115 Pump Solutions - From Showers to Whole House Stuart Turner has an engineering heritage dating back to 1906 and continues to manufacture from its original site in Henley-on-Thames. With an unrivalled reputation for quality and service, Stuart Turner can provide the pumping solution that is right for you, raising your daily shower to an invigorating and refreshing experience. The wide range of products provide solutions from single tap boosting and power showers, to complete bathrooms and whole home pressure systems. Systems, Pressure e and Pump types explained Twin pumps Tw win pumps are designed to boost both hot and cold water supplies equally. Positive or Negative System? Single pumps Single pumps are designed to boost single water supplies; hot, cold or pre-mixed. Universal Pumps Universal pumps operate in positive or negative head conditions and do not require e a gravity flow to start, incorporating both a pressure e and flow switch. The pump automatically starts when the pressure e switch detects a drop in pressure when an outlet is opened. The flow switch keeps the pump running as long as there is a sufficient flow of water. When the flow stops, the pump continues to run for 3 seconds allowing the system to re-pressurise. Standard Pumps Standard d pumps operate under positive head conditions only. A standard d pump is operated by a flow switch, automatically starting when a gravity flow of water greater than 0.6-0.8 ltrs/min through the outlet is detected. The pump will automatically stop when the outlet is closed and the flow ceases. Peripheral Pumps In a peripheral pump water is circulated culated and gains pressure around the periphery of the pump head. Peripheral pumps are compact and system friendly as they tolerate high hot water temperatures and air within the system to a greater extent than an equivalent centrifugal pump. They are ideal for applications where higher pressures with nominal flows are required. ed. Centrifugal Pumps A centrifugal pump draws water into the centre of the impeller where rotation throws the water out under force to generate pressure. e. Centrifugal pumps are designed to produce good flow at nominal pressure. Higher pressures are achieved by using multiple impellers within the same pump head, where the pressure generated by the first impeller is fed into a second impeller and so on, this is called staging. Larger Centrifugal pumps are therefore termed as multistage. Pump Assist - technical advice 0844 98 000 97 www.stuart-turner.co.uk.co.uk
116 Monsoon is a range of high performance brass pumps specifically designed to meet the demands of the power showering and home water pressure e boosting market. All Monsoon pumps are supplied with flexible hoses with integral isolating valves. Monsoon Universal Twin Monsoon Universal single U1.5 bar 46505 632.22 U2.0 bar 46498 451.26 U2.0 bar 46480 654.84 U3.0 bar 46413 462.57 U3.0 bar 46410 700.08 U4.5 bar 46414 473.88 U4.0 bar 46411 745.32 U4.5 bar 46412 790.56 Monsoon Standardd Twin Monsoon Standardd Single S1.5 bar 46506 456.91 S2.0 bar 46497 321.20 S2.0 bar 46415 479.54 S3.0 bar 46419 332.50 S3.0 bar 46416 536.08 S4.5 bar 46420 350.60 S4.0 bar 46417 581.32 S4.5 bar 46418 626.56 Monsoon Extra are high flow rate pumps designed for meeting power showering and pressure boosting demands in larger homes, leisure centres es and hotels. All Monsoon Extra pumps are supplied with flexible hoses with integral isolating valves. Monsoon Extra Universal Single Monsoon Extra Standard d Single U1.4 bar 46349 533.89 U2.6 bar 46593 544.81 S1.4 bar 46387 435.63 U3.6 bar 46594 599.40 U5.0 bar 46595 763.17 Showermate is a range of high quality plastic pumps which have been designed to boost the performance of shower and tap outlets within a bathroom and provides excellent value for money. All pumps are supplied with flexible hoses, with integral isolating valves on the inlets. Showermate Universal Twin Showermate Universal single U1.8 bar 46532 490.28 U2.6 bar 46534 374.92 U2.6 bar 46533 538.73 Showermate Standardd Twin Showermate Standardd Single S1.8 bar 46407 225.44 S2.6 bar 46429 195.78 S2.6 bar 46431 272.90 Showermate eco is a range of competitively priced compact designed pumps which provide the ideal solution to boost the performance of your shower. All pumps are supplied with flexible hoses, with integral isolating valves on the inlets. Showermate eco Standardd Tw win Showermate eco Standard d Single S1.5 bar 46502 159.91 S2.0 bar 46503 149.25 S2.0 bar 46500 213.21
117 Techflo qt centrifugal pumps use the most advanced multistage impeller ler and diffuser design which not only provides high pressure e and flow but also provides a whisper quiet operation when boosting the performance of a single shower, complete bathroom or whole house. Techflo qt are supplied with flexible hoses, with integral isolating valves on inlets. U2.3 bar 49080 564.44 U3.3 bar 49081 603.58 U2.3 bar 49082 413.03 U3.3 bar 49083 444.96 S1.3 bar 49074 253.38 S2.3 bar 49075 376.98 S1.3 bar 49077 238.96 S2.3 bar 49078 285.31 S3.3 bar 49076 440.84 S3.3 bar 46079 330.63 Techflo tp centrifugal shower pumps offer an affordable entry level solution for boosting the performance of a single shower. Techflo tp pumps are supplied with flexible hoses. S1.5 bar 49084 125.00 S2.0 bar 49086 120.00 S2.0 bar 49085 165.00 Flomate offers a simple patented solution to boost low incoming mains water pressure without the need for a cold water break tank and has been designed to operate within the current UK Water Regulations. Flomate Mains Boost Pump Flomate Mains Boost Pump will deliver an additional 1.5 bar pressure e to the existing mains pressure at a maximum flow rate of 12 litres per minute. The pump will start automatically when a flow rate of 0.6 litres per minute or more exists. Flomate Mains Boost Mains Boost Flomate Mains Boost Pump Extra 46574 335.00 Suitable for low occupancy properties with typically one bathroom Designed to connect directly to incoming mains Suitable for smaller properties, typically one bathroom Boosts incoming water pressure to 2.2 bar Delivers 12 litres/ minute flow rate No on-site commi ssioning required Flomate Mains Boost Extra will deliver up to 16 litres/minute flow at 3.0 bar pressure e to multiple outlets within the property, up to the preset cut-in limit of the 60 litre pressure e vessel, at which time the system will deliver 12 litres/minute until demand ends and the pressure vessel recharges. Flomate Mains Boost Extra Mains Boost Extra 60 Mains Boost Extra 100 46631 559.00 Mains Boost Extra 80 46634 649.00 46635 699.00 Mains Boost Extra 200 46636 999.00 Mains Boost Extra 300 46637 1099.00 Suitable for higher occupancy properties, with typically up to two bathrooms Designed to connect directly to incoming mains Suitable for larger properties with more than one bathroom Boosts incoming water pressure to 3.0 bar Delivers up to 40 litres/minute flow rate for a defined period No on-site commissioning required
118 The wasteflo range offers three macerators and a lifting station all designed with an innovative removable watertight cassette system, which houses the electrical and mechanical components. This cassette system allows for easy and clean access without having to remove any pipework or appliance when servicing or maintaining the product. Easy product selection 4 models satisfy all application requirements Suitable for domestic and commercial applications Innovative watertight cassette system Houses all mechanical and electrical components Easy and clean to maintain - no more dirty hands No need to r emove pipework or the appliance to service. Can be used in any envir onment Low noise levels - less than 60 db Powerful performance Macerators pump 5 m vertically or 52 m horizontally Lifting station pumps 7 m vertically or 72 m horizontally Super slim design ideal for converting any area into a simple toilet only. WC1 46626 325.00 Super slim design ideal for converting any area into a simple cloakroom oom with a toilet and basin. WC2 46575 375.00 Super slim design, ideal for transforming any area into a complete bathroom or en-suite, with a toilet, basin, shower or bath and even a bidet. WC3 46576 425.00 Allows you to create a shower/bathroom, oom, kitchen or utility room anywhere. A shower, bath, basin, sink, washing machine or dishwasher can all be connected. LS5 46577 390.00
119 When gravity flow is insufficient Wa769: 10s shower waste pump and auto gullies offer the perfect solution to quietly remove waste water from any shower, wet room or level access bathroom. Wasteflo shower waste pump and auto gullies ar e supplied complete with each of the following components, offering all you need for a variety of showering applications. Control Module accor% % ** /. 1(;&7* /. ;7-2 86;6 9) 5/0 10. (( system purge leaving the shower area drained Safety Extra Low V oltage Transformer 230AC - 24v DC supply IP 55 rated Variable Speed Pump Non-handed pump to ease installation Built-in non return valves 22 mm inlet & outlet Extracts up to 12 lires/minute Pumps up to 1 m vertically and 4 m horizontally Pump Cover White high gloss Easy clean Suitable for use in wet rooms Extracts up to 12 l/min 116 mm diameter gully 83 mm depth Stainless steel grate Tiled Floor 46597 475.00 Extracts up to 12 l/min 116 mm diameter gully 83 mm depth Chr ome plated grate V inyl Floor 46598 475.00 Suitable for low level shower tray Extracts up to 12 l/min 90 mm diameter gully 77 mm depth Chrome plated grate SWP - 90 mm 46599 450.00 Suitable for traditional step in shower tray Extracts up to 9 l/min 52 mm diameter gully 90 mm depth Chrome plated grate SWP - 52 mm 46600 450.00
161 120 Submersible Pumps These pumps offer fer a compact design which is ideal for general purpose applications where e space is at a premium. They are ideal for pumping rain water, dirty or waste water and include an integral float switch which can be set to either automatic or manual modes. 150VA = 6.5 m head or max flow 150 l/min 0V VA = 8.5 m head or max flow 250 l/min 150VA 46538 93.26 250VA 46539 105.06 Flood Kit 46638 165.00 This pump comes complete with a float switch and is ideal for use in clean water, rain water, waste water or pond applications. 230A = 8.3 m head or max flow 230 l/min Supersub 230A 46540 128.67 These pumps are supplied complete with a float switch and are capable of handling semi-solids in suspension of up to 20 mm in diameter. They are suitable for dirty water applications and are ideal for ponds with large gravity fed filter systems, where e the pump can be incorporated in the filter. 140A = 5 m head or max flow 140 l/min 240A = 7.4 m head or max flow 240 l/min Supervort 140A 46541 116.86 240A 46542 128.67 These pumps are ideal for applications where e pressure e is needed, such as sprinklers or pumping up to storage tanks. Diver 35 = 34 m head or max flow 88 l/min Diver 45 = 42 m head or max flow 94 l/min Diver Diver 35 46585 181.41 Diver 45 46586 211.12