Warm or tempered in all weather condition! SOLAR-CLEAN LESS THAN 1 DAY
SOLAR-CLEAN HEATING ELECTRICAL PRODUCTION SANITATION The SOLAR'CLEAN'S range equals heat production on average to 10 solar panels Aerovoltaic. The heating nozzle system as well as the heating capacity of our panel installed on the front of Home yields unequaled performance. The Aerovoltaic system or system will provide Outlet temperatures from 20 to 30 with 10 panels and with heating resistance For 0 to - 5 outdoor with 600 w / m² solar irradiation, our panel will bring a temperature At the outlet of the mouth between 40 and 53 always with temperatures of 0 to -5 outside and its same in full night! And always for an average use of 15 to 20 per month of heating following sector. The power to heat your home at lower cost. SOLAR-CLEAN special series, FRENCH product, allows to temper or heat a house Following isolation at a lower cost. The innovative solar panel heating system with Heating nozzle, allows with a single panel of heating a well insulated room of 20m ² to 50m ². TheHeating nozzle system can in no case exceed a maximum consumption of 500w, Equipped with a progressive resistance by PTC heating elements (Positive Temperature Coefficient) Low surface temperature, the consumption will therefore be regulated according to the Heat demanded. As an indication, a SOLAR-CLEAN'S module consumes if the sun is not present For 1 full month and assuming that the resistance is working at full speed 7 days on 7 and 24h on 24h not more than 40, the average consumption is of the order for 1 month of Operation of 13 for a well insulated house or 64ct / per day of heating!!! Its system Will make it possible to bring temperatures of heating at the outlet of the inner nozzle between 35 and 50 following the outside temperature. Beyond the exceptional heating capabilities of SOLAR-CLEAN'S, the Also makes it possible to purify the indoor air with a particle filtration system, which is reheated and dehumidified. The power generation system will take up much of the consumption of the nozzle during the day For a day with can of sun and the rest of the year will bring a reduction of the invoice user.
SOLAR-CLEAN roofing panel Equipped with a micro-inverter power generation SOLAR-CLEAN panel on the front Equipped with a micro-inverter power generation Suction nozzle equipped with a dust filter Heat recovery not used top of room Touch setpoint thermostat Radio in the room Heating nozzle equipped with a progressive resistance From 400w, heats up according to the requested temperature
Energy efficiency of SOLAR-CLEAN Heating SOLAR-CLEAN 400W Standard electric heating 2000W The capacity of a heating mode to diffuse heat changes completely depending on the type of appliance used. A classic heating mode goes for a room of 30m ², to have to overheat in order to be able to bring a Comfort temperature in the middle of the volume (see electric heating diagram). The average capacity for a radiator electric will be for 30M² minimum of 2000W. The heat will rise rapidly and stagnate at the top of the room, Will have to overheat in order to feel a suitable temperature in the middle of the room. In the case of operation with diffused air, the diffusion system will create a dynamic of hot air and Thus making it possible to achieve an almost identical temperature over the entire height of the part. The ingenious system of SOLAR-CLEAN goes with the high suction nozzle, to recover the stagnant heat in order to rebroadcast it at the bottom of room And thus allow the system not to produce heat which will not be used because more accessible at the height Of man. Recovering the heat in height greatly reduces the energy expenditure and for the same Volume will require an average of 4 times less power with scattered air with a high heat recovery Compared to a passive heating system.
Heating + 250w electric Heating + 250w electric Heating + 250w electric SOLUTION 1 For example, the SOLAR-CLEAN panel is installed on the façade. It produces independently its electricity via a microinverter which reinjects the electrical production in the network of the house. During heating, it produces and takes Charges a portion of the consumption of the heating nozzle. All the rest of the year it continues to produce and allows To lower the electricity bill of the house. SOLUTION 2 The SOLAR-CLEAN panel is connected to a solar photovoltaic field, it manages the heating part independently, And remains connected with the other panels for the power generation part. The SOLAR-CLEAN panel remains in All independent cases for heating mode
System Comparison Aerovoltaics and SOLAR-CLEAN system during the day Air temperature outlet nozzle indoor house Outdoor temperature during the day Night Air temperature outlet nozzle indoor house Outdoor temperature in the night The SOLAR-CLEAN panel in the world to work at night and when there is no sun!
Temperature reading 12/28/2015-12/29/2015 Sunny day Test in real condition France Time of the survey 7.30pm 11.30pm 7.00am 10.00am 11.00am 12.00am 2.00pm 4.00pm 6.00pm outside temperature 3 2 3 8 9 10 12 11 7 Temperature required 21 21 20 20 20 20 20 20 21 ambient temperature 20.9 21.3 20.7 20.4 20.9 21.6 22.6 22.3 21.7 Temperature sent home 51.1 50.8 51.2 51.9 44.2 44.5 43.5 43.2 52.3 System consumption W 372 381 389 298 0 0 0 0 309 Temperature reading 12/27/2015-12/28/2015 Sunny day Test in real condition France Time of the survey 7.30pm 11.30pm 7.00am 10.00am 11.00am 12.00am 2.00pm 4.00pm 6.00pm outside temperature 3 0-3 -1 1 2 3 4 3 Temperature required 21 21 20 20 20 20 20 20 21 ambient temperature 21.3 21.1 20.3 20.2 20.2 20.4 20.8 20.5 20.1 Temperature sent home 52.6 51.6 48.9 49.3 50.1 50.3 50.7 51.5 51.4 System consumption W 368 375 392 384 373 371 370 363 376
Characteristic panel SOLAR-CLEAN Heating nozzle feature
Installation of the panel on the front of the house Laying the panel on the house roof www.energienouvelle.on