Development of optical fiber sensors for selected chemical and physical sensing applications

Transcription

1 Preface The modern age of fiber optic sensors is enabled by the development of extremely low-loss optical fibers in late 1970s. In recent years Fiber optic sensors have developed from the research laboratory to practical applications. Fiber Optic Sensors are immune to radio frequency and Electromagnetic interference hence it can be deployed in electrically and magnetically noisy atmosphere. It can be used in harsh environment and in locations difficult to access. Fiber is made of glass or plastic and offers environmental ruggedness and it can be employed in chemical process industries. Fiber Optic Sensors are small in size, light weighted and flexible. Low loss in optical fibers enables remote in situ monitoring. The measurement of physical or chemical parameter as a function of position along the length of an optical fiber provides a unique capacity to measure different variations. Such distributed sensors are finding applications in industrial and environmental monitoring. Fiber Optic Sensors are highly sensitive and has large band width. The proposed thesis titled Development of optical fiber sensors for selected chemical and physical sensing applications consists of seven chapters followed by a concluding section. The first Chapter of the thesis provides a general introduction to Fiber Optic Sensors. The evanescent wave fiber optic sensors reported has a single source, hence the selectivity and sensitivity and repeatability is very poor. In order to improve the performance of the sensor two wavelengths are used; one corresponding to the absorption peak of

2 the analyte (analytical wavelength), and the second a non -absorbing one. Introduction of analytical wavelength helps to provide selectivity and the use of non absorbing wavelength supports repeatability aspect. The dual wavelength probing scheme, the related theory, verification using KMnO 4 and the measurement of traces of silica in water is discussed in chapter 2. A sensitive and useful design of dual wavelength probing scheme for evanescent wave based fiber optic sensor has been developed and it is extended for the measurement the concentration of Iron, Phosphate and Ammonia in water. Preparation of Reagents, standard solutions, measurement results are described in Chapter 3. Fiber Bragg Grating (FBG) is an important sensing element for the measurement of several important physical parameters such as strain, temperature. Apart from other fiber sensors the FBG sensors have many advantages like high resolution, insensitivity to fluctuations, multiplexing, distributed sensing etc. So in the present study we have simulated and measured the strain on a cantilever structure made of spring steel using a FBG sensor. The FBG is mounted to the structure using a commercially available fast setting epoxy. The drift of strain due to temperature is also measured and a correction factor due to the temperature drift is suggested. A temperature controlled water bath was used for the measurement of temperature. The measurement of strain, Temperature, cross sensitivity is discussed in Chapter 4. The main bottle neck in the use of FBG sensors for different applications is the costly demodulation techniques. In this study we

3 suggest two simple methods for wavelength to intensity conversion. The first method is by selecting a narrow band source, and a FBG with Bragg reflection at trailing edge of the source spectrum. So, as the Bragg reflected wavelength shifts due to strain or temperature the reflected power vary depending on the selection of Bragg wavelength. In the second method two matched FBGs are used. The Bragg reflected signal from the reference FBG is fed in to the FBG in which the measurements are carried out. During the measurement the reflected power varies as the Bragg reflected wavelength shifts. This can be monitored using a power meter. The Simulation of Interrogation technique and the measurements of strain and temperature are discussed in Chapter 5. Chapter 6 is a study distributed sensing of weightdisplacement measurement using optical time domain reflectometry. OTDR has the advantage that the measuring parameter can be monitored continuously along the fiber. A quasi distributed sensing of weight/ displacement realised, in which the parameter is measured at specific locations. Specially made triangular corrugations on Aluminium block are used to create macro bends in a single mode fiber, which measures weight/ displacement. Distributed study, measurement of displacement and weight, study of variation in number of corrugation, size of corrugation etc are discussed in this chapter. Chapter 7 is a demonstration of simultaneous measurement of strain, weight and temperature using wavelength division multiplexed, quasi-distributed FBG sensors.

4 The summary of research work and the relevant results obtained from the present study are outlined in the concluding section. The scope of future work is also presented. Part of the thesis has been published in the following journals: [1] P.Benjamin Varghese, Satish John and K.N. Madhusoodanan, Fibre optic sensor for the measurement of concentration of silica in water with dual wavelength probing, Rev. Sci. Instrum., 81,035111, [2] P.Benjamin Varghese, P.Vinod, Jibukumar, K. N.Madhusoodanan and P. Radhakrishnan, A quasi distributed fiber optic weight-displacement sensor using macro bends, Opt. Fiber Technol., 18, (4), 215, [3] P. Benjamin Varghese, P. Vinod, K. N. Madhusoodanan and P.Radhakrishnan, Development of a strain sensor using Fiber Bragg Grating and its effect on temperature variation, Jl. of the Instrum. Soc. of India, 41, (4), 197, [4] P.Benjamin Varghese, K.N.Madhusoodanan, P.Vinod and P. Radhakrishnan, A Novel Fiber Bragg Grating Sensor for Measuring Weight, IEEE Xplore Digital Library, , DOI : /INDICON, [5] P.Benjamin Varghese, R.Dinesh, MittuRaju, Jose J.Edathala and K. N.Madhusoodanan, Fiber Bragg grating interrogator for temperature measurement, Jl. of the Instrum. Soc.of India, 42, 4, 2012.

5 [6] Benjamin P. Varghese, Aji Balan Pillai and Madhusoodanan Kottarathil Naduvil, Fiber optic sensor for the detection of Ammonia, Phosphate, Iron in water, J. Opt., DOI /s , [7] P. Benjamin Varghese, R. Dinesh, MittuRaju, Jose J.Edathala, K. N.Madhusoodanan, A Simple Interrogator for FBG Sensors, International Journal of Advanced Electrical and Electronics Engineering,1, (3), 17, 2012 [8] Benjamin Varghese P, Dinesh Kumar R, Mittu Raju, K N Madhusoodanan, P Radhakrishnan. Wavelength division multiplexed FBG sensors for the simultaneous measurement of strain, weight and temperature, J.of Instrum. Technol. and Innovations 3, 3, [9] Benjamin Varghese P, Denesh R, Mittu Raju, K N Madhusoodanan Implementation of Interrogation systems for Fiber Bragg Grating sensors, Photonic Sensors 3, 3, 283, 2013.