B 177/178, GIDC Electronics Estate, Sec-25, Gandhinagar-382024 (Under STQC Programme, DIT, Ministry ofcomm. & Infonnation Technology, Govt. ofindia) REPORT NO.: EQP/G0204/0304/2012 Page 1 00 TEST REPORT Service Request Form No. SRFDate: Date of Issue: G0204/2012 16/03/2012 30/03/2012 Name & Address ofthe Customer Mis. Raychem RPG Limited, Ceta Mahal Annexe, 463, Dr.Annie Besant Road, Worli, Mumbai. DESCRIPTION/ IDENTIFICATION OF THE ITEM Nomenclature Junction Box (Dimension 123x78mm) MakelModel No. Raychem /- Serial No. l?qdcg/1641 Quantity/ No. of samples 01 Date ofreceipt ofitem 16/03/2012. Date ofcompletion oftest 19/03/2012 Condition ofequipmentlmaterial on receipt. Good Location where test is performed LAB, EQDC- Gandhinagar Test Specification With reference to IS/IEC 60529: 2001 Clause No. 13.4, 13.6.2, 14.2.7, 14.3 Test facilities used: Nomenclature Make/Model Serial Number Calibration Due Date 1J Dust Chamber C.K. Enterprise/- EQDCG/0203 01/12/2012 2] Water Tank EQDC/- EQDCG/WT-01 - Prepared by:.~j---- Form No.: T/2/GEN.,Issue No: 03, Rev-OS, Dated. 03.11.10
.'''.'''~ - -, ELECTRONICS AND QUALITY DEVELOPMENT CENTRE B 177/178, GillC Electronics Estate, Sec-25, Gandhinagar-382024 (Under STQC Progranune, DlT, Ministry ofcomm. & lnfonnation Technology, Govt. oflndia) REPORT NO.: EQP/G0204/0304/2012 Page 2 of3 TEST RESULT Sr. Test No. Parameters 1 IP6X: (Dust-tight Test) Test Method /Requirement Observations Remarks Ensure the degree of protection provided by the enclosure against penetration of dust by using following test. The EDT is supported in its normal operating position inside the test chamber in which talcum powder is maintained in suspension. The duration ofthe test is eight hours. The protection is satisfactory if no deposit of dust is observable inside the enclosure at the end of the test. After the test no dust found inside the EDT. 2 IPX8: (Temporary Immersion in water Test) Ensure the Degree of Protection provided by the enclosure against water by using following test: Method The EDT is completely immersed in the water. The surface ofthe wilier shall be at least 150 mm above the highest poin(ofthe item. The lowest portion of the item shall be at least 1 meter below the surface ofthe water. The duration ofthe test is Ihr. The water temperature shall not differ from that of the item by more than 5 C. After completion of test the item shall be removed from the water and visually examined for the ingress of water inside the item. Requirement Ingress ofwater shall not be sufficient to interfere the satisfactory operation ofthe equipment. No water found inside. the EDT. I Prepared by: &~ Form No.: T/2/GEN.,Issue No: 03, Rev-OS, Dated 03.11.10
B 177/178, GIDC Electronics Estate, Sec-25, Gandhinagar-382024 (Under STQC Programme, DlT, Ministry ofcomrn. & Infonnation Technology, Govt. ofindia) REPORT NO.: EQPJG0204J0304J2012 Page 3 of3 Remarks: 1) EUT: - Equipment under Test. 2) Holograms having Sr. No. 013570 to 013572 affixed on each page oftest report. NOTE: 1. This report refers only to particular item(s)l equipment(s) submitted for testing. 2. This report shall not be reproduced except in full without the written approval from Director, EQDC (Gandhinagar). 3. The test results reported are valid at the time of and under the stated condition of measurement. 4. Only the test asked for by the party have been carried out. 5. Any anomalies/ discrepancies in this report should be brought to 0 from the date of issue of this re ort. Prepared by: ~ Officer In-CHarge Customer Service Celt
B 177/178, GillC Electronics Estate, Sec-25, Gandhinagar-382024 (Under STQC Progranune, DIT, Ministry ofcomm. & Infonnation Technology, Govt. ofindia) REPORT NO.: EQP/G0214/0314/2012 Page 1 of3 TEST REPORT Service Request Form No. SRFDate: Date ofissue : G0214/2012 20103/2012 30103/2012 Name & Address ofthe Customer Mis. Raychem RPG Limited, Ceta Mahal Annexe, 463, Dr.Annie Besant Road, Worli, Mumbai. DESCRIPTIONI IDENTIFICATION OF THE ITEM Nomenclature Junction Box (Dimension 123x78mm) MakelModel No. Raychem 1--. Serial No. EQDCGI1642 Quantity/ No. of samples 01 Date ofreceipt ofitem 2010312012 Date ofcompletion oftest ~ 23/03/2012 Condition ofequipmentlmaterial on receipt Good. Location where test is performed LAB, EQDC- Gandhinagar Test Specification With reference to IS/IEC 60529: 2001 Clause No. 13.4, 13.6.2, 14.2.7, 14.3 Test facilities used: Nomenclature MakelModel Serial Number Calibration Due Date 1] Dust Chamber C.K. Enterprise/- EQDCG/0203 01112/2012 2] Water Tank EQDCI- EQDCGIWT-01 -- Prepared by: ~J--- Form No.: T/2/GEN.,Issue No: 03, Rev-OS, Dated 03.11.10
B 177/178, GIDC Electronics Estate, Sec-25, Gandhinagar-382024 (Under STQC Programme, DIT, Ministry ofcomrn. & Infonnation Technology, Govt. ofindia) REPORT NO.: EQP/G0214/0314/2012 Page 2 of3 Sr. No. Test Parameters IP6X: (Dust-tight Test) (Dimension 123x78mm) 2 IP X8: (Temporary Immersion in water Test) (Dimension 123x78mm) TEST RESULT Test Method /Requirement Observations Remarks Ensure the degree of protection provided by the enclosure against penetration of dust by using following test. The EUT is supported in its nonnal operating position inside the test chamber in which talcum powder is maintained in suspension. The duration of the test is eight hours. The protection is satisfactory if no deposit of dust is observable inside the enclosure at the end of the test. Ensure the Degree of Protection provided by the enclosure against water by using following test: ~ Method water. The EUT is completely immersed in the The surface of the water shall be at least 150 mm above the highest point of the item. The lowest portion of the item shall be at least 1 meter below the surface of the water. The duration of the test is Ihr. The water temperature shall not differ from that ofthe item by more than 5 C.. After completion of test the item shall be r~moved from the water and visually examined for the ingress of water inside the item. Reguirement Ingress of water shall not be sufficient to interfere the satisfactory operation of the equipment. After the test no dust found inside the EUT. No water found inside the EUT. Prepared by: ~ Form No.: T/2/GEN.,Issue No: 03, Rev-OS, Dated 03.11.10
~\\ yd ~~. g' ELECTRONICS AND QUALITY DEVELOPMENT CENTRE B 177/178, GlDC Electronics Estate, Sec-25, Gandhinagar-382024 (Under STQC Programme, DlT, Ministry ofcornm. & Information Technology, Govt. ofindia) REPORT NO.: EQP/G0214/0314/2012 Instrument Photographs E(!)<~C.... c,i Page 3 of3 " Remarks: 1) EUT: - Equipment under Test. 2)Holograms having Sr. No. 013567 to 013569 affixed on each page of test report. PrepMedby: ~ NOTE: I. This report refers only to particular item(s)/'equipment(s) submitted for testing. 2. This report shall not be reproduced except in full without the written approval from Director, EQDC (Gandhinagar). 3. The test results reported are valid at the time ofand under the stated condition ofin: urement. 4. Only the test asked for by the party have been carried out. 5. Any anomalies! discrepancies in this report should be brought to our no. date ofissue ofthis re ort. Issued by : Name : N' ii S jl a Desi nation: n Char e C