STOP! YOU WILL SAVE TIME BY FOLLOWING THESE INSTRUCTIONS. OWNER'S MANUAL Model SS-703. The Tahiti Showertm

Transcription

1 STOP! YOU WILL SAVE TIME BY FOLLOWING THESE INSTRUCTIONS. OWNER'S MANUAL Model SS-703 The Tahiti Showertm This manual contains important information regarding the Tahiti Outdoor Shower.Please read completely before assembly and use. FOR CUSTOMER SERVICE CALL for additional information please visit our website! SIERRA STERLING - P.O. BOX 5128 CONCORD, CA TOLL FREE

2 CHOOSING A LOCATION TO PLACE YOUR SHOWER: Please read the important CAUTIONS and WARNINGS below before use and before choosing a location to place your shower: CAUTION: Do not leave hose pressurized for extended periods of time. Turn off at source. To reduce risk of injury, enter and exit the shower carefully. Do not use harsh abrasives or solvents for cleaning your shower. Place in area with proper drainage. Place on level, non-slip surface. Do not hang on chrome tube or showerhead. Do not make any modifications other than those recommended by the manufacturer. Please caution users of the shower to be aware that soaps and/or Shampoo may make the base surface slippery. Do not use with a hot/cold mixer as it may be difficult to control water temperature, and may result in a burn. ALWAYS TEST THE WATER TEMPERATURE BEFORE USE TO AVOID CONTACT WITH WATER THAT MAY BE TOO HOT! WARNING: Do not use around electrical cords, outlets, or other power source. WARNING: Not to be used a source for drinking water. CARE MAINTENANCE INSTRUCTIONS: To properly clean the surface, wipe with a soft damp cloth, or sponge, using household soap or liquid detergent.during normanl weathering, wood may crack slightly due to changes in the moisture. This does not effect the structural integrity of your product. Apply teak oil as needed to maintain its natural beauty. DO NOT use any cleaning products containing abrasives or solvents since these could damage the surface. HARSH CHEMICALS SHOULD NOT BE USED ON THE SURFACE. For extended life, store inside during winter. Burs or sharp edges may be lightly sanded smooth. DO NOT use any wood sealer that could create a slippery surface. SOLAR USES: A dark color garden hose may be attached to the shower for added solar heating. This can create a short hot shower when done properly. ( CAUTION - ALWAYS TEST THE WATER TEMPERATURE BEFORE USE TO AVOID CONTACT WITH WATER THAT MAY BE TOO HOT.) 1

3 L D C I G H F E PARTS LIST A- BASE(1) B- LOWER EXTENSION(1) C- UPPER EXTENSION(1) D- TOP CAP(1) E- BASET(1) W/ SCREWS(2) F- NOB/FAUCET(1) G- SHOWER HEAD(1) H- SHOWER HOSE(1) W/ SMALL RUBBER WASHERS (2) I- GOOSE NEC(1) J- ELBOW HOSE(1) W/ SMALL WASHER (1) AND WASHER NUT(1) - (3) 5.5" BOLTS L- (2) 4.25" BOLTS M- SPACER BANDS(2) N- BRACE (1) W/ SCREWS(2) J B M L A N M EXPLODED VIEW 2

4 C heck to be sure all parts are included. If anything is missing please call T OLL F R E E S tep 1 Attach Lower E xtension "B " to B ase "A" using (1) 5.5" bolt " " & (1) 4.25" bolt "L". T IP - T he mounting block may require tightening if loos e. S tep 2 Attach B race "N" to inside lower extension "B ", and corner of B ase "A" using provided screws and predrilled holes. S tep 3 R emove top spacer band "M" by pushing upward to release. Loosen screws if needed. What tools are needed...? 1. P HIL L IP S (S T A R ) HE A D S C R E W DR IV E R (ME DIUM S IZE ) 2. P LY E R S B M L A N 3

5 Step 4 Attach Top Extension "C" to Lower Extension "B" using (2) 5.5" bolts "". TIP: Align the (4) screw heads for the spacer band and the bolt holes should line up correctly. C Step 5 Remove Washer Nut from Elbow "J" leaving the small washer on the elbow. Place the short threaded end of Elbow Hose "J" thru hole in Top Extension "C" with hose facing down toward Base "A". Place washer-nut provided over threads on front side of extension. Tighten washer-nut firmly. Replace Spacer Band "M". Washer Nut F Step 6 Attach nob/faucet "F" on remaining threaded area of Elbow Hose "J" and tighten with spout facing up away from base. E Step 7 Attach Basket "E" to front side of Lower Extension "B" with included screws(2). Holes are predrilled. J M B Note: Be sure that there is a small black rubber washer inside the valve nut. 4

6 S tep 8 P lace T op C ap "D" on to T op E xtension "C " with hole aligned with center of white clips inside top extension. I G S tep 9 S lide straight end of G oose Neck "I" thru hole in T op C ap "D" from the top and press into the white clips. Adjust to desired height and bolt to T op E xtension "C " with (1) 4.25" bolt "L" and tighten. D H S tep 10 Attach nut end of S hower Hose "H" to spout of nob/f aucet "F " and the tapered end to S hower Head "G ". P lace shower head into holder on G oose Neck "I". T IP - Make sure small rubber washers are in place at each end of the hose before attaching. C S tep 11 Attach garden hose to hose connector at the end of E lbow Hose "J ". B e sure to press the provided rubber washer into place firmly before connecting. F I 5

7 TROUBLE SHOOTING: SYMPTOM 1. Water is leaking around fittings. REMEDY Insert a rubber washer into connecting nut. Washer should be seated firmly, then tighten nut. 2. Water does not flow when shower valve is turned on. Turn water source on. Be sure that there is no debris in the tube. 3. Base teeters from side to side. 4. Water pressure is very low 5. Extension feels loose. Move to a flat level surface. Check to be sure all rubber feet are installed Increase pressure at water source valve. Also, be sure that there is no debris in the tube. Tighten the mounting block attachment bolts at base, and be sure Brace (N) is attached. 6. Shower head flow is poor. 7. Bolt will not fit through holes. 8. Shower head will not stay seated on the shower head rod. 9. Garden hose does not screw into hose connector on part "J". Adjust shower head setting switch on the shower head face, to desired position. be sure that there is no debris in the shower head. Tap bolt lightly to ease it through. Be sure that the correct end (tapered) of the shower hose is connected to the head. Be sure there is a black rubber washer seated inside the nut on part "J". Check your hose to be sure the threads are not damaged or out of round. FOR CUSTOMER SERVICE CALL For additional information please visit our website! 6

8 STOP! YOU WILL SAVE TIME BY FOLLOWING THESE INSTRUCTIONS. for additional information please visit our website! SIERRA STERLING - P.O. BOX 5128 CONCORD, CA TOLL FREE