Task Monitor the basement for unforeseen water with a water sensor Monitor the ground water level below the basement with a float switch Monitor the basement ducts or windows for housebreaking with reed contacts Monitor the rooms with motion detectors or smoke detectors Immediately trigger acoustic or visual alarm devices, e.g. horns or flashing lights. Scan the code and get more information! Active alarming via SMS with the LOGO! CMR module Page 1
Automation Solution 4 GPRS/GSM SIM card 1 2 3 PROFINET_IE 1 LOGO! Power 2 LOGO! logic module 3 LOGO! CMR2020 4 SINAUT rod antenna Page 2
Main Components 1 2 3 4 5 Product LOGO! Power 6EP1331-1SH03 LOGO! 12/24 RCE 6ED1052-1MD00-0BA8 LOGO! CMR2020 6GK7142-7BX00-0AX0 SINAUT ANT 794-4MR, rod antenna 6NH9860-1AA00 LOGO!Soft Comfort V8.0 6ED1058-0BA08-0YA1 Function description Supplies the control unit with 24V DC Reads control signals from the sensors Sends control signals to the actuators Signals warning and fault alarms Remote communication via mobile phone network Autonomously sends SMS messages Establishes connection to mobile phone network Programming the LOGO! logic module Page 3
Main Components 6 7 8 9 10 Product Water sensor Float switch Reed contacts Motion detector Smoke detector Function description The signal is reported to the LOGO! immediately via the relay contact in case of water contact The signal is reported to the LOGO! immediately via the relay contact in case of ground water level overflow The reed contact transfers the information if a basement duct or window has been opened A relay contact immediately reports if a person is present in a room Detects smoke development early on and reports this to the LOGO! via the relay contact Page 4
Main Components 11 12 13 Product Magnet valve Pump Acoustic alarm device with flashing light Function description The magnet valve is controlled with a LOGO! output. As soon as the water sensor comes into contact with water, the valve closes. Optionally, normally open or normally closed magnet valves can be used. The pump is controlled with a LOGO! output. As soon as an overflow of the ground water level is detected, the pump is activated. We recommend not to control the pump directly via the LOGO! output Q3, but with an additionally connected contactor/relay. The acoustic alarm device with flashing light is controlled with a LOGO! output. If required, several acoustic alarm devices with flashing light can be used Page 5
More Information Benefits Cost-effective and simple monitoring of buildings Easy extension with additional sensors Automatic alarm function directly via SMS Application areas Buildings, storage, utility rooms, summerhouse, caravan, yacht, motor vehicles Similar topics Building Control with LOGO! (Set 9-11) Further Information LOGO! and S7-1200 sets: https://support.industry.siemens.com/cs/ww/en/view/35923253 Industry Online Support: http://support.industry.siemens.com Page 6
Security Notice For the secure operation of Siemens products and solutions, it is necessary to take suitable preventive action (e.g. cell protection concept) and integrate each component into a holistic, state-of-the-art industrial security concept. Third-party products that may be in use should also be considered. For more information about industrial security, visit http://www.siemens.com/industrialsecurity. Page 7