IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed. These instructions should be saved for future reference: Read and familiarise yourself with all operating instructions before using this pie maker. Before plugging your unit into the mains, visually check that it is intact and has not suffered any transit damage. Check that the voltage indicated on the data plate corresponds with that of the local network before connecting the appliance to the mains power supply. Do not use this product with a programmer, timer, separate remote-control system or any other such device. Do not immerse this appliance in water or any other liquids. Cooking appliances should be positioned in a stable situation with the handles (if any) positioned to avoid spillage of liquids. DO NOT touch hot surfaces. Accessible surfaces are liable to get hot during use. Always use the handle. Oven gloves should be used whilst using the pie maker. Close supervision is required when using this appliance near children. Never leave this appliance within reach of children. This appliance shall not be used by children from 0 to 8 years. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Keep the appliance and its cord out of reach of children less than 8 years. Cleaning and user maintenance shall not be made by children. Do not leave the appliance unattended during use. Do not leave the appliance unattended whilst connected to the mains supply. Always use this appliance on a solid, level, non-flammable surface. Do not use this appliance outdoors. It is imperative to unplug the power cord after the appliance has been used, before it is cleaned and whilst being repaired. Regular, periodic checks should be carried out on the supply cord to ensure no damage is evident. Should there be any signs of damage
the appliance should not be used. If the supply cord is damaged it is to be replaced by a qualified person in order to avoid a hazard. Do not operate this appliance with a damaged plug or cord, after a malfunction or after being dropped or damaged in any way. Do not allow the mains cable to hang over sharp edges or come in contact with hot surfaces. Allow the unit to cool before storage. Never place the appliance near to flammable material or high pressure containers. This appliance is intended for household use only and should not be used for industrial purposes. Do not use any accessories or attachments with this appliance other than those supplied or recommended by supplier. Do not use this appliance for anything other than its intended use. Do not push objects into any openings as damage to the appliance and/or electric shock may occur. Ensure appliance is situated in an open area, do not allow it to come in contact with cupboards, curtains, wall coverings, clothing or other flammable materials. Unplug after each use. Grasp the plug, not the cord. Do not cover this appliance. Never place this appliance on an electric, gas, or any other type of hob. Ensure adequate ventilation whilst cooking foods that are prone to giving off smoke. Clean the ceramic plates with clean damp soft cloth do not use harsh abrasives or chemicals. WARNING: Do not attempt to move the pie maker whilst it is hot. WARNING: This appliance must be earthed. WARNING: Do not wrap the power cord around the appliance when storing.
Description of parts Ready to cook Indicator Power On Indicator Hinged Lid Handle Reversible Pastry Cutter Lid Locking Mechanism Your pastry cutter is double sided to cut both the top and the bottom of your pie crusts Ceramic Top Plate Deep Fill Ceramic Bottom Plate Lid Hinge (Approx 45mm)
Before the first time you use your Pie Maker Please read these operating instructions thoroughly and keep them in a safe place for future reference. Remove all packaging materials including in between the plates inside the Pie Maker. Before using, wipe the ceramic plates with a soft, clean, damp cloth. Close the Pie Maker and plug into a suitable wall socket and pre-heat for 10 minutes. Note You may notice some smoking coming from the Pie Maker during this initial phase, this is normal. Season the ceramic plates with vegetable oil and remove excess with kitchen towel. There is no need to season the plates again. Warning: Do not immerse the appliance, cord or plug in water. To remove any excess dust that may have accumulated during packing, wipe the exterior with a clean, soft, damp cloth. Do not use harsh or abrasive cleaners on any part of the appliance. Instructions for use Place your Pie Maker on a stable, level, non-flammable surface and place the pastry and filling. Close the cover and plug into a suitable wall socket, the red indicator will illuminate indicating that the appliance is powered on and is heating. In approximately 3-8 minutes the green indicator will illuminate. The green indicator will cycle on and off during the cooking process indicating that the correct cooking temperature is being maintained. Always keep the top cover closed when pre-heating or between uses. NOTE: All pie fillings, particularly meats should be precooked before placing in the Pie Maker
Cakes and Muffins 1. If making cakes or muffins fill the deep fill bottom plate directly until approximately 2/3 full unless your recipe states otherwise. Close the lid and press the locking mechanism until it clicks. 2. Set a timer for the specified time as indicated in your recipe, the green indicator will cycle on and off during the cooking process indicating a steady temperature is being maintained. 3. When the cooking time is complete unplug the Pie Maker from the wall socket. 4. Pull the locking mechanism up from the bottom and slowly open the lid. (if additional browning time is needed close the lid and set the timer for the desired additional time). 5. Carefully remove the cake or muffin from the deep fill bottom plate using a silicone or wooden spatula. Do not use metal utensils to avoid damaging the ceramic surface. Pies and Tarts 1. If making pies or tarts use the reversible pastry cutter to make the pastry casings. The larger side is for the pie base and the smaller size is for the pie lid. The larger side of the cutter will also cut slits into the pastry to allow easier folding into the deep fill plate. 2. Open the pie maker and place the pie base pastry into the deep fill bottom plate. You can use the bottom of a ladle or similar utensil to gently push the pastry into the deep fill plate. Warning: Surfaces are hot, never touch the cooking surface directly with your fingers. 3. Add your pie filling according to your recipe instructions, the weight of the filling will also help the pie base pastry to fully form in the deep fill plate. 4. If your recipe calls for a lid, cut the pastry with the smaller side of the pastry cutter and set in place 5. Close the Pie Maker lid and press the locking mechanism until it clicks. This will seal the pie lid to the base. 6. Set a timer for the specified time as indicated in your recipe, the green indicator will cycle on and off during the cooking process indicating a steady temperature is being maintained. 7. When the cooking time is complete unplug the Pie Maker from the wall socket. Pull the locking mechanism up from the bottom and slowly lift the lid 8. Carefully remove the pie from the deep fill bottom plate using a silicone or wooden spatula. Do not use metal utensils to avoid damaging the ceramic surface.
Electrical Connections This appliance is fitted with a fused three-pin plug to BS 1363. If the plug has to be removed, it should be cut off and carefully disposed of immediately. To avoid a possible shock hazard, do not insert the discarded plug into a mains socket. Fitting a new plug If for any reason you need to fit a new plug, the flexible mains lead must be connected as shown below. The wires in the mains lead fitted to this appliance are coloured in accordance with the following code: Brown wire = Live (L) Blue wire = Neutral (N) Green & Yellow = Earth (E) Connect Green & Yellow to Earth (E) Connect Blue to Neutral (N) Connect Brown to Live (L) Ensure the outer sheath is securely held by the cord clamp If colours of the wires in the mains lead of this appliance do not correspond with the coloured marking identifying the terminals in your plug, proceed as follows:the wire which is coloured Blue must be connected to the terminal which is marked with the letter N or coloured Black. The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Red. The wire which is coloured Green & Yellow must be connected to the terminal which is marked with the letter E or coloured Green.Before refitting the plug cover check that there are no cut or stray strands of wire inside the plug. Use a 13 Amp BS 1362 fuse, only BSI or ASTA approved fuses should be used. If you are in any way unsure which plug or fuse to use, always refer to a qualified electrician.
Note: After replacing or changing a fuse on a moulded plug which has a fuse cover, the cover must be refitted to the plug, the appliance must not be used without a fuse cover. Cleaning and maintenance Always unplug the Pie Maker from the mains power supply before cleaning. Allow the appliance to cool before cleaning. Do not clean any part of your Pie Maker in a dishwasher. Do not submerge any part of the main body, plug or mains cable in water or any other liquids. Wipe excess oil from the plates, with kitchen roll or similar. Wipe clean the outside of the main body and the ceramic plates with a soft damp cloth. Never clean any part of the pie maker with harsh or abrasive cleaners. Technical Data Voltage: 220-240V Rated Power 1000W Model Number SDA1078 Protection Class 1 (This appliance must be earthed) Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. Hairy Bikers is a Registered Trade mark. Produced and imported by Europasonic (UK) Ltd. Manchester M3 1JS www.europasonic.com