Sigma CP (K and T Series) and Sigma CP-A Conventional Fire Control Panel (K11020M2, K11040M2, K11080M2) (T11020M2, T11040M2, T11080M2) (KA11020M2, KA11040M2, KA11080M2) User Manual Man-1082 Issue 05 August 2012
Fire alarm condition General fire indicator lights and zonal fire indicators flash. Buzzer pulses rapidly. Carry out fire procedure Fault condition General fault indicator lights and specific fault indicators flash. Buzzer sounds continuously. Call maintenance engineer Man-1082_Sigma_CP_User_05 Page 2 of 6
Disabled condition General disablement indicator and specific fault indicator lit continuously. Test condition Test indicator and specific fault indicator lit continuously. Maintain vigilance during disablement conditions Ensure system is returned to normal when testing is finished Man-1082_Sigma_CP_User_05 Page 3 of 6
How To Do This Display Comments Silence buzzer Test lamps Alarm/Fault Buzzer Silenced Lamp Test Alarm/Fault Buzzer Silenced Buzzer sounds whilst button is pressed All lamps on Enable buttons (Only Alarm/Fault warning Silence and Lamp Test buttons are operable without turning enable key) Silence alarms Sound alarms Reset Disable a zone step 1 Disable a zone step 2 Enable Control Turn key Silence/Sound Alarm Silence/Sound Alarm Reset Alarm/Fault Buzzer Silenced Fire Buzzer beeps twice every few seconds Buzzer pulses rapidly Ensure source of fire event is cleared before resetting Zone 5 for example to scroll zones Zone 5 Disable a zone step 3 General Disablement 5 6 7 Zone 5 fault LED lit disablement Man-1082_Sigma_CP_User_05 Page 4 of 6
How To Do This Display Comments Put a zone into test mode step 1 Put a zone into test mode step 2 Zone 5 for example Put a zone into test mode step 3 Enable a zone step 1 Enable a zone step 2 Enable a zone step 3 Exit test mode step 1 Exit test mode step 2 to scroll zone to display disablements Zone 5 Zone 1 fault LED lit to scroll zones Zone 5 to enable zone 1 2 3 5 6 7 Zone 5 LED extinguishes General Disablement test mode Note: Proceed with caution if the number is flashing. The panel will alarm if enabled so should be reset first. Flashing dot indicates zone is disabled General Disablement General disablement indicator extinguishes Flashing dot indicates zone is in test mode to scroll zones Zone 5 Exit test mode step 3 Test On to exit test mode Man-1082_Sigma_CP_User_05 Page 5 of 6 1 2 3 Zone 1 flt LED extinguishes Test mode LED extinguishes
How To Do This Display Comments Disable sounders step 1 till db is displayed Disable sounders step 2 Enable sounders step 1 Enable sounders step 2 Activate zone input delays step 1 Activate zone input delays step 2 De-activate zone input delays Return system to normal till db is displayed till Ad is displayed till Ad is displayed Enable Control bells disabled. General disablement and Sounder Fault/Disablement indicators lit Flashing dot indicates bells disabled. Dot stops flashing to indicate sounders are enabled that delays are active if they have been set in engineering mode (refer to operation and maintenance manual configuration table) Dot stops flashing to indicate delays have been de-activated Leaves only Alarm/Fault Warning Silence and Lamp test buttons operable For service contact: Turn key and remove Telephone: Man-1082_Sigma_CP_User_05 Page 6 of 6