IMC-RBX Series Steam shrinking Tunnel Operating points for attention l The machine should be manipulated in the best condition by the person in charge of operating the machine. l The tools and other things are forbidden to be putted on or in the machine. l When the tunnel is heating, touching the inside metal is forbidden to avoid the burns and scald. l Verify the machine, being aware of the electrics and scald, cut off the circuit or stop the related heating master control assembly switches first if necessary. l Turn off the switch after the machine working, and then begin cleaning operation. Installation points for attention l The machine position and installation should keep the glory hole and the conveyor belt parallel and vertical, and keep the center of the notch inside machine cavity and the center of the conveyor belt in the same level. l The position of the entrance and exit of the machine decides according to the peripheral equipment. Being aware of whether the hot air or steam from the machine cavity affects the other equipments around. It is recommended to leave machine s fore and back parts at least 0.6 meter away from any wall, column, etc. l It is recommended to leave the fan entrance and exit of the machine not in the same level with the ventilation system or other outlet, avoiding the lost of the heat of the tunnel and other damage to low the quality of shrinking and waste energy. l It is recommended to connect the 1.5 square conveyor line with the machine and use 3&220V380V415V60/50HZ power supply and 5A electromagnet switches(nfb). l The specific interface is like the following picture
l SP-1M: The length of the machine is 1000mm, which adopts SUS stainless steel mechanism and 2 pairs of steam pipe. It is suitable for the shrinking of the cap machine and lower speed machine. l SP-2M: The length of the machine is 2000mm, which adopts SUS stainless steel mechanism and 3 pairs of steam pipe. It is suitable for the shrinking of the long type containers and higher speed machine.
n <steam blower> Blower: Use to discharge the steam from the shrinking tunnel, the model is 3&370W 380V. l The order of the machine switch on open the intake valve open the conveyor belt switch and the fans switch open the sewage valve switch, after the discharge all the sewage, close the valve switch. adjust the nozzle gas volume and the fans air volume of the shrinking tunnel, if be set beforejust need to verify them. start shrinking when open the machine for one minute and the temperature of the tunnel is stable. l Adjustment According to the picture (1) Adjust the position of the 3 pairs of the gas ejector pipe according to the position of the bottle label. (2) Cylindrical type bottles, like the left picture.
3Other bottle types,the nozzle adjustment is like the left picture. And shrink the label from the bottom to the top according to the largest bottle diameter. 1Nozzle valve: 2Intake pipe: 3Sewage valve: Adjust the flow volume from the steam and control it. The pipe for steam enter usually connects the 1/2 pipe port. The 1/4 pipe port is usually blocked. After the daily operation close the steam port, open the sewage valve to discharge the Condensate.
l Shutdown procedures open the steam intake valve open the condensate valve for 2 minutes stop the conveyor belt switch stop the fans switch stop the sewage valve Safety points for attention n Be care of the thermal injuryheat energy is used in this area; please avoid the bodies touch to avoid the scald. n The machine use high-currentbe care of the electrics safeties. n Avoid the debris into the machine. If have, remove it to avoid charred and attachment to keep shrink quality. n Don t put the shrinking materials onto the machine to avoid them deformation. n The maintenance of circuit is only for verifying and maintenance. Don t change the circuit. We are not liable for the maintenance. n Please contact and ask our engineer department for help if it is necessary for you to change the machine s hardware and software. n Our company reserves the right to modify the machine and the manual.