Certificate of Compliance Certificate: 70028359 Master Contract: 170351 Project: 70028359 Date Issued: April 08, 2015 Issued to: Bel Fuse Inc. 206 Van Vorst St Jersey City, New Jersey 07302 USA Attention: Editha S. Vergara The products listed below are eligible to bear the CSA Mark shown with adjacent indicators 'C' and 'US' for Canada and US or with adjacent indicator 'US' for US only or without either indicator for Canada only. Issued by: Lai Mei Lam Lai Mei Lam PRODUCTS CLASS - C531111 - POWER SUPPLIES-Component Type(CSA 60950-1-07-2nd Ed) CLASS - C531191 - POWER SUPPLIES-Component Type(UL 60950-1-2nd Ed)Certified to U.S.Stds Component type power supplies intended for use with Information Technology and Business Equipment, where the suitability of the combination is to be determined by CSA Group. AC/DC Switching Power Supply, Models PET2000-12-074NA, PET2000-12-074NAA, PET2000-12-074NAC, PET2000-12-074NACS354 (Cisco P/N: 341-100362-01), PET1600-12-074NA, maybe followed by alpha numeric characters indicating non-safety critical options DQD 507 Rev. 2012-05-22 Page 1
Certificate: 70028359 Project: 70028359 Master Contract: 170351 Date Issued: April 08, 2015 Electrical Rating: Input: 100-127/200-240 Vac, 12/10 A, 50/60 Hz. Output: see below table. Model PET1600-12-074NA PET2000-12-074NA PET2000-12-074NAA PET2000-12-074NAC, PET2000-12- 074NACS354 (Cisco P/N: 341-100362-01 Input Voltage Output, DC Vac 55 C ambient 70 C ambient 100-127 V1:12 V, 83.3 A V1:12 Vdc 50 A 200-240 V1:12 V 133 A V1:12 Vdc 80 A 100-127/200-240 Vsb: 12.15 V, 4A Vsb: 12.15 V, 2.4 A 100-127 V1:12 V, 83.3 A V1:12 Vdc 50 A 200-240 V1:12 V 167 A V1:12 Vdc 100 A 100-127/200-240 Vsb: 12.15 V, 5 A Vsb: 12.15 V, 3.0 A APPLICABLE REQUIREMENTS CAN/CSA-C22.2 No 60950-1-07, Amendment 1: 2011 (MOD)+Am2:2014 Information Technology Equipment - Safety - Part 1: General Requirements ANSI/UL 60950-1-2014 Information Technology Equipment - Safety - Part 1: General Requirements CONDITIONS OF ACCEPTABILITY 1. This component has been judged on the basis of the required spacings in the Standard for Safety of Information Technology Equipment, CSA/UL 60950-1, Second Edition, Amendment 2, Sub-clause 2.10, which would cover the component itself if submitted for Listing. 2. The equipment has been evaluated for use in Pollution Degree 2 environment. 3. The Clearance values of the Power Supply Unit (PSU) have been evaluated for an altitude of 10,000ft (3048m), under IEC60664-1: 1992 Table A.2 (altitude correction factor is 1.15). 4. Touch Current Test was conducted at 264Vac, 60Hz and measured current for single unit was 1.8mA. 5. The ground path from the appliance inlet to the PSU case meets protective bonding and has been evaluated at 40A. 6. Evaluated as Class I (earthed equipment). Reliable connection to Protective Earth shall be provided in the end use installation. 7. Evaluated for connection to AC power with a branch circuit protector rated max 20 A. DQD 507 Rev. 2012-05-22 Page 2
Certificate: 70028359 Project: 70028359 Master Contract: 170351 Date Issued: April 08, 2015 8. The secondary outputs of the PSU are SELV. 9. The VSB:12.15V output is non-hazardous energy level. 10. The main output ( V1:12 V) is at hazardous energy level, but when removed from the end use product, with no connections to the secondary connectors, the outputs are not an energy hazard even under single fault conditions. 11. The PSU has been evaluated for a TN (Including TN-S and TN-C) and TT systems power source. 12. All Isolating transformers isolation barrier insulation temperatures have been measured within the winding on the insulator. The internal temperature did not exceed the insulation Class limits for NORMAL operation and ABNORMAL operation. 13. The temperature of the Isolating Transformers (T71, T201) employ an OBJY3 electrical insulation system designated Class F. 14. The connector current interruption test (Hot Plugging test) was conducted on the secondary output mating connector (external to the unit, manufactured by FCI Type Power Blade P/N: 1013248-005LF ) of the PSU for 200 cycles. 15. Suitability of the enclosure provided with the equipment as a FIRE, MECHANICAL and ELECTRICAL enclosure is to be determined in the end system except front panel (including top and bottom sides) which complies with the FIRE, MECHANICAL and ELECTRICAL enclosure requirements. 16. The PSU is not intended for use in vehicles, on board ships or aircraft. DQD 507 Rev. 2012-05-22 Page 3
Supplement to Certificate of Compliance Certificate: 70028359 Master Contract: 170351 The products listed, including the latest revision described below, are eligible to be marked in accordance with the referenced Certificate. Project Date Description Product Certification History 70028359 Apr 8 2015 AC/DC Switching Power Supply, Models PET2000 Series and PET1600 Series. (C/US) DQD 507 Rev. 2012-05-22 Page 1
CERTIFICATE No. P15219692 Order No. 282150 Page 1/3 Product Applicant Manufacturer AC-DC switching power supply Bel Fuse Inc. 206 Van Vorst St. Jersey City, NJ 07302 USA Bel Fuse Inc. 206 Van Vorst St. Jersey City, NJ 07302 USA Factory See page 3 Ratings Trade mark All models except PET1600-12-07NA Input: 100-127V~/200-240 V~, 12/10A, 50/60 Hz Output: V1: 12 Vdc, 83.3 A max.(100-127v), 167 A max.(200-240v) VSB: 12.15V, 5A max PET1600-12-074NA Input: 100-127V~/200-240V~, 12/10A 50/60Hz Output: V1: 12 Vdc, 83.3 A max. (100-127V), 133 A max.(200-240v) VSB: 12.15 V, 5 A max. Model / Type Ref. Principal characteristics PET2000-12-074NA, PET2000-12-074NAA, PET2000-12-074NAC, PET1600-12-074NA, PET2000-12-074NACS354 (Cisco P/N: 341-100362-01) The model name may be followed by alpha numeric characters indicating nonsafety critical options See next page(s) A sample of the product was tested and found to be in conformity with OFF EN 60950-1:2006;A11;A1;A12;A2 Validity Additional information This certificate documents conformity with the standards shown, and also applies as license for use of Nemkos name and certification mark. The certificate and license is valid as long as the applicable conditions are complied with, and provided that any changes to the product are notified to Nemko for acceptance prior to implementation. New standards or amendments to the standards may imply that the product design must be updated and/or that re-testing and re-certification is necessary. See next page(s) The abovementioned certified equipment complies with current regulatory requirements regarding electrical safety in Norway and other EU/EEA member states, as far as this can be checked. Compliance with requirements regarding building-in, protection against electric shock and Date of issue 20-04-2015 Juan Z. Kleppenes Certification Department Nemko AS Gaustadalléen 30, P.O. Box 73 Blindern, 0314 Oslo, Norway TEL +47 22 96 03 30 FAX +47 22 96 05 50 EMAIL info@nemko.com ENTERPRISE NUMBER NO974404532 nemko.com
CERTIFICATE No. P15219692 Order No. 282150 Page 2/3 Additional model(s) Electromagnetic Compatibility (EMC) must be checked when the equipment is built-in a completed product or forms a part of a complete system. See next page(s) Date of issue 20-04-2015 Juan Z. Kleppenes Certification Department Nemko AS Gaustadalléen 30, P.O. Box 73 Blindern, 0314 Oslo, Norway TEL +47 22 96 03 30 FAX +47 22 96 05 50 EMAIL info@nemko.com ENTERPRISE NUMBER NO974404532 nemko.com
CERTIFICATE No. P15219692 Order No. 282150 Page 3/3 Factories: BPS Asia Pacific Electronics (Shenzhen) Co., Ltd. Building# 6, Nanming Road, Gongming Town Huahong Xintong Industrial Park Guangming District, Shenzhen 518108 China Bel Power Solutions, s.r.o. Areal ZTS 924 Dubnica nad Vahom 01841 Slovakia Date of issue 20-04-2015 Juan Z. Kleppenes Certification Department Nemko AS Gaustadalléen 30, P.O. Box 73 Blindern, 0314 Oslo, Norway TEL +47 22 96 03 30 FAX +47 22 96 05 50 EMAIL info@nemko.com ENTERPRISE NUMBER NO974404532 nemko.com
Ref. Certif. No. NO86275 IEC SYSTEM FOR MUTUAL RECOGNITION OF TEST CERTIFICATES FOR ELECTRICAL EQUIPMENT (IECEE) CB SCHEME SYSTEME CEI DACCEPTATION MUTUELLE DE CERTIFICATS DESSAIS DES EQUIPEMENTS ELECTRIQUES (IECEE) METHODE OC CB TEST CERTIFICATE CERTIFICAT D'ESSAI OC Product Produit Name and address of the applicant Nom et adresse du demandeur Name and address of the manufacturer Nom et adresse du fabricant Name and address of the factory Nom et adresse de l'usine Note: When more than one factory, please report on page 2 Note: Lorsque il y plus d'une usine, veuillez utiliser la deuxième page Ratings and principal characteristics Valeurs nominales et caractéristiques principales Trademark (if any) Marque de fabrique (si elle existe) AC-DC switching power supply Bel Fuse Inc. 206 Van Vorst St. Jersey City, NJ 07302 USA Bel Fuse Inc. 206 Van Vorst St. Jersey City, NJ 07302 USA Additional information on page 2 All models except PET1600-12-07NA Input: 100-127V~/200-240 V~, 12/10A, 50/60 Hz Output: V1: 12 Vdc, 83.3 A max.(100-127v), 167 A max.(200-240v) VSB: 12.15V, 5A max PET1600-12-074NA Input: 100-127V~/200-240V~, 12/10A 50/60Hz Output: V1: 12 Vdc, 83.3 A max. (100-127V), 133 A max.(200-240v) VSB: 12.15 V, 5 A max. Type of Manufacturer s Testing Laboratories used Type de programme du laboratoire d essais constructeur Model / Type Ref. Ref. De type WMT PET2000-12-074NA, PET2000-12-074NAA, PET2000-12-074NAC, PET1600-12-074NA, PET2000-12-074NACS354 (Cisco P/N: 341-100362-01) Additional information (if necessary may also be reported on page 2) Les informations complémentaires (si nécessaire, peuvent être indiqués sur la deuxième page A sample of the product was tested and found to be in conformity with Un échantillon de ce produit a été essayé et a été considéré conforme à la As shown in the Test Report Ref. No. which forms part of this Certificate Comme indiqué dans le Rapport dessais numéro de référence qui constitue partie de ce Certificat The model name may be followed by alpha numeric characters indicating non-safety critical options Additional information on page 2 IEC 60950-1(ed.2);am1;am2 282150 This CB Test Certificate is issued by the National Certification Body Ce Certificat dessai OC est établi par l'organisme National de Certification Gaustadalléen 30 NO-0373 Oslo, Norway Date: 20-04-2015 Signature: Juan Z. Kleppenes Certification Department Issued 2007-04 1/2
Ref. Certif. No. NO86275 BPS Asia Pacific Electronics (Shenzhen) Co., Ltd. Building# 6, Nanming Road, Gongming Town Huahong Xintong Industrial Park Guangming District, Shenzhen 518108 China Bel Power Solutions, s.r.o. Areal ZTS 924 Dubnica nad Vahom 01841 Slovakia Gaustadalléen 30 NO-0373 Oslo, Norway Date: 20-04-2015 Signature: Juan Z. Kleppenes Certification Department Issued 2007-04 2/2