Instruction manual Steam ironing centre SDBC 3.5 A1.
GB English
1 8 9 2 10 11 12 7 6 5 4 3 22 21 20 14 15 25 23 16 26 26 24 17 24 27 19 18
GB 1 2 3 4 5 6 7 8 9 10 11 12 14 15 16 INDEX OF CONTENTS Foreword Intended use Safety instructions Contents of the box Product overview and technical data Accessories and information Problems solutions Costumer service Warranty and service Disposal PAGE 2 2 3 5 6 7 8 9 9 14 16 17 19 20 20 1
1. Foreword centre SDBC 3.5 A1. Please read this instruction manual and especially the safety instructions help For further information or any problem not covered in this manual, or failure to observe the information in the instruction manual. Importer Name: Pressure steam iron system SILVERCREST Model: SDBC 3.5 A1 herewith declares the conformity of the named steam iron with the Mr. Pierantonio Milanese rooms in due consideration of the instruction manual. 2
! contact your customer service centre. stored safely. not conform to this standard. who have reduced physical, sensory or mental capabilities, or who been provided with the appropriate instructions to use the equipment by a person responsible for their safety. assured if the product is in perfect condition. expert to ensure that it is safe. protects you and the appliance. Please consider also the total power and follow the safety instructions to ensure your safety. 3
Do not use it if the holes are blocked, it may overheat.! Danger of burning 1 intact safety cap 1. 1 contact. it may fall and hurt or burn somebody. 21 23 contact your costumer service centre. 2! 15 contact with water. 15 15 not by the cord itself. 15 boiler. 15 15 showers, bathtubs, washbasins or any other container. The contact switched off. 4
costumer service centre only. manufacturer declines any responsibility for any defect, which can be please contact an expert. ELECTRICAL CONNECTION (UK ONLY) 50 cycle AC supply by means of a three pin socket, suitably earthed and should be The appliance is supplied with a rewireable amp require replacement, it must be replaced with a fuse rated at amp and approved to BS62. outlet in your home or is removed for any other There is a socket outlet.! Warning: Check the completeness and intactness of the equipment after 23 2 b. Iron c. Iron cord holder 22 19 18 f. Instruction manual 27 Note: centre. 5
1 2 3 4 5 6 7 8 9 10 11 12 14 15 16 17 18 19 20 21 22 23 24 25 26 27 Safety cap Iron rest pad Main power switch Steam quantity selection knob Iron socket Temperature selection knob Steam button with lock slider Iron soleplate Power cord Power cord holder Iron cord Iron cord holder Steam station Wheels Eccentric rubber feet DVD Pressure: 3,5 bar Water capacity: 1,2 l 6
. 20. 20. 25. feet 26. Due to differences in thickness of the eccentric 26 22 in the steam unit. 14 steam unit 9. 22 21 Please always use the iron cord holder 22 21 2 7
! Warning: 1 unnecessary pauses. Note: 2 1 clockwise. 19 19 19 19 1 2 Hint: Fill the boiler completely before every use, so you can avoid 8
7 11 indicator 10 turns red. 10 4 the water level. 12 any residue from of the iron cord 21, the iron and the sole plate holes. old piece of tissue to catch the residues. 9. Ironing Note: In case of doubt, start with the lowest temperature. If any wrinkles textiles like you do on others.
MIN Start ironing: 7 5 7 15 with the second step in this chapter. 11 10 4 10 Dry ironing: Note: If you do not push the steam button 12 for 11 minutes you will hear a 12 12 10 indicator 4 looks like. Steam ironing Fabric MIN MAX turn MIN MAX turn until the middle Synthetic, Polyester, Polyamid, etc. MAX Do not use steam with this Water could drop out of the iron soleplate. 10
12 21 to be ironed, so that any condensed water still in the iron may be 8 Hint:! Warning: The permanent steam function should not be used whilst the iron is soleplate and you may burn yourself. 12 locked on. textiles.! Warning: the top downwards. centimetres far from the textile. 11
5 7 15 Note: the function switch 6. 20 6 to activate the suction mode. 20 surface 20. 6 no marks from the lower to the upper layer 12
6 Note: 7 only. If you do not push the steam button 12 for 11 minutes you can hear a 12 3 7 10 4 10. After ironing 2 board 20. 7 15 iron cord 14. Now you can store it. 16 15 round it. 22 25 away. Pay attention not to clamp the power cord 15. Storage: is folded.
! Warning: 15 Note: For this purpose follow below steps: The iron has not to be conneted. board.. 17. 18 2 1 several times carefully to dissolve the limescale deposits. 17 1 2 board. 14
The iron should be cleaned at least every 3 months. For this purpose follow below steps: 7 11 4 12 steam mode. 8 open. out of the iron soleplate. 15 15
Tipp: Machine wash at 40 C Do not bleach Do not tumble dry Iron at max temperature Due to the pressure put on the board with the iron, dust and other particles the permeability of the cover to air and steam can be year. Wash at 40 C without softener. resumed. If you need some accessories or more information please contact us at: 16
costumer service. A variety of possible problems and relevant solutions can be found here with explanations. PROBLEM REASON SOLUTION centre does not show any function. is not connected to the power switch 7. The iron does not show any function. function is activated. 14 connected to the iron socket 9. power switch 7. 14 iron socket 9. The iron soleplate does not heat up. The electric power supply is disconnected. centre in. is switched off. the main power switch 7. steam. The temperature 11 ter in the boiler. centre is not yet ready Turn the temperature 11 Fill up the tank with water. Wait until the steam ready indicator 4 Turn the steam selection knob 8 to a 17
PROBLEM REASON SOLUTION Water drops from the iron soleplate. The iron soleplate is dirty or it stains the clothes. Steam comes out of the iron permanently. Dirty water comes out of the iron. Steam comes out of the saftey cap 1. The temperature of the soleplate is too low or Condensed water remained in the iron cord 21, because you The lock slider on the steam button is activated. There is too much lime scale in the boiler or the iron. Some kind of addictive has been mixed to the water. The safety cap is not Check steam and tem Press the steam supply 12 steam. The steam button Press the steam button has been pressed for a only for a short time when needed. steam has been used for 1 12 12 Turn the temperature tu 11 Release the lock slider on the steam button. 12 12 Decalcify the boiler and the iron. Contact the costumer service. Close the safety cap correctly. Contact the costumer service. 1 18
based on above table, please contact the costumer service centre: 00800 387 693 539 please follow the steps below to remove the faulty part. 14 to remove it follow below steps: 15 centre has completely cooled down. 20. you need to replace it as described below: 20.
properly produced. Please keep your receipt as proof of purchase. please contact our costumer service centre. 2 Any fault that may be present at purchase has to be claimed within 2 weeks. Excluded from warranty are: 20
6812708.0 07/11 project 64425 6