection: All single phase motors have built-in thermal overload protection. All three phase motors must be installed with a magnetic starter which provides full -leg protection. Failure to use correct starter and overloads will void motor warranty. All Single Phase Open Drip Proof Motors Are U.L. Recognized. RATINGS AWPTA-/ HP, Single Phase, 5V, 60Hz, 0RPM, ODP, Split Phase. WPTA-/ HP, Single Phase, 5/0V, 60Hz, 0RPM, ODP, Capacitor Start. WPTA-/ HP, THree Phase, 0/460V, 60Hz, 0RPM, ODP WPT5 & WPT5X Series: Single Phase: / thru HP, 5/0V, 60HZ, 0RPM, ODP, Capacitor Start. HP is 0V only. Three Phase: / thru HP, 0/460V, 60HZ, 0RPM, ODP. MATERIALS OF CONSTRUCTION ALL BRONZE Adapter Cast Iron Case Cast Iron Impeller Bronze Diffuser Cast Iron Shaft Stainless Steel Shaft Seal Carbon-Ceramic-S. Steel-Buna-N Suction Sleeve Viton Strainer Gasket Viton Strainer Basket Stainless Steel All Plugs Brass MAXIMUM OPERATING CONDITIONS TEMPERATURE (For Standard Buna-N Seal) INLET PRESSURE (WPT & WPT5) INLET PRESSURE (WPT5X) CASING WORKING PRESSURE (WPT & WPT5) CASING WORKING PRESSURE (WPT5X) 5 F (07 C) 00 PSI (60kpa) 5 PSI (0kpa) 65 PSI (7kpa) 60 PSI (4kpa) PUMPS & SYSTEMS A Crane Co. Company
40 Third Street Piqua, Ohio 4556-060 DIMENSIONS SECTION 4C PAGE 7 ISSUED /0 REPLACES /0 SERIES WPTA CATALOG AWPTA WPTA WPTA DIMENSIONS IN INCHES SINGLE PHASE THREE PHASE 5 5 / 7 7 /8 8 /8 5 / 8 /8 DIMENSIONS IN MILLIMETERS CATALOG SINGLE PHASE THREE PHASE AWPTA WPTA WPTA 8 00 All models have " NPT suction and discharge. SERIES WPT5 CATALOG 0WPT5 0WPT5 0WPT5 0WPT5A DIMENSIONS IN INCHES SINGLE PHASE THREE PHASE 5 7 /8 6 7 /8 7 /4 8 8 8 / 8 / 8 /8 0 /8 0 /8 0 5 /8 0 5 /8 5 5 /8 6 7 /8 6 7 /8 6 7 /8 7 /4 8 8 7 /4 /8 0 /8 0 /8 DIMENSIONS IN MILLIMETERS CATALOG SINGLE PHASE THREE PHASE 0WPT5 0WPT5 0WPT5 0WPT5A 40 48 48 46 46 0 8 8 57 57 6 6 6 48 48 48 48 All models have NPT suction and discharge. SERIES WPT5X 6 8 8 8 8 57 57 CATALOG X 0WPT5X X 0WPT5X 0WPT5X 0WPT5AX DIMENSIONS IN INCHES SINGLE PHASE THREE PHASE 0 /4 /4 /8 7 /8 7 /8 /8 /8 8 /8 0 /8 0 /8 0 5 /8 0 5 /8 0 / /4 /4 /4 /8 7 /8 7 /8 7 /4 /8 0 /8 0 /8 DIMENSIONS IN MILLIMETERS CATALOG SINGLE PHASE THREE PHASE X 0WPT5X X 0WPT5X 0WPT5X 0WPT5AX 57 55 56 58 58 5 5 0 8 8 57 57 6 6 55 55 55 56 58 58 All models have NPT suction and discharge. 6 8 8 8 8 57 57 A Crane Co. Company PUMPS & SYSTEMS
CSPP-64 - MOTORS RPM & HP PHASE FOR WT5 & WPT5 (Std) SERIES - OPEN DRIP PROOF 0 RPM Single Phase (ODP) 0 RPM Three Phase (ODP) 06 0 0 0 04 05 064 06 07 08 0 0 / /4 -/ / /4 -/ FOR WST5 (Std) SERIES - EXPLOSION PROOF 0 RPM Single Phase (XP) 0 RPM Three Phase (XP) 0655 05 055 057 05 0656 054 056 058 0 / /4 -/ / /4 -/ NOTE: Impeller must extend from face of frame as follows: Pumps with 0405 Diffuser - /64" 0405- Diffuser - / 0406 Diffuser - 5/64" Shim washers (Symbol 5) may be added or removed as required to obtain dimensions. SERIES: WT5, WPT5, WST5 SELF-PRIMING CENTRIFUGAL PUMPS File: WT5.dwg
SYMBOL QUANTITY DESCRIPTION SYMBOL QUANTITY DESCRIPTION 4 0805 0854 076 0764-C 08 4 Slinger Washer Mechanical Seal -Buna N - WT & WST (Std) Mechanical Seal -Viton - WPT (Std) Mechanical Seal- EPT + Cap Screw /8 x " Lg 087 0 00 0 Flat Gasket O-Ring Gasket - Buna N - WT5 & WST5 (Std) O-Ring Gasket - Viton - WPT5 (Std) O-Ring Gasket - EPT + O-Ring Gasket -Teflon 5 040-A-8 040-A- 040-A-4 040-A- 040-A 0408-A 0407-A 040-A-6 040-A-5 040-A- 040-A-4 040-A 0408-A 040-A-7 040-A-5 040-A- 040-A- 040-A 0408-A FOR SERIES WT5, & PHASE Impeller - 5WT5 Impeller - 7WT5 Impeller - 0WT5 Impeller - 5WT5 Impeller - 0WT5 Impeller - 0WT5A FOR SERIES WPT5, & PHASE Impeller - Impeller - Impeller - 0WPT5 Impeller - Impeller - 0WPT5 Impeller - 0WPT5A Impeller - 0WPT5A FOR SERIES WST5, & PHASE Impeller - X5WST5 Impeller - X7WST5 Impeller - X0WST5 Impeller - X5WST5 Impeller - X0WST5 Impeller - X0WST5A 0 4 5 045 0405 0405-0406 04 065 085 05 046 068 0854-A 04 047 5 4 046-A As Req. As Req. As Req. Pin Diffuser - ALL IRON S 0WT5A & 0WT5A 0WPT5A & 0WPT5A X0WST5A & X0WST5A Diffuser - & Diffuser - All Except Above Suction Sleeve - Buna N - WT5 & WST5 (Std) Suction Sleeve - Viton - WPT5 (Std) Suction Sleeve - EPT + Case Plug, /4-8 NPT Washer, /6 - & Washer,.0 Washer,.00" Washer,.005" Impeller (Omit Letter A) Plug, /4-8 NPT 6 7 8 045 045 045 045-4 Impeller Lock Nut Cap Screw /8 x -/4 Adapter - 0WT5A & 0WT5A & 0WPT5A & 0WPT5A X0WST5A & X0WST5A Adapter - All except Above CSPP-65 SERIES: WT5, WPT5, WST5 * Series WT5, WPT5 & WST5 pumps have been manufactured with either cast iron or bronze impellers as standard. All replacement impellers will be bronze as listed, unless iron is specified. For iron impellers, omit the letter "A" from part number. EXAMPLE: 040-8. ** Series WT5, WPT5 & WST5 pumps have been manufactured with either a flat or O-ring type gasket. Determine which type is required before ordering. When in doubt, order flat gasket. + For hot water or caustic service.
For technical advice or service please take your pump into your local pump service center. To order pump or parts or for pricing please go to the following links : Burks Pumps Home >> Burks Pumps stock list >>