Brute Elite Volume Water Heaters Indoor 150, ,000 BTU/Hr. Up to 97% Thermal Efficiency

Transcription

1 rute lite Volume ater eaters Indoor 1,000 -,000 TU/r. Up to % Thermal fficiency The unit will be designed and constructed in accordance with the S oiler and Pressure Vessel ode Section IV requirements for 10 psi working pressure. The units will bear the S "" stamp and be registered by the ational oard. 5-Year imited eat xchanger arranty / 1-Year imited arranty on omponent Parts. or more information on warranty, please visit or products installed in US, anada and Puerto Rico. Some states do not allow limitations on warranties. See complete copy of the warranty included with the heater. UTUR UR O OR OR O T OOI U.S. PTTS: 5,2,; 7,,; 5,0,; 5,95,92;,05,52;,95,20; 5,72,; 5,5,79; 5,57,22; 7,1,; 7,992,52;,,21;,2,17; 7,,; 7,,1; 7,270,07; 7,007,7; 5,59,952;,12,21; 7,99,02; 5,1,770; 7,7,517; 7,5,2; 7,5,210; 7,0,12; 7,0,1; 7,559,29; 7,900,59; 5,9,9;,02,; 5,9,7; 7,21,2; 7,,59; 5,71,79; 7,09,9; 5,277,171;,1,772; 7,5,1; 2,22,17. OTR U.S. ORI PTT PPITIOS PI. URRT I PTTS: 2,1,5; 2,,2; 2,10,1; 2,1,01; 2,09,271; 2,5,95; 2,2,5; 2,7,5; 2,29,007; 2,092,105; 2,107,

2 rute lite Volume ater eater Specifications - Sizes 1-0 imensions shown in inches imensions TV-9 TV / 20 1 / / 0 1 / 5 1 / 5 1 / 7 1 / 5 1 / 5 1 / / / / 1 / 1 / 1 / 1 / 1 / 10 / 17 / 1 / 1 / 1 / 7 1 /2 7 1 /2 1 1 /2 1 1 / / 1 1 / 1 1 / 20 1 /2 1 /2 1 /2 1 1 /2 7 1 /2 / / 2 1 / 1 / 1 / 1 / 1 / /2 2 / 2 / 1 1 /2 7 / 1 / 1 / 1 / 1 / 1 / * 1 /2 1 /2 1 /2 * 1 /2 1 /2 1 /2 PT Size 1 1 / 1 /2 1 1 / 1 /2 2 / 2 / 2 1 TV-9 TV * * PT Size *rute lite is shipped with adapters for the air and vent that accept standard pipe of the proper size and type.

3 rute lite Volume ater eater Specifications - Sizes 00- imensions shown in inches imensions 29 / 5 1 /2 9 / 5 1 /2 1 /2 1 /2 1 / 5 1 / 5 1 / /2 / 1 / 1 /2 2 0 / 5 1 / 1 / 1 / 1 / 1 / 1 / 7 / / 1 / 1 / 1 / * 1 /2 1 /2 1 /2 * 1 /2 1 /2 1 /2 PT Size / / * * PT Size *rute lite is shipped with adapters for the air and vent that accept standard pipe of the proper size and type.

4 rute lite Volume ater eater Specifications Sizing ata TV-9 TV-99 Input TU/r. 1,000 9,000 25,000 99,000 0,000 00,000 7,000,000 s 1-0 (o Pump) 1-9 (ith Pump) 25-0 (ith Pump) k System lectrical ata Output TU/r. 12,0,00 270,7,00 0,000 52, ,000 1,000 k oiler (Includes Pump) Volts Phase mps * inimum circuit required. 00- pump not included. Single Single Single 2* 7* * Thermal fficiency % ax. quivalent* ength PV/PV (each intake and each exhaust) TV-9 TV-99 Intake ** Intake ** x. ** x. ** lbs ax. llowable ength 20 ft. 0 ft. ** 0 ft. 0 ft. Shipping eight 0 m. 0 m..1 m. 0 m. 0 m. 0 m. 12 m. 0 m.** 12 m. 0 m. 12 m. 0 m. Intake (air) pipe may be S, PV, PV or galvanized material. ** llowed only if the vent pipe is no more that 20 equivalent feet longer than the air pipe. kg learances ppliance Surface eft Side Right Side Top ack loset, ront (25-0) lcove, ront (25-0) ront (00-) Suggested Service ccess learance ertified by S for zero clearance to combustible materials on all sides. Installations in the U.S. require exhaust vent pipe that is a combination of PV & PV complying with SI/ST 175 1, polypropylene pipe that conforms with U S, or stainless steel complying with U17. Installations in anada require exhaust vent pipe that is certified to US. Installer must comply fully with manufacturer's installation instructions, including use of minimum exhaust length PV, to maintain SI Z21.1 safety certification. loset and alcove installations do not allow the use of PV under any circumstances *To calculate max equivalent length, measure the linear feet of the pipe, and add 5 feet (1.5m) for each elbow used. ater low Requirements TV-9 TV-99 low P / t ormal ater* Temp. Rise low P / m * aximum water hardness of 10 grains per gallon allowed. Temp. Rise Recovery ata TV-9 TV Required ater Temperature Rise TV-9 TV Required ater Temperature Rise

5 rute lite Volume ater eater Specifications 1 2 T V SRIS US SIZ U P OPTIO O X PUP OPTIO X RVISIO haracter esignation (1-) Series esignation T = rute lite () Usage V= Volume ater (5-7) Size 1 = 1,000 TU/r. Input 9 = 9,000 TU/r. Input 25 = 25,000 TU/r. Input 99 = 99,000 TU/r. Input 0 = 0,000 TU/r. Input 00 = 00,000 TU/r. Input 7 = 7,000 TU/r. Input =,000 TU/r. Input () uel = atural as P = Propane (9) Options X = one =S-1,, P, I (0- only)) (10) Pump Options = ormal Pump (1-0 only) X = o Pump () Revision = Third Revision Standard eatures arge display with touchpad userinterface enus for login, display setup, quick start, advanced setup, test and diagnostics Password-protected parameters for installer use ustomizable homescreen and contrast Quick start feature for simple, single heater installations Test feature allows forced min or max firing omplete diagnostics for analog and digital inputs isplays holds, alerts and errors in clear text form ry alarm contacts for ignition failure igh condensing efficiency odulation down to 20% of full fire (5:1 turndown) Sealed combustion chamber Pre-mix stainless steel burner ow Ox system exceeds the most stringent regulations for air quality - less than 10ppm Ox orizontal or vertical direct vent orizontal vent and air terminals and air pipe lengths of up to 100 equivalent feet (each) uilt-in condensate trap temperature cutoff feature irect spark ignition system Sensor for domestic water tank 10 psi maximum working pressure Stainless steel heat exchanger with welded construction (no gaskets) S "" stamp 1 psi (1 kpa) S rated pressure relief valve ater flow switch (99- only) Temperature & pressure gauge ascades with other eotherms rain valve Integrated PI temperature and ignition controls lectronic PI modulating control larm output ccepts external (-20m or 0-10V) modulation signal On/off toggle switch anual reset high limit urner site glass Zero clearance to combustible surfaces uilt-in cascade function for up to eight rute lites 5 year limited warranty actory ounted Options S-1,, P, I code equipment (0-) - includes O (low water cutoff), high and low pressure switches O (0-) dditional auto reset high limit igh and low gas pressure switches (0-) larm bell w/silence switch for ignition failure 0 PSI pressure relief valve 75 PSI pressure relief valve 1 PSI pressure relief valve ccessories for ield ounting ater flow switch (1-25) O igh and low gas pressure switches Propane conversion kit ondensate neutralizer kit net gateway O gateway 2" PV oncentric Terminal (1-9) " PV oncentric Terminal (1-25) " PV lush ount Terminal (1-25) (side wall only) " PV lush ount Terminal (25-) (side wall only)

6 rute lite Volume ater eater Specifications Sample Specification The heater shall be a radford hite TV, rated at the input and output shown on the schedule. The heater shall modulate % of full fire. The unit(s) shall be design-certified to comply with the current edition of the armonized SI Z21.1 / S. Standard for as-ired ow Pressure Steam and as ater eaters. The unit(s) shall be designed and constructed in accordance with the S oiler & Pressure Vessel ode, Section IV requirements for 10 psi (0 kpa) maximum working pressure, and shall bear the S "" Stamp and be listed by the ational oard. The unit(s) shall be constructed to comply with the efficiency requirements of the latest edition of SR Standard The heater shall be equipped with an S certified relief valve set at 1 psi (1 kpa). The water tube heat exchanger shall be stainless steel, rated at 10 psi (0 kpa) working pressure. The heat exchanger shall be a low water volume design, welded construction, with no gaskets, o-rings or bolts in the header. eat exchanger shall be accessible for visual inspection and cleaning of all internal surfaces. The heater shall be fully condensing design with built-in condensate drain and tap. The heat exchanger shall have a limited five-year warranty. ach heater shall be fully test fired, (with water, gas, and venting connected), and all safety components tested, at the factory. 1-0 models shall be shipped with a pump and a conduit. The wiring and terminals shall be wired to the pump. The heater shall have a flanged inlet water connection that allows the pump to be connected directly to the top of the heater in the field. The pump shall be capable of serving the heaters's heat exchanger and 0 feet (9m) of piping that is the same size as the heater's water connections, with a normal amount of pipe fittings. The heater shall use a premix burner with a stainless steel woven metal fiber wrap, and a negative pressure gas valve to burn cleanly, with Ox emissions not exceeding 10ppm. The heater shall meet the emissions requirements of SQ The heater shall be designed for the vertical or horizontal ategory IV venting, up to 100 equivalent feet (0m) with a PV, PV, polypropylene that complies with U S, or stainless steel vent material. may be taken from the room, or ducted directly to the heater, using up to 100 equivalent feet (0m) S, PV, PV. The heater shall be shipped with PV sidewall vent and air terminals, for use with horizontal systems. The first section of PV vent pipe shall be shipped with each heater. imensions and specifications subject to change without notice in accordance with our policy of continuous product improvement. mbler, P or U.S. and anada field service, contact your professional installer or local radford hite sales representative. Sales ax / Technical Support ax arranty ax International: Telephone Telefax 2-1- / Sales / Technical Support / ax / 201, radford hite orporation. ll rights reserved Printed in U.S..