Automatic switcing base on motion an ligt level Prouct escription Motion etector for luminaire installation Motion etection troug glass an tin materials (except metal) For automatic on/off switcing of electronic ballasts Brigt-out function: luminaire is not switce on if tere is aequate brigtness Delay time, etection range an ligt value for te brigt-out function can be set via 9 ip switces Max. installation eigt 5 m Two ousing options allowing flexible installation Variable etection area (100 10 %) Zero cross switcing supporte 5-year guarantee È Prouct matrix, page 3 Wiring iagrams an installation examples, page 4 HF 5DP S f www.trionic.com 1
Automatic switcing base on motion an ligt level Tecnical ata Rate supply voltage 220 240 V Mains frequency 50 Hz Power < 0.5 W Frequency 5.8 GHz (± 75 MHz) Transmission power < 0.2 mw Loa resistive 800 W Loa capacitive 400 VA Detection angle 30 150 Max. etection area at 3 m mounting eigt ø = 7 m Max. mounting eigt 5 m tc 85 C Ambient temperature ta -20... +70 C Storage temperature ts -20... +70 C Humiity min. 5 %... max. 85 % at 30 C Type of protection IP20 Protection class Reinforce insulation Casing material PC, alogen-free Casing colour RAL 9016 (wite) 36,5 4,2 48,5 43 36,5 58 64,5 70 24,5 23,5 23 24,5 23,5 58 4,2 HF 5DP S f 23 Orering ata Type Article number Dimensions L x W x H Packaging, carton Weigt per pc. 28002214 70 x 36.5 x 24.5 mm 5 pc(s). 0.040 kg HF 5DP S f 28002235 58 x 48.5 x 24.5 mm 5 pc(s). 0.040 kg www.trionic.com 2
1. Stanars E 61347-1 E 61347-2-11 E 300 440-2 V1.4.1 (2010-08) E 301 489-3 V1.6.1 (2013-08) E 62479:2010 E 55015:2013 + A1:2015 E 61000-3-2:2014 E 61000-3-3:2013 E 61547:2009 1.1 Glow-wire test accoring to E 60598-1 850 C passe 2. Common an S f provies simple cost-effective motion etection in combination wit te corriorfuctio offere by Trionic electronic control gear. Wen te sensor etects movement it triggers a preefine motion etection profile in te control gear. If te user-efinable ligt value at te integrate ligt sensor is exceee te control gear remains switce off. Hig-frequency tecnology enables te sensor to be installe in completely enclose luminaires. DIP switces Antenna moule tc LED inication Dayligt sensor L 1 2 3 4 5 6 7 8 9 Hol-time Dayligt tresol Ajustable etection area 3. Installation ot for use wit pase cut immers Te sensor must protrue over te ligt sources Te power supply must be isconnecte before installation Suitable for installation only in inoor luminaires (e.g. corriors an close parking garage) witout vibration Opening angle of te sensor: must be at least 45 % Motion etection: only possible troug tin ousing material (e.g. plastic or glass), o not use metal ousing Ligt sensor: must be able to etect reflecte artificial ligt an reflecte ayligt Reflecte HF waves (e.g. of walls, floors, ceilings or furniture) from oter transmitters affect motion etection www.trionic.com 3
3.1 Wiring iagram 230/240 V AC 50/60 Hz L PE L L Isel2-1 Isel2-2 (GD) DA/ DA/L LCA one4all PRE Isel2-1 Isel2-2 (GD) DA/ DA/L LCA one4all PRE L L PE corriorfuctio HF 5DP S f Stanar 3.2 Combination multiple sensors an rivers Maximum loa (capacitive): 400 W / 400 VA 230/240 V AC 50/60 Hz L PE L L L L 3.3 Wiring type an cross section Strane wire wit ferrule or soli wire up to 1.5 mm 2 may be use for wiring. Strip 8 mm of insulation from te cables to ensure perfect operation of te pus-in terminals. Use one wire for eac terminal connector only. wire preparation: 0.45 1.5 mm² 8 mm 3.4 Minimum spacing for furter sensors min. 1,5 m www.trionic.com 4
4. Functions 4.2 corriorfuctio 4.1 Setting up Setting te etection area Te etection area can be restricte to prevent te ligting system being switce on unnecessarily, as woul be te case if te area were too large. Te etection area inicates te iameter witin wic motion is etecte. Te corriorfuctio can be activate by applying a voltage of 230 V for 5 minutes at te switcdim connection of te control gear or via corriorfuctio Plug. ote: To apply a voltage of 230 V for 5 minutes at te switcdim input of te control gear te sensor must etect motion for more tan 5 minutes or a switc-off elay longer tan 5 minutes must be set. 1 2 3 Sensitivity I 100 % (efault) II 75 % III 50 % IV 30 % V 10 % 4.3 Start up beaviour 20 secons after mains is connecte to te sensor is reay an inicates tis by switcing on te green LED. 4.4 Motion etection Setting te switc-off elay To prevent te ligting system being switce on an off unnecessarily you can set a switc-off elay. Te elay starts after te last motion in te etection area. If a furter motion is etecte in te etection area uring tis elay ten te elay is retriggere. At te en of te elay te ligt will be switce off or te corriorfuctio is starte. 4 5 6 Hol time I 5 s (efault) II 30 s III 1 min IV 5 min V 10 min VI 20 min VII 30 min Setting te ayligt tresol value A tresol value can be set to prevent te ligting system from being switce on wen tere is alreay aequate illuminance. Te tresol value inicates te illuminance value below wic etecte motion causes te ligting system to be switce on. 7 8 9 Dayligt sensor I Disable (efault) II 50 Lux III 20 Lux IV 5 Lux V 2 Lux ote: To ensure te sensor switces on in conjunction wit te corriorfuctio you soul set te tresol value to I = Disable. If te tresol value isable te sensor will always switc on. Ceiling mounte: 150 0.5 m 0.5 m 1.0 m 1.0 m 1.5 m 2.0 m 2.0 m 4.0 m 2.5 m 6.0 m 3.0 m 7.0 m 3.5 m 6.0 m 4.0 m 5.0 m 4.5 m 4.0 m 5.0 m 3.0 m Wall mounte: 150 Diameter of te etection cone as a function of eigt at maximum etection area witout taking objects in te room into consieration. Stationary objects (walls, tables, floor-staning luminaires, etc.) locate in te irect view of te sensor cange te caracteristics of te etection area. Te mentione values are typical minimum values epening on te environment an application te etection area may increase. 4.5 Detection sensibility Optimize for etection of peestrians wit a spee of 0.5 1.5 m/s correspons to 1.8 5.4 km/. Depening on te Application an environmental conitions te maximum etectable spe of object may vary. 5. Miscellaneous 5.1 Aitional information Aitional tecnical information at www.trionic.com Tecnical Data Guarantee conitions at www.trionic.com Services Life-time eclarations are informative an represent no warranty claim. o warranty if evice was opene. www.trionic.com 5