A Totally Unique 2 INUBATR By
ASSURES ULTURE QUALITY Your cells are precious. You want to control culture process variables. Wally does that in more ways than ever before. Power loss risk reduced. Unit stays above 30º for over 9 hours with GelJacket phase-change technology. In-process contamination reduced. Validated IS 5 quality air in under 5 minutes. Assurance of periodic contamination elimination. Validated optional 2 hour H22 sterilization. INREDIBLY EASY T USE Time spent with your incubator is time not spent on research. Wally cuts that interaction to a minimum. Zero maintentance thermal protection. GelJacket system is sealed for the life of the unit. Hands-free door opening. Push/pull latch with interior viewing. Minimized cleaning effort, courtesy of shallow chamber and HEPA filtered IS 5 quality airflow. Simple touchscreen programming, with bold setpoint displays, and easy-to-navigate menus. UNIQUELY SPAE EFFIIENT Usable culture space is at a premium. Lab floor space is tight. Wally maximizes both. No inaccessible back of chamber areas. Nearly twice the usable shelf space as a conventional cube incubator. Finally, all interior space is usable space. nly 34" deep with door open; 30% less than that of most incubators. Slim profile is built for tight spaces. Slimmer than the typical 24" work surface. Finally, a benchtop that doesn't monopolize your bench. 2 INUBATR 1 Foot Slimmer Base Footprint NVENTINAL 2 INUBATR 7 Inches Farther Door Swing
aron s clean-slate approach to 2 incubator design is uniquely space efficient, assures quality culturing and is incredibly easy to use. 2 incubators have always had deep boxy footprints, heavy water jackets or rapid-cooling direct heat, cumbersome inner/outer doors, and high-maintenance, in-chamber water pans...until now. From the efficiency of a slim profile design with no wasted space to the security of GelJacket technology and ease of use of a hands-free door, Wally is all new. N WASTED SPAE More Usable Shelf Space Slim profile makes all space usable No wasted area at the back of the shelf Nearly twice the culture area as standard cube incubators 5.0 90 Thermal Protection Stays above 30º for over 9 hours after a power loss Water jacket performance, but with zero maintentance GelJacket technology is sealed for life of the unit
MRE PTINS T FIT YUR LAB Not only does Wally maximize usable interior space, but it also frees up extra space outside of the incubator with a slimmer base footprint. With multiple unit configurations, Wally makes the most of your crowded lab environment. RAK MUNT / Top, Middle, Bottom WALL MUNT RAK MUNT / Dual Stack, Quad Stack BENHTP 5.0 90 ontinuous ontamination ontrol Validated IS 5 HEPA filtered chamber air Reduced chance of in-process contamination Minimized cleaning effort Ease of Access Disruption-free sample viewing through smart glass doors Single-door access via hands-free push/pull handle Slim shelf eliminates awkward deep chamber reach Available hamber Sterilization ptional 2 hour H22 sterilization cycle Periodic contamination elimination Fast cycle setup and cleanup
SPEIFIATINS & AESSRIES Wally Incubators are available in either 2 or 2 / 2 variants with additional accessories. See unit accessories on the back. SPEIFIATINS Model Temperature Range Temperature ontrol Temperature Uniformity Humidity Range 2 Range 2 ontrol 2 Sensor 2 Range 2 ontrol 2 Sensor Interior Dimensions Exterior Dimensions Exterior onstruction Work Space Shelf ount Shelf onstruction Shelf Dimensions onf iguration ptions Unit Installed Weight Unit Ship Weight 7410-5 7411-5 5 Above Ambient to 45 ±0.1 at 37 ±0.3 at 37 Elevated Up to 90 % at 37 Ambient to 20 % ±0.1 % IR 1 to 21 % 2 ±0.1 % 2 Fuel ell 31.3" W x 9.5" FB x 26" H 36" W x 13.6" FB* x 36" H Powder oated old Rolled Steel 5 cu.ft. (142 liters) 3 Standard / 13 Maximum Perforated Stainless Steel 31.3" W x 8.8" FB (79cm x 22cm) Wall Mount / Benchtop Dual, or Quad Rack 200 lbs. 227 lbs. (60Hz units) 275 lbs. (50Hz units) * Add 1.7 " FB for handle. ELETRIAL 7410-5-1 & 7411-5-1 7410-5-2 & 7411-5-2 7410-5-3 & 7411-5-3 115V / 60Hz / 5A 230V / 60Hz / 2A 230V / 50Hz / 2A
AESSRIES / Factory Installation Model ALRM302 DLG301 GASG303 GASG304 HUMD309 HUMD310 UTP 302 UTP 303 UTP 304 7410-5 Analog utput Temperature, 2 & Humidity Remote Alarm ontacts Data Logging to USB Port Built-in 2 Gas Guard 7411-5 Built-in 2 & N 2 Gas Guard Humidity Sensor & Display (with standard water pan) ontrolled Humidity Sensor & Display (with nebulizer) Analog utput-temperature & 2 Analog utput Temperature, 2 & 2 Analog utput Temperature, 2, 2 & Humidity AESSRIES / n-site Installation AESSRIES Model / n-site 7410-5 Installation 7411-5 BTL302 arboy Water Fill Bottle / 4 Liters (HUMD310 required) FLTR308 HEPA, Inline 2 Replacement Filter Kit FLTR309 FLTR310 RAK300 RAK301 RAK302 RAK303 SENS300 SHLF334 SHLF335 SHLF336 STER301 STER302 STER303 STER304 HEPA, Inline 2 & N 2 Replacement Filter Kit Ultrasonic Nebulizer Wick Replacement (HUMD310) Single Sided Rack / Holds up to 2 Incubators Double Sided Rack / Holds up to 4 Incubators Bench Top Mounted Rack / Holds 1 Incubator Wall Bracket Mounting Kit / Holds 1 Incubator 2 Replacement Sensor Kit Perforated Stainless Steel Shelf (for incubator) Shelf Kit / Set of 4 ( for RAK300/301) Sliding Shelf ( for RAK300/301) H 2 2 Sterilization Module Single-use 35ml H 2 2 anister (use with STER301) Set of 5 35ml H 2 2 anisters (5 STER302 for use with STER301) Silver atalyst and Wick Replacement for H 2 2 Module (STER301) ARN PRDUTS & SERVIES, IN. / caronproducts.com P Box 715 / Marietta H 45750 / PHNE 740 373 6809 / 800 648 3042 / FAX 740 374 3760 REV 12 /16