FS_IM_G.indd 1 14/02/ :44

Transcription

1 Cancel Seal Only Vaccum/Seal FS_IM_G.indd 1 14/02/ :44

2 Cancel Thank you for purchasing this Food Sealer from JML. To get the most out of this product please make sure you read, and follow these instructions in full and keep them safe for future reference. Seal Only Vaccum/Seal Contents Safety Warnings & Advice...02 Your Food Sealer...04 Using Your Food Sealer...06 Preservation guide...07 Cleaning and Care...08 Troubleshooting...09 Guarantee...10 Technical Information...10 Technical Specifications...10 Fuse and Mains Plug Replacement...10 Disposal and the Environment FS_IM_G.indd 1 14/02/ :44

3 Safety Warnings & Advice The JML Food Sealer is an electrical device, and certain basic safety standards must be applied at all times, as follows: Keep the unit away from water or other liquids to avoid electrical discharge; don t plug the product in if it s resting on a wet surface. Place the unit on a solid surface to avoid movement or falling. Don t place the unit on or near warm surfaces, in the oven, or in a dishwasher. Never immerse the unit in water. If the cord and plug become wet at any time, remove the plug from the electric socket while wearing dry rubber gloves. If the unit has been immersed, send it immediately to an authorized service centre or to your dealer. To avoid getting burned, never touch the sealing bar while the unit is operating. Never use adapters with input voltage not indicated on the bottom of the unit (rating plate). Don t use the product outside the work area. Keep the cord away from hot surfaces and sharp edges. Before the first use and periodically thereafter check the plug; if it s damaged do not use. Don t open the unit or attempt to change or repair. Unauthorized repairs will invalidate the warranty. Unplug the cord after use, before assembling or disassembling parts, or before cleaning. Don t use detergents or abrasive cloths to clean the unit. For best results use the rolls supplied by JML. 2 FS_IM_G.indd 2 14/02/ :44

4 Safety Warnings & Advice continued Vacuum packaging is not a substitute for refrigeration. To avoid possible illness, do not re-use the bag after storing raw meats, fish or greasy food. The product is not intended to be used by children; if children are present, be sure to monitor them closely. Do not use for any purpose other than described in this user guide. This is not a toy. Keep away from children. 3 FS_IM_G.indd 3 14/02/ :44

5 Cancel Your Food Sealer F D A B C E F Seal Only Vaccum/Seal A Sealing Control Button Operates the sealing function only. B Cancel Button Press this to stop the operation of the unit. C Vacuum/Seal Button Operates the vacuum followed by the seal function. D Sealing Light The red light will activate whilst the unit is sealing. E Vacuum Light The red light will activate whilst the vacuum is in operation. F Release Mechanism Push both of these to open the unit. 4 FS_IM_G.indd 4 14/02/ :44

6 Your Food Sealer continued G I J H J I G G Locking Mechanism Push this down until it clicks to lock the bag into place. H Vacuum Nozzle The bag must be placed below this nozzle for the vacuum to operate correctly. I Vacuum Plate The bag must sit within the rippled section for the vacuum and seal to operate correctly. If the plate is removed, please ensure it is replaced correctly and the black seal is pushed into place. J Sealing Bar Allows the bag to seal without sticking to the bar. 5 FS_IM_G.indd 5 14/02/ :44

7 CAUTION: HOT Cancel Vaccum/Seal Using Your Food Sealer 1. Plug the unit in and then switch it on. 2. Unroll the bag and put one end of the bag on top of the lower black rubber strip. Ensure the bag does not cover the vacuum nozzle. Then close the cover (Fig.1). Fig.1 3. Press the cover down ensuring that the locking mechanism locks into place (Fig.2). Seal Only Fig.2 4. Press the Seal Only button. 5. Once the sealing light turns off the seal is complete and the unit can be opened. 6. Cut the roll to your desired bag length. 7. Fill the bag with desired contents. 8. Clean and straighten the open end of the bag, make sure there are no wrinkles or ripples on the panels of the open ends. 6 FS_IM_G.indd 6 14/02/ :44

8 CAUTION: HOT Cancel Vaccum/Seal Using Your Food Sealer continued 9. Make sure that both panels of the bag are located within the rippled area (vacuum plate), but below the vacuum nozzle (Fig.3). 10. Close the cover and press down at each end ensuring that both locking mechanisms click into place. Fig Press the Vacuum/Seal button and the bag will be vacuumed and sealed (Fig.4). The machine automatically stops when the bag is ready. Seal Only 12. Open the unit and the process is complete. Fig.4 Preservation Guide Room temperature (25+/-2C) No vacuum JML Food Sealer Fresh Bread 1/2 days 8/10 months Biscuits 4/6 months 12 months Uncooked Pasta/Rice 5/6 months 12 months Flour 4/6 months 12 months Dry Fruits 3/4 months 12 months Ground Coffee 2/3 months 12 months Loose Tea 5/6 months 12 months Milk Powder 1/2 months 12 months 7 FS_IM_G.indd 7 14/02/ :44

9 Using Your Food Sealer continued In the fridge (5+/-2C) No vacuum JML Food Sealer Red Meat 3/4 days 8/9 days White Meat 2/3 days 6/8 days Fish 1/3 days 4/5 days Cooked Meat 3/5 days 10/15 days Soft Cheese 5/7 days 20 days Hard/Semi Hard Cheese 15 days 60 days Fruits 5/7 days 14/20 days Vegetables 1/3 days 7/10 days Soup 2/3 days 8/10 days Pasta/Rice leftover 2/3 days 6/8 days Cream Desserts 2/3 days 8 days In the freezer (-18+/-2C) No vacuum JML Food Sealer Red Meat 4/6 months 15/20 months White Meat 3/4 months 10/12 months Fish 8/10 months 18/24 months Cleaning and Care Your JML Food Sealer is easy to clean, just observe the following steps: Cleaning the Vacuum Sealer 1. Always unplug the unit before cleaning. 2. Wipe the outside of the unit with a damp cloth or sponge and mild soap if necessary. Storing Your JML Food Sealer Keep the unit in a flat, safe place, out of the reach of children. When not in use, store with the cover closed, but not locked as this can distort the foam gasket over time. 3. To clean the inside of the unit, wipe away any food or liquid with a paper towel. 4. Dry thoroughly before using again. 8 FS_IM_G.indd 8 14/02/ :44

10 Troubleshooting Here are the steps to follow if you re experiencing difficulties with your product. Problem Nothing happens when I press the Vacuum/Seal button Air is not removed from the bag completely Bag loses vacuum after being sealed Bags are not sealing correctly Solution Make sure the power cord is plugged in correctly. Test the electrical outlet by plugging in another appliance. Check to see if either the power cord or the plug is damaged. If they are, don t attempt to start. The bag may not be completely sealed. To seal properly, the open end of the cut roll should be resting entirely inside vacuum channel area. The bag may have a hole. To test, seal the bag with some air in it, submerge in water, and apply pressure. If there are bubbles present this indicates a leak and a new bag should be used. This may be caused by a leakage due to wrinkles, crumbs, fats or liquids. Open the bag, clean the upper part and take any foreign matter off the sealing bar before trying to seal again. Make sure the bag is free of holes. If sealing foods with sharp edges, first line the bag with napkins or paper towels. The cause may be the sealing bar overheating or melting the bag. Open the lid and let the sealing bar cool down for several minutes. DO NOT overfill the bag: leave enough empty length at the open end of the bag so that it can be placed on the vacuuming plate easily. Ensure that the open end of the bag is not wet before sealing. Ensure both locking clips are secure on either side (until they click). Ensure the end of the bag is inserted fully into the jaws of the sealer. Ensure the Vacuum Nozzle (see circled section in fig.3. on page 7) is not covered by the bag or food particles as this will block the vacuum function. Ensure the Vacuum Plate is the correct way up (see fig.3. on page 7). 9 FS_IM_G.indd 9 14/02/ :44

11 Guarantee This product is unconditionally guaranteed for one year against all defects of workmanship and materials. This guarantee does not affect your statutory rights. If you have any problems or queries about this product please contact JML customer services. Technical Information Technical Specifications L 38cm Model Number VS2010 Dimensions W 15cm H 7.5cm Rated Voltage AC V~50/60Hz Weight 1.519kgs Rated Power Input 110W AB: 1 min per cycle Vacuum Power bar (approx). Fuse & mains plug replacement (UK & Ireland only) This appliance is fitted with a BS amp plug. If you have to replace the fuse, only use those that are ASTA or BSI approved to BS 1362 and have a rated current of 3 amps. To change the fuse 1. Use a flat-head screwdriver to prise the cover off the fuse compartment. 2. Carefully remove the existing fuse. 3. Clip the new 3 amp fuse into place. 4. Clip the cover back firmly into place. If the power cord is damaged in any way please contact JML Customer Services. 10 FS_IM_G.indd 10 14/02/ :44

12 Technical Information continued Disposal and the environment This product is covered by the waste electrical and electronic equipment (WEEE) regulations. It should not be discarded with normal household waste, but taken to your local collection centre for recycling. For further information, please contact your local authority or approved disposal agency. Distributed by JML JML, Unit 1 Eastside, Port of Tyne, South Shields, NE33 5SP Customer Services: UK: (Freephone) ROI: (Local rate) info@jmlgroup.co.uk Web: JohnMillsLtd/MB/02.17/BG/G Product code: V0650 Made in China FS_IM_G.indd 11 14/02/ :44