Technical Application Guide for UP-SHINE LED Panel Light UP-PL33-18W
Introduction Up-shine led panel adopts high lumen SMD LED with CRI >8.The ultra slim profile fits seamlessly into any work place. It is available in various installation ways: embedded into ceiling, suspended with hanging wires, surface mounted in a concrete ceiling by using surface mounting frame. Up to 8% energy saving compared to standard CFL Long lifetime of 4, hours 12 wide beam angle CCT: 3K 4K 5K 57K No UV/IR light Environment friendly, without Mercury or any other hazardous substances Application notes IP4 for indoor use only Professional electrician for installation only Switch off before installation Do not touch when in use Keep away from hot steam and corrosive gas Application Areas Office & school lighting: office room, meeting room, class room etc. Commercial lighting: shopping mall, super market, retailer shops etc. Other situations: hospital, laboratory, dust-free workshop etc. Certificates
Product Information 295 295 1 Technical Specifications Model Voltage Power Power Factor Lumen (±5%) Beam angle CCT Lifespan CRI Dimmable Dimension UP-PL33-18W AC1-24V 18W.9 123 12 o 3K 4h 8 No 295*295*1mm UP-PL33-18W AC1-24V 18W.9 13 12 o 4K 4h 8 No 295*295*1mm UP-PL33-18W AC1-24V 18W.9 132 12 o 5K 4h 8 No 295*295*1mm UP-PL33-18W AC1-24V 18W.9 134 12 o 57K 4h 8 No 295*295*1mm Driver data Sheet Driver data Non-dim Input rated Voltage Frequency Input Voltage AC1-24V 5/6Hz AC85-265V Efficiency 86% Total load Wattage 18W±1W Power Factor.9 Rated input current Full load output Voltage Rated output current Output current range.2a DC29-33V 55mA 55mA±5% Power tolerance ±5% Current output tolerance ±5% Dimming range Dimmer Short circuit protection Over voltage protection Over temperature protection Withstand voltage PASS PASS PASS AC375V Fixture Compatibility Rated Wattage Electrical Classification Ingress Protection Operating Temp Operating Humidity Storage Temp 18W Ⅱ IP4-2 o C~45 o C ~9% -2 o C~65 o C
Spectral Distribution 3K 4K.8 Max=5338 [1.=2] 3.5SDCM F3K.8 Max=7171 [1.=2] 2.12SDCM F4K.7.7.6.6.5.4.3 x=.4464 y=.449.5.4.3 x=.3841 y=.3816.2.2.1.1. 38 5 6 7 8. 38 5 6 7 8 5K 57K.8 Max=8841 [1.=2] 5.5SDCM F5K.8 Max=8627 [1.=2] 2.12SDCM F57K.7.7.6.6.5.4.3 x=.3464 y=.379.5.4.3 x=.3841 y=.3816.2.2.1.1. 38 5 6 7 8. 38 5 6 7 8 Photometric Diagram 3K 4K -12-9 -/+18 9 12 9 MH=1m C/18 C9/27 Flux out: 857.8 lm 3.281ft 1.7, 37.42fc 1m 115.2, 42.8lx 6.562ft 2.675, 9.355fc 2m 28.79, 1.7lx 1.1ft 37.79cm 2.2ft 615.58cm -12-9 -/+18 9 12 9 MH=1m C/18 C9/27 Flux out: 942. lm 3.281ft 11.31, 4.65fc 1m 121.7, 437.5lx 6.562ft 2.826, 1.16fc 2m 3.42, 19.4lx 1.11ft 38.9cm 2.22ft 616.17cm 18 9.843ft 1.189, 4.158fc 3m 12.8, 44.75lx 3.29ft 923.37cm 18 9.843ft 1.256, 17fc 3m 13.52, 48.62lx 3.32ft 924.26cm 27 27 36 13.12ft.6687, 2.339fc 4m 7.197, 25.17lx 4.39ft 1231.16cm 36 13.12ft.766, 2.541fc 4m 7.66, 27.35lx 4.43ft 1232.34cm 45-3 3 AVERAGE BEAM ANGLE(5%): 114. DEG.9.45-25 -2-15 -1-5 5 1 15 2 25 16.4ft.4279, 1.497fc 5.49ft 5m 4.66, 16.11lx 1538.96cm Height Eavg, Emax Angle: 113.97deg Diameter 45-3 3 AVERAGE BEAM ANGLE(5%): 114. DEG.9.45-25 -2-15 -1-5 5 1 15 2 25 16.4ft.4522, 1.626fc 5.54ft 5m 4.868, 17.5lx 154.43cm Height Eavg, Emax Angle: 114.deg Diameter 5K 57K -12-9 -/+18 9 12 9 MH=1m C/18 C9/27 Flux out: 118 lm 3.281ft 13.29, 47.67fc 1m 143.1, 513.2lx 6.562ft 3.324, 11.92fc 2m 35.77, 128.3lx 1.19ft 31.63cm 2.38ft 621.26cm -12-9 -/+18 9 12 9 MH=1m C/18 C9/27 Flux out: 93.5 lm 3.281ft 11.17, 4.9fc 1m 12.2, 431.5lx 6.562ft 92, 1.2fc 2m 3.5, 17.9lx 1.16ft 39.56cm 2.31ft 619.12cm 18 9.843ft 3m 1.477, 5297fc 15.9, 57.2lx 3.57ft 939cm 18 9.843ft 1.241, 4.455fc 3m 13.36, 47.95lx 3.47ft 928.68cm 27 27 36 13.12ft.839, 2.98fc 4m 8.944, 3lx 4.77ft 1242.52cm 36 13.12ft.698, 2.56fc 4m 7.513, 26.97lx 4.62ft 1238.25cm 45-3 3 AVERAGE BEAM ANGLE(5%): 114.3 DEG.9.45-25 -2-15 -1-5 5 1 15 2 25 16.4ft.5318, 1.97fc 5.96ft 5m 5.724, 2.53lx 155cm Height Eavg, Emax Angle: 114.45deg Diameter 45-3 3 AVERAGE BEAM ANGLE(5%): 114.3 DEG.9.45-25 -2-15 -1-5 5 1 15 2 25 16.4ft.4467, 1.64fc 5.78ft 5m 4.88, 17.26lx 1547.81cm Height Eavg, Emax Angle: 114.27deg Diameter
Polar Diagram Comparison -15 O +/-18 O 15 O -12 O 12 O -9 O 9 O 11 22-6 O 33 6 O 44-3 O 55 3 O O AVERAGE BEAM ANGLE (5%): 114.4DEG C/18, 114.4 deg C3/21, 114.1 deg C6/24, 114.3 deg C9/27, 114.6 deg Driver lifetime & LED light decay rate Driver Lifetime LED Light Decay Rate 9 11%.4 Lifetime (hours) 8 7 6 5 4 3 2 1 65 o C 75 o C 85 o C 95 o C 15 o C Capacitor Tc ( o C) % Luminous Flux 15% 1% 95% 9% 85%.35.3.25.2.15 8% 75% FLUX.1.5 U'V' 7%. 1 2 3 4 5 6 7 8 9 1 LifeTime (hours) Temperature The testing is operated at 25 C The lifetime of capacitor, minimum of 5, hours if operated at 15 C, will be doubled whenever the temperature drops 1 C The highest withstand temperature of IC, MOS could be 12 C The highest withstand temperature of LED junction temperature is 15 C 8 Temperature ( o C) 7 6 5 4 3 2 1 14:29:22 15:2:16 16:11:16 17:2:16 17:53:16 18:44:16 19:35:16 2:26:16 21:17:16 22:8:16 22:59:16 23:5:16 :41:16 1:32:16 2:23:16 3:14:16 4:5:16 4:56:16 5:47:16 6:38:16 7:29:16 8:2:16 Time The driver lifespan is based on capacitor working temperature. IC Capacitor MOS PCB Fitting Voltage transformer Environmental temperature
Installation 1.Recessed into ceiling 1. Remove ceiling plaster slab 2. Connect power supply 3. Fix the panel light into right place 4. Stabilize the panel 2. Suspending 1. A.Fix the anchor into target place on the ceiling B.Fix the installation mount on the ceiling with plastic anchor 2. Hang the panel to ceiling with suspended installation kits 3. Adjust the length of steel wire. Connect the power supply 3. Surface mounted 1. Fix the frame on the ceiling with screw 2. Pull down the side frame 3. Push the panel into the frame, connect the driver 4. Install the side frame 5. Turn on the power switch, finish the installation Packaging Information SIZE(CM) N.W/pc (KGS) G.W.(KGS) Q'TY(PCS) Carton 35.5*33*43.5 1.4 8.6 5 CTNS Q'TY(PCS) VOLUME(CBM) 2'' standard container 4'' standard container 535 2675 28 17 535 56 Phone: +86 755 2919 7389 Add: 2nd building Dingfeng High-Tech Zone, Fuyuan 1st road, Fu Yong Sub-district, Bao'an, Shenzhen China